• Proceedings of the Korean Society of Propulsion Engineers Conference
• /
• 2001.04a
• /
• pp.54-58
• /
• 2001

In order to Improve the performance of a free power turbine type gas turbine engine by injecting the atomized water into a compressor inlet., a study on Moisture Air Turbine (MAT) cycle was proposed. Compressor work by air-water mixtures in phase change was theoretically considered, and it was found that the water evaporation might reduce the compressor work. Cycle model calculations predicted that power increments of 21.7%, 20.2% and 18.4% by 1.5% water to the air flow rate at the compressor intake with rotational shaft speeds of 1000, 1210, 1350 rps were obtained, and also thermal efficiency due to the reduction of compressor work was improved.

• The Journal of Korean Academy of Orthopedic Manual Physical Therapy
• /
• v.29 no.1
• /
• pp.33-39
• /
• 2023

Background: Most Pilates programs for older adults have been based on mat Pilates, and there has been limited research on Pilates with mini-balls. Therefore, this study aims to compare the effects of Pilates with mini-balls and mat Pilates interventions on strength, total body endurance, flexibility, and dynamic equilibrium to determine the differences. Methods: The elderly aged 65 or older living in Gyeongsan, Daegu, were divided into two groups, and the experimental group (n=10) conducted a Pilates exercise program using mini balls for 12 weeks, and the control group (n=10) conducted a mat Pilates exercise program for 12 weeks without mini balls. Strength, endurance, flexibility, and dynamic equlibrium were measured as a pre-test, and post-test was performed in the same way after 12 weeks of application. Results: Comparing the mini-ball Pilates group to the mat Pilates group, there was a significant difference (p<.05) in the 'chair sit and reach' after the intervention. In the within-group comparison, there was a significant increase (p<.05) in 'arm curl right', '30-second chair stand', '2-minute walk', 'back scratch', 'chair sit and reach', and '2.44m up and go' in the experimental group using the mini-ball Pilates program. Mat Pilates program significantly increased the within-group comparisons in '30-second chair stand' and 'chair sit and reach' (p<.05). Conclusion: It is suggested that mini-ball Pilates has a positive effect on the senior fitness and will be a good exercise method for using it as an exercise program for the elderly in the future.

• Journal of the Microelectronics and Packaging Society
• /
• v.20 no.1
• /
• pp.27-31
• /
• 2013

Copper-oxide (CuO) thin films were prepared by reactive sputtering of Cu onto Si wafers and characterized using a statistical design of experiments approach. The most significant factor in controlling the electrical resistivity and deposition rate was determined to be the $O_2$ fraction. The deposited CuO thin films were characterized in terms of their physical and chemical properties, using X-ray photoelectron spectroscopy (XPS), atomic force microscopy (AFM), X-ray diffraction (XRD), and 4-point resistance measurements. The deposited copper thin films were characterized by XPS and XRD analyses to consist of $Cu^{2+}$. The CuO thin films of highest resistivity exhibited superior rectifying responses with regard to n-type Si wafers, with a current ratio of $3.8{\times}10^3$. These superior responses are believed to be associated with the formation of a charge-depletion region originating from the p-type CuO and n-type Si materials.

• Journal of Korea Technical Association of The Pulp and Paper Industry
• /
• v.41 no.4
• /
• pp.8-14
• /
• 2009

Characteristics of biodegradable polymers for mulching mat for seedling were investigated. The solvent solubility of polymers is highest in methylene chloride and chloroform. Tensile strength and breaking elongation of polymer dipped paper were increased to the 0.43-1.46 kN/m and the 0.03-0.26%, respectively. PLAs had showed lower glass transition temperature and melting point than those of polyester. As a result, PLA should be most suitable polymer for mulching mat manufacturing. After biodegradation of polymers by lipase, surface of polymers was change to more flat due to enzymatic degradation.

• Journal of Microbiology
• /
• v.35 no.1
• /
• pp.61-65
• /
• 1997

A novel strategy was developed for isolating suppressors from sporulation-deficient mutants. The mutation in the BCY1 gene, which codes for the regulatory subunit of cAMP-dependent protein kinase, when homozygous, results in diploids being meiosis and sporulation deficient. Two plasmids, YCp-MAT.alpha. and YEp-SPOT7-lacZ, were introduced into MAT.alpha. BCY1$\^$+/ or MAT.alpha. bcy1 haploid cells. The transformant of the BCY1$\^$+/ haploid cell produced .betha.-galactosidase under nutrient starvation, but the bcy1 transformant did not. Using this system, the mutagenesis experiment performed on the bcy1 transformant strain resulted in a number of sporulation mutants that produced .betha.-galactosidase under nutrient starvation. One complementation group, sob1, was identified from the isoalted suppressor mutants and characterized as a single recessive mutation by tetrad analysis. Genetic analysis revealed that the sob1 mutation suppressed the sporulation deficiency, the failure to arrest at the G1 phase of the cell cecle, and the sensitivity to heat or nitrogen starvation caused by the bcy1 mutation. However, the sob1 mutation did not suppress the sporulation deficiency of ime1 and of ime2 diploids. These results suggest that the sob1 mutation affects a gene which functions as a downstream regulator in both meiosis and cell cycle regulation.

