• Journal of Bio-Environment Control
• /
• v.5 no.2
• /
• pp.152-159
• /
• 1996

Experiment was performed in a newly developed wind tunnel with light system to determine the aerodynamic resistance and eddy diffusivity above the plug stand under artificial light. Maximum air temperature appeared near the top of the plug stand under artificial light. Since Richardson number was ranged from -0.07 to +0.01, the atmosphere above the plug stand in wind tunnel was in an unstable or near- neutral stability state. The average aerodynamic resistance at rear region of plug stand was 25 % higher than that at middle region. Eddy diffusivity($K_{M}$) linearly increased with the increasing air current speed. $K_{M}$ at air current speed of 0.9 m.$s^{-1}$ was about two times as many as that at air current speed of 0.3 m.$s^{-1}$. And average $K_{M}$ at the rear region was 15% lower than that at the middle region. These results indicated that the diffusion of heat and mass along the direction of air current inside the plug stand was different. It might cause the lack of uniformity in the growth and quality of plug seedlings. The wind tunnel developed in this study would be useful to investigate the effects of air current speed on microclimates and the growth of plug seedlings under artificial light in a semi- closed ecosystem.

• Asian-Australasian Journal of Animal Sciences
• /
• v.15 no.11
• /
• pp.1568-1572
• /
• 2002

A 152 day trial was conducted to see the effect of feeding naturally fermented wheat straw (FWS) with either energy, protein or energy protein supplements on the growth of buffalo calves. Twenty four male buffalo calves (10-12 months old) divided in 6 equal groups were individually offered FWS as sole roughage along with either conventional concentrate mixture (conc), maize grains (M), solvent extracted mustard cake (DMC), M-DMC mixture (50:50), deoiled rice bran (DRB) or uromol bran mixture (UBM) in 70:30 ratio. The digestibility of nutrients, nitrogen retention and nutritive value was maximum in FWS:UBM followed by FWS:DMC and FWS:Conc groups. Almost, all the blood parameters were observed well within the normal range except that of blood urea (FWS:UBM) and creatinine (FWS:DMC and FWS:DRB). The dietary combination in which FWS was supplemented with only conventional protein supplement like DMC proved to be highly efficient as far as live weight gain was concerned. FWS supplemented with energy-protein combination i.e. MDMC could also be used as complete feed for growing calves in comparison to conventional feeding system.

• Proceedings of the KIEE Conference
• /
• 2001.11b
• /
• pp.106-108
• /
• 2001

As 3V cathode material, a new doping spinel material, LiMn1.6Se0.4O4 powder with a phase-pure polycrystalline was synthesized by a sol-gel method. In spite of Jahn-teller distortion in 3V region($2.4{\sim}3.5V$), the LiMn1.6Se0.4O4 electrode shows no capacity loss. The material in the 3V region initially delivers a discharge capacity of 100mAh/g which increase with cycling to reach 105mAh/g after 90cycles. And 5V cathode material LiNi0.5-xMxMn1.5O4(M=Cr, V, Fe) compounds have been synthesized by sol-gel method. a series of electroactive spinel compounds, LiNi0.5-xMxMn1.5O4(M=Cr, V, Fe) has been studied by crystallographic and electrochemical methods. The material presents only one plateau at around 4.5 V vs. Li/Li+ with a large discharge capacity of 152mAh/g and fairly good cyclability.

• Journal of the Korean Solar Energy Society
• /
• v.30 no.6
• /
• pp.44-49
• /
• 2010

The purpose of this study is to analyze the situation of energy consumption and its characteristics in large scale store. The related survey is carried out in large scale store to investigate the energy consumption and energy use trend of heating, cooling, hot water, lighting, ventilation, equipments and others. The area of large scale discount store is about $65000m^2$, located in Daejeon. For Annual Energy Analysis of building, We surveyed used energy for 1 year and simulated using a building energy simulation(TRNSYS 16). The results of this study are as follows. 1)The amount of annual total energy consumption are 18615.244MWh/yr(286.4KWh/$m^2yr$), The rate of heating, cooling and base energy(for hot water, lighting, ventilation, equipments, cooking and others) is 3054MWh/yr(47kWh/$m^2yr$), 5660.09MWh/yr(87.08kWh/$m^2yr$), 9900.47MWh/yr(152.31KWh/$m^2yr$) respectively. The total used energy is higher than others building in Korea. Especially, The energy consumption of large scale store is very depends on operating period and pattern such as space temperature, occupancy, lighting system, equipments operating schedule and etc.

• The Korean Journal of Zoology
• /
• v.22 no.4
• /
• pp.141-152
• /
• 1979

Feline leukemia virus DNA polymerase was purified by ion-exchange and nucleic acid affinity chromatographies. The enzyme consists of a single polypeptide chain of approximately 72, 000 molecular weight as determined by both of a glycerol density gradient centrifugation and SDS-polyacrylamide gel electrophoresis. The preferred divalent cation for DNA synthesis is $Mn^2+$ on a variety of template-primers, and its optimum concentration appears to be significantly lower than reported results of other mammalian type-C viral enzymes. The divalent cation requirement for maximum activity of RNase H is similar to those of DNA polymerase. Both DNA polymerase and RNase H activities appear to reside on the same molecule as demonstrated by the copurification of both activities through various purification steps. An additional RNase H without detectible polymerase activity was generated by a limited chymotrypsin digestion. This RNase H activity was inhibited equally effectively as RNase H in the intact reverse transcriptase by antisera prepared against reverse transcriptase of feline leukemia virus. Neutralization and binding test showed that antibody binding to reverse transcriptase molecule did not completely inhibit the polymerase activity.

