• Proceedings of the Optical Society of Korea Conference
• /
• 1990.02a
• /
• pp.242-247
• /
• 1990

By self-homodyne method we measured the relative phase fluctuation of a light wave. Balanced detection system can eliminate local oscillator excess noise and multiport detection makes it possible ot measure the phase change of the signal beam. Deriving the SB(Signal Beam) and the LO(Local Oscillator) from the same laser source, we find the SB maintain constant phase relative to that of the LO. We have introduced a phase fluctuation in the SB by modulating the beam path of the SB. The measured phase fluctuation agreed well with the predicted one, thereby we confirmed the reliability of our system.

• Journal of electromagnetic engineering and science
• /
• v.15 no.4
• /
• pp.258-265
• /
• 2015

A de-embedding method for multiport networks, especially for coupled odd interconnection lines, is presented in this paper. This method does not require a conversion from S-parameters to T-parameters, which is widely used in the de-embedding technique of multiport networks based on cascaded simple two-port relations, whereas here, we apply an operation to the S-matrix to generate all the uncoupled and coupled coefficients. The derivation of the method is based on the relations of incident and reflected waves between the input of the entire network and the input of the intrinsic device under test (DUT). The characteristics of the intrinsic DUT are eventually achieved and expressed as a function of the S-parameters of the whole network, which are easily obtained. The derived coefficients constitute ABCD-parameters for a convenient implementation of the method into cascaded multiport networks. A validation was performed based on a spice-like circuit simulator, and this verified the proposed method for both uncoupled and coupled cases.

• Journal of Korea Water Resources Association
• /
• v.32 no.2
• /
• pp.153-162
• /
• 1999

In this study, mixing and dilution characteristics of vertical multijet discharged by multiport diffuser into stagnant water are investigated. The results obtained from the experiment of multiport diffuser performed in the three dimensional flume are as follows. As far as merging process of multiport diffuser is concerned, merging starts at about z/l = 3 although merging length is dependent upon stability condition and thereafter lateral temperature distribution becomes gradually uniform which is typical distribution of plane jet. Analyses of experimental data for minimum dilution show that characteristics of minimum dilution are described based on three regions which are jet region where momentum is dominated, intermediate region, and plume region where buoyancy is dominated. Minimum dilution coefficient in plume region of multiport diffuser obtained in this study is 15% higher than that of plane diffuser. This is because individual jet of multiport diffuser entrains more ambient water before merging is occurred, and therefore dilution increases.

• Journal of the Korean Institute of Telematics and Electronics A
• /
• v.32A no.10
• /
• pp.81-92
• /
• 1995

In this paper, we present a high-level synthesis system that generates area-efficient RT-level datapaths with multiport memories. The proposed scheduling algorithm assigns an operation to a specific control step such that maximal sharing of functional units can be achieved with minimal number of memory ports, while satisfying given constraints. We propose a measure of multiport memory cost, MAV (Multiple Access Variable) which is defined as a variable accessed at several control steps , and overall memory cost is reduced by equally distributing the MAVs throughout all the control steps. Experimental results show the effectiveness of the proposed algorithm. When compared with previous approaches for several benchmarks available from literature, the proposed algorithm generates the datapaths with less memory modules and interconnection structures by reflecting the memory cost in the scheduling process.

• Journal of the Korean Institute of Telematics and Electronics A
• /
• v.31A no.7
• /
• pp.117-124
• /
• 1994

In this pape, we propose a graph-theoretic approach for solving the allocation problem for the synthesis of datapaths based on multiport memories. An efficient algorithm is devised by using the weighted bipartite matching algorithm to assign variables to each port of memory modules. The proposed algorithm assigns program variables into a minimum number of multiport memory modules such that usage of memory elements and interconnection cost can be kept minimal. Experimental results show that the proposed algorithm generates the datapaths with fewer registers in memory modules and less interconnection cost for several benchmarks available from the literatures.

