• Atmosphere
• /
• v.21 no.2
• /
• pp.131-142
• /
• 2011

Spectral solar irradiances were observed using a visible and UV Multi-Filter Rotating Shadowband Radiometer on the rooftop of the Science Building at Yonsei University, Seoul ($37.57^{\circ}N$, $126.98^{\circ}E$, 86 m) during one year period in 2006. 1-min measurements of global(total) and diffuse solar irradiances over the solar zenith angle (SZA) ranges from $20^{\circ}$ to $70^{\circ}$ were used to examine the effects of clouds and total optical depth (TOD) on enhancing four solar irradiance components (broadband 395-955 nm, UV channel 304.5 nm, visible channel 495.2 nm, and infrared channel 869.2 nm) together with the sky camera images for the assessment of cloud conditions at the time of each measurement. The obtained clear-sky irradiance measurements were used for empirical model of clear-sky irradiance with the cosine of the solar zenith angle (SZA) as an independent variable. These developed models produce continuous estimates of global and diffuse solar irradiances for clear sky. Then, the clear-sky irradiances are used to estimate the effects of clouds and TOD on the enhancement of surface solar irradiance as a difference between the measured and the estimated clear-sky values. It was found that the enhancements occur at TODs less than 1.0 (i.e. transmissivity greater than 37%) when solar disk was not obscured or obscured by optically thin clouds. Although the TOD is less than 1.0, the probability of the occurrence for the enhancements shows 50~65% depending on four different solar radiation components with the low UV irradiance. The cumulus types such as stratoculmus and altoculumus were found to produce localized enhancement of broadband global solar irradiance of up to 36.0% at TOD of 0.43 under overcast skies (cloud cover 90%) when direct solar beam was unobstructed through the broken clouds. However, those same type clouds were found to attenuate up to 80% of the incoming global solar irradiance at TOD of about 7.0. The maximum global UV enhancement was only 3.8% which is much lower than those of other three solar components because of the light scattering efficiency of cloud drops. It was shown that the most of the enhancements occurred under cloud cover from 40 to 90%. The broadband global enhancement greater than 20% occurred for SZAs ranging from 28 to $62^{\circ}$. The broadband diffuse irradiance has been increased up to 467.8% (TOD 0.34) by clouds. In the case of channel 869.0 nm, the maximum diffuse enhancement was 609.5%. Thus, it is required to measure irradiance for various cloud conditions in order to obtain climatological values, to trace the differences among cloud types, and to eventually estimate the influence on solar irradiance by cloud characteristics.

• Journal of Radiation Protection and Research
• /
• v.38 no.1
• /
• pp.29-36
• /
• 2013

The aim of this study was to determine the correlation between exposure index (EI) and dose factors related to radiation dose optimization in digital radiography (DR) system. Two phantoms with built-in regional test object for quantitative assessment of images were used to produce image signals that acquired in chest radiography background. EI and entrane surface dose (ESD) increased proportionally with rise of radiation dose (kVp, mAs) in both DR and CR systems. Especially, DR detector was effective to form good contrast and hence, reached easily to improvement of image quality with minimal dose changes. It made operators possible to expect the accuracy of EI values deeply related to absorbed dose of the detector. The evaluation of images was obtained specially employed calculation of noise to signal ratio (NSR) and contrast to noise ratio (CNR). These measurements were performed for how exposure factors affect image quality. NSR was inversely proportional to kVp and mAs and low NSR represented high signal detection efficiency. Consequently, EI values was the measure of the amount of exposure received by the image receptor and it was proportional to exposure factors. Therefore the EI in a recommended range from manufacturer can offer optimal image quality. Also, continuous monitoring of EI values in the digital radiography can reduce the unnecessary patient dose and help the quality control of the system.

• Journal of Energy Engineering
• /
• v.29 no.2
• /
• pp.61-67
• /
• 2020

ESS-based buildings are being widely studied as an effective methods for saving energy with ZEB, BEMS, and FEMS. However, in large scale buildings, there are many energy-consuming facilities, so it is necessary to identify important energy-consuming facilities to build a real-time measurement system. In addition, there are a myriad of factors that affect the dependent variable of energy use, therefore there is a limitation that effective energy management is difficult. Therefore, this study applied the measurement boundary setting methodology according to the energy supply status through due diligence for the demonstration ESS distribution logistics facility, and suggested the methodolgy for presenting priority for the construction of the measurement system. Afterwards, the impact variables that Acting as an independent variable affecting the energy consumption of the distribution and logistics facilities were categorized into intrinsic and meteorological variables. Lastly, all factors that could affect the energy consumption of the actual distribution and logistics facilities, were classified and presented as guidelines list. By applying the results of this study, it is possible to build a monitoring system at a low cost and high efficiency in a distribution and logistics facility with a complex structure. And by identifying the main independent variables for the measured energy consumption, effectively identifying trends in energy consumption and deriving saving points It is expected to be able to operate the ESS-based infrastructure.

