• Journal of Surface Science and Engineering
• /
• v.32 no.4
• /
• pp.521-530
• /
• 1999

The corrosion resistance and the hardness of the tin-nickel alloy deposits electroplated in pyrophosphate bath were invesitigated according to electrolysis conditions and microstructure of the alloy. The weight loss of alloy deposits increased with the Sn content of single phase (Ni-Sn) alloy showing the lowest weight loss in the alloy with 54∼57wt% Sn. On the other hand, the multiphase alloy with 35∼42wt% Sn showed the highest one. The CASS test result was consistent with that of immersion test, and was good agreement with the corrosion data of polarization measurements. The hardness of alloy deposits decreased with the increase of Sn ratio in bath due to the grain size increase of the alloy. However, it increased noticeably with decreasing current density in the bath condition of low Sn ratio (0.1)

• Journal of the Korean Electrochemical Society
• /
• v.23 no.4
• /
• pp.105-112
• /
• 2020

Transition metal oxide, which undergoes a conversion reaction in the negative electrode material for a lithium-ion batteries, has a high specific capacity, but still has several critical problems. In this study, manganese pyrophosphate (Mn₂P₂O₇), nickel pyrophosphate (Ni₂P₂O₇), and carbon composite materials with pyrophosphates as novel negative electrode materials instead of transition metal oxide, are synthesized through simple solid-state reaction. The initial reversible capacity of Mn₂P₂O₇ and Ni₂P₂O₇ are 333 and 340 mAh g^-1, and when the composite materials are composed with carbon, the reversible capacity increases to 433 and 387 mAh g^-1, respectively. The initial Coulombic efficiency is also improved by about 10%. The Mn₂P₂O₇ and carbon composite material has the highest initial capacity and efficiency, and has the best cycle performance. Mn₂P₂O₇ containing polyanion, has a lower specific capacity due to the large mass of polyanion compared to MnO (manganese oxide). However, since Mn₂P₂O₇ shows a voltage curve with a slope, the charging (lithiation) voltage increases from 0.51 to 0.57 V (vs. Li/Li⁺), and the discharge (delithiation) voltage decreases from 1.15 to 1.01 V (vs. Li/Li⁺). Therefore, the voltage efficiency of the cell is improved because the voltage difference between charging and discharging is greatly reduced from 0.64 to 0.44 V, and the operating voltage of the full cell increases because the negative electrode potential is lowered during the discharging process.