• 멤브레인
• /
• 제13권1호
• /
• pp.47-53
• /
• 2003

Poly(ether ether ketone)(PEEK)를 황산을 사용하여 설폰화시킨 후 폴리설폰과 다양한 조성으로 혼합하여 블렌드 고분자 전해질 막을 제조하였고 조성의 변화에 따른 메탄을 투과도, 수소이온전도도, 그리고 이온교환용량의 변화를 측정하였다. 폴리설폰의 경우 이온전도도는 낮은 반면에 메탄올에 대한 저항은 우수하였다. 그러나, 설폰화된 PEEK의 양이 증가함에 따라 메탄을 투과도와 수소이온전도도가 함께 증가하였다. 이온전도도와 메탄을 투과도의 비로부터 폴리설폰의 양이 20%일 때 가장 좋은 선택성을 가지는 것을 알 수 있었다.

• 한국자동차공학회논문집
• /
• 제21권5호
• /
• pp.15-24
• /
• 2013

Numerical studies were conducted to investigate the internal flow field and combustion characteristics of DISI engine with methanol blended in gasoline. Dual injection was applied and the characteristics were compared to single injection strategy. The amount of the fuel injection was corresponded to air-fuel ratio of each fuel for complete combustion. The preforming model in this study, software STAR-CD was employed for both modeling and solving. The operating speed condition were at 4000 rpm/WOT (Wide open throttle) where the engine was fully warmed. The results of single injection with M28 showed that the uniformity, equivalence ratio, in-cylinder pressure and temperature increased comparing to gasoline (M0). When dual injection was applied, there was no significant change in uniformity and equivalence ratio but the in-cylinder pressure and temperature increased. When M28 fuel and single injection was applied, the CO (Carbon monoxide) and NO (Nitrogen oxides) emission inside the combustion chamber increased approximately 36%, 9% comparing with benchmarking case in cylinder prior to TWC (Three Way Catalytic converter). When dual stage injection was applied, both CO and NO emission amount increased.

• Macromolecular Research
• /
• 제16권5호
• /
• pp.457-466
• /
• 2008

The relation between the phase separated morphologies and their transport properties in the polymer blend membrane for direct methanol fuel cell application was studied. In order to enhance the proton conductivity and reduce the methanol crossover, sulfonated poly(arylene ether sulfone) copolymer, with a sulfonation of 60 mol% (sPAES-60), was blended with nonsulfonated poly(ether sulfone) copolymer (RH-2000, Solvay). Various morphologies were obtained by varying the drying condition and the concentration of the casting solution (10, 15, 20 wt%). The transport properties of proton and methanol molecule through the polymer blend membranes were studied according to the absorbed water. AC impedance spectroscopy was used to measure the proton conductivity and a liquid permeability measuring instrument was designed to measure the methanol permeability. The state of water in the blend membranes was confirmed by differential scanning calorimetry and was used to correlate the morphology of the membrane with the membrane transport properties.

• Korean Chemical Engineering Research
• /
• 제47권2호
• /
• pp.237-242
• /
• 2009

화석연료의 고갈과 원유가격 폭등으로 인해 이를 대체할 수 있는 다양한 연료의 개발이 이루어지고 있다. 동물성 지방이나 식물성 기름의 주성분인 트리글리세라이드를 메탄올과 반응시켜 생산된 바이오디젤은 기존의 석유디젤을 대체할 수 있는 친환경적인 연료로 알려져 있다. 본 연구에서는 국내에서 유통중인 경유에 6종류의 원료별 바이오디젤을 일정 비율로 혼합한 뒤, 다양한 연료특성을 분석하였다. 바이오디젤의 농도가 높아질수록 밀도, 동점도, 인화점이 상승하였고, 저온특성은 악화되는 것을 확인하였다. 또한 경유의 중요한 연료특성인 세탄가를 IQT를 이용해 측정한 결과, 바이오디젤의 혼합비율이 높아질수록, 유도세탄가가 높게 측정되었으며, 특히 팜유로부터 생산된 바이오디젤의 경우, 71.26의 높은 유도세탄가가 측정되었다.

• 공업화학
• /
• 제16권1호
• /
• pp.144-149
• /
• 2005

Poly(ether ether ketone)을 설폰화시킨 후 poly(ether sulfone) (PES)과 다양한 조성으로 혼합하여 블렌드 막을 제조하였고, 직접메탄올 연료전지(DMFC; Direct Methanol Fuel Cell)용 고분자 전해질 막으로의 응용 가능성을 살펴보기 위하여 조성의 변화에 따른 메탄올 투과도, 수소 이온 전도도, 이온 교환 용량, 그리고 함수율의 변화를 살펴보았다. Sulfonated poly(ether ether ketone) (SPEEK)의 경우 수소 이온 전도도는 비교적 우수하였으나 메탄올 투과도 역시 비교적 높았다. 그러나, PES의 양이 증가함에 따라 수소 이온 전도도보다 메탄올 투과도가 급격히 감소하여서 PES의 양이 40%일 때 가장 좋은 선택성을 나타내었다.

• 한국수소및신에너지학회논문집
• /
• 제26권6호
• /
• pp.629-637
• /
• 2015

As concern about energy security and global warming many countries have been making effort to reduce fossil fuel. In the case of US, as one of the efforts, the standards of the alcohol vehicle fuels(including blended with gasoline) have been established. Alcohol is known that make some trouble concerning startability, durability and corrosion when using as fuel of a conventional vehicle. For these reason, alcohol usage needs not only the fuel standard, but also a modified car. In the case of Korea, although there are no the standard and the modified vehicle yet, high concentration alcohol blended fuel has being sold at illegal market. In this study, exhaust gas and performance of the conventional vehicle that alcohol(methanol and isopropyl alcohol) blends were fueled were measured to notify danger of using them without preparation of institutional arrangements. Also, to analyze correlation characteristics of the fuels and them, property test of the fuels was conducted. The test result show that bad-startability caused by low RVP and high T10 affected increase in NMOG and CO. NOx was increased under the highest short term fuel trim caused by high Oxygen content and low NHV of alcohol. According to increasing as alcohol content, fuel economy and acceleration ability were decreased but $CO_2$ was not significantly decreased.