• Water Engineering Research
• /
• v.1 no.4
• /
• pp.309-320
• /
• 2000

In this study, laboratory study of the behavior of wastewater discharged from the Boston ocean outfall was compared with the predictions of mathematical models. The dta sets cover broad ranges of discharge conditions and oceanic conditions, and are associated with a typical type of outfall discharges with multiport diffusers. The laboratory data sets were obtained in density stratified towing tanks. These data sets were used to evaluate four commonly used models: UM, UDKHDEN, RSB and CORMI$\times$2 for minimum dilution, the height to the top of the wastefield, and wastefield thickness. For minimum diluation and height to the top of the wastefield, UM and RSB predictions agree well with laboratory data. UDKHDEN overestimated the minimum dilution and height to the top of the wastefield while CORMI$\times$2 underestimated these values. All of the model predictions for the wastefield thickness were widely scattered. about the measured values. The hydraulic model study reproduced the major features observed in the laboratory. It also afforded considerable insight into the mechanics of mixing of multiport risers which could not have been obtained either from the laboratory test or the mathematical models.

• ETRI Journal
• /
• v.35 no.4
• /
• pp.718-721
• /
• 2013

This letter proposes a novel calibration method for a multiport amplifier (MPA) to achieve optimum port-to-port isolation by correcting both the amplitude and phase of the calibration signals. The proposed architecture allows for the detection of the phase error and amplitude error in each RF signal path simultaneously and can enhance the calibrated resolution by controlling the analog phase shifters and attenuators. The designed $2{\times}2$ and $4{\times}4$ MPAs show isolation characteristics of 30 dB and 27 dB over a frequency range of 19.5 GHz to 22.5 GHz, respectively.

• The Transactions of the Korean Institute of Electrical Engineers
• /
• v.37 no.2
• /
• pp.73-79
• /
• 1988

A fault current in Simultaneous faults is calulated, which satisfies the reliability for expansion of power scale. New algorithm for analyzing fault current is developed, which calculates exactly thevnin equivalent impedance from fault point by cecomposing increment bus admittance matrix ( Ybus), and fault current is calculated by applying multiport theory. The signeficant results are as follows ` 1) When system fault changes system configulation, equivalent impedance can be calculated simply with this new algorithm. 2) Mutual coupling of transmission line can be calculated efficiently. 3) Simultaneous fault current is analyzed by applying multiport theory, which can be applicable to large scale systems.

• The Proceeding of the Korean Institute of Electromagnetic Engineering and Science
• /
• v.6 no.3
• /
• pp.80-90
• /
• 1995

The scattering parameters of a microstrip single line, a right-angle bend and a coupled line are calculated using the multiport network model for the frequency range from 1 to 18 GHz. The single line is analyzed using the planar waveguide model. The right-angle bend is broken into two rectangular segments, and each segment is analyzed in a similar fashion as the single line. Impedance matrices corresponding to the two segments are combined by the segmentation method. In the analysis of elec- tromagnetic coupling of the coupled line, a new method is employed resulting in much less computation time than those previous methods involving Green's functions. A good agreement between the numerical results for the three structures and those from SuperCompact reveals the usefulness of the multiport network medel in analyzing complicated mirostrip single and coupled line discontinuities.

• Journal of the Society of Cosmetic Scientists of Korea
• /
• v.17 no.1
• /
• pp.1-17
• /
• 1991

Multiport-600 Solar SimulatorR is one of the most recent and convenient in-strument for evaluation of sun protection factor(SPF). In this study, we examined the practicability of the SPF determining system using Multiport -600 and the effects of several factors-light sources, seasons and experimental animals-on the minimal erythema dose(MED) and SPF. We also tested the UV sensitivity according to the sites of Korean people, And the ultraviolet radiation reaching the earth's surface In Seoul have been observed for one year. As a result of this study, the determinig system for SPF using Multiport-600 was proved to be a good system in accuracy and time-saving. The biological activity of fluorescence UV lamp of PUVA-800R was significantly higher than natural light or solar simulator with Xe arc lamp, and the determined MED became lower in inverse proportion to room temperature rise. Skin sensitivity by ultraviolet adiation was hights. in order \circled1 back \circled2 inns, upper arm \circled3 outer upper arm \circled4 foream. We also observed that UV radiation intensity was highest at noon in july and 1 sun burn unit(MED) was 28 minutes at that time.