• Journal of Navigation and Port Research
• /
• v.32 no.4
• /
• pp.271-277
• /
• 2008

When performing steering by an autopilot (automatic steering gear), a sensitivity adjustment is mainly determined by P value and D value. These values differ in the optimal combination by model of ship and external forces. This research was carried out simulation case studies and examined movement of Pure Car Carrier, which easily received ship by wind pressure influence in low speed We investigated the relation of horizontal migration(transfer) of ship's body and P-D value. Based on it, four parameters of P-D at approaching berth could be suggested Hence there were suggestions of parameters; Distance to maximum lee point, Time to maximum lee point, Time to return to original course and Time to 300th second. The correlation of these parameters and P-D value were also considered. As a result, we think that this index, like formulated P-D, leads to an easy and safe navigation by utilizing these indices.

• Journal of Embryo Transfer
• /
• v.13 no.3
• /
• pp.277-289
• /
• 1998

To establish a system for sperm swim-up separation through sucrose layer, indiscreet sperm migration should sufficiently to block but movement of sperm shouldn't inhibit. Thus, the effects of sucrose levels in sucrose layer, incubation times and types of sucrose layer on sperm separation were examined. And the results obtained were as follows; 1. Layer of 10mM sucrose inhibited sperm swim-up migration through sucrose layer. 2. Incubation for 25 minutes without sucrose layer significantly increased sperm swim-up migration. However, incubation for 10 minutes to induce swim-up through sucrose layer significantly stimulated sperm migration and maintained sperm movement. 3. There was no significant difference between Type I and Type II in barrier effect of sucrose layer. However, sucrose layer of Type II with shorter distance of barrier was efficient for sampling. To elucidate a function of follicular fluid on sperm chemotaxis using in vitro system of sucrose layer of Type II and incubation for 10 minutes, the effects of dilution, heat treatment, and protein and lipid extracts of follicular fluid on sperm swim-up separation were examined. And the results obtained were as follows; 4. Follicular fluid stimulated sperm migration and movement, and significantly-attracted capacitated-sperm at 10% level. 5. Follicular fluid heated at 55$^{\circ}C$ for 30 minutes maintained the effect of follicular fluid stimulating sperm migration and movement. 6. Follicular protein stimulated sperm movement that was reduced by filtration of the protein. 7. Follicular lipid didn't significantly stimulate sperm migration and movement. 8. Both of follicular protein and lipid reduced the effect of follicular fluid stimulating sperm migration and movement. In conclusion, sucrose layer could be used for a barrier against indiscreet sperm migration by swim-up. And follicular fluid stimulated migration and movement of sperm and attracted capacitated-sperm through sucrose layer. Especially, heat-resistant protein of follicular fluid stimulated sperm migration.

• Clinics in Shoulder and Elbow
• /
• v.20 no.4
• /
• pp.230-235
• /
• 2017

Background: Neer type II distal clavicle fractures have the drawback of coracoclavicular instability and insufficient distal bony fragment, thereby making it difficult to achieve adequate fixation. Although various surgical treatments have been described for Neer type II fracture, the optimal treatment remains controversial. This study reports the clinical results and usefulness of anatomical locking plate with additional K-wire fixation. Methods: A totally of 21 patients with type II distal clavicle fracture were included in the study. The surgical procedure reduced the fracture temporarily; it included insertion of one or two K-wire from the lateral margin of the distal fragment to the proximal fragment through the fracture site, followed by application and fixation of the locking plate. The bony union and migration of K-wire was evaluated in the follow-up radiography. The coracoclavicular distance and acromioclavicular joint arthrosis were assessed at the final follow-up. The Constant Score (CS) and Korean Shoulder Score (KSS) were evaluated for clinical scoring. Results: Bone union was achieved in all cases. At the final follow-up, coracoclavicular distance of the injured shoulder was increased, as compared to the intact shoulder (p=0.002), with no accompanying clinical symptoms. No K-wire migration was observed. At the final follow-up, K-wire irritation was observed in two cases and acromioclavicular arthrosis in one case, with no other adverse effects. Pain visual analogue scale, CS, and KSS were improved in all cases. Conclusions: The method of anatomical locking plate with additional K-wire fixation could be useful in achieving beneficial clinical results.

