• Nuclear Engineering and Technology
• /
• 제56권4호
• /
• pp.1277-1283
• /
• 2024

This study presents a radiation-induced thermal conductivity degradation (TCD) model of zirconium as compared to the conventional UO2 TCD model. We derived the governing factors of the radiation-induced TCD model, such as maximum TCD value and temperature range of TCD. The maximum TCD value was derived by two methods, in which 1) experimental result of 32 % TCD was directly utilized as the maximum TCD value and 2) a theoretical approach based on dislocation was applied to derive the maximum TCD value. Further, the temperature range of TCD was determined to be 437-837 K by 1) experimental results of post-annealing of irradiation hardening as compared to 2) the rate theory and thermal equilibrium. Consequently, the radiation-induced TCD model of zirconium was derived to be $f_r=1-{\frac{0.32}{1+{\exp}\,\{(T-637)/45\}}}$. Because the thermal conductivity of zirconium is one of the factors determining the storage and transport system, this newly proposed model could improve the safety analysis of spent fuel storage systems.

• 한국국방경영분석학회지
• /
• 제6권2호
• /
• pp.27-46
• /
• 1980

Computer model for calculating the maximum detection range of the pulse radar used for surface surveillance is developed, and the detailed procedures of each theoretical step are discussed. The quantity of radar antenna's receiving energy, transmitting energy and noise level are compared in this model. All the calculation steps are programmed in BASIC language. Finally, I have found the output of this model well matched with the some experimental results.

• Journal of Power Electronics
• /
• 제18권2호
• /
• pp.640-650
• /
• 2018

A TRIAC dimmable LED driver with a wide tuning range and a two-stage uniform dimming scheme is proposed in this paper. To solve the restricted dimming range problem caused by the limited conduction ratio of TRIAC dimmers, a conduction ratio compensation technique is introduced, which can increase the output current up to the rated output current when the TRIAC dimmer turns to the maximum conduction ratio. For further optimization, a two-stage uniform dimming diagram with a rapid dimming curve and a slow dimming curve is designed to make the LED driver regulated visually uniform in the whole adjustable range of the TRIAC dimmer. The proposed control chip is fabricated in a TSMC $0.35{\mu}m$ 5V/650V CMOS/LDMOS process, and verified on a 21V/500mA circuit prototype. The test results show that, in the 90V/60Hz~132V/60Hz ac input range, the voltage linear regulation is 2.6%, the power factor is 99.5% and the efficiency is 83%. Moreover, in the dimming mode, the dimming rate is less than 1% when the maximum dimming current is 516mA and the minimum dimming current is only about 5mA.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 2004년도 학술대회 논문집 정보 및 제어부문
• /
• pp.595-597
• /
• 2004

In this paper range measurement systems using ultrasonic and visual sensors are designed. By varying the focus of a camera, the range to a target pattern is computed. Pour different methods are tested for the focusing-based range measurement. The best result is obtained when counting edge pixels found by Laplacian operator. Higher accuracy can be obtained by fusing the measurement of camera focusing with that of ultrasonic sensor. The system designed is experimented within the range of 300-450mm.

• 한국전자파학회:학술대회논문집
• /
• 한국전자파학회 2005년도 종합학술발표회 논문집 Vol.15 No.1
• /
• pp.33-38
• /
• 2005

In this paper, a simulator for radar performance evaluation in a far-field test range is proposed, which can forecast maximum detection range, minimum detection range, number of test trials, resolution (range, azimuth, elevation) with input parameters before radar performance test and process results after. The proposed simulator is designed by Microsoft Foundation Class (MFC) of VC++ 6.0.

