• Journal of Hydrogen and New Energy
• /
• v.24 no.1
• /
• pp.91-97
• /
• 2013

Recently a novel cycle named organic flash cycle (OFC) has been proposed which has improved potential for power generation from low-temperature heat sources. This study carries out thermodynamic performance analysis of OFC using various working fluids for recovery of low-grade heat sources in the form of sensible energy. Special attention is focused on the optimum flash temperature at which the exergy efficiency has the maximum value. Under the optimal conditions with respect to the flash temperature, the thermodynamic performances of important system variables including mass flow ratio, separation ratio, heat addition, specific volume flow rate at turbine exit, and exergy efficiency are thoroughly investigated. Results show that the exergy efficiency has a peak value with respect to the flash temperature and the optimum working fluid which shows the best exergy efficiency varies with the operating conditions.

• The KSFM Journal of Fluid Machinery
• /
• v.18 no.4
• /
• pp.13-21
• /
• 2015

The system design of the Organic Rankine Cycle(ORC) is greatly influenced by the thermal properties such as the temperature or the thermal capacity of heat source. Typically waste heat, solar energy, geothermal energy, and so on are used as the heat source for the ORC. However, thermal energy supplying from these kinds of heat sources cannot be provided constantly. Hence, an experimental study was conducted to utilize fluctuating thermal energy efficiently. For this experiment, an impulse turbine and supersonic nozzles were applied and the supersonic nozzle was used to increase the velocity at the nozzle exit. In addition, these nozzles were used to adjust the mass flowrate depending on the amount of the supplied thermal energy. The experiment was conducted with maximum three nozzles due to the capacity of thermal energy. The experimented results were compared with the predicted results. The experiment showed that the useful output power could be producted from low-grade thermal energy as well as fluctuating thermal energy.

• Journal of Power System Engineering
• /
• v.18 no.6
• /
• pp.106-112
• /
• 2014

The diesel engine, which has high compression ratio than other heat engines, has been using as the main power source of marine transport. Especially, since marine diesel engines offer better specific fuel consumption (SFC), it is environment-friendly compared to those used in other industries. However, attentio should be focused on emissions such as nitrous oxide ($N_2O$) which is generated from combustion of low-grade fuels. Because $N_2O$ in the atmosphere is very stable, the global warming potential (GWP) of $N_2O$ is 310 times as large as that of $CO_2$, and it becomes a source of secondary contamination after photo-degradation in the stratosphere. It has been hitherto noted on the $N_2O$ exhaust characteristics from stationary power plants and land transportations, but reports on $N_2O$ emission from the marine diesel engine are very limited. In this experimental study, a author investigated $N_2O$ emission characteristics by using changed diesel fuel components of nitrogen and sulfur concentration, assessed on the factors which affect $N_2O$ generation in combustion. The experimental results showed that $N_2O$ emission exhibited increasement with increasing of sulfur concentration in fuel. However, all kinds of nitrogen component additives used in experiment could not change $N_2O$ emission.

• Journal of Hydrogen and New Energy
• /
• v.6 no.1
• /
• pp.11-16
• /
• 1995

Chemical heat pump is one of the energy conversion technologies, which enables to use waste heat as a source of high grade heat. In 2-propanol/acetone system, the dehydrogenation of 2-propanol is an endothermic(heat absorption) reaction, and can be used to generate hydrogen because 2-propanol can be converted to acetone and hydrogen at low temperature(about $8^{\circ}C$) using catalyst. For the dehydrogenation of 2-propanol 5% Ru catalyst based on activated carbon is the best one at the reaction temparature of $83^{\circ}C$.

• Journal of Advanced Marine Engineering and Technology
• /
• v.22 no.6
• /
• pp.754-762
• /
• 1998

Exhaust emissions in diesel engine are affected by fuel properties but the reason for this is not clear. Especially the recent strong interest in using low-grade fuel demands extensibe investigation in order to clarify the exhaust emissions. Bio-Diesel oil has a great possibility to solve the pollution problem caused by the exhaust gas from diesel engine vehicles. The use of bio-oils in diesel engines has received considerable atten-tion to the forseeable depletion of world oil supplies. So bio-diesel oil has been attracted with attentions for alternative and clean energy source. The purpose of this paper is to evaluate the fea-sibility of the rice-bran oil for alternative fuel in a diesel engine with rgard to exhaust emis-sions.

• Transactions of the Korean Society of Mechanical Engineers B
• /
• v.22 no.9
• /
• pp.1267-1276
• /
• 1998

Falling-film evaporation experiments with aqueous lithium bromide (LiBr) solution were performed to investigate the heat transfer characteristics of enhanced copper tubes. Enhanced tubes (a knurled tube, a spirally grooved tube, and a tube coated with $20{\mu}m$ aluminum particles) and a bare tube were selected as test specimens. Averaged evaporation fluxes of water were obtained from horizontal tubes with various film Reynolds numbers, system pressures, LiBr concentrations and degrees of wall superheat. The enhanced performance of steam generation was compared between tubes with varying parameters. The knurled tube geometry showed the most excellent performance among the tubes tested. The specified enhanced tubes were more useful for generating steam on a low grade heat source such as waste heat.

