• Steel and Composite Structures
• /
• v.45 no.1
• /
• pp.119-131
• /
• 2022

Due to the complexity of the structure and the limits of classical SEA, a combined SEA approach is employed, with angle-dependent SEA in the low- and mid-frequency ranges and advanced SEA (ASEA) considering indirect coupling in the high-frequency range. As an important component of the steel box girder, the dynamic response of an L-junction periodic ribbed plate is calculated first by the combined SEA and validated by the impact hammer test and finite element method (FEM). Results show that the indirect coupling due to the periodicity of stiffened plate is significant at high frequencies and may cause the error to reach 38.4 dB. Hence, the incident bending wave angle cannot be ignored in comparison to classical SEA. The combined SEA is then extended to investigate the vibration properties of the steel box girder. The bending wave transmission study is likewise carried out to gain further physical insight into indirect coupling. By comparison with FEM and classical SEA, this approach yields good accuracy for calculating the dynamic responses of the steel box girder made of periodic ribbed plates in a wide frequency range. Furthermore, the influences of some important parameters are discussed, and suggestions for vibration and noise control are provided.

• The Transactions of the Korean Institute of Power Electronics
• /
• v.18 no.6
• /
• pp.593-600
• /
• 2013

The asymmetric pulsed DC reactive magnetron sputtering system is widely used for the high quality plasma sputtering process such as a thin film deposition. In asymmetric pulsed DC power supply a reverse voltage is applied to the target periodically to minimize arc discharging effect. When sputtering in the mid-frequency range (20-350 kHz), the periodic target voltage reversals suppress arc formation at the target and provide long-term process stability. Thus, high quality, defect-free coatings of these materials can now be deposited at competitive rates. In this paper, a new style asymmetric pulsed DC power supply including mid-transformer is presented. In the proposed, an energy recovery circuit is adopted to reduce the mutual inductance of the transformer. As a result, the system dynamics of the voltage control loop is increased highly and the non-linear voltage boosting effect of the conventional system is removed. This work was proved through simulation and laboratory based experimental study.

• Proceedings of the KSR Conference
• /
• 2002.10b
• /
• pp.1086-1093
• /
• 2002

In Korea mid chord offset method has been used to measure the track irregularities. This method has been also used all over the world widely because of its accessibility and the operational excellence for measured data. But it has been pointed out recently that track irregularities reconstructed from measured data have unexpected noise in the high frequency area as the defect of this way. This study shows the cause of noise which occurs during reconstructing process and mentions the solutions briefly.

• Proceedings of the KIPE Conference
• /
• 2005.07a
• /
• pp.45-47
• /
• 2005

A digital controller of stepping motors is designed for removing mid-range resonance. Rotor oscillation is detected from motor currents and the microprocessor generates frequency modulation taking into account rotor oscillation. ATmega16 is employed and the controller drives stepping motors up to 3000[rpm] at micro stepping.

• Journal of the Korea institute for structural maintenance and inspection
• /
• v.26 no.1
• /
• pp.39-48
• /
• 2022

In earthquake situations, broadcasting and communication services are directly linked to rapid on-site rescue and effective restoration works. Recently, a variety of base isolation devices are widely introduced on building floors to avoid critical seismic damages of telecommunication facilities. However, in buildings with long fundamental periods, those devices may have undesirable amplification of seismic responses due to resonance effect between the building floors and base isolation devices. This study performs the seismic safety evaluation of two types of base isolation devices deployed for telecommunication facilities in mid- and high-rise buildings through numerical and experimental approaches. It is found that mid- and high-rise buildings can have low-frequency dynamic responses at the top floor when being subjected to design basis earthquake loading. Furthermore, bi-directional shake table testing demonstrated that the selected base isolation devices can exhibit unstable dynamic behaviors under such low-frequency excitations of the floor.

• Journal of Environmental Science International
• /
• v.28 no.10
• /
• pp.863-872
• /
• 2019

Using the Standard Precipitation Index (SPI), this study analyzed the drought characteristics of ten weather stations in Gyeongbuk, South Korea, that precipitation data over a period of 30 years. For the number of months that had a SPI of -1.0 or less, the drought occurrence index was calculated and a maximum shortage months, resilience and vulnerability in each weather station were analyzed. According to the analysis, in terms of vulnerability, the weather stations with acute short-term drought were Andong, Bonghwa, Moongyeong, and Gumi. The weather stations with acute medium-term drought were Daegu and Uljin. Finally the weather stations with acute long-term drought were Pohang, Youngdeok, and Youngju. In terms of severe drought frequency, the stations with relatively high frequency of mid-term droughts were Andong, Bonghwa, Daegu, Uiseong, Uljin, and Youngju. Gumi station had high frequency of short-term droughts. Pohang station had severe short-term ad long-term droughts. Youngdeok had severe droughts during all the terms. Based on the analysis results, it is inferred that the size of the drought should be evaluated depending on how serious vulnerability, resilience, and drought index are. Through proper evaluation of drought, it is possible to take systematic measures for the duration of the drought.