• Journal of the Korean Society for Railway
• /
• v.19 no.1
• /
• pp.38-45
• /
• 2016

The power transformation system of High Speed rolling stocks like KTX-Sancheon has shown excellent control capacities in the areas of riding comfortability, switching efficiency, safety and energy consumption due to technical developments in power-electronics, high speed & large scale integrated semiconductors and microprocessors. However, harmonics from IGBT, a high speed switching device used in the Convertor & Invertor equipment of rolling stocks have given rise to various problems in transformer substations, signaling systems, data transmission systems and facility monitoring systems. Especially, TI21 non-insulated track circuits have malfunctioned due to the influence of returning current harmonics which were generated at around of integer times of the number of power transformation equipment in the frequency domain. This paper, measures and analyzes various schemes to analyze the traveling path of the returning current harmonics generated due to the relationship between the rolling stocks and track circuits on site. Ultimately, theseschemes will be used to design high speed rolling stocks, AF track circuits and a common grounding network.

• Korean Journal of Veterinary Research
• /
• v.40 no.2
• /
• pp.383-391
• /
• 2000

Milk urea nitrogen (MUN) determination is being used an indicator of the protein-energy balance in dairy herds. A faulty balance can be corrected to optimize milk production and animal health. This parameter is regarded as a potential tool to evaluate suboptimal feeding practices and reproductive disorders. Therefore, the purpose of this study was to investigate the response of milk composition by regular feeding analysis and to compared the relationship between MUN and milk protein(MP) and fertility at the insemination period in Holstein dairy cows. Total of 355 artificial insemination (AI) for 150 Holstein cows in the herd were used to examine the relationship between MUN and MP content and conception rate. The AI occured for the cows 50 to 150 day in milk, and MUN and MP concentration were determined using automated infrared procedures. The mean${\pm}$standard deviation of MUN and MP concentration in the herd were $15.6{\pm}2.1mg/dl$ and $3.23{\pm}0.38%$, respectively. MUN contents of bulk milk were increase by elevated crude protein intake. The conception rate was lower in the cows in which the level of MUN was lower than > 8.0mg/dl (10.0%) or > higher than 25mg/dl (15.4%) relative to the cows in MUN content of 12.0~17.9 mg/dl (36.7%) at the time of insemination. Also, lower MP than 3.0% or higher MP than 3.25% were associated with a lower conception rates. Consequently, MUN and MP analyses may be used serve as a monitoring tool of protein and energy nutritional balance to improve reproduction efficiency in Holstein dairy cows.

• Journal of Korea Water Resources Association
• /
• v.53 no.spc1
• /
• pp.813-826
• /
• 2020

This study analyzes the effects of the Smart Water City (SWC) project that was introduced from 2014 to 2016 in Paju City, Gyeonggi Province, Korea, focusing on the achievement of the business goals. The SWC is referred to as a city that embraces a healthy water supply system based on Smart Water Management (SWM) that promotes the efficiency of water management by combining Information and Communication Technologies (ICTs) with water and sewerage facilities. In order to evaluate the effectiveness of the SWC project, this study deploys evaluation criteria corresponding to the project objectives, and analyzes the outputs before and after the project. The results show that the SWC has contributed to enhancing water supply services and the reliability and drinking rate of tap water. Specific improvement areas include the rise of average water flow rate and water leakage reduction, the diffusion of water quality monitoring system, and the reduction of floating particle concentration and turbidity in drainage pipes was achieved. These were possible because of specific implementation plans for clear goal setting and achievement and active services for citizens. The data related to water quantity and quality showed improved performance compared to before the introduction of SWMS, which is a positive effect. However, a quantitative analysis of the outputs has limitations in identifying other external factors that have led to the changes. In the future, guidelines for spreading SWC and more comprehensive and specific evaluation indicators for SWC should be prepared, and SWMS should be developed in consideration of the needs of users.