• 수산해양기술연구
• /
• 제21권2호
• /
• pp.157-166
• /
• 1985

가변 압축비 기관(C. F. R.)에 ionization gap probe를 피스톤 및 실린터 헤드 sleeve에 설치하여 화염거동에 대하여 실험한 결과는 다음과 같다. 1) 혼합연료에서 화염전파속도는 메타놀 함량에 따라 증가한다. 2) 혼합연료에서 메타놀 percent가 증가하면 에너지 소모비 (Btu/HP-hr)가 감소하여 열효율은 증가한다. 3) 당량비가 일정하면 평균유효압력은 메타놀 량이 증가할수록 감소한다. 4) 순수한 가솔린 및 혼합연료는 점화진각이 클수록 NO 하(X) 방출량은 증가하고 희박 혼합기 영역에서 NO 하(X) 방출량은 최대가 된다. 또 RG50/M40/THF10/W1의 연료에서는 당량비가 0.95이하에서는 당양비가 낮을수록, 점화진각이 높을수록 NO 하(X) 방출량은 증가하고, 0.95 이상에서는 당량비와 점화진각이 클수록 방출량은 감소한다. 5) CO, HC의 최소값은 메타놀 함유량이 높을수록 감소한다.

• 한국산학기술학회논문지
• /
• 제21권3호
• /
• pp.380-389
• /
• 2020

포화지방산 함량이 높은 우지와 불포화지방산 함량이 높은 식물성 유지인 해바라기유를 혼합한 혼합오일의 바이오디젤 전환특성을 규명하고 연료특성을 분석하였다. 다변량분산분석을 이용하여 도출한 기여율로 각 실험변수 (메탄올/유지 몰비, 오일혼합비) 가 바이오디젤 전환에 미치는 영향을 규명하였다. 또한, 바이오디젤의 고점도 문제를 해결하기 위해 가열과 초음파 조사의 방법을 적용하여 동점도 감소효과를 검증하였다. 연료별 온도 도와 동점도간의 상관관계식을 통해 동점도 감소를 위한 연료별 최적 온도를 도출하였다. 그 결과, 바이오디젤 전환율은 오일 혼합비 TASU7, 메탄올/유지 몰비 10에서 가장 우수한 것으로 나타났고 지방산 조성에 따라 연료특성에 차이가 있었다. 또한, 우지, 해바라기유 오일 혼합 바이오디젤의 연료특성 분석 결과 바이오디젤의 품질기준을 만족하는 것으로 나타났다. 바이오디젤의 고점도를 해결하기 위한 동점도 실험 결과 가열 방법의 동점도 감소 효과가 초음파 조사 방법에 비해 우수한 것으로 나타나 간단한 가열장치로 바이오디젤의 고점도를 해결할 수 있음을 확인하였다.

• Macromolecular Research
• /
• 제13권6호
• /
• pp.514-520
• /
• 2005

Composite membranes of Nafion and sulfonated poly(arylene ether sulfone) were prepared. Sulfonated poly(arylene ether sulfone)s with different degrees of sulfonation were blended with Nafion to reduce the methanol crossover. The morphology, proton conductivity and methanol permeability of the resulting composite membranes were investigated by SEM, EDAX, AC impedance spectroscopy and permeability measuring instrument. The cross­sections of the composite membranes showed a phase separated morphology. The morphology and phase separation mechanism could be controlled by varying the blend ratio and the degree of sulfonation of poly(arylene ether sulfone). These complex morphologies can be applied for reducing methanol crossover. The methanol permeability and proton conductivity of the composite membranes were lower than those of Nafion 117 membrane since the development of an ionic pathway in the blend membrane was more difficult than that in Nafion itself.

• 수산해양기술연구
• /
• 제28권4호
• /
• pp.418-429
• /
• 1992

Recently, many researchers make a great effort to develop high efficient marine diesel engines using low grade heavy oil, and also study substitution fuel oil for engines and boilers. In case of Fisheries Vessels, we need to know that fish oil can be substituted for fuel oil. Therefore, it is studied that evaporation, ignition and combustion phenomena of the single droplet of fish oils (i.e., Sardine fish oil, File fish oil and Alaska pollac oil) on heated plane surface to evaluate appropriateness as substitution oil. Methanol and light oil are tested simultaneously to help the evaluation on these Fish oils. The results are summarized as follows: 1. The type of evaporation and combustion is spherical evaporation in case of methanol and light oil. And fish oil blended with light oil was finished after spherical evaporation happen when high temperature. 2. Ignition of Pure fish oil was shorter than that of fish oil blended with light oil. 3. Heat transferred to droplet could make qualitative comparison by contact diameter of droplet with hot surface as time changes. Life time of droplet according to the change of heated surface temperature was greatly influenced by droplet contact condition on the heated surface. 4. As far as combustion phenomena was concerned, apparent diameter of the fish oil droplet increased after ignition and decreased suddenly by internal boiling of droplet. 5. Three fish oils had similar phenomena on the evaporation, ignition and combustion. 6. Evaporation and combustion feature of fish oil could not be shown by coefficient of evaporation velocity of droplet and coefficient of combustion velocity of droplet.