• Bulletin of the Korean Chemical Society
• /
• v.25 no.9
• /
• pp.1309-1313
• /
• 2004

A simple and reliable method has been developed to selectively separate and concentrate trace amounts of thallium ion from real samples for the subsequent measurement by flame atomic absorption spectrometry (FAAS). Thallium ions are absorbed quantitatively during passage of aqueous real samples through an octadecyl bonded silica membrane disk modified by 4-(4-Chloro-phenylazo)-2-[(4-hydroxy-phenylamino)-methyl]-phenol. The retained $Tl^+$ ions are then stripped from the disk quantitatively with a minimal amount of thiosulfate solution as eluent. The proposed method permitted large enrichment factors of about 130 and higher. The relative standard deviation for ten replicate extraction of thallium from 1 L samples containing 5 ${\mu}g$ thallium is 1.2%. The break through volume for 5 ${\mu}g$ thallium is 1000 mL. The limit of detection of the proposed method is 11.2 ng of $Tl^+$ per 1000 mL. The effects of various cationic interferences on the recovery of thallium in binary mixtures were studied. The method was applied to the recovery of $Tl^+$ ions from natural water and human hair samples.

• Journal of the Korean Chemical Society
• /
• v.52 no.2
• /
• pp.133-139
• /
• 2008

A new sensitive and selective spectrophotometric method for determination of trace amounts of cadmium using a polyvinyl chloride membrane containing bis-(2-ethylhexyl)phthalate as a solid phase extraction medium was investigated. Bis-(2-ethylhexyl)phthalate has used as a plasticizer. Cd(II) in an aqueous solution was trapped on the membrane in the form of colorful Cd (II)-I- - MG complexes (which MG is malachite green) and the cadmium complex was concentrated in the membrane. The absorbance of the green membrane was measured at 629 nm using a spectrophotometer, and then, the concentration of the cadmium was calculated using a calibration curve, which expressed the relationship between the Cd(II) concentration and the membrane absorbance after coloring for 25 min. The calibration curve was linear in the range of 10-760 μgL-1 cadmium in the test solution. The detection limit based on the 3Sbl criterion was 1.8199 μgL-1 and the relative standard deviations (RSD) were less than 4 % (n=5). The proposed method has been successfully applied to the determination of trace amounts of cadmium in the Tadjan River water sample (Sari-Iran), and the mean value of 28.7 μgL-1 was obtained.

• Applied Chemistry for Engineering
• /
• v.7 no.5
• /
• pp.977-984
• /
• 1996

Liquid-liquid extractions by use of hollow fiber membrane module are fast because of the large surface area per volume. In these membranes, the extractant and feed can be contacted at high speed and two flows are completely independent, so there are no problems with loading and channeling. In this paper, it was investigated the selectivities of extractants for extraction of heavy metals from aqueous solution into organic extractants by using the hollow fiber membrane. To identify the effect of distribution ratio on mass transfer in the membrane, we also compared the distribution ratio with mass transfer coefficient. From these experiments for the system with high distribution ratio, effect of the distribution ratio on mass transfer was weak compare with the low distribution ratio system in the hollow fiber membrane.

• Journal of the Korean Association of Oral and Maxillofacial Surgeons
• /
• v.45 no.6
• /
• pp.332-342
• /
• 2019

Objectives: Socket grafting is vital to prevent bone resorption after tooth extraction. Several techniques to prevent resorption have been described, and various bone graft substitutes have been developed and used with varying success. We conducted this pilot study to evaluate the performance of nanohydroxyapatite (nHA) derived from chicken eggshells in socket preservation. Materials and Methods: This was a prospective, single center, outcome assessor-blinded evaluation of 23 sockets (11 patients) grafted with nHA and covered with platelet-rich fibrin (PRF) membrane as a barrier. Bone width and radiographic bone density were measured using digital radiographs at 1, 12, and 24 weeks post-procedure. Postoperative histomorphometric and micro-computed tomography (CT) evaluation were performed. The study protocol was approved by the Institutional Ethics Committee. Results: All patients had uneventful wound healing without graft material displacement or leaching despite partial exposure of the grafted socket. Tissue re-epithelialized with thick gingival biotype (>3 mm). Width of the bone was maintained and radiographic density increased significantly with a trabecular pattern (73.91% of sockets) within 12 weeks. Histomorphometric analysis showed 56.52% Grade 3 bone formation and micro-CT analysis revealed newly formed bone with interconnecting trabeculae. Conclusion: Use of a PRF membrane with nHA resulted in good bone regeneration in sockets. Use of a PRF membrane prevents periosteal-releasing incisions for primary closure, thereby facilitating the preservation of keratinized mucosa and gingival architecture. This technique, which uses eggshell-derived nHA and PRF membrane from the patient's own blood, is innovative and is free of disease transfer risks. nHA is a promising economic bone graft substitute for bone regeneration and reconstruction because of the abundant availability of eggshell waste as a raw material.