• Proceedings of the Korean Geotechical Society Conference
• /
• 2010.09b
• /
• pp.152-160
• /
• 2010

In this study, cohesion of soft ground, soft ground depth and embankment height varying conditions, such as the impact of each condition after the calculation of the range, SCP was performed to evaluate the applicability of the method. Reinforcing effects of scope, and permit lateral movement of SCP 2D and 3D analysis of the program were calculated by the displacement ratio, the result follows. The height and depth of soft soil embankment with increasing and decreasing the cohesion tends to be affected were long range, SCP method applied by the finite element analysis Cu = 1.0tf/$m^2$, embankment height is 3.0m depth of soft soil can be applied in a less than 5.0m, and Cu = 3.0tf/$m^2$, embankment height, the soft soil depth is 3.0m 12.0m, Cu = 3.0tf/$m^2$, embankment height is 5.0m less than 7.0m depth of soft soil can be applied in was. And Cu = 5.0tf/$m^2$, embankment height is 3.0m below 15.0m depth rouge anti Floor, Cu = 3.0tf/$m^2$, embankment height of 5.0m 12.0m depth below the soft soil, Cu = 5.0tf/$m^2$, If the depth of soft soil embankment height of 7.0m and below 5.0m was applicable.

• Electronics and Telecommunications Trends
• /
• v.27 no.3
• /
• pp.143-152
• /
• 2012

본고에서는 Machine Type Communications(MTC) 표준화 동향을 소개한다. MTC는 사람이 개입하지 않는 상태에서 기기 및 사물 간에 일어나는 통신이라고 정의하고 있고, 사물의 이동성, 도서, 산간, 해양 등을 포함하는 광범위한 서비스 지역, 네트워크의 운영 및 유지보수의 용이성, 신뢰도 높은 데이터 전송을 위한 보안, 그리고 서비스 품질 보장 등을 고려하여, 이동통신 네트워크를 기반으로 하는 사물통신을 수용하기 위한 것이다. 우선 M2M(Machine to Machine) 개념 및 3GPP(3rd Generation Partnership Project)에서 도출한 응용 분야를 기술하고, 이어서 3GPP MTC 표준화 일정을 살펴보고, 현재까지의 주요 표준 문서의 작성 내용 중 MTC 요구사항의 정의와 구조 모델의 정의, 과부하 제어를 위한 표준화가 주된 내용으로 2011년 9월에 완성된 Release 10 NIMTC(Network Improvements for MTC) 내용을 살펴보고, 마지막으로 현재 3GPP RAN(Radio Access Network)1에서 활발하게 논의되고, 작성하고 있는 저가의 MTC 단말을 지원하기 위한 방안에 대한 기술보고서의 내용에 대해서 살펴보았다.

• 제어로봇시스템학회:학술대회논문집
• /
• 1996.10a
• /
• pp.149-152
• /
• 1996

In this paper, the authors propose a new method for linearizing a nonlinear dynamical system by use of Volterra kernel of the nonlinear system. The authors have recently obtained a new method for measuring Volterra kernels of nonlinear control systems by use of a pseudo-random M-sequence and correlation technique. In this method, an M-sequence is applied to the nonlinear system and the crosscorrelation function between the input and the output gives us every crosssection of Volterra kernels up to 3rd order. Once we can get Volterra kernels of nonlinear system, we can construct a linearization method of the nonlinear system. Simulation results show good agreement between the observed results and the theoretical considerations.

• Journal of the Korean Society for Precision Engineering
• /
• v.21 no.8
• /
• pp.152-156
• /
• 2004

A new tool of surface patterning technique for general purpose lithography was developed based on shadow mask method. This paper describes the fabrication of a new type of miniaturized shadow mask. The shadow mask is fabricated by photolithography and etching of 100-mm full wafer. The fabricated shadow mask has over 388 membranes with apertures of micrometer length scale ranging from 1${\mu}{\textrm}{m}$ to 100s ${\mu}{\textrm}{m}$ made on each 2mm${\times}$2mm large low stress silicon nitride membrane. It allows micro scale patterns to be directly deposited on substrate surface through apertures of the membrane. This shadow mask method has much wider choice of deposit materials, and can be applied to wider class of surfaces including chemical functional layer, MEMS/NEMS surfaces, and biosensors.

• Journal of Korean Vacuum Science & Technology
• /
• v.6 no.4
• /
• pp.149-152
• /
• 2002

We performed the modeling of the dielectric functions of C $d_{0.77}$M $g_{0.23}$Te by using parametric semiconductor model. Parametric model describes the analytic dielectric function as the summation of several energy-bounded Gaussian-broadened polynomials and provides a reasonably well parameterized function which can accurately reproduce the optical constants of semiconductor materials. We obtained the values of fitting parameters of the Mg composition 0.23 in the parametric model. From these parameters we could remove interference oscillations to obtain the dielectric function of C $d_{0.77}$M $g_{0.23}$Te alloy film for full 0.5-6.0 eV energy range.y range.