• Journal of Chest Surgery
• /
• 제22권4호
• /
• pp.562-572
• /
• 1989

The changes of serum glutamic oxaloacetic transaminase [SGOT], serum glutamic pyruvic transaminase [SGPT], serum lactic dehydrogenase [LDH] and serum creatine phosphokinase [CPK] were examined during and after the open heart surgery. In the total of 52 patients with heart diseases including 40 cases of congenital heart anomalies and 12 cases of acquired valvular heart diseases who undergone open heart surgery under cardiopulmonary bypass. The results obtained are as follows: 1. The average value of SGOT before surgery was 30.27 [ 18:86 units. The enzyme was reached to the maximum of 139.88 [ 89.43 units on the 1st day after the operation [p< 0.05], the enzyme activity was gradually decreased from the 3rd day after the operation, returned to the normal range on the 7th day after the operation. 2. The average value of SGPT before surgery was 14.36 [ 7.45 units. The enzyme was reached to the maximum of 34.67 [ 27.64 units on the 2nd day after the operation, but it was valueless statistically, the enzyme activity was gradually decreased from the 3rd day after the operation, returned to the normal range on the 5th day after the operation. 3. The average value of LDH before surgery was 263.07 * 86.66 units. The enzyme was reached to the maximum of 662.29 * 303.60 units on the 2nd day after the operation [p < 0.05], the enzyme activity was gradually decreased from the 5th day after the operation, returned to the normal range on the 7th day after the operation. 4. The average value of CPK before surgery was 141.35 * 43.44 units. The enzyme was reached to the maximum of 377.42 [ 222.02 units on the 1st day after the operation [p < 0.05], the enzyme activity was gradually decreased from the 5th day after the operation, returned to the normal range on the 7th day after the operation. 5. In the relationships of the serum enzymes and duration of the extracorporeal circulation, the values on the group over 90 minute of the extracorporeal circulation were increased than on the group below 90 minute of the extracorporeal circulation, but it was valueless statistically.

• 대한통합의학회지
• /
• 제8권3호
• /
• pp.93-101
• /
• 2020

Purpose : Temporomandibular joint disorder (TMJD) is often accompanied by pain and limited range of motion of the jaw joint, which affect patients' quality of life and result in hypertrophy or hyperactivity of the muscles around the jaw joint. In this study, we compared the muscle thickness and tone of the masseter and sternocleidomastoid (SCM) muscles and the jaw range of motion in individuals with and without TMJD. Correlation comparison was performed on the results of the TMJD group. Methods : This study included 40 patients; 20 patients were assigned to an experimental group (TMJD group) and 20 to a control group (non-TMJD group). Ultrasonography, myotonometry, and measurements performed with digital Vernier calipers were used to determine the changes in muscle thickness, muscle tone, and maximum jaw opening, respectively. The independent t-test was used for intergroup comparison of data, and Pearson correlation coefficients were used to compare correlations in the TMJD group results. Results : We observed a significant intergroup difference in the masseter and SCM thickness during the relaxed and clenched phases (p<.05). A significant intergroup difference was also observed in maximum jaw opening (p<.05). With regard to muscle tone, we observed a significant intergroup difference in frequency (p=.011) and stiffness (p=.011) of the masseter, as well as in the frequency (p=.009) and stiffness (p=.026) of the SCM. We observed a moderate negative correlation (r=-.524) between maximum jaw opening and the frequency of the masseter. Additionally, we observed a moderately negative correlation between jaw opening and muscle stiffness (r=-.321). Conclusion : Planning exercise programs to treat patients with TMJD who present with pain should focus on efforts to reduce muscle thickness and achieve muscle relaxation (to reduce muscle tension) for improved jaw range of motion.

• 대한기계학회:학술대회논문집
• /
• 대한기계학회 2004년도 춘계학술대회
• /
• pp.156-161
• /
• 2004

To predict the direction of the fatigue crack initiated from a hole under various types of biaxial fatigue loads with different phase difference and biaxiality, fatigue parameters were investigated. Axial and torsional biaxial fatigue loads were selected with the respective combination of five different phase differences of 0, 45, 90, 145 and 180 degrees and five biaxialities of 0, $1/{\sqrt{3}}$, 1, ${\sqrt{3}}$, ${\infty}$. Directions of the fatigue crack initiation around the hole were found to approach to the circumferential direction of the specimen with increment of the phase difference for fatigue tests with phase differences less than $90^{\circ}$. Whereas directions for tests with phase differences greater than $90^{\circ}$ went away from the circumferential direction and those were symmetric to the directions for tests with phase difference less than $90^{\circ}$. With increase of biaxilities, the fatigue crack initiated more apart from the circumferential direction of the specimen. These crack initiation direction were predicted using maximum tangential stress range and maximum shear stress range obtained at far-field and around the hole. Comparing these two stress parameters, The crack initiation direction can be successfully explained by using the direction of the maximum tangential stress range obtained around the hole and at far-field.

