• Magazine of the Korean Society of Agricultural Engineers
• /
• v.34 no.3
• /
• pp.43-52
• /
• 1992

Design low flows were derived from the decision of a best fitting probability distribution and of an optimum transformation method can be contributed to the planning of water utilization and management of various hydraulic structures during dry season in the main river systems in Korea. The results were analyzed and summarized as follows. 1.Basic statistics for the selected watersheds were calculated as one of means for the analysis of extremal distribution. 2.Parameters for the different frequency distributions were calculated by the method of moment. 3.Type m extremal distribution was confirmed as a best one among others for the frequency distribution of the low flows by x$^2$ goodness of fit test. 4.Formulas for the design low flows of the Type m extremal distribution with two and three parameters were dervied for the selected watersheds. 5.Design low flows for the Type m extremal distribution when a minimum drought is zero or larger than zero were derived for the selected watersheds, respectively. 6.Design low flows of the Type m extremal distribution with two parameters are appeared to be reasonable when a minimum drought approaches to zero and the observed low flows varied within a relating small range while those with three parameters are seemed to be consistent with the probability distribution of low flows when a minimum drought is larger than zero and the observed low flows showed a wide range.

• Proceedings of the KIEE Conference
• /
• 2005.11b
• /
• pp.322-324
• /
• 2005

This paper describes the comparison of Two frequency ranges for power line communication. The first one is that the frequency range from 100 to 400 KHz is supported by the Federal Communication Committee(FCC). The other one is that the frequency range from 1MHz to 30MHz is based on the European-supported EN5006A band. In this paper, the advantages and disadvantages of their frequency ranges are discussed for PLC. By ATP/EMTP software, the signal attenuation is simulated both the frequency ranges. It shows that the signal attenuation is bigger at high frequency than at low frequency.

• Journal of Power Electronics
• /
• v.7 no.2
• /
• pp.118-123
• /
• 2007

This paper presents a new ZCS-PWM high frequency inverter. Zero current switching operation is achieved in the whole load range by using a simple auxiliary reverse blocking switch in parallel with series resonant capacitor. Dual duty cycle control scheme is used to provide a wide range of high frequency AC output power regulation that is important in many high frequency inverter applications. It found that a complete soft switching operation can be achieved even for low power setting ranges by introducing high-frequency dual duty cycle control scheme. The proposed high frequency inverter is more suitable for consumer induction heating(IH) applications. The operation and control principle of the proposed high frequency inverter are described and verified through simulated results.

• Journal of electromagnetic engineering and science
• /
• v.11 no.4
• /
• pp.235-238
• /
• 2011

In this paper, a novel low phase noise voltage-controlled oscillator (VCO) using metamaterial structure and rat race coupler is presented for reducing the phase noise without the reduction of the frequency tuning range. The metamaterial structure has been realized by microstrip square open loop double split ring resonator (SRR). The rat race coupler shows slightly higher transmission compared to a Wilkinson combiner and is, therefore, used instead to improve the performances of VCO. By providing these unique modifications, the proposed push-push VCO has a phase noise of -126.30~-124.83 dBc/Hz at 100 kHz in the tuning range of 5.672~5.800 GHz.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.25 no.11
• /
• pp.1190-1196
• /
• 2014

This paper presents the design of a Frequency Modulated Continuous Wave(FMCW) radar altimeter with wide altitude range and low measurement errors. Wide altitude range is achieved by employing the optic delay in the transmitting path to reduce the dynamic range of measuring altitude. Transmitting power and receiver gain are also controlled to have the dynamic range of the received power be reduced. In addition, low measurement errors are obtained by improving the sweep linearity using the Direct Digital Synthesizer(DDS) and minimizing the phase noise employing the reference clock(Ref_CLK) as the offset frequency of the Phase Locked Loop(PLL).