• Journal of Hydrogen and New Energy
• /
• v.32 no.6
• /
• pp.649-655
• /
• 2021

The recently proposed Kalina based power and cooling cogeneration cycles (KPCCCs) have shown improvement in the energy utilization of the system compared to the basic Kalina cycle. This paper suggests a combined tri-cogeneration system for power, heating and cooling based on the Kalina cycle. And thermodynamic performances of the suggested system based on the first and second thermodynamic laws are parametrically investigated with respect to the ammonia mass fraction and the boiler pressure. Results showed that the thermodynamic performance of the system could be greatly improved compared to the former KPCCCs.

• 보존과학연구
• /
• s.17
• /
• pp.123-160
• /
• 1996

There have been many studies and experiments regarding exhibition lighting. Many experiments on photochemical damaging effect and visibility resulted in a practice limited to assigning light levels and adjusting annual exposure time. The three damaging factors to the artifacts are intrinsicsusceptibility to absorb radiant energy, spectral distribution of light source and intensity of illumination and time of exposure. Dividing all the artfacts into three categories to suggest a recommended illuminance level causes some problems. Blue wool, for example, used as the reference material for susceptibility, is not a standard material representing museum artifacts. In the most light sensitive category, ISO class I or anything below have been excluded. The exposure time of one soure can be three times more than another sourece. The spectral distribution of the light source and the relative spectral responsibility of the artifact are not considered in the practice. So in case of very light sensitive material, the recommended illuminance is only the referring value and it is indispensable to check the characteristic of susceptibility of each artifacts. Daylighting is prevailing method to solve the psychological need of the visitors. However, it sould transparent, and should not diffused, and the green-house effect must be considered. llluminance uniformity should based on the maximum illuminance to handle the limitation of exposure for the conservation of a large sensitive object such as a painting. Damage index is not absolute reference for selecting the lighting source because it is experimented from the paper of low grade then calculated. Visibility should be increased by reducing the visual noiseand by planning of appropriate luminance contrast. This paper reviews the problems with the previous studies and experiment sand the current exhibition lighting design practice. The plan for museum showcase lighting is to check the susceptibility and to raise the visibility simultaneously.

• Journal of the Korean Society of Food Culture
• /
• v.11 no.5
• /
• pp.663-671
• /
• 1996

The purpose of this study was to compare high-school students importance and performance toward restaurant service attributes for the marketing strategy development. Specific objectives were to: a) investigate restaurant patronage characteristics of high school students; b) identify the difference of patronage behavior among three types of restaurants; and c) analyze the importance and performance among three types of restaurants. A questionnaire was developed and hand-delivered to 400 students enrolled 9th grade in 4 different high schools in Seoul. A total of 320 students (80%) was responded to this study. The questionnaire was composed of two parts with 47 restaurant service attribute statements. Results of this study were as follows: 1. A total of 57% was female and 61% of respondents spent less than ￦5,000 per week on eating out. 2. The frequency of visiting the low-priced restaurant was 8.9 times per week. 3. Reasons for being a patronage to low- (${\geq}$￦2,000) and mid-priced ( <￦2,000 and ${\geq}$￦5,000) restaurants were hunger, appointment, and seeking favorites with freinds but the reason for high-priced (<￦5,000) restaurants was celebrating special days with parents. 4. The main source of information for selecting restaurants was family and friends, T.V. advertising, and bulletin board. 5. For the low-priced restaurants, food, hygiene, price, and location were rated as important; location, price, menu, and food were rated as satisfied. 6. For the mid-priced restaurants, hygiene, food, price, and menu were rated as important; food, hygiene, service, and menu were rated as satisfied. 7. For the high-priced restaurants, hygiene, food, and atmosphere were rated as important; food, hygiene, atmosphere, and menu were as satisfied. 8. According to paired t-test, the score gap between importance and performance was the highest in the hygiene attribute; differences were high with the low-priced and low with high-priced restaurants.

• Structural Engineering and Mechanics
• /
• v.89 no.5
• /
• pp.525-538
• /
• 2024

An explosion from a specific source can generate high pressure, causing damage to structures and people in and around them. For the design of protective structures, although explosion overpressure is considered the main loading parameter, parts are only considered using standard design procedures, excluding special installations. Properties of the explosive, such as molecular structure, shape, dimensional properties, and the physical state of the charge, determine the results in a high-grade or low-grade explosion. In this context, it is very important to determine the explosion behaviors of the structures and to take precautions against these behaviors. Especially structures in areas with high explosion risk should be prepared for blast loads. In this study, the behavior of non-anchored blast resistant modular buildings was investigated. In the study, analyzes were carried out for cases where modular buildings were first positioned on a reinforced concrete surface and then directly on the ground. For these two cases, the behavior of the modular structure placed on the reinforced concrete floor against burst loads was evaluated with Stribeck curves. The behavior of the modular building placed directly on the ground is examined with the Pais and Kausel equations, which consider the structure-ground interaction. In the study, head and neck injuries were examined by placing test dummies to examine human injury behavior in modular buildings exposed to blast loads. Obtained results were compared with field tests. In both cases, results close to field tests were obtained. Thus, it was concluded that Stribeck curves and Pais Kausel equations can reflect the behavior of modular buildings subjected to blast loads. It was also seen at the end of the study that the human injury criteria were met. The results of the study are explained with their justifications.