• Bulletin of the Korean Mathematical Society
• /
• v.55 no.3
• /
• pp.735-747
• /
• 2018

This paper deals with the asymptotic behavior of solutions to the generalized MHD and Hall-MHD systems. Firstly, the upper bound for the generalized MHD and Hall-MHD systems is investigated in $L^2$ space. Then, the effect of the Hall term is analyzed. Finally, we optimize the upper bound of decay and obtain their algebraic lower bound for the generalized MHD system by using Fourier splitting method.

• Proceedings of the Korean Institute of Navigation and Port Research Conference
• /
• v.29 no.1
• /
• pp.299-303
• /
• 2005

A new method of oil separation from oil-contaminated seawater based on electromagnetic forces, so-called MHD method was designed and formulated. MHD method has advantages of easy treatment of separated oil as well as little effect upon the environment, comparing with a conventional separation method using magnetic powders. Assuming high polymer particles instead of oil, the separation ratio (the mass of simulation particles / the total mass of simulation particles) for the sample fluid was calculated as fuction of electric current, magnetic field and seawater velocity.

• 전기의세계
• /
• v.25 no.5
• /
• pp.79-87
• /
• 1976

This paper is to investigate the A.C generation of MHD engine, converting directly the kinetic energy of conductive gas in high temperature to electric power by the effect of magnetic field. It is known that there are at least two kinds of method in A.C MHD power generation; one, by sending stationary plasma flow in an alternating or rotating magnetic field and the other, by transmission of pulse type plasma flow in uniform and constant magnetic field, former method is adopted here. In order to raise the total efficiency of close cycle in combination with nuclear power and MHD genertaion, an argon plasma jet is utilized as heat source, which is not mixed with the seed material, and the design data are obtained for A.C MHD generation in small capacity, but induced voltage and power output have the maximum values, 15 voltages and 7.5W respectively due to plasma flow with low conductivity and weak magnetic field.

• Journal of Energy Engineering
• /
• v.2 no.2
• /
• pp.231-236
• /
• 1993

The feasibility of Magnetohydrodynamic(MHD) Ship Propulsion using Superconduction Magnets is reviewed in light of relent advances in high-temperature superconducting. The propulsion using a screw propeller in the noise reduction has it's own limitation. The epochal noiseless MHD propulsion method which does not have this disadvantage is studying nowadays. The subject of a marine MHD as propulsion has been examined before and was found to be interesting because of relatively low magnetic flux densities. It is demonstrated that the MHD propulsion is technically interesting with high magnetic flux density. The development of large-scale magnets using the high-temperature superconductor now under development could make it practical to construct submersibles for high-speed and silent operation.

• Korean Chemical Engineering Research
• /
• v.55 no.4
• /
• pp.510-513
• /
• 2017

Patchouli oil extraction in general is still using conventional methods that require a long time of extraction. It is therefore necessary to develop extraction methods to obtain patchouli oil with optimum yield and quality. One of the new methods, which has been successfully developed, is microwave hydrodistillation (MHD). In addition to optimizing the extraction process of patchouli oil, this study also used microwave air-hydrodistillation (MAHD). Based on the research results, extraction using MAHD method can produce higher yield of patchouli oil when compared using MHD method. Also, based on the results of the analysis by GC-MS, extraction using MAHD method can produce quality of patchouli oil that is almost the same when compared using MHD method. This is supported by the results of the analysis by GC-MS, which showed that the content of patchouli alcohol is the main component of patchouli oil, and is almost the same for patchouli oil extracted using MHD method (26.32%) and MAHD method (25.23%).

• The Transactions of the Korean Institute of Electrical Engineers
• /
• v.38 no.9
• /
• pp.733-739
• /
• 1989

Fixed boundary MHD static equilibrium for the axisymmetric toroidal plasma is analyzed numerically. The Grad-Shafranov equation is solved using finite element method. The toroidal current term is expressed by plasma pressure and toroidal field function. The numerical results are compared to the Solovev analytic equilibrium for the verification of the solution. For SNUT-79 tokamak device in Seoul National University, the flux surfaces, the toroidal current profiles, the safety factor q and average beta values are obtained when the p and g profiles are varied.