• Journal of Korean Society for Geospatial Information Science
• /
• v.22 no.1
• /
• pp.31-39
• /
• 2014

The trend of information service and its utilization has been gradually evolving due to the technological breakthrough in IT industries and the spread of smart phones. Especially regarding smart phones, a vast array of applications are being developed and employed for the purpose of providing real time information. Recently, numerous studies have been made and applied in regards to the efficient management and the supply of cadastral control point information. This research has developed and applied the NFC Cadastral Control Point, an advanced version of QR code Cadastral Control Point, which is installed and utilized in Dong-gu Ulsan, Korea, and an application that can utilize both the QR code and the NFC. In addition, this research continues on to analyzing the utility of the two methods that the survey use of a General Cadastral Control Point and the NFC Cadastral Control Point. Having implemented both methods, NFC Cadastral Control Point outweighed its counterpart in terms of the damage it gets from the outside influence and availability. Moreover, through developing Cadastral Control Point that could apply both the QR code Cadastral Control Point and NFC Cadastral Control Point, the research saw tremendous improvements compared to the survey method using the previously existing reference point performance. The results conveyed the fact that cadastral information application was time saving, convenient, and efficient in terms of finding information. Henceforth, with government's administration over Cadastral Control Point and with the development of more application for providing information, a nation-wide monitoring of Cadastral Control Point is considered possible and an efficient usage of information service is expected as well.

• Journal of the Microelectronics and Packaging Society
• /
• v.14 no.1
• /
• pp.49-53
• /
• 2007

The direct methanol fuel cell (DMFC) is a promising power source for portable applications due to many advantages such as simple construction, compact design, high energy density, and relatively high energy-conversion efficiency. In this work, an electrochemical methanol sensor for monitoring the methanol concentration in direct methanol fuel cells was fabricated using a thin composite nafion membrane as the electrolyte. We have analyzed the I-V characteristic of the fabricated methanol sensor as a function of methanol concentration, catalyst electrode and platinum(Pt) thickness. The fabricated sensor was analyzed by I-V measurement with various methanol concentration. When we measured the sensor characteristics with 10nm Pt and at 1V, the current value was $1.30{\times}10^{-6}A,\;1.96{\times}10^{-6}A\;and\;2.80{\times}10^{-6} A$ for three methanol concentration of 1M, 2M and 3M, respectively. When the methanol concentration was fixed at 2M, the current value of the fabricated device with Pt layers of 5, 10 and 15 nm thickness was $3.06{\times}10^{-6}A,\;1.96{\times}10^{-6}A\;and\;1.00{\times}10^{-6}A$, respectively. These results lead us to the conclusion that when the methanol concentration increases, the output current increases and when the catalyst electrode become thinner, the current increase more. It showed that, the thinner the catalyst electrode, the more electrochemistry become activation.

• Journal of Digital Convergence
• /
• v.14 no.12
• /
• pp.65-72
• /
• 2016

Personal Health Record(PHR) service can be helpful to patients with diseases requiring strict everyday care and medical treatment, such as diabetes or cancer. In this paper, we propose a PHR system specialized in collecting and analyzing health record data of cancer patients, and present the process of how the system can improve the efficiency of cancer treatment process. Through the smart device application, cancer PHR system obtains daily PHR data which is highly related and critical to cancer therapy. The analysis report is provided to the medical staff with an available format suited for Electronic Medical Record used at medical institution. With the final result of PHR analysis which is easily merged with medical chart, most efficient Chemotherapy treatment can be provided for the patients. Also it is possible for the patients to give the information of side-effect and other pain experience during therapy to their doctors without loss of information. The proposed PHR system has the effect of improving the quality of patient care by allowing the medical staff to acquire the main objective data necessary for drug prescription and medical care benefits.

• Journal of Navigation and Port Research
• /
• v.27 no.1
• /
• pp.97-102
• /
• 2003

Wire ropes are used in a myriad of various industrial applications such as elevator, mine hoist, construction machinery, lift, and suspension bridge. Especially, the wire rope of crane is important component to container transfer. If it happens wire rope failures during the operation, it may lead to safety accident, economic loss by productivity decline and so on. To solve this problem, we developed remote wire rope fault detecting system, and this system is consisted of 3 parts that portable fault detecting part, signal processing part and remote monitoring part. All detected signal has external noise or disturbance according to circumstances. So, we applied to discrete wavelet transform to extract a signal from noisy data. It is verified that the detecting system by de-noising has good efficiency for inspecting faults of wire ropes in service. As a result, by developing this system, container terminal could reduce expense because of extension fo wire ropes exchange period and could competitive power. Also, this system is possible to apply in several field such as elevator, lift and so on.