• Korean journal of dermatology
• /
• v.56 no.9
• /
• pp.577-578
• /
• 2018

• Journal of The Korean Society of Agricultural Engineers
• /
• v.56 no.3
• /
• pp.31-38
• /
• 2014

Four actual cultivations were prepared and a variety of soybean was cultivated. A H-flume, an automatic water level gauge and an automatic water sampler were installed at the outlet of each plot equipped for the measurement of flow rate and its water quality. The amount of rainfall of the study area in 2013 was measured as 975.6 mm which was much lower than the annual average rainfall of 1,271.8 mm, resulting in less occurrences in rainfall-runoff events. Rainfall-runoff events were occurred three times during the rainfall event of 4~5 July, 23 and 24 August. The characteristics of NPS pollution discharge of the plots and the reduction effect of the selected BMPs were analyzed during these events. The reduction effect of straw mat and soil amendments (Polyacrylamide (PAM) and Gypsum) on runoff ratio ranged between 38.2 and 92.9% (average 71.6%). The NPS pollution load reduced between 27.7 and 95.1% (average 70.0%) by the application of rice straw mat and soil conditioner when compared with that of control plot. Soybean yield (2,133.3 kg/ha) of the straw mat covered plots increased by 14.3% when compared with control (1,866.7 kg/ha). The effect of straw mat on the yield was not economically viable if the material and accompanying labor costs were considered. The data collected and analyzed on different soil textures and crops in this study are expected to be a fundamental reference for the expansion of the results to the application nationwide and the development of NPS pollution management policies.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.15 no.2
• /
• pp.1102-1108
• /
• 2014

This study was to compare the protection abilities of an SPF through ground or underwater casting. A mat of 1/10 scale was made and then mortar was placed on the ground and submerged conditions. A limit velocity of each mat was estimated with this experiment. As a result of the test, the mat failed because of the decrease of bearing power in the center of the waterway. On the one hand, the edge of the mat, where the velocity is slow, secures stability. The result of the limit velocity analysis suggests that a velocity of ground placement with 6.51m/s and underwater casting with 9.80m/s is the minimum to ensure stability. When SPF mat with a thickness of 0.50m is replaced with a concrete block, it is calculated to need a maximum thickness of 2.21m.

• Proceedings of the KIEE Conference
• /
• 1992.07b
• /
• pp.759-761
• /
• 1992

$0.10Pb(Sb_{1/2}Sn_{1/2})O_3-0.25PbTiO_3-0.65PbZrO_3+MnO_2(0.18mol%)$, NiO(0.15mol%) temary compound ceramics won fabricated by the mixed-oxide method. Noise properties of the pyroelectric infrared sensor were investigated with particle size of the raw materials and gain size of the specimens. Particle size were decreased and sintered density, voltage resposivity were increased with increasing the ball-mill times. The specimen ball-milled for a 80[hr] showed a good pop-corn noise properties.

• Korean Journal of Agricultural Science
• /
• v.41 no.2
• /
• pp.101-106
• /
• 2014

This study was conducted to identify lily species native to Korea from formosan lily (Lilium formosanum) belonging to Longiflorum section. Due to flowering time, flower color and orientation, long shelf life and resistant to diseases, the native lily species can be valuable genetic resources for interspecific hybrids. One of the chloroplast genes, matK, was used to clone and sequence to explore any base changes. The matK was successfully amplified into 1,539 bp (94% of the gene) and phylogenetic tree demonstrated 6 clades for those 11 lily species used in this study. There were one or two base substitutions among 10 lilies native to Korea, while formosan lily native to Taiwan exhibited 6 base substitutions in matK gene, rendering it genetically distant. A restriction enzyme NruI recognized one of the six base changes, and digested the matK gene of 10 native lily species only, but not in formosan lily. The confirmed cleavage characteristic of the target region in matK gene was designed into a CAPS (cleaved amplified polymorphic sequences) marker which will be available to estimate compatibility of interspecific hybridization and to trace the pedigree when those native lilies are crossed with the formosan lily.