• 대한기계학회논문집B
• /
• 제34권5호
• /
• pp.481-489
• /
• 2010

수직관내 발달 유동의 층류혼합대류에 관한 본 연구는 Re 1,000에서 3,000, $Gr_H\;10^5$에서 $10^8$, Pr 2,000 에서 7,000 그리고 종횡비 1부터 7에 대한 범위에 대해서 수행되었다. 유사성(Analogy)의 원리를 이용하여 수직관내 발달 유동의 층류혼합대류 열전달계를 물질전달계로 모사하였다. 물질전달계로써 Nu 수는 기존의 문헌들의 그것들보다 상당히 큰 값이었는데, 이는 본 실험의 높은 Pr 수 때문이다. 본 연구에서의 종횡비는 완전발달 할 만큼 크지 않았기 때문에, 실험 결과는 긴 수직관내 혼합대류 유동보단 평행평판에서의 혼합대류 유동과 유사하였다. 본 연구의 결론으로서 낮은 종횡비와 $Gr_H$ 수를 갖는 수직관내 발달 유동의 층류혼합대류 유동은 수직 평판에서의 층류혼합대류 유동과 유사한 거동을 보인다는 것이다. 그리고 종횡비와 $Gr_H$ 수가 증가할 때 유체의 거동은 수직관내 완전발달 유동과 유사한 현상을 보였다.

• 한국건축시공학회:학술대회논문집
• /
• 한국건축시공학회 2005년도 춘계 학술기술논문발표대회 논문집
• /
• pp.65-68
• /
• 2005

This paper investigated the engineering properties of cement mortar mixed with more than 2 kinds of sand. For fresh mortar properties, unit volume weight is constant regardless of mixing content and type of sand. An increase in contents of river and crushed sand resulted in an increase in flow, whereas an increase in recycled sand contents reduced flow. Gap between maximum flow in N3C0R0 and minimum flow in N0C0R3 exhibited about $12\%$. Compressive strength at 28 days ranged from 32 to 36 MPa in order for crushed sand, river sand and recycled sand. Mortar with mixed sand along with river sand and crushed sand showed compressive strength comparable to crushed sand. An increase of fraction of recycled sand in mixed sand resulted in a decrease in compressive strength. For drying shrinkage, N0C0R3 had the largest drying shrinkage among various mixture type. The combination of large contents of recycled sand and small contents of river and crushed sand had a large amount of drying shrinkage.

• 한국환경복원기술학회지
• /
• 제13권4호
• /
• pp.52-64
• /
• 2010

This study was carried out to analyze the occurrence characteristics and the influence of forest environment factors on the debris flow of 3 national parks in korea. The results obtained from this study were summarized as follows; The total number of debris flow occurrence was 125 areas. The average length of the debris flow scar was 144m, average width was 20m. And the average area and sediment were $2,854m^2$ and $3,959m^3$ respectively. The factors influencing the debris flow were highly occurred in Metamorphic rock, mixed forest type. And also, slope gradient was $30{\sim}35^{\circ}$, aspect was NE, altitude was over 1,000m, vertical and cross slope was concave (凹), soil depth was below 15cm, stream order was 0 order. The variables of cross slope (complex), deciduous tree, soil depth (over 46cm), cross slope (concave), mixed forest type and altitude (801~1200m) in correlation analysis were significant at 1 % level. The landslide of high mountain area highly tend to change the debris flow in stream bed of torrent. The debris flow in national parks mainly occurred in high mountain area with long ridge and steep slope.

• Tribology and Lubricants
• /
• 제17권3호
• /
• pp.236-243
• /
• 2001

In this study, flow factors are evaluated in terms of kurtosis using random rough surface generated numerically. As h/$\sigma$become large ø$\sub$x/, ø$\sub$y/, ø$\sub$fp/, approach to 1 and ø$\sub$s/, ø$\sub$fs/ to 0 asymptotically regardless of kurtosis. ø$\sub$x/, ø$\sub$y/, ø$\sub$fp/ increase with increasing kurtosis in the mixed lubrication regime. ø$\sub$s/, ø$\sub$fs/ is associated with an additional flow transport due to the combined effect of sliding and roughness. As h/$\sigma$ decreases ø$\sub$s/, ø$\sub$fs/ increase up to a certain point, and then decrease toward zero. This behavior can be attributed to the increasing number of contacts in the mixed lubrication regime. ø$\sub$x/ in the presence of elastic deformation on the surface is larger than ø$\sub$x/ in the absence of it because local film thickness(h$\sub$T/) increases by elastic deformation.

