• 한국대기환경학회지
• /
• 제30권3호
• /
• pp.223-232
• /
• 2014

Monthly variations of radiative forcing (RF) and mean temperature changes by greenhouse gases emitted from commercial aircraft were estimated based on the simplified expression at four international airports (Incheon, Gimpo, Jeju, and Gimhae Airports) during the years of 2009~2010. The highest RF and mean temperature change in the study area occurred at Incheon Airport, whereas the lowest RF and mean temperature change at Gimhae Airport. During 2009~2010, the mean RF and mean temperature change estimated from aircraft $CO_2$ emissions at Incheon Airport were approximately 30.0 $mW/m^2$ and $0.022^{\circ}K$, respectively. The mean RF and mean temperature changes caused by other greenhouse gas $N_2O$ was significantly small (<<0.1 $mW/m^2$ and << $1{\times}10^{-3}^{\circ}K$). Meanwhile, $CH_4$ emissions caused negative mean RF ($-4.45{\times}10^{-3}mW/m^2$ at Incheon Airport) and the decrease of mean temperature ($-3.83{\times}10^{-6}^{\circ}K$) due to consumption of atmospheric $CH_4$ in the aircraft engine.

• Asian Journal of Atmospheric Environment
• /
• 제9권3호
• /
• pp.214-221
• /
• 2015

This study considers mean skin temperature to calculate expected temperature using the new heat balance model because the skin temperature is the most important element affecting the heat balance outdoors. For this, we measured the skin temperature in high temperature condition of Korea and applied it to calculate the expected temperature. The calculated expected temperature is compared with the result calculated using previous models which use the estimated mean skin temperature by considering metabolic rate only. Results show that the expected temperatures are higher when measured mean skin temperature is applied to the model, compared to the expected temperature calculated by applying mean skin temperature data calculated using metabolic rate like previous models. The observed mean skin temperature was more suitable for outside conditions and expected temperature is underestimated when mean skin temperature calculated by the equation using metabolic rate is used. The model proposed in this study has a few limitations yet, but it can be applied in various ways to facilitate practical responses to extreme heat.

• Journal of Positioning, Navigation, and Timing
• /
• 제3권4호
• /
• pp.143-147
• /
• 2014

The mean temperature is one of the key parameters in computing Precipitable Water Vapor (PWV) from Global Positioning System (GPS) measurements and is usually derived as a function of surface temperature through the use of a mean temperature equation (MTE). In this study, two new types of MTEs were developed as functions solely of the observation time so that the mean temperature can be obtained without surface temperature measurements. To validate the new models, we created one-year time series of GPS-derived PWV using the new MTEs and compared them with the radiosonde-observed PWV. The bias and root-mean-square error were on the other of ~1 mm and ~2 mm, respectively.

• 설비공학논문집
• /
• 제16권12호
• /
• pp.1140-1148
• /
• 2004

Recently the Predicted Mean Vote (PMV) has been used as an important index to evaluate the degree of the indoor thermal comfort in modern residential buildings. It is known that the PMV is mainly affected by four major factors, which are the air temperature, the air velocity, the humidity and the mean radiant temperature (MRT). Through the numerical calculation of the temperature and the modeling of the mean radiant temperature considering the solar radiation, we proposed the new modeling strategies of the mean radiant temperature and investigated the PMV index and evaluated the MRT. Also, we compared the numerical results with the experimental values. As the results, we found out that the MRT is affected by the wall temperature and the solar radiation. We also knew that the new modeling strategies of the mean radiant temperature is a more correct way of PMV calculation. Especially, the new modeling is necessary for the spaces like an atrium and large rooms with windows mainly influenced by solar radiation.

