• Journal of the Korean Geographical Society
• /
• v.48 no.2
• /
• pp.204-217
• /
• 2013

This study shows the geomorphological processes of Yuga alluvial fan at Dalseong-gun, Daegu in Korea, based on characteristics of geomorphological surfaces, analysis of geomorphological deposits and OSL age dating. Alluvial fans of this area are classified into three surfaces(YG-F1, YG-F2, YG-F3) and were formed by the depositional processes resulting from the changes in hydraulic geometry of flowing water which was a stream flowing out of mountains debouched on to a plain, not by a sudden decrease in surface gradient of river bed. YG-F3 surface, about 110,000 yr B.P.(MIS 5.4), was formed as Yongri river deposited a lot of debris. This result was due to the process that the deposition took place actively with the upward of base level as the last interglacial period began. Later, the denudation of the river valley and geomorphological surface constantly occurred and the local and seasonal changes were found in precipitation and stream discharge with the beginning of the interstadial of the last glacial stages(MIS 3), leading to YG-F2 formed by debris flow, earth flow, mud flow and stream flow. Then, short-term climate changes and temporal climate events repeatedly caused aggradation and denudation over time and going through these processes, YG-F1 is believed to have been made by earth flow or mudflow during the last glacial maximum(MIS 2).

• Journal of the Korean Geographical Society
• /
• v.48 no.2
• /
• pp.167-183
• /
• 2013

This paper aimed to investigate the Asian dust source region and climatic condition of source region by the case of Asian dust in south Korea. In order to analyze the weather condition of source region, observed the Asian dust days data and weather data in China were used. The Asian dust days originating from inner-Mongolia were the most frequent. The Asian dust days originating from all the source regions except Loess plateau were increased recently and occurred over the country. In case of Loess plateau, the frequency of the Asian dust days in 1960s was the highest and only the southern region of the south Korea was mostly affected. The relationship between the Asian dust days of Korea and climatic factors of spring and April of source region was significant. The relationship between the Asian dust days originating from the inner Mongolia and sea level pressure of April and relative humidity of spring was negative. The Asian dust days from Gobi had positive relationship with wind gust days and negative relationship with sea level pressure in April. The Asian dust days from Manchuria had negative relationship with precipitation and sea level pressure in April. The Asian dust days from Loess plateau had positive relationship with maximum wind speed and negative relationship with sea level pressure in April.

• Journal of the Korean Magnetics Society
• /
• v.9 no.2
• /
• pp.111-120
• /
• 1999

The effects of annealing in rotating magnetic field after deposition on electromagnetic properties of $Co_{82}Zr_6Mo_{12}$ thin (200~1200 $\AA$) films prepared by RF-magnetron sputtering were investigated in terms of microstructure and surface morphology. The coercivity decreases, but $4{\pi}M_5$ does not change with increasing the film thickness. The coercivity of the films was decreased below 300 $^{\circ}C$ due to stress relief and decreasing the surface roughness, while increased at 400 $^{\circ}C$ due to partial grain growth. And then, $4{\rho}M_5$ was almost independent of annealing temperatures below 200 $^{\circ}C$, but increased from 7.4 kG to 8.0 kG at 300 $^{\circ}C$ and at 400 $^{\circ}C$, which was caused by precipitation and growth of fine Co particles in the films. The electrical resistivity of films was decreased with increasing annealing temperatures and the magnetoresistance was a negative value of nearly 0 $\mu$$\Omega$cm. After annealing at 300 $^{\circ}C$, maximum effective permeability was 1200 to the hard axis of the thin films according to high frequency change. Considering the practical application of biasing layers of the films for magnetoresistive heads, optimal annealing conditions was obtained after one hour annealing at 300 $^{\circ}C$ in 400 Oe rotating magnetic field.

• Korean Journal of Food Science and Technology
• /
• v.31 no.6
• /
• pp.1635-1641
• /
• 1999

Bacillus subtilis PCA20-3 was isolated from meju and was found to produce a protease. The strain produced the maximum amount of enzyme in the medium containing soytone (0.2%), soluble starch (2%), $(NH_4)_2SO_4\;(0.1%),\;CaCl_2(0.1%),\;yeast\;extract\;(0.01%),\;K_2HPO_4\;(0.1%),\;and\;KH_2PO_4\;(0.1%)$. Protease was first concentrated by ammonium sulfate (80% saturation, w/v) precipitation of culture supernatant. Then the enzyme was purified by column chromatography using CM Sephadex C-50. The collected proteins were rechromatographed using Sephadex G-100 gel filtration column. The fraction with protease active from Sephadex G-100 gel chromatography was found to be pure when examined by SDS-polyacrylamide gel electrophoresis and YMC-pak reverse phase chromatography. Specific activity, yield and purity were 76 U/mg. 2.7%, and 7.6 fold, respectively. The molecular weight of the enzyme was estimated to be 31.5 kDa by SDS-PAGE. The number of amino acids calculated from molecular weight was evaluated about 321 residues. N-terminal sequence of the enzyme was $Val^1-Pro^2-Tyr^3-Gly^4-Val^5-Ser^6-Gln^7-Gly^8-Lys^9-Ala^{10}$.

