• Asian Journal of Atmospheric Environment
• /
• 제11권3호
• /
• pp.153-164
• /
• 2017

Odor dispersion around a cubic building from rooftop odor emissions was investigated using computational fluid dynamics (CFD). The Shear Stress Transport (here after SST) $k-{\omega}$ model in FLUENT CFD code was used to simulate the flow and odor dispersion around a cubic building. The CFD simulations were performed for three different configurations of cubic buildings comprised of one building, two buildings or three buildings. Five test emission rates were assumed as 1000 OU/s, 2000 OU/s, 3000 OU/s, 4000 OU/s and 5000 OU/s, respectively. Experimental data from wind tunnels obtained by previous studies are used to validate the numerical result of an isolated cubic building. The simulated flow and concentration results of neutral stability condition were compared with the wind tunnel experiments. The profile of streamline velocity and concentration simulation results show a reasonable level of agreement with wind tunnel data. In case of a two-building configuration, the result of emission rate 1000 OU/s illustrates the same plume behavior as a one-building configuration. However, the plume tends to the cover rooftop surface and windward facet of a downstream building as the emission rate increases. In case of a three-building configuration, low emission rates (<4000 OU/s) form a similar plume zone to that of a two-building configuration. However, the addition of a third building, with an emission rate of 5000 OU/s, creates a much greater odorous plume zone on the surface of second building in comparison with a two-building configuration.

• 천문학회보
• /
• 제37권1호
• /
• pp.80.1-80.1
• /
• 2012

NGC 6803 is an elliptical ring shape planetary nebula. We analyzed the high dispersion spectra which had been observed with the Hamilton Echelle Spectrograph attached to the 3-m Shane telescope of Lick Observatory. We also investigated the low dispersion UV spectral data obtained with the 60-cm interstellar ultraviolet explorer. Diverse excitation lines were found from neutral to quadruply ionized ions. The temperature diagnostic lines indicate relatively low electron temperatures, i.e., $T_{\epsilon}{\leq}9500$ K for most lines except for [ClIV] - 11,500 K. In spite of its simplistic bi-laterally symmetrical elliptical shape, the nebula appears to be very complex of a hugh density range from 1300 to 80,000 $cm^3$. A comparison of the two epoch data suggests that the density increase occurred in the high excitation line zone near the inner boundary. We derived the chemical abundances of He, C, N, O, Ne, S, Ar, Cl, and K. The chemical abundances of NGC 6803 are enhanced compared with the average Galactic planetary nebula. Our self-consistent photo-ionization model study implies that the effective temperature of the central star is 90,000 K and its luminosity is 2400 $L_{\odot}$. The evolutionary track suggests that the progenitor of NGC 6803 was about 0.9 -- 1.0 $M_{\odot}$ star, which might be born from a metal-rich zone near the galactic disk, but now relocated into the present high Galactic latitude.

• 한국주거학회:학술대회논문집
• /
• 한국주거학회 2008년도 춘계학술발표대회 논문집
• /
• pp.281-284
• /
• 2008

The purposes of this study were to make clear the present condition of indoor thermal environment in apartment units and to analyze the relation of the living factors with indoor thermal elements. The field surveys consisted of measurements on physical elements and observations on living factors and interview on resident's subjective responses were carried out in 20 apartment units. The field surveys were carried out during the $January{\sim}March$ 2007. Measuring elements were air temperature, globe temperature, and relative humidity. As results, the averages of indoor temperature each houses were $21.2{\sim}27.2^{\circ}C$, the number of houses exceed the comfort zone were 4. The averages of globe temperature each houses were $21.3{\sim}27.5^{\circ}C$, 6 houses exceeded the comfort zone. The means of relative humidity were $19.5{\sim}58.8%$, relatively dry condition. The clothing value of residents were $0.39{\sim}0.89$ clo(average 0.68 clo). The average of thermal sensation ratings each room were $4.2{\sim}4.8$, 'neutral'$\sim$'slightly warm'. The results of regression analysis on relations of living factors with the thermal elements are as follow; ventilation time(outdoor air exchange), door opening time with balcony, and gas cooker use time had significant effect on indoor temperature.

• Asian-Australasian Journal of Animal Sciences
• /
• 제18권7호
• /
• pp.997-1002
• /
• 2005

The objective of this experiment was to determine agronomic characteristics, and forge yield and quality responses of rye variety to location and year for a double-cropping system in South Korea. Five forage rye varieties ('Koolgrazer', 'Jlee select', '9909', 'Homill22', 'Danko') were evaluated for forage quality and yields during the two growing years (the First year; 2001-2002, and the Second year; 2002-2003) at two locations (the central and southern zone). The heading date of rye in the central zone (Cheonan) was 15 April, and that of the southern zone (Daegu) was 10 April. The heading dates of 'Koolgrazer', 'Jlee select' and '9909' were earlier than those of the others. Although the five varieties had resistance to foliar diseases and insects, these had less lodging resistance. Dry matter (DM) content, DM and total digestible nutrients (TDN) yields had significant differences among rye varieties. DM and TDN yields of the rye varieties at the second year were higher than the first year in the central zone. In the southern zone, DM and TDN yields at the first year were lower than the second year. 'Jlee select' and '9909' had higher DM and TDN yields than the other varieties in both location and year except the first year of the central zone (p<0.001). The crude protein (CP) contents of rye grown in Cheonan were higher than Daegu. The CP content of 'Danko' variety was highest among tested varieties. The acid detergent fiber (ADF) and neutral detergent fiber (NDF) contents were greater for the varieties grown in Cheonan and in the second year. The ADF and NDF contents of 'Danko' were lowest, while 'Danko' in TDN and relative feed value (RFV) was highest among rye varieties. Our study showed that there are differences in forage production and quality from location to location, year to year and variety to variety. Therefore, forage quality and forage production are an important factor for screening forage rye varieties. Early maturing varieties should be recommended as high-yielding forage in a double-cropping system because their production of forage was greatest early in the season.