• 한국초지조사료학회지
• /
• 제41권1호
• /
• pp.56-61
• /
• 2021

본 연구는 기 개발된 풀사료 수량예측모델의 기후정밀도 향상을 위하여 지점별 일평균온도 추정의 가능성을 기상대 자료(종관기상관측지점 75개 와 방재기상관측지점 278개)의 연평균기온 및 월평균기온을 이용하여 검토하였다. 연평균기온과 월평균기온은 각각 정규성 확인, 위치정보(경도, 위도 및 해발고도)와의 상관관계 및 다중회귀분석을 실시하였다. 해발고도는 연평균기온 및 월평균기온에도 지속적인 영향을 미치는 것으로 나타났으며, 위도는 6월을 제외한 월평균기온에 영향을 미치는 것으로 나타났다. 경도는 6, 7, 8, 9, 10 및 11월의 월평균기온에 영향을 미치는 것으로 나타났다. 이상의 결과로 부터 일평균기온 추정은 경도, 위도 및 해발고도를 이용하여 가능할 것으로 판단하였다. 본 연구에서 전국의 기상자료를 사용하여 일평균기온의 추정은 가능하지만 보다 정확도를 높이기 위해서는 기상자료를 각 시·도로 세분화하여 적용할 필요가 있다.

• 생물환경조절학회지
• /
• 제17권2호
• /
• pp.124-131
• /
• 2008

본 연구에서는 감 재배지 간 과실 특성 차이에 관계한 기온 요인을 분석하고자 8개 단감 '부유' 재배지의 16개 기온요인과 과실 특성을 조사하여 주성분 및 다중회귀 분석을 실시하였다. 16개 기온요인 중 제1주성분은 12개 요인으로 이중 연 평균최저기온, 10월 평균기온, 연 평균최저극온, 생육기 평균기온의 영향력이 아주 높았다. 그리고 제2주성분은 4개 요인으로 4월에서 7월까지의 월 평균기온이었고 5월과 6월 평균기온의 영향력이 높았다. 이에 제2주성분까지 누적기여율은 91.4%로 재배지 간 기온 차이에 관여하는 기온 요인을 분석하는 데에는 충분하였다. 8개 재배지 중 5 재배지은 주요 기온요인이나 그 영향력에서 뚜렷한 차이를 나타내었다. 기온요인과 과실 특성 간 다중회귀분석에서 과고는 생육기 평균기온($X_8$) 겨울철 적산온도($X_6$) 영향을 뚜렷이 받으며 회귀식 $Y=150.55-5.375X_8+0.014X_6$을 나타내었고, 이 회귀식에 대하여 생육기 평균최저기온($X_9$), 적산온도($X_5$), 8월 평균기온($X_{12}$) 등이 영향을 주었다. 과경은 생육기 평균기온($X_8$, 부의 상관), 과육갈반정도는 생육기 평균최저기온($X_9$, 정의 상관), 과피색 $a^*$값은 연 평균최저기온($X_2$, 정의 상관)의 영향을 받는 것으로 나타났다.

• 한국산업융합학회 논문집
• /
• 제25권1호
• /
• pp.101-110
• /
• 2022

For this purpose, the authors proposed and proved usefulness of the modified mean skin temperature which is integrated mean radiation temperature and the effect of floor contacted heat conduction. The mean radiation temperature is applied form factor between half cross-legged human body and surrounding wall of indoor. In addition the floor contacted heat conduction is applied heat transfer coefficient of half cross-legged human body. Eight Korean young men were targeted for the experiment. From the experiment the authors excerpted physiological reaction and psychological reaction in Ondol environment which is combined physiccal environmental factor of artificial climate chamber, air and floor temperature. As a result of the experiment it is confirmed that heat conduction has more impact than heat exchange from existing research for the heat exchange between half cross-legged human body and surrounding wall in Ondol thermal environment. Thereby, it is proved the effectiveness of the modified mean skin temperature which is added floor contacted temperature to the Ondol thermal environmental evaluation index.

• Journal of Positioning, Navigation, and Timing
• /
• 제5권2호
• /
• pp.75-85
• /
• 2016

The performance of up-to-date mapping functions and various mean temperature equations were analyzed to derive optimal mapping function and mean temperature equation when GNSS precipitable water vapor (PWV) was investigated in the Korean Peninsula. Bernese GNSS Software 5.2, which can perform high precision GNSS data processing, was used for accurate analysis, and zenith total delay (ZTD) required to calculate PWV was estimated via the Precise Point Positioning (PPP) method. GNSS, radiosonde, and meteorological data from 2009 to 2014 were acquired from Sokcho Observatory and used. ZTDs estimated by applying the global mapping function (GMF) and Vienna mapping function 1 (VMF1) were compared with each other in order to evaluate the performance of the mapping functions. To assess the performance of mean temperature equations, GNSS PWV was calculated by using six mean temperature equations and a difference with radiosonde PWV was investigated. Conclusively, accuracy of data processing was improved more when using VMF1 than using GMF. A mean temperature equation proposed by Wu (2003) had the smallest difference with that in the radiosonde in the analysis including all seasons. In summer, a mean temperature equation proposed by Song & Grejner-Brzezinska (2009) had the closest results with that of radiosonde. In winter, a mean temperature equation proposed by Song (2009) showed the closest results with that of radiosonde.