• MALSORI
• /
• no.60
• /
• pp.67-84
• /
• 2006

The purpose of this study is to find some acoustic parameters on frequency domain to distinguish the Korean nasals, $/m,\;n,\;{\eta}/$ from each other. The new parameters are devised on the basis of LTAS (Long Term Average Spectrum). The maximum peak amplitude and the relevant formant frequency are measured in low and high frequency range, respectively. The frequency of spectral valley and its energy level are also obtained in the specific frequency range of the spectrum. Spectral slope, total energy value in specific frequency range, statistical distribution of spectral energy like centroid, skewness, and kurtosis are suggested as new parameters as well. The parameters that show statistically significant differences across nasals are summerized as follows. 1) in syllable initial positions: the total energy value from 1,500 to 2,200 Hz(zeroENG); 2) in syllable final positions: the peak amplitude of the first formant(peak1_a), the formant frequency with maximum peak amplitude from 4,000 to 8,000 Hz(peak2_f), the maximum peak amplitude of the formant frequency from 4,000 to 8,000 Hz(peak2_a), and the total energy value from 1,500 to 2,200 Hz(zeroENG).

• Proceedings of the IEEK Conference
• /
• 1999.06a
• /
• pp.353-356
• /
• 1999

A 3.3V PLL(Phase Locked loop) is designed for a high frequency, low voltage, and low power applications. This paper proposes a new PLL architecture to improve voltage to frequency linearity of VCO(Voltage controlled oscillator) with new delay cell. The proposed VCO operates at a wide frequency range of 30MHz~1㎓ with a good linearity. The DC-DC voltage up/down converter is utilized to regulate the control voltage of the two-stage VCO. The designed PLL architecture is implemented on a 0.6${\mu}{\textrm}{m}$ n-well CMOS process. The simulation results show a locking time of 2.6$\mu$sec at 1Hz, Lock in range of 100MHz~1㎓, and a power dissipation of 112㎽.

• Bulletin of the Korean Chemical Society
• /
• v.30 no.1
• /
• pp.145-148
• /
• 2009

Nucleotides are the building blocks of nucleic acids and essential for many cellular functions. In this study, ultrasonic absorption spectra of $\beta$-cyclodextrin ($\beta$-CD) and adenosine 5'-monophosphate (AMP) in aqueous solution were measured over the broad frequency range 0.1-40 MHz with emphasis on the low-frequency range below 1 MHz. Here we show that the interaction of $\beta$-CD and AMP complies with a typical spectrum of a single relaxation process. We determined reliable rate (kb) and equilibrium (K) constants and a standard volume change ($\Delta$V) of the reaction. They are $k_b=2.3{\times}{{10^{-6}}_s}^{-1},\;K=89M^{-1},\;and\;{\Delta}V=13.8(10^{-6}m^3mol^{-1})$, respectively.

• Proceedings of the KIEE Conference
• /
• 1998.07b
• /
• pp.728-730
• /
• 1998

The control valve positioner is a high gain plain proportional controller which measures the valve stem position and compares it to its setpoint which is the primary controller output. The positioner in effect is the cascade slave of the primary controller. In order for a cascade slave to be effecttive, it must be fast enough compared to the speed of its set point change. This paper describes the positioner transfer function and its effect on the entire control loop characteristic based on the simulation results. The result showed that the control valve and positioner determined the gain and phase angle in the high frequency range, while the primary controller and process determined those of the low frequency range. We can also anticipate the combined characteristics in the whole frequency range when each element's frequency response is known.

• Bulletin of the Korean Chemical Society
• /
• v.10 no.6
• /
• pp.495-500
• /
• 1989

The ionic conductivity of polycrystalline, glass, and glass-ceramic silicates was measured using two-terminal AC method with blocking electrode over a frequency range of 100 Hz to 100 KHz in the temperature range of $200^{\circ}C$ to $320^{\circ}C$. Analysing the capacitance (C), susceptance (B), impedance (Z), and conductance (G) under the given conditions, an equivalent circuit containing temperature and frequency dependent component is proposed. Higher capacitance could be observed in the low frequency region and on the improved ionic migration conditions i.e., at higher temperature in a better ionic conductor. Also the electrode polarization built up at the electrode-specimen interface could be sorted out above 10 KHz. However, grain boundary contribution couldn't be extracted from the bulk resistance over the frequency range measured here.