• Transactions of the Korean Society of Automotive Engineers
• /
• v.18 no.5
• /
• pp.76-84
• /
• 2010

The aim of this study is to analyze the effect of the ethanol blending in diesel-ethanol blended fuels on the spray and combustion characteristics in a common-rail four-cylinder diesel engine. For the analysis of the spray characteristics, the spray images were obtained using a high speed camera with metal-halide lamps. From these spray images, the macroscopic spray characteristics such as the spray tip penetration and spray cone angle were investigated. Also, the combustion characteristics including the combustion pressure and the rate of heat release were studied with the analysis of the exhaust emissions in diesel-ethanol blended fuel driven diesel engine. It can be confirmed from the experiment on spray characteristics of diesel-ethanol blended fuels that the increased ethanol blending ratio induced the decrease of the spray tip penetration after the end of the injection. The spray cone angle slightly increased by the blending of ethanol fuel. In the experiment on atomization characteristics, the ethanol blending caused the improvement of the diesel atomization performance. On the other hand, at the same engine load condition, the increase of the ethanol blending ratio lead to lengthen the ignition delays, and to decrease the peak combustion pressure and the rate of heat release. Totally, the combustion and emission characteristics of ULSD and DE10 showed similar characteristics. However, in the case of DE20, CO and HC rapidly increased, and $NO_x$ decreased. It can be believed that 20% ethanol disturbed the combustion of diesel-ethanol blended fuel due to the low cetane number and evaporation.

• Journal of the Korean Institute of Gas
• /
• v.19 no.6
• /
• pp.8-14
• /
• 2015

Synthetic natural gas(SNG), acquired from coal, is regarded as an alternative to natural gas since a rise in natural gas due to high oil price can be coped with it. In the present study, 11-liter heavy duty compressed natural gas(CNG) engine was employed in order to examine the combustion and emission characteristics of SNG. The simulated SNG, made up 90.95% of methane, 6.05% propane and 3% hydrogen was used in the experiment. Power output, thermal efficiency, combustion stability and emission characteristics were compared to those with CNG at the same engine operating conditions. Knocking phenomenon was also analyzed at 1260 rpm, full load condition. Combustion with SNG was more stable than CNG. Nitrogen oxides emissions increased while Carbon dioxides emissions decreased. Anti-knocking characteristics were improved with SNG.

• Clean Technology
• /
• v.15 no.1
• /
• pp.1-8
• /
• 2009

The adoption of compressed natural gas (CNG) as a vehicle fuel is a common phenomenon as it is accelerating worldwide. Increasing number of CNG driven vehicles around the world has jumped up from one million in 1996 to five million in 2006. CNG as a vehicle fuel is very popular to the end users because of its clean-burning properties and cost effective solution compared to other alternative fuels like diesel and gasoline. The use of CNG as a fuel reduces vehicular emission that is consisted of carbon monoxide (CO), hydrocarbons (HC), oxides of nitrogen ($NO_x$), carbon dioxide ($CO_2$) etc. This research highlights the characteristics of CNG vehicles, CNG arrangement in the vehicles, CNG fueling procedures and most importantly the environmental and economic factors that are highly considered as cost effective solution for the flexibility of using CNG in the automobiles.

• Journal of the Korean Society of Marine Environment & Safety
• /
• v.27 no.7
• /
• pp.1074-1081
• /
• 2021

Nitrous oxide (N₂O) is one of the six major greenhouse gases and is known to produce a greenhouse ef ect by absorbing infrared radiation in the atmosphere. In particular, its global warming potential (GWP) is 310 times higher than that of CO₂, making N₂O a global concern. Accordingly, strong environmental regulations are being proposed. N₂O reduction technology can be classified into concentration recovery, catalytic decomposition, and pyrolysis according to physical methods. This study intends to provide information on temperature conditions and reaction time required to reduce nitrogen oxides with cost. The high-temperature ranges selected for pyrolysis conditions were calculated at intervals of 100 K from 1073 K to 1373 K. Under temperatures of 1073 K and 1173 K, the N₂O reduction rate and nitrogen monoxide concentration were observed to be proportional to the residence time, and for 1273 K, the N₂O reduction rate decreased due to generation of the reverse reaction as the residence time increased. Particularly for 1373 K, the positive and reverse reactions for all residence times reached chemical equilibrium, resulting in a rather reduced reaction progression to N₂O reduction.

• Journal of the Korean earth science society
• /
• v.22 no.6
• /
• pp.480-490
• /
• 2001

The soil-air exchange processes of Hg were investigated from the Hari area of Kang Hwa Island during the late March 2001. In the course of our study, we determined the concentration gradients of Hg and combined these gradient data with micrometeorological components to derive its fluxes. Results of our study indicate that the concentration levels of Hg in the study area are notably lower than those typically found in urbanized areas of Korea. However, the computed fluxes were seen to be significantly larger for relatively remote areas, reaching over 200 ng/m$^2$/hr. Comparison of environmental conditions shows that the concentrations of most pollutant species including NO$_X$ and PM were significantly higher during emission, while meteorological conditions were characterized by high temperature and low humidity. Results of correlation analysis also indicate that such pollutants as hydrocarbons, nitrogen oxides, and PM generally exhibit strong positive correlations with Hg-related parameters during emission events, while such relationships were reversed during dry deposition events. The results of our present study suggest the possibility that the concentrations and fluxes of total gaseous Hg observed during deposition events can be influenced by the processes that are also important for the fine, rather than coarse, size fraction of particles.

• Applied Chemistry for Engineering
• /
• v.32 no.5
• /
• pp.516-523
• /
• 2021

A study using selective catalytic reduction (SCR) was conducted in conjunction with ammonia as a reducing agent for controlling nitrogen oxides, a typical secondary inducer of fine dust in the atmosphere. For NH₃-SCR experiments, a commercial catalyst of V/W/TiO₂ only and also V/W-Sb/TiO₂ catalyst with Sb were used, and phosphorous durability was confirmed. As a result of NH₃-SCR experiments, it was confirmed that the addition of Sb to V/W/TiO₂ had durability against phosphorous. In addition, the physical and chemical properties were comparatively analyzed through BET, XPS, H₂-TPR, NH₃-TPD, and FT-IR analysis. From the anaylsis results, when Sb was added to V/W/TiO₂ catalyst, P was also added resulting in the formation of SbPO₄ and the generation of VOPO₄ was suppressed. The phosphorous durability was confirmed by maintaining the redox characteristics of the catalyst before P was added.

• Applied Chemistry for Engineering
• /
• v.32 no.6
• /
• pp.599-606
• /
• 2021

In this study, an experiment and a reaction characteristic study were conducted to enhance the reaction activity of V₂O₅/WO₃/TiO₂ at 300 ℃ or less by adding selenium to the support, in a selective catalytic reduction method using ammonia as a reducing agent to remove nitrogen oxides. Se-TiO₂ and TiO₂ were synthesized using the sol-gel method, and used as a support when preparing V₂O₅/WO₃/TiO₂ and V₂O₅/WO₃/Se-TiO₂ catalysts. The reaction activity of our catalyst was compared with that of a commercial catalyst. The denitration efficiency of the catalyst using TiO₂ prepared by the sol-gel method was lower than that of the catalyst prepared using commercial TiO₂, but was improved by the addition of selenium. Thus, the effect of selenium addition on the catalyst structure was analyzed using BET, XRD, Raman, H₂-TPR, and FT-IR measurements and the effect of the increase in specific surface area by selenium addition and the formation of monomer and complex vanadium species on reaction characteristics were confirmed.