• 한국소성가공학회:학술대회논문집
• /
• 한국소성가공학회 2003년도 춘계학술대회논문집
• /
• pp.176-179
• /
• 2003

The mean temperature prediction of strip is very important in hot strip finishing mill because of affecting on product quality and shape. Also, temperature can be used by basic information in other on-line control models with affecting control accuracy in factory. So, FE based on-line temperature model was developed for predicting strip mean temperature accurately in various process conditions and factory environments. There are many variables in affecting strip mean temperature in on-line states of factory. But some problems are occurred in considering all variables for making temperature model because of the bad efficiency of regression or fitting analysis. In this report, we have adopted dimensional analysis for solving these problems. We have many variables with dimensions affecting strip temperature but we are able to make non-dimensional variables less than dimensional variables from the combination of dimensional variables caused by PI-Theorem in fluid mechanics. The developed models are divided by two parts. The one is interstand temperature prediction model. The other is roll gap temperature model.

• 대한간호학회지
• /
• 제29권4호
• /
• pp.903-916
• /
• 1999

The purpose of this study was to compare the ear-based rectal temperature measured with a tympanic thermometer with the rectal temperature measured with a glass mercury thermometer in order to test the accuracy of tympanic thermometer and to determine relationship among rectal, axilla, and abdominal temperature in neonates. The samples consisted of thirty four neonates admitted to the neonatal intensive care unit and nursery at an university affiliated hospital. The mean age of the subjects was 4.9 days. The ear-based rectal temperatures were taken with a tympanic thermometer in rectal mode (First Temp Genius 3000). Rectal and axilla temperatures were taken with a glass mercury thermometer, Abdominal temperature was continuously monitored with the probe connected to the servo controller of incubator. The results of the study can be summarized as follows : 1. Intrarater comparison : Agreement between the first and the second ear-based rectal temperature was 97% within 0.1$^{\circ}C$. 2. Comparison of ear-based rectal temperature and the rectal temperature from a glass mercury thermometer : ear-based rectal temperature ranged from 36.95$^{\circ}C$d to 37.95$^{\circ}C$, with a mean of 37.58$^{\circ}C$(SD＝0.22$^{\circ}C$). Rectal temperature from a glass mercury thermometer ranged from 36.2$0^{\circ}C$ to 37.2$0^{\circ}C$, with a mean 36.75$^{\circ}C$(SD＝0.29). The mean difference between both temperatures was 0.84$^{\circ}C$. The correlation coefficient between both temperatures was r＝0.77(p＝0.00). 3. Comparison of rectal and axilla temperature : Axilla temperature ranged from 35.8$0^{\circ}C$ to 37.1$0^{\circ}C$, with a mean of 36.55$^{\circ}C$. The mean absolute difference between the rectal and axilla temperature was 0.23$^{\circ}C$. The correlation coefficient between rectal and axilla was r＝0.67. 4. Comparison of axilla and abdominal temperature : Abdominal temperature ranged from 36.2$0^{\circ}C$ to 37.0$0^{\circ}C$, with a mean of 36.58$^{\circ}C$. The mean absolute difference between axilla and abdominal temperature was only -0.03$^{\circ}C$. Findings of this study suggest that ear-based rectal temperature overestimates the actual rectal temperatures in neonates. Therefore, the interchangeble use of both temperatures in clinics seems problematic. The site offset(adjustment value) programmed in rectal mode of the tympanic thermometer needs to be readjusted. Choosing one optimal site for temperature measurement for each patient, and using the specific site consistently would result in more consistent measurements of changes in body temperature, and thus can be more effective in diagnosing fever or hypothermia.