• International Journal of Highway Engineering
• /
• v.19 no.4
• /
• pp.69-78
• /
• 2017

PURPOSES : In this study, we analyzed the road crossing behavior of older pedestrians on a mid-block signalized crosswalk, and compared it to that of younger pedestrians. In addition, we analyzed the correlation between accidents involving older pedestrians while crossing roads and their behavioral characteristics. Finally, we confirmed the reasons for an increase in accidents involving older pedestrians. METHODS : First, 30 areas with the highest incidence of accidents involving older pedestrians while crossing roads were selected as target areas for analysis. Next, we measured the start-up delay (the time elapsed from the moment the signal turns green to the moment the pedestrian starts walking) and head movement (the number of head turns during crossing a road) of 900 (450 older and 450 younger) pedestrians. The next step was to conduct a survey and confirm the differences in judgment between older and younger pedestrians about approaching vehicles. Finally, we analyzed the correlation between the survey results and traffic accidents. RESULTS : The average start-up delay and head movement of the older pedestrians was 1.58 seconds and 3.15 times, respectively. A definite correlation was obtained between head movement and the frequency of pedestrian traffic accidents. The results of our survey indicate that 17.3% of the older pedestrians and 7.8% of the younger pedestrians have a high crash risk. CONCLUSIONS : Behavioral characteristics of older pedestrians were closely correlated with accidents involving older pedestrians while crossing roads in mid-block signalized crosswalks. Our study indicates that in order to reduce the number of accidents involving older pedestrians, it is necessary to develop an improvement plan including measures such as installation of safety facilities taking the behavioral characteristics of older pedestrians into consideration and their safety education.

• Journal of the Korean Society for Nondestructive Testing
• /
• v.32 no.3
• /
• pp.276-283
• /
• 2012

In this study, it was studies the utilization of LIT(lock-in infrared thermography) which can detect defects in welded parts of ship and offshore structures. Quantitative analysis was used through methods of filtering and texture measurement of image processing techniques to find the optimized experimental condition. We verified reliability in our methods by applying image processing techniques in order to normalize evaluations of comparative images that show phase difference. In addition, low to mid exposure showed good results whereas high exposure did not provide significant results in regards to intensity of light exposure on surface. Lock-in frequency was satisfactory around 0.1 Hz regardless of intensity of light source we had. In addition, having the integration time of thermography camera inversely proportional to intensity of exposed light source during the experiment allowed good outcome of results.

• Horticultural Science & Technology
• /
• v.32 no.1
• /
• pp.77-83
• /
• 2014

To improve the breeding efficiency of oriental pear, the inheritance of major fruit traits were analyzed using 4,035 seedlings of 15 cross combinations combined with 13 cultivars. Yearly variation of parental cultivars, broad-sense heritability of the traits, and frequency of seedlings with commercially acceptable characteristics by the mid-parent values were studied. Despite the heritabilities of traits related with pear the fruit texture were different depending on cross combination, the average narrow-sense heritability ($h^2$) for firmness, flesh hardness, flesh density and grit were over 0.6, a relatively high value. However fruit firmness showed different heritability among the cross combination and its value of cross combination between 'Niitaka' and 'Choju' was very low as 0.11. Positive correlation was not observed on fresh hardness, fresh density and grit but observed on firmness between mid-parent value and average value of offspring. Regression of offspring on firmness, fresh hardness, fresh density and grit between mid-parent value and average value of offspring were 0.778, 0.343, -0.273, 0.313, respectively. Frequency distributions of fruit texture in 15 cross combinations of pear seedling was influenced by parental characteristics. When fruit firmness was estimated as low, low ${\times}$ high and high ${\times}$ high values in parental fruits, firmness in their offspring exhibited low, medium and high, respectively. In addition, when parental grit by sensory evaluation were light ${\times}$ light and light-medium ${\times}$ medium-heavy, most of offsprings showed light and medium grit, respectively.

• Journal of Advanced Navigation Technology
• /
• v.21 no.4
• /
• pp.353-358
• /
• 2017

In order to reduce the size of the previous stepped slot antenna for UWB applications(3.1 ~ 10.6 GHz) to half, an open ended stepped slot antenna is proposed. The proposed antenna consists of a stepped slot etched on the ground plane as radiation part and a microstrip feed-line with rectangular patch on the top plane for wideband impedance matching. The proposed antenna is designed and fabricated on the FR4 substrate with dielectric constant of 4.3, thickness of 1.6 mm and size of $28.5{\times}32mm^2$. The measured impedance bandwidth (${\mid}S_{11}{\mid}{\leq}-10dB$) of the fabricated antenna is 7.99 GHz(3.01~11 GHz) which is sufficient to cover UWB band (3.1 ~ 10.6 GHz). In particular, it has been observed that antenna has a good omnidirectional radiation patterns and high gain over the entire frequency band of interest even though the size of the proposed antenna is reduced to half when compared with the previous antenna.