• Journal of the Korean Society for Aeronautical & Space Sciences
• /
• v.40 no.1
• /
• pp.49-60
• /
• 2012

Synthetic aperture radar (SAR) has been employed in various fields due to its capability to generate high resolution images regardless of weather and visibility. This paper presents a performance analysis on the image formation of high resolution SAR according to various slant range distance and synthetic aperture lengths using a range migration algorithm simulator. Although the visual performance on the SAR image is more accurate, a numeric analysis resulted in a comparable measurement. More specifically, raw data were generated for an ideal point target upon imaging geometries and design parameters such as slant range distance and synthetic aperture lengths. Finally, spatial resolution, peak to sidelobe ratio and integrated sidelobe ratio are drawn to provide SAR capabilities in the initial concept design, final in-flight calibration and validation stages.

• Korean Journal of Ecology and Environment
• /
• v.52 no.1
• /
• pp.9-12
• /
• 2019

The red-eared slider (Trachemys scripta elegans) is the one of the most popular pets, and the most commonly traded species in the world. It is designated as an ecosystem disturbance species that has been managed in South Korea. To date, no reports of natural or anthropogenic migration and spreading of T. s. elegans in South Korea are available. In the present study, we estimated the expected route and the movable path of one female T. s. elegans found in Namsan-myun, Gyeongsan-si, Gyeongsangbuk-do. Based on the movable path, the potential destination of the female turtle was estimated to be about 282 m and 468 m away. Therefore, the moving distance of the red-eared slider to the nearest water system will be at least 606 m and at most 792 m. Our results provide the first evidence about the natural migration and spreading of exotic turtles. This study can serve as a basis for the management and countermeasures against the introduced of T. s. elegans and other exotic species in South Korea.

• Industrial Engineering and Management Systems
• /
• v.3 no.2
• /
• pp.129-133
• /
• 2004

Studies on the optimal location of retail store have been made in case of no obstacle(Minagawa etal. 1999). This paper deals with the location problem of retail store considering obstacles (e.g. rivers, railways, highways, etc.) and obstacle-overcoming points (e.g. bridges, railway crossings, zebra crossings, overpasses, etc.). We assume that (1) commercial goods dealt here are typically convenience goods, (2) the population is granted as potential demand, (3) the apparent demand is a function of the maximum migration length and the distance from the store to customers, (4) the scale of a store is same in every place and (5) there is no competitor. First, we construct the basic model of customers' behavior considering obstacles and obstacle-overcoming points. Analyzing the two dimensional model, the arbitrary force attracting customers is represented as a height of a cone where the retail store is located on the center. Second, we formulate the total demand of customers and determine the optimal location that maximizes the total demand. Finally, the properties of the optimal location are investigated by simulation.

• Journal of Soil and Groundwater Environment
• /
• v.22 no.3
• /
• pp.42-49
• /
• 2017

TOUGH2 was used to simulate the migration of $CO_2$ injected into a sandy aquifer. A series of numerical simulations was performed to investigate the effects of a low-permeability layer (LPL) embedded in the aquifer on the injection rate and the pressure distribution of $CO_2$. The results show that the size and location of the LPL greatly affected the spread of $CO_2$. The pressure difference between two points in the aquifer, one each below and above the LPL, increased as the size of the LPL increased, showing a critical value at 200 m, above which the size effect was diminished. The location of the LPL with respect to the injection well also affected the migration of $CO_2$. When the injection well was at the center of the LPL, the injection rate of $CO_2$ decreased by 5.0% compared to the case with no LPL. However, when the injection well was at the edge of the LPL, the injection rate was decreased by only 1.6%. The vertical distance between the injection point and the LPL also affected the injection rate. The closer the LPL was to the injection point, the lower the injection rate was, by up to 8.3%. Conclusively, in planning geologic storage of $CO_2$, the optimal location of the injection well should be determined considering the distribution of the LPL in the aquifer.

• Korean journal of applied entomology
• /
• v.50 no.2
• /
• pp.97-105
• /
• 2011

Understanding the metapopulation structure and movement of a species are required for conserving the species. In this paper, migration patterns and connectivity of patches of a threatened butterfly, Parnassius bremeri Bremer, were postulated using the mark-release-recapture (MRR) technique in a habitat located in the mid-southern region of the Korean peninsula. A total of 194 individuals were captured (137 males and 57 females) and, of them, 93 individuals (73 males and 20 females) were recaptured during the MRR experiment. The migration analysis showed 23-150% immigration and 28-53% emigration. There were high correlations between the migrating individuals and the distance between patches, but there was no correlation between migrating individuals and patch size or between migrating individuals and the number of host plants. Consequently, the migration of butterflies occurred frequently between closer patches, while patch size and quantity of the food plant had minor effects on migration behavior. Additionally, males migrated more frequently than females. Analysis of the migration patterns of P. bremeri showed that the central patch played an important role on linking patch groups and more frequent migrations were monitored between nearby patches than between the remote patches. This study suggested that active migrations take place between the neighboring multiple patches and these are accelerated if there is a stepping-stone patch between them.