• Corrosion Science and Technology
• /
• 제13권2호
• /
• pp.48-55
• /
• 2014

Influence of annealing temperature on the microstructure and resistance to pitting corrosion of the hyper duplex stainless steel was investigated in acid and neutral chloride environments. The pitting corrosion resistance is strongly dependent on the microstructure, especially the presence of chromium nitrides ($Cr_2N$), elemental partitioning behavior and volume fraction of ferrite phase and austenite phase. Precipitation of deleterious chromium nitrides reduces the resistance to pitting corrosion due to the formation of Cr-depleted zone. The difference of PREN (Pitting Resistance Equivalent Number) values between the ferrite and austenite phases was the smallest when solution heat-treated at $1060^{\circ}C$. Based on the results of electrochemical tests and critical crevice temperature tests, the optimal annealing temperature is determined as $1060^{\circ}C$.

• Architectural research
• /
• 제13권2호
• /
• pp.23-30
• /
• 2011

Critical regionalism has been consistently influential in architecture since the 1980s. While acknowledging its contribution to the discipline of architecture, this article inquires into two co-related issues in critical regionalism as elaborated upon by Kenneth Frampton: critical subjectivity and identity. Regarding critical subjectivity, critical regionalism demands one to stand critical of both tradition and technological development. It assumes that one can locate herself in a neutral zone unshackled from both conditions so that she can make an unbiased judgment. This article criticizes this form of subjectivity by illuminating the situated nature of the subject in the continuity of tradition within which one always stands. The second issue is identity. Keeping the identity of a region through architecture is accepted as a rule in critical regionalism. However, how we shall understand the identity is unclear. This article introduces a notion of identity as rooted in the dialectics of opposites, and demonstrates it by referring to Le Corbusier's architecture and Tetsuro Watsuji's philosophy of climate. The objective of this series of inquiries is not to shake the validity of critical regionalism, but to renew and extend its significance for contemporary architecture.

• 대한가정학회지
• /
• 제31권3호
• /
• pp.213-222
• /
• 1993

The purpose of this study was to investigate the present conditions of thermal environment in small-size apartments. The research methods used were measuring of environmental elements and personal self-administration for the residents' thermal comfort responses. The house subjected were 25 peung apartments facing southeast and southwest directions. The results of this study were summarized as follow ; The indoor temperature and humidity of houses subjected were 25.0∼27.3℃, 37.1∼42.5%. Compared with the distribution of indoor temperature and globe temperature of houses subjected, those of southeast house were more stable. And in the residents' thermal sensation responses, the residents of southeast houses checked more often neutral zone. Therefore the thermal environment of southeast houses were more comfortable condition than southwest houses.

• 제어로봇시스템학회:학술대회논문집
• /
• 제어로봇시스템학회 2000년도 제15차 학술회의논문집
• /
• pp.317-317
• /
• 2000

The mathematical set-up model was developed to reduce the mechanical property deviation in annealed and slightly rolled steel strip. The mechanical peculiarities of temper rolling process, such as high friction value and non-circular contact arc, Low reduction and non-negligible entry and exit elastic zones as well as central restricted deformation zone are all taken into account. The deformation of work rolls is calculated with the influence function method and arbitrary contact arc shape is permitted. The strip deformation is modeled by slab method and the entry and exit elastic deformation zones are included. The restricted deformation Bone near the neutral point is also considered. It was revealed that the new model has better accuracy than present regression model by statistical analysis with actual mill rolling data.

• 자원환경지질
• /
• 제32권1호
• /
• pp.63-72
• /
• 1999

In order to examine the contamination levels of trace elements in stream sediments in the Chungnam coal mine area, stream sediment and water samples were collected and analyzed for trace elements. The pH of stream water was neutral or weak-alkaline and the mobility of metal in stream sediments was supposed to be low. From the result of cluster analysis, non-polluted sampling stations can be distinguished from polluted sampling stations influenced by mining activities. The trace element concentrations in sediments from non-polluted zone were considered to be the natural backround concentrations of this area. The trace element concentrations in sediment samples from the mining area were higher than those from non-polluted area, and contaminated area of enriched trace element levels need to be properly managed. From the results of discriminant and regression analyses, concentrations of Cd, Cu, Pb AND zN and predicted values of Be, Mo, and Ni in Chungnam coal mine area were found to be lower than those in metal mining areas in Korea.

• 대한치과의사협회지
• /
• 제53권6호
• /
• pp.411-417
• /
• 2015

In an edentulous situation, the oral rehabilitation with complete denture is substantially different from treatment of natural teeth. The artificial teeth arrangement and occlusion are important factor for the stability of the denture. Bilateral balanced occlusion is that stability of the denture is attained when bilateral contacts exist throughout all excursion and static states of the denture during function and, artificial teeth are arrangement in neutral zone where the forces between the tongue and cheeks or lips are equal. This is how dentist make a favorable prognosis. Therefore, dentists are have to be a little more involved in the selection and arrangement of artificial teeth.