• Proceedings of the Korea Society for Energy Engineering kosee Conference
• /
• 1992.11a
• /
• pp.35-38
• /
• 1992

The feasibility of magnetohydrodynamic (MHD) Ship propulsion using superconduction magnets is reviewed in light of recent advances in high-temperature superconducting. The propulsion using a screw propeller in the noise reduction has it's own limitation. The epochal noiseless MHD propulsion method which does not have this disadvantage is studying nowadays. The subject of a marine MHD as propulsion has been examined before and was found to be interesting because of relatively low magnetic flux densities. It is demonstrated that the MHD propulsion is technically interesting with high magnetic flux density. The development of large-scale magnets using the high-temperature superconductors now under development could make it practical to construct submersibles for high-speed and silent operation.

• Journal of The Korean Astronomical Society
• /
• v.34 no.4
• /
• pp.317-319
• /
• 2001

The response of the earth's magnetosphere to the variation of the solar wind parameters and Interplanetary magnetic field (IMF) has been stud}ed by using a high-resolution, three-dimension magnetohydrodynamic (MHD) simulation when the WIND data of velocity Vx, plasma density, dynamic pressure, By and Bz every 1 minute were used as input. Large electrojet and magnetic storm which occurred on October 21 and 22 are reproduced in the simulation (fig. 1). We have studied the energy transfer and tail reconnect ion in association with geomagnetic storms.

• The Bulletin of The Korean Astronomical Society
• /
• v.43 no.1
• /
• pp.56.2-56.2
• /
• 2018

Astrophysical shocks accelerate particles to high velocities, which we observe as cosmic rays. The acceleration process changes the nature of the shock because the particles interact with the local magnetic field, removing energy and potentially triggering instabilities. In order to simulate this process, we need a computational method that can handle large scale structures while, at the same time, following the motion of individual particles. We achieve this by combining the grid magnetohydrodynamics (MHD) method with the particle-in-cell (PIC) approach. MHD can be used to simulate the thermal gas that forms the majority of the gas near the shock, while the PIC method allows us to model the interactions between the magnetic field and those particles that deviate from thermal equilibrium. Using this code, we simulate shocks at various sonic and Alfvenic Mach numbers in order to determine how the behaviour of the shock and the particles depends on local conditions.

• Nuclear Engineering and Technology
• /
• v.40 no.3
• /
• pp.213-224
• /
• 2008

The pumping of coolant in a liquid metal fast reactor may be performed with an annular linear induction electro-magnetic (EM) pump. Linear induction pumps use a traveling magnetic field wave created by poly-phase currents, and the induced currents and their associated magnetic field generate a Lorentz force, whose effect can be the pumping of the liquid metal. The flow behaviors in the pump are very complex, including a time-varying Lorentz force and pressure pulsation, because an induction EM pump has time-varying magnetic fields and the induced convective currents that originate from the flow of the liquid metal. These phenomena lead to an instability problem in the pump arising from the changes of the generated Lorentz forces along the pump's geometry. Therefore, a magneto-hydro-dynamics (MHD) analysis is required for the design and operation of a linear induction EM pump. We have developed a time-harmonic 2-dimensional axisymmetry MHD analysis method based on the Maxwell equations. This paper describes the analysis and numerical method for obtaining solutions for some MHD parameters in an induction EM pump. Experimental test results obtained from an induction EM pump of CLIP-150 at the STC "Sintez," D.V. Efremov Institute of Electro-physical Apparatus in St. Petersburg were used to validate the method. In addition, we investigated some characteristics of a linear induction EM pump, such as the effect of the convective current and the double supply frequency (DSF) pressure pulsation. This simple model overestimated the convective eddy current generated from the sodium flow in the pump channel; however, it had a similar tendency for the measured data of the pump performance through a comparison with the experimental data. Considering its simplicity, it could be a base model for designing an EM pump and for evaluating the MHD flow in an EM pump.