• Economic and Environmental Geology
• /
• v.39 no.6 s.181
• /
• pp.711-717
• /
• 2006

In order to study gas hydrate, potential future energy resources, Korea Institute of Geoscience and Mineral Resources has conducted seismic reflection survey in the East Sea since 1997. one of evidence for presence of gas hydrate in seismic reflection data is a bottom simulating reflector (BSR). The BSR occurs at the interface between overlaying higher velocity, hydrate-bearing sediment and underlying lower velocity, free gas-bearing sediment. That is often characterized by large reflection coefficient and reflection polarity reverse to that of seafloor reflection. In order to apply depth migration to seismic reflection data. we need high performance computers and a parallelizing technique because of huge data volume and computation. Phase shift plus interpolation (PSPI) is a useful method for migration due to less computing time and computational efficiency. PSPI is intrinsically parallelizing characteristic in the frequency domain. We conducted conventional data processing for the gas hydrate data of the Ease Sea and then applied prestack depth migration using message-passing-interface PSPI (MPI_PSPI) that was parallelized by MPI local-area-multi-computer (MPI_LAM). Velocity model was made using the stack velocities after we had picked horizons on the stack image with in-house processing tool, Geobit. We could find the BSRs on the migrated stack section were about at SP 3555-4162 and two way travel time around 2,950 ms in time domain. In depth domain such BSRs appear at 6-17 km distance and 2.1 km depth from the seafloor. Since energy concentrated subsurface was well imaged we have to choose acquisition parameters suited for transmitting seismic energy to target area.

• Economic and Environmental Geology
• /
• v.34 no.3
• /
• pp.271-281
• /
• 2001

The characteristics of the heavy metal contamination in the soils affected by the tailings of the Palbong mine have been studied. The soils in the studied area consist mostly of loam by the particle size analysis, but a little of it, located near the stream, consist of loamy sand to sandy loam, finally to loam downward. The organic contents of soils are significantly low aoom 2 percent and the pH is in acidic ranging 6.0 $\pm$ 0.1. The samples of the parent rocks, the normal soils, the tailings and the channel deposits from the studied area were chemically analysed. From the result, the heavy metal concenlration of the soils is a little Jow compared with that of the parent rocks, shows the hydrologic process of the surface and the groundwater. The contamination of the tailings from the ore mining are high in lead, copper and arsenic. In the channel deposits the concenlrations of lead and copper are abnormally high but that of arsenic is uniquely low. And most of heavy metal contamination are decreased with the distance from the mine. It is caused by the properties of the surface and the ground water during the process of the heavy metal migration. The correlation-coefficient between sand and silt contents and the concentrations of Cd, Cu and Pb are significant but the amounts of As and Hg are increased with the clay contents. The dispersion of the heavy metals with the distance shows that the concentrations of them in the soils sampled at distance of 100 m to 200 m along the stream started near the Palbong mine are extremely high compared with those from other distances. These discrepancies are significant in Cd, Cu, Pb and Hg, but low in As. All the samples contain below detection limit of Cr+6 In the present stream water the concentrations of the heavy metals are not detected. So, it is interpreted that the concentrations in the soils are caused by the activities of the mining during the operation and have been continued by the dispersion from the tailings since after the closure of the mining, especially by the surface and ground water. The concentrations are diminished with the distance from the mining site, but in the interval of 800-2000 m increases abruptly. In the soil samples counted on the dispersion direction by wind, the lowering of the concentration is relatively uniform with the distance from the mining site. So, the rapid increase of the heavy metal concentrations is presumed to have been caused by the ground-water movement. In the migration of the heavy metals, the groundwater conditions, such as pH, Eh, the contents of colloidal particles, and Mn and Fe oxides are closely involveo. Integrating with these factors, it is interpreted that the groundwater conditions which have caused the heavy metal contamination of the studied area are those that the pH is about 3 in oxidized conditions, the contents of the colloidal particles are low, and Mn and Fe oxides are not involved in the migration of the heavy metals. Meanwhile, the vegetables growing on the soils in the studied area are not affected by the contamination of the heavy metals.