• Journal of the Mineralogical Society of Korea
• /
• v.22 no.4
• /
• pp.331-342
• /
• 2009

Groundwater samples were collected from the bedrock aquifers related with Okcheon metasedimentary rocks. Arsenic (As) concentrations in the samples varied between 0.0051 and 0.887 mg/L, with an average of 0.0248. Cations and anions of groundwaters had no relationship with As contents as well as with spatial distribution of geology in the area. Pyrite, chalcopyrite and arsenopyrite in the core samples of the monitoring wells were identified in thin section, X-ray diffraction (XRD) and electron probe microscope analysis (EPMA). It was suggested that these minerals are responsible for the As in groundwater. The groundwater showed saturations with respect to calcite $(CaCO_3)$, dolomite (CaMg$(CO_3)_2$) and Magnesite $(MgCO_3)$. $HAsO_4{^{2-}}$ activities in the groundwater samples were close to $Ca_3(AsO_4)_2(c)$ and $Mn_3(AsO_4)_2(c)$ solubility isotherms, indicating that the maximum As contents in groundwater are secondly controlled by the precipitation and dissolution of carbonate minerals due to alkaline and oxic nature of the groundwater (pe+pH>10).

• Resources Recycling
• /
• v.29 no.2
• /
• pp.69-77
• /
• 2020

With rapid increasing production and installation, recycling of photovoltaic modules has become the main issue. According to the research, the accumulation of waste modules will reach to 8600 tons in 2030. Moreover, Crystalline-silicon (c-Si) Photovoltaic modules account for more than 90% of the waste. C-Si PV modules contain 1.3% of weight of photovoltaic ribbon inside which contains the most of lead, tin and copper in the PV modules, which would cause environmental and humility problem. This study provided a valuable metal separation process for PV ribbons. Ribbons content 82.1% of Cu, 8.9% of Sn, 5.2% of Pb, and 3.1% of Ag. All of them were leached by 3M of hydrochloric acid in the optimal condition. Ag was halogenated to AgCl and precipitated. Cu ion was extracted and separated from Pb and Sn by Lix984N then stripped by 3M H2SO4. The effect of the optimal parameters of extraction was also studied in this essay. The maximum extraction efficiency of Cu ion was 99.64%. The separation condition of Pb and Sn were obtained by adjusting the pH value to 4 thought ammonia to precipitate and separate Pb and Sn. The recovery of Pb and Sn can reach 99%.

• The Journal of Engineering Geology
• /
• v.14 no.1
• /
• pp.71-80
• /
• 2004

The failure of cut slopes frequently occurs particularly during the thawing season and the rain season in summer. This study interpreted data collected from site to which a real-monitoring system was applied in order to analyze the causes of ground behaviors and to forecast future slope failure. As for research methods, this study analyzed the size and mechanism of failure by integrating the results of field surveys and measurements. Furthermore, it analyzed data transmitted by the monitoring system installed in the a result, three times of ground displacement occurred as well as a number of partial tension cracks. The cut slope composed of sandstone and siltstone started its initial behavior as a result of torrential downpour and the loss of support of the substructure. For quantitative analysis of the characteristics of ground behavior, this study measured 5 lateral lines. According to the result of the measurement, displacement happened little in the section to which countermeasure had been applied, but displacement of maximum 400mm happened in the section to which countermeasure had not bee applied. The analysis of data on displacement and rainfall suggested a close relationship between ground behavior and rainfall. According to the result of stability interpretation along with the change of ground saturation, stability rate appeared to be less than 1.0 when ground saturation is over 55%. Although the current trend of ground behavior is at a stable stage falling within the range of tolerance, it is considered necessary to continue monitoring and data analysis because ground displacement is highly possible with the change of temperature during the winter.