• 한국전산유체공학회지
• /
• 제8권4호
• /
• pp.1-5
• /
• 2003

A Thin-layer Wavier-Stokes equations are applied for the hypersonic flow over blunt bodies with applications to laminar as well as turbulent flows. The equations are expressed in the forms of flux-vector splitting and explicit algorithm. The upwind schemes of Steger-Warming and Van Leer are investigated to predict accurately the heating loads along the surface of the body. A mixed scheme has been presented for the differencing the convective terms and the mixed scheme is found to be less dissipative producing accurate solutions.

• Bulletin of the Korean Chemical Society
• /
• 제34권12호
• /
• pp.3877-3880
• /
• 2013

• 대한기계학회논문집
• /
• 제15권5호
• /
• pp.1774-1780
• /
• 1991

본 연구에서는 유한 길이를 갖는 수직 덕트내 공기 유동의 속도 분포를 LDV를 사용하여 측정하며 유동 특성에 미치는 가열정도, 덕트간격 및 입구소도등의 영향을 보고하고자 한다. 또한 속도분포, 온도분포 및 열전달에 미치는 부력의 영향을 수치 적으로 예측하여 그 타당성을 검증하고자 한다.

• 한국산업보건학회지
• /
• 제6권1호
• /
• pp.125-137
• /
• 1996

This study was designed to investigate effects of relative humidity on the breakthrough of charcoal tubes at a fixed vapor concentration and sampling time during mixed organic vapor sampling. A vapor generator was used to generate three different concentrations of mixed organic vapor and a stainless steel chamber was fabricated and utilized to maintain three different percentages of relative humidity while maintaining a constant temperature. The results were as follows; 1. At high relative humidity, breakthrough of mixed organic vapor occurred quickly at low vapor concentration than at high vapor concentration because of the reduced adsorption volume of charcoal tube due to humidity. 2. Breakthrough by competitive adsorption of vapors onto charcoal tube was observed at first from n-hexane having the lowest boiling point and highest vapor pressure among the three organic vapors investigated, followed by TCE. No breakthrough was observed from toluene under all experimental conditions. 3. For n-hexane, breakthrough was observed after 2 hours of sampling and breakthrough rates were increased as relative humidity increased. For TCE, breakthrough was found after 3 hours of sampling and breakthrough rates by sampling time were increased as vapor concentration increased. 4. The adsorbed amount of mixed organic vapor at breakthrough was shown to have statistically significant correlations with sampling time, relative humidity, and vapor concentration in descending order of correlation. Relative humidity and sampling time for n-hexane and sampling time and concentration for TCE were both statistically significantly correlated. 5. Relative humidity was found to affect the amount of breakthrough of mixed organic vapor and n-hexane. Among three percentages of relative humidity investigated, the amount of breakthrough at 85 % relative humidity was significantly larger than those of at lower percentages of relative humidity. No statistically significant difference was found between 25 % and 55 % relative humidity. 6. The results of multiple regression analysis between breakthrough and relative humidity, vapor concentrations showed that the coefficient of determination of mixed organic vapor was 0.263 and those of n-hexane and TCE were 0.275 and 0.189, respectively. 7. Flow rates of sampling pumps used were found to be affected by relative humidity present. At 25 %, 55 %, and 85 % relative humidity, the relative errors of sampling pump were 1.4 %, 13.4 %, and 18.6 %, respectively. In conclusion, the results of this study showed that high relative humidity could reduce the adsorption volume of charcoal tubes and subsequently increase breakthrough rates. Therefore, to prevent breakthrough when sampling mixed organic vapors, it is suggested that either sampling volume be reduced on the flow rate be lowered so as to minimize breakthrough of the most volatile organic vapor in the mixture. In addition, since the flow rates of a sampling pump can be adversely affected by high relative humidity, it is recommended to use a constant flow mode pump when sampling in the highly humid environment.

• Journal of Advanced Marine Engineering and Technology
• /
• 제28권3호
• /
• pp.509-515
• /
• 2004

The PIV(Particle Image Velocimetry) with liquid crystal tracers is used for visualizing and analysis of the mixed convection in the parallel plates with the upper part cooled and the lower part heated. It is found that the flow pattern of mixed convection in the parallel plates can be classified into three patterns which was affected by Reynolds number. Also, the periodic nature is confirmed, and visualized in experiment.

• 한국전산유체공학회:학술대회논문집
• /
• 한국전산유체공학회 2009년 춘계학술대회논문집
• /
• pp.87-89
• /
• 2009

In the present paper, transition turbulence model is applied to the NACA64(3)618 and detailed flow features are studied. The turbulence model is sensitive to the boundary layer grid quality and y+ of the grid was limited to 1. The prediction of the transition region is dependent on the local flow condition. The pressure coefficient distribution of the transition turbulence model is compared with that of the fully turbulent mode and the drag distribution of the transition turbulence model was compared with that of the wind tunnel test.