• 한국연소학회:학술대회논문집
• /
• 2000.05a
• /
• pp.85-92
• /
• 2000

End-gas temperatures were measured using CARS technique in a conventional DOHC spark-ignition engine fueled with PRF80. The measured pressure data were analyzed using band pass filter method. The measured CARS temperatures were compared with adiabatic core temperatures calculated from measured pressure. Significant heating by pre-flame reaction in the end gas was observed in the late part of compression stroke under both knocking and non-knocking condition. CARS temperatures measured at 10 crank angle degree before knock occurrence was higher than adiabatic core temperatures. These results indicate that there exist some exothermic reactions in low pressure and temperature region. CARS temperatures began to be higher than the adiabatic core temperature when the end-gas temperatures reached 700 K. The temperature elevation due to the pre-flame reaction correlated better with CARS temperature than with cylinder pressure.

• Atmosphere
• /
• v.26 no.1
• /
• pp.97-109
• /
• 2016

Heavy rainfall (over $80mm\;hr^{-1}$) system associated with unstable atmospheric conditions occurred over the Seoul metropolitan area on 27 July 2011. To investigate the heavy rainfall system, we used three-dimensional data from Korea Local Analysis and Prediction System (KLAPS) reanalysis data and analysed the structure of the precipitation system, kinematic characteristics, thermodynamic properties, and Meteorological condition. The existence of Upper-Level Jet (ULJ) and Low-Level Jet (LLJ) are accelerated the heavy rainfall. Convective cloud developed when a strong southwesterly LLJ and strong moisture convergence occurring around the time of the heavy rainfall is consistent with the results of previous studies on such continuous production. Environmental conditions included high equivalent potential temperature of over 355 K at low levels, and low equivalent potential temperature of under 330 K at middle levels, causing vertical instability. The tip of the band shaped precipitation system was made up of line-shaped convective systems (LSCSs) that caused flooding and landslides, and the LSCSs were continuously enhanced by merging between new cells and the pre-existing cell. Difference of wind direction between low and middle levels has also been considered an important factor favouring the occurrence of precipitation systems similar to LSCSs. Development of LSCs from the wind direction difference at heights of the severe precipitation occurrence area was also identified. This study can contribute to the identification of production and development mechanisms of heavy rainfall and can be used in applied research for prediction of severe weather.

• Journal of the Korean Ceramic Society
• /
• v.34 no.4
• /
• pp.436-442
• /
• 1997

The bimodal distribution of CuCl nano-crystals precipitated in alumino-