• Korean Journal of Ichthyology
• /
• v.18 no.3
• /
• pp.202-208
• /
• 2006

An experiment was conducted to investigate the effects of three water temperatures (15, 20 and $25^{\circ}C$) in combination with three salinities (0, 15 and 30 psu) on the oxygen consumption rate of juvenile spotted sea bass, Lateolabrax maculatus (mean body weight $5.5{\pm}0.3g$). The oxygen consumption rates of L. maculatus were measured in triplicate for 24 hours using a continuous flow-through respirometer. Water temperature resulted in significant differences in the mean oxygen consumption rate of L. maculatus (p<0.001), but salinity and combinations of salinity and water temperature did not have (p>0.05). The oxygen consumption increased with increasing water temperatures in all experimental salinity regimes (p<001). Mean oxygen consumption rates at 15, 20 and $25^{\circ}C$ ranged 328.8~342.3, 433.9~441.0 and 651.5~659.9 mg $O_2\;kg^{-1}\;h^{-1}$, respectively. $Q_{10}$ values did not vary with salinity, bud varied with water temperature. $Q_{10}$ values ranged 1.63~1.75 between 15 and $20^{\circ}C$, 2.24~2.26 between 20 and $25^{\circ}C$, and 1.92~1.98 over the full temperature range. The energy loss by metabolic cost increased with increasing water temperatures in all experimental salinity regimes (p<0.001) Mean energy loss rates at 15, 20 and $25^{\circ}C$ ranged 224.6~233.8, 296.3~301.2 and $444.9{\sim}450.7kJ\;kg^{-1}\;d^{-1}$, respectively. These data suggest that the culture of juvenile spotted sea bass is possible without energy loss by salinity difference in freshwater as well as seawater after salinity acclimation. Thus, this result has an application for culture management and bioenergetic model for growth of this species.

• Proceedings of the KSPS conference
• /
• 2007.05a
• /
• pp.211-212
• /
• 2007

Stroke makes several physical deficits. Dysarthria is one of the most difficult problems in conventional medicine because of the weakness of neuromotor control. The purpose of this study is to find the acoustic characteristics of acupuncture therapy effects on post-stroke dysarthria. Seven patients with stroke(infarction or hemorrhage) were selected by CT or MR imaging. The authors applied acupuncture therapy by inserting needles into 8 acupuncture points, ipsilateral ST4, ST6 and contralateral LI4, ST36 on facial palsy side, and CV23, CV24, bilateral "Sheyu" for 4 weeks. Speech sample were composed of five simple vowels /a,e,i,o,u/ and meaningless polysyllabic words CVCVC(C: stops, affricated, fricative sounds, v: /e/). .VOT, total duration of each speech samples and vowel formant (F1&F2) were analyzed on Spectrogram. The results are as follows: 1. VOT of bilabial and velar stops was decreased post treatment. The VOT of bilabial glottalized pre and post treatment were statistically significant (p < 0.05). 2. Total duration of polysyllabic words was decreased post treatment. Decrement of total duration containing the bilabial was statistically significant (p<0.05). 3. First formant of round vowel /o/ pre and post treatment was statistically significant (p<0.05).

• Journal of Pharmaceutical Investigation
• /
• v.28 no.2
• /
• pp.87-92
• /
• 1998

Kojic acid (KA) is an antimelanogenic agent which has been widely used in cosmetics to whiten the skin color. However, it has the drawbacks of the skin irritancy and the instability against the pH, temperature, and light. In order to overcome these problems, various topical gels and multiple emulsion creams which can control the release of active ingredient, KA, were formulated employing cream bases of mineral oil with caprylic capric triglyceride and hydrophilic polymers such as chitosan, carbopol. and pluronics. Using Franz diffusion cells mounted with a synthetic cellulose membrane (MWCO 12,000), drug release characteristics of the formulations were evaluated by the HPLC assay of KA concentration in the receptor compartment of pH 7.4 phosphate buffered saline solution. Drug release from chitosan-based gels (ChitoGel) obeyed to the first order kinetics with a rapid release especially in the initial period. However, pluronic-based gels (PluGel) and carbopol-based gels (CarboGel) revealed controlled release of drug to some extent, followed by the square root-time kinetics. Moreover, the release of KA was further controlled with the W/O/W multiple emulsion creams (MultiCream), showing the apparent zero order release kinetics by virtue of dynamic ratecontrolling membrane of the oil layer. The flux $(J,\;{\mu}g/cm^2/hr)$ of ChitoGel. CarboGel. PluGel. and MultiCream in the initial period of 6hr were 73.30, 28.67. 24.04 and 7.72, respectively. On the other hand, the skin irritancy score of ChitoGel and MultiCream were observed as 2.5 and 2.3 respectively, in the rabbit skin irritation test. Although there were insignificant differences at p<0.05 between those formulations, it was possible to conclude that the W/O/W multiple emulsion creams containing KA might be a good candidate for an antimelanogenic drug delivery system due to the controlled release of acidic drug molecules.

• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.39 no.10
• /
• pp.35-42
• /
• 2002

Modulation frequency dependences of the pyroelectric properties of PLT (P $b_{1-x}$ L $a_{x}$ $Ti_{1-x}$ 4/ $O_3$) thin films with La concentrations of 5, 10 and 15㏖% have been investigated by using the dynamic method. The PLT thin film with 10㏖% of the La concentration (PLT(10) thin film) shows the most excellent pyroelectric properties among the films. For PLT(10) thin film, the pyroelectric coefficient shows the maximum value of 6.6$\times$10$^{-9}$ C/$\textrm{cm}^2$ㆍK without frequency dependence. The figure of merits for the voltage responsivity and specific detectivity are 1.03$\times$10$^{-11}$ Cㆍcm/J and 1.46$\times$10$^{-9}$ Cㆍcm/J, respectively. Voltage responsivity corresponding to the pyroelectric voltage is almost constant at low modulation frequency and decreases in proportional to frequency at high modulation frequency. Voltage responsivity is 5.15 V/W at 8Hz. Noise equivalent power (NEP) and specific detectivity ( $D^{*}$) of the PLT(10) thin film are 9.93$\times$10$^{-8}$ W/H $z^{1}$2/ and 1.81$\times$10$^{6}$ cmH $z^{1}$2/W at the frequency of 100Hz, respectively. The results indicate that PLT(10) thin film is very suitable for pyroelectric IR sensors.s.s.

• Journal of the Korean Vacuum Society
• /
• v.8 no.3B
• /
• pp.297-301
• /
• 1999

High quality CdTe single crystal for the solar cell fabrication was grown by vertical Bridgman method. The etch pits patterns of {111} surfaces of CdTe etched by Nakagawa solution was observed the {11} A composed of Cd atoms with typical triangle etch pits of pyramid mode. From the photoluminescence measurement of {111} A, we observed free exciton $(E_x)$ existing only high quality crystal and neutral acceptor bound exciton ($A^{\circ}$, X) having very strong peak intensity. Then, the full width at half maximum and binding energy of neutral acceptor bound exciton were 7 meV and 5.9 meV, respectively. By Haynes rule, and activation energy of impurity was 59meV. Therefore, the origins on impurity level acting as a neutral acceptor were associated Ag or Cu elements.

• Journal of Environmental Science International
• /
• v.27 no.5
• /
• pp.299-308
• /
• 2018

The adsorption characteristics of Cu ions were studied using the zeolite Na-A synthesized from Jeju volcanic rocks. The effects of various operating parameters such as initial concentration of Cu ions, contact time, solution pH, and solution temperature were investigated in batch experiments. The adsorption of Cu ions by Na-A zeolite was fitted well by pseudo-second-order kinetics and the Langmuir isotherm model. The maximum adsorption capacity determined using the Langmuir isotherm model was 152.95 mg/g. In addition, the adsorption of Cu ions by zeolite Na-A was primarily controlled by particle diffusion model in comparison with the film diffusion model. As the temperature increased from 303 K to 323 K, ${\Delta}G^o$ decreased from -2.22 kJ/mol to -3.41 kJ/mol, indicating that the adsorption of Cu ions by Na-A zeolite is spontaneous process.

• Korean Journal of Air-Conditioning and Refrigeration Engineering
• /
• v.6 no.4
• /
• pp.380-387
• /
• 1994

An experimental study was performed to investigate the characteristics of refrigerant flow rate control and superheat in an evaporator with an electronic expansion valve(EEV). The EEV used in this study was devised using a needle valve coupled with a stepping motor controlled by a personal computer. A Pill control equation was used to control the superheat of the evaporator and to set the superheat to $5^{\circ}C$. In order to determine an optimum running condition for the system, Pill parameters were varied for the wide range of values. The running condition of an air conditioning system with a PI control was reasonably stable compared with that of the Pill control. Experimental results for the PI control using parameter values, $K_p=1.5$, $T_i=400(sec)$ and $T_s=6(sec)$ show that the superheat reached its target value. When external disturbances were introduced to the system, the superheat target value was reached within about 3 minutes. When the EEV was applied to the air conditioning system driven by an inverter, room temperature control was excellent.

• Journal of Magnetics
• /
• v.10 no.2
• /
• pp.41-43
• /
• 2005

We have investigated an optical waveguide isolator with a multimode interference section by wafer direct bonding, operating at a wavelength $1.55\;{\mu}m$. In order to fabricate the device for monolithic integration, the wafer direct bonding between a magnetic garnet material as a cladding layer and a semiconductor guiding layer has been achieved. We found that wafer direct bonding between InP and GGG $(Gd_3Ga_5O_{12})$ is effective for the integration of a waveguide optical isolator. The isolation ratio was obtained to be 2.9 dB in the device.

• Proceedings of the KIEE Conference
• /
• 1999.07g
• /
• pp.3304-3306
• /
• 1999

In this study, we used the sputtering method with single target to obtain the thick and uniform PZT($PbZrTiO_3$) films for micromached IR sensor application. Then, we investigated the etching characteristics and conditions which is necessary process to fabricate the IR sensor. We tested the C-axis orientation and P-E loop of the deposited PZT films with the XRD and RT66A, respectively. Also we investigated the surface of the films by the AFM and SEM analysis.

• Nuclear Engineering and Technology
• /
• v.25 no.3
• /
• pp.447-456
• /
• 1993

A simplified model to assess the performance of engineered barrier for the retardation of radionuclide release in a low- and intermediate-level radioactive waste repository was developed. The model is based on the repository design concept being suggested in Korea, and considers two types of release scenario ; a design-bas release for the design of engineered barrier and a realistic release for the performance assessment. For the numerical illustration, the sample calculations were performed for five radionuclides with different chemical characteristics, and the results were analyzed.