• Microbiology and Biotechnology Letters
• /
• v.48 no.2
• /
• pp.215-222
• /
• 2020

The marine microorganism PX-1, which can hydrolyze xylan, was isolated from coastal sea water of Jeju Island, Korea. Based on the 16S rRNA gene sequence and chemotaxonomy analysis, PX-1 was identified as a species of the genus Aestuariibacter and named Aestuariibacter sp PX-1. From the culture broth of PX-1, an extracellular xylanase was purified to homogeneity through ammonium sulfate precipitation and subsequent adsorption chromatography using insoluble xylan. Sodium dodecyl sulfate-polyacrylamide gel electrophoresis and gel filtration chromatography estimated the molecular weight of the purified putative xylanase (XylA) as approximately 64 kDa. XylA showed xylanase activity toward beechwood xylan, with a maximum enzymatic activity at pH 6.0 and 45℃. Through thin-layer chromatographic analysis of the xylan hydrolysate produced by XylA, it was confirmed that XylA is an endo-type xylanase that decomposes xylan into xylose and xyloligosaccharides of various lengths. The K_m and V_max values of XylA for beechwood xylan were 27.78 mM and 78.13 μM/min, respectively.

• Environmental Engineering Research
• /
• v.13 no.3
• /
• pp.131-135
• /
• 2008

In this study, Fe(VI) was employed as a multi-functional agent to treat the simulated industrial wastewater contaminated with Cu(II)-EDTA through oxidation of EDTA, decomplexation of Cu(II)-EDTA and subsequent removal of free copper through precipitation. The decomplexation of $10^{-4}\;M$ Cu(II)-EDTA species was performed as a function of pH at excess concentration of Fe(VI). It was noted that the acidic conditions favor the decomplexation of Cu(II)-EDTA as the decomplxation was almost 100% up to pH 6.5, while it was only 35% at pH 9.9. The enhanced degradation of Cu(II)-EDTA with decreasing the pH could be explained by the different speciation of Fe(VI). $HFeO_4^-$ and $H_2FeO_4$, which are relatively more reactive than the unprotonated species $FeO_4^{2-}$, are predominant species below neutral pH. It was noted that the decomplexation reaction is extremely fast and within 5 to10 min of contact, 100% of Cu(II)-EDTA was decomplexed at pH 4.0. However, at higher pH (i.e., pH 10.0) the decomplexation process was relatively slow and it was observed that even after 180 min of contact, maximum ca 37% of Cu(II)-EDTA was decomplexed. In order to discuss the kinetics of the decomplexation of Cu(II)-EDTA, the data was slightly fitted better for the second order rate reaction than the first order rate reaction in the excess of Fe(VI) concentration. On the other hand, the removal efficiency of free Cu(II) ions was also obtained at pH 4.0 and 10.0. It was probably removed through adsorption/coagulation with the reduced iron i.e., Fe(III). The removal of total Cu(II) was rapid at pH 4.0 whereas, it was slow at pH 10.0. Although the decomplexation was 100% at lower pH, the removal of free Cu(II) was relatively slow. This result may be explicable due to the reason that at lower pH values the adsorption/coagulation capacity of Fe(III) is greatly retarded. On the other hand, at higher pH values the decomplexation of Cu(II)-EDTA was partial, hence, slower Cu(II) removal was occurred.

• Korean Journal of Agricultural and Forest Meteorology
• /
• v.11 no.4
• /
• pp.233-246
• /
• 2009

The partitioning of evapotranspiration (ET) into evaporation (E) and transpiration (T) is critical in understanding the water cycle and the couplings between the cycles of energy, water, and carbon. In forests, the total ET measured above the canopy consists of T from both overstory and understory vegetation, and E from soil and the intercepted precipitation. To quantify their relative contributions, we have measured ET from the floors of deciduous and coniferous forests in Gwangneung using eddy covariance technique from 1 June 2008 to 31 May 2009. Due to smaller eddies that contribute to turbulent transfer near the ground, we performed a spectrum analysis and found that the errors associated with sensor separation were <10%. The annual sum of the understory ET was 59 mm (16% of total ET) in the deciduous forest and 43 mm (~7%) in the coniferous forest. Overall, the understory ET was not negligible except during the summer season when the plant area index was near its maximum. In both forest canopies, the decoupling factor ($\Omega$) was about ~0.15, indicating that the understory ET was controlled mainly by vapor pressure deficit and soil moisture content. The differences in the understory ET between the two forest canopies were due to different environmental conditions within the canopies, particularly the contrasting air humidity and soil water content. The non-negligible understory ET in the Gwangneung forests suggests that the dual source or multi-level models are required for the interpretation and modeling of surface exchange of mass and energy in these forests.