• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.19 no.11
• /
• pp.1193-1203
• /
• 2008

An active antenna(AA) can have wider bandwidth and more gain with small antenna size than those of passive antennas. However, AA inherently generates thermal noise and spurious signals from an active device. Moreover, the spurious performance of AA is very important in a highly sensitive receiving system since it is located at the front end of the receiving system. In this study, we developed an AA with $100{\sim}500\;MHz$, having the output P1dB higher than 3 dBm and little spurious signals in real environments. To achieve such performance, we designed an AA with 3-stage amplifier using CD(common drain) FET and 2 BJTs. Its electrical performances were simulated using ADS. The measurement results for typical gain, NF, OIP3, VSWR and P1dB in the required frequency band were 9.7 dBi, 10 dB, 14 dBm, 1.7:1 and 3 dBm respectively. They are in good agreement with simulation results. The unwanted spectrum level of the proposed AA is $10{\sim}30\;dB$ lower than that of the antenna with CS(common source) FET configuration at a west suburban area of Seoul, which shows that the proposed AA can be applicable to a highly sensitive receiving system for detecting unknown weak signals mixed with broadcasting and civilian communication signals.

• Journal of Communications and Networks
• /
• v.10 no.2
• /
• pp.127-136
• /
• 2008

For mobile wireless systems with full frequency reuse, co-channel interference near the cell coverage boundaries has a significant impact on the signal reception performance. This paper addresses an approach to efficiently mitigate the effect of downlink co-channel interference when multi-antenna terminals are used in cellular environments, by proposing a signal detection strategy combined with a system-level coordination for dynamic frequency reuse. We demonstrate the utilization of multi-antennas to perform spatial demultiplexing of both the desired signal and interfering signals from adjacent cells results in significant improvement of spectral efficiency compared to the maximal ratio combining (MRC) performance, especially when an appropriate frequency reuse based on the traffic loading condition is coordinated among cells. Both analytic expressions for the capacity and experimental results using the adaptive modulation and coding (AMC) are used to confirm the performance gain. The robustness of the proposed scheme against varying operational conditions such as the channel estimation error and shadowing effects are also verified by simulation results.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.35 no.6C
• /
• pp.547-553
• /
• 2010

In this paper, novel approximated closed-form expressions of the SER(Symbol Error Rate) and BER(Bit Error Rate) are presented for the multi-input multi-output space-time block coding(MIMO-STBC) system employing two transmit and N receive antenna(s) in Rayleigh fading channels. Assuming a zero-forcing equalizer and a single-symbol maximum-likelihood (ML) decoder, the formulas are derived for the SER and BER, and then their approximated counterparts are also derived. In the derivation of the approximated expressions, acurve-fitting model is adopted that can eliminate the integral operators in the exact expressions.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.28 no.10A
• /
• pp.775-779
• /
• 2003

A spatio-temporal searcher structure for 3rd generation W-CDMA systems is proposed to enhance the detection capability of the multi-path searcher for the desired signal. This searcher employs the spatio-temporal signal structure to search for newly emerging multipath signals. The proposed multi-path searcher provides better detection capability andthus reduces the mean acquisition time. The detection and false alarm probabilities of new and conventional schemes are calculated and numerical examples of mean acquisition time are given thereafter.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.38C no.4
• /
• pp.378-386
• /
• 2013

In this paper, we propose a multi-way relaying system, in which N communicating nodes interchange their information one another by the help of a multiple-antenna non-regenerative relay station (RS). While the conventional multi-way relaying requires 2N transmission phases to complete the data exchange, the proposed system completes the mission with N phases composed of one multiple access phase and N-1 broadcast phases. For effective broadcast transmission, the proposed system pairs users for signal transmission with a new RS beamforming matrix not to interfere with the nodes of different pairs and a self-interference canceler at each node. The performance evaluation in terms of the average sum rate shows that the proposed system outperforms the conventional one with more significant gain when the number of RS antennas is comparable to the number of communicating nodes. The proposed schemes can be applicable to marine communications where the ships need to share their information with extended coverage.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.21 no.4
• /
• pp.718-723
• /
• 2017