• Elastomers and Composites
• /
• v.33 no.1
• /
• pp.37-43
• /
• 1998

The permeation of gas through polymer membrane at temperatures above its glass transition, generally occurs by a solution-diffusion mechanism. This mechanism is performed by the affinity difference between polymeric materials and gas molecules, and various technologies, such as copolymerization, impregnation and so on, have been researched to improve the affinity of polymeric material for the gases. In this study, permeability and selectivity for some gases were obtained from steady-state rates of gas permeation through silicone rubber membrane which is prepared by supercritical fluid extraction method. The permeability was measured by the volumetric method proposed by Barrer. Permeability was increased generally with temperature and permeation pressure. Silicone rubber membrane shows a higher permeability to $CO_2$ than to $O_2$, $N_2$. This results probably reflect the relatively high solubility of CO_2 in silicone rubber membrane, which is due to the affinity of $CO_2$ molecules. Since separation powers of $CO_2/N_2$, $CO_2/O_2$ were more than 200, and 100, respectively, it is able to separate $CO_2$ from the air, and the optimum temperature and pres-sure was 328.15 K, 60 cmHg respectively. In future, it is possible that the silicone rubber membrane can be used for separation or concentration of $CO_2$ through experiment for mixed gas separation.

• Korean Chemical Engineering Research
• /
• v.52 no.6
• /
• pp.789-795
• /
• 2014

Acetic acid is the most abundant and serious ethanol fermentation inhibitor in dilute-acid hemicellulosic hydrolysates. A mixture of xylose, acetic acid and sulfuric acid was chosen as a simulated hemicellulosic hydrolysate so as to find an optimal separation system to selectively remove acetic acid from the hydrolysates. In order to attain the purpose, emulsion liquid membrane was applied to removal of acetic acid from the simulated hemicellulosic hydrolysate. The effects of main constituents of water-in-oil (W/O) emulsion, such as amine extractant type, surfactant composition, additive type, and type and concentration of stripping agent, on extraction of acetic acid, xylose, and sulfuric acid in the simulated hemicellulosic hydrolysate were investigated. Under specific experimental conditions, degree of extraction of acetic acid was higher than 95% while loss of xylose was insignificant, which means that the current emulsion liquid membrane can be an economically feasible process.

• Journal of KIISE
• /
• v.42 no.10
• /
• pp.1239-1246
• /
• 2015

Cell counting is extensively used to analyze cell growth in biomedical research, and as a result automated cell counting methods have been developed to provide a more convenient and means to analyze cell growth. However, there are still many challenges to improving the accuracy of the cell counting for cells that proliferate abnormally, divide rapidly, and cluster easily, such as cancer cells. In this paper, we present an automated cell counting method for HeLa cells, which are used as reference for cancer research. We recognize and classify the morphological conditions of the cells by using a cell segmentation algorithm based on cell membrane extraction, and we then apply a cell back-tracking algorithm to improve the cell counting accuracy in cell clusters that have indistinct cell boundary lines. The experimental results indicate that our proposed segmentation method can identify each of the cells more accurately when compared to existing methods and, consequently, can improve the cell counting accuracy.

• Polymer(Korea)
• /
• v.25 no.2
• /
• pp.151-160
• /
• 2001

Polymeric membranes consisting of poly(d,1-lactide) as a polymer matrix and crystallizable progesterone as a drug were prepared by coagulating polymeric solutions. The homogeneous casting solutions in dimethyformamide were solidified by using three different coagulating processes : solvent evaporation under vacuum, solvent extraction via immersion into the nonsolvent bath, or vapor exposure at high humidity condition. With solvent removal via evaporation under vacuum, the cast solution film was vitrified to form a homogeneous film containing progesterone of spherical shape distributed evenly in the film. Being prepared by solvent extraction via immersion into a water bath, the resulting membrane showed an asymmetric structure, with progesterone of big crystallites distributed unevenly in the structure. On the other hand, the coagulation under high humidity transformed the cast film into a sponge-like structure, where progesterone took a shape like flake.

• KSBB Journal
• /
• v.9 no.3
• /
• pp.332-338
• /
• 1994

Solubilization phenomena of a protein in a reversed micellar solution were investigated and a hollow fiber membrane extractor was tested for reversed micellar protein extraction equipment. Alkaline protease was used as a model protein compound and the reversed micellar solution was consisted of AOT and isooctane. It was found that protein solubilization was strongly influenced by ionic strength and pH. The distribution coefficient of the protease between the aqueous solution and the AOT/isooctane solution was also observed to be as high as 4.0 within the scope of this experiment. A hollow fiber membrane extractor was constructed and tested for the protein extraction. The overall mass transfer coefficient at a typical experimental condition of this study was observed to be $6.7{\times}10^{-5}cm/s$. It was also found that the mass transfer resistance on reversed micellar solution was the dominant resistance for the protein transfer.

• Bulletin of the Korean Chemical Society
• /
• v.33 no.10
• /
• pp.3387-3390
• /
• 2012

In this research work the potentialities of microemulsion bulk liquid membrane for the selective transport of L-tryptophan (L-Trp) and L-tyrosine (L-Tyr) are investigated at 298.15 K. Reversed micelle formed by sodium bis(2-ethylhexyl)sulfosuccinate (AOT) in dichloroethane, was used as mobile carrier to transport amino acids between a source and a receiving aqueous phase. The effects of pH, surfactant concentration and initial amino acid concentration on the extraction efficiency and transfer rate of the amino acids were studied. It is verified that for a mixture of two amino acids, L-Trp can be extracted selectively by using this type of the bulk liquid membrane with optimized condition.