• 한국방사선학회논문지
• /
• 제12권1호
• /
• pp.115-122
• /
• 2018

본 연구에서는 CT영상기반 3차원 고관절모델을 이용한 컴퓨터시뮬레이션을 통해서 고관절의 운동범위(Range of Motion)를 측정하는 방법을 제시하였다. 본 연구에서는 그 측정방법에 대한 기술적인 사항을 제시하고, 그 기술이 재현성 있게 실현할 수 있도록 대퇴골두 중심점의 결절, 대퇴골 외전(Abduction)/내전(adduction)회전축, 굽힙(flexion)/신전(extension) 회전축을 정의하고 측정하는 명확한 방법을 제시하였다. 외전각은 해부학적인 시상면(Sagittal plane)상의 Anterior-Posterior축에 대해 아래쪽(Inferior)면으로부터 Lateral 쪽으로의 회전각으로 정의된다. 최대외전각은 대퇴골두가 엉덩이뼈(Pelvis)의 절구(Acetabulum)의 테두리와 겹치지 않고 Anterior-Posterior축을 중심으로 회전할 수 있는 최대 외전각으로 결정된다. 굴곡각은 해부학적인 관상면(Coronal plane)상의 Medial-Lateral축에 대해 아래쪽(Inferior)면으로부터 회전각으로 정의된다. 최대굴곡각은 대퇴골이 Medial-Lateral축을 중심으로 엉덩이뼈(Pelvis)의 절구(Acetabulum)의 테두리와 겹치지 않고 회전할 수 있는 최대 굴곡각으로 결정된다. 정상고관절에 비해 인공고관절술을 받은 해당 환자의 경우, 외전에서는 60도 정도, 굽힘에서는 4도 정도 운동범위가 줄어들 수 있다는 예측이 나왔다. 본 연구에서 행한 시뮬레이션을 해보고 외전의 경우 운동범위의 감소가 예측되므로, 대퇴골두를 조금 큰 것을 고르거나 대퇴골목부의 길이 (femoral neck offset)를 길게 시술해야 할 필요가 있음을 의미한다.

• Journal of Plant Biology
• /
• 제14권3호
• /
• pp.36-42
• /
• 1971

The effects of irregular burning of vegetation by man were studied in relation to composition and productivity in a non-agricultural montane grassland in the Chongsun area, Kangwon-Do, Korea. The floristic composition in all study area includes 38 species. Three of the stations are dominated by Arundinella hirta and one is dominated by Miscanthus sinensis. The standing crop of the first station, which was fired in early spring, 1970, was 358.7g/$m^2$ to 497.5g/$m^2$; that of the second station, fired in late 1969 was 351. 5g/$m^2$; the third station, fired sometime in 1968, had a standing crop of 314.5g/$m^2$ to 397.1/$m^2$; the fourth station, having had no recent fires, had a standing crop of 370.0g/$m^2$ to 448.0g/$m^2$. The daily productivity shows a maximum of 6.03g/$m^2$ in the first station, and a minimum of 0.85g/$m^2$ in the fourth station. The productivity of grassland in the study area is at a maximum during July and August because of much precipitation, and decreases rapidly in the months to follow. The productive structure of the first and fourth stations is shown in Fig. 2 and 3. At the first station the maximum height attained by the plants was 180cm. In the height range of 50cm to 100cm there was a maximum of assimilative organs (5.6g/0.25$m^2$$\times$10cm), while in the height range below 50cm there was a maximum of non-assimilative organs (13.0g/0.25$m^2$$\times$10cm). At the fourth station, which has not been fired recently, the maximum height reached by the plants was commonly below 100cm. The assimilative organs showed a maximum abundance in the height range of 40cm to 50cm (4.5g/0.25$m^2$$\times$10cm). while the non-assimilative organs showed their greated abundance in the height range below 10cm (6.0g/0.25$m^2$$\times$10cm). There was a direct relationship between daily productivity and organic matter, available phosphorous, exchangeable calcium and potassium. It appears that the nutrients provided by the ash created in the firing of the study can be an important factor in the productivity of these grasslands.