We propose a pilot hopping scheme that improves the limited system capacity due to pilot contamination in multi-cell environment with large-scale antenna arrays at a base station, assuming the infinite number of antennas. In the conventional fixed pilot scheme, each user obtains the same signal-to-interference ratio (SIR) over a long period of time. Therefore, a user with strong interference has continuously low SIR which degrades its service quality. In the proposed pilot hopping scheme, different pilot signals are used for each time slot, and different amounts of interference are received every time. When such a pilot hopping technique is applied, the SIR fluctuates at every time slot. When the Hybrid Automatic Repeat & reQuest (HARQ) technique is applied in such a channel, the outage probability and transmission rate are improved. We show that there is the performance gain of the proposed scheme over the conventional scheme through computer simulations.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.25 no.5A
• /
• pp.696-701
• /
• 2000

Electronic Toll Collection (ETC) System makes the telecommunication possible between the Beacon and the On Board Unit(OBU) for automatic toll collection. In this paper, the propagation path of microwave is modelled and the induced voltage of receiving antenna is analyzed numerically according to multi-path fading effect. In our modelling, we consider frequency, weather condition, polarization and antenna radiation pattern. Also, we suggest the diversity technique in order to reduce the fading effect. In the resuts, the fading effect is reduced significantly in case of the vertical polarization at the rain condition. In general the circular polarization is the most desirable in this application. The antenna which has the high directivity, is also desirable. Using the space and frequency diversity technique at the Beacon, the fading effect is reduced effectively. These results are compared with our experimental data.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 1999.11a
• /
• pp.101-105
• /
• 1999

Electronic Toll Collection(ETC) System makes the telecommunication possible between the Beacon and the On Board Unit(OBU) in vehicle at the highway. In this paper, the propagation path of microwave is modelled and the induced voltage of receiving antenna is analyzed numerically according to multi-path fading effort. In this modelling, we consider the weather condition, polarization and antenna radiation pattern. Also, we suggest the diversity technique in order to re duce the fading effect. In the result, the lading effort is reduced significantly in case of the vertical polarization at the rain condition. The circular polarization is the most desirable in this application. The antenna which has the high directivity, is also desirable. Using the space diversity technique at the Beaten, the fading effect is reduced as the distance increases between the Beacon and OBU. These results are presented at the graphs whose axes are related to the magnitude of received voltage(dB) and the distance of the beacon and a vehicle.

• ETRI Journal
• /
• v.30 no.6
• /
• pp.807-817
• /
• 2008

We present a low-density parity-check (LDPC)-based, threaded layered space-time-frequency system with emphasis on the iterative receiver design. First, the unbiased minimum mean-squared-error iterative-tree-search (U-MMSE-ITS) detector, which is known to be one of the most efficient multi-input multi-output (MIMO) detectors available, is improved by augmentation of the partial-length paths and by the addition of one-bit complement sequences. Compared with the U-MMSE-ITS detector, the improved detector provides better detection performance with lower complexity. Furthermore, the improved detector is robust to arbitrary MIMO channels and to any antenna configurations. Second, based on the structure of the iterative receiver, we present a low-complexity belief-propagation (BP) decoding algorithm for LDPC-codes. This BP decoder not only has low computing complexity but also converges very fast (5 iterations is sufficient). With the efficient receiver employing the improved detector and the low-complexity BP decoder, the proposed system is a promising solution to high-data-rate transmission over selective-fading channels.

• Journal of the Korean Society for Railway
• /
• v.4 no.4
• /
• pp.155-161
• /
• 2001

In this paper, the method is suggested to prevent data collision or damage on RFID(Radio Frequency Identification) system, in case a reader reading multi-tag simultaneously, using binary-search algorithm and Time-domain anti-collision procedure at reader and tag, respectively. The RFID system is designed that Reader enable to communicate with Tag on 13.56MHz bandwidth which is ISM(Industrial Science Medical) bandwidth, antennas of Tag part are designed using MCRF335 Chip. When RF communication is achieved between reader and tag, in case that data is transmitted to reader pass through multiple tags simultaneously, a study on the anti-collision method for the situation that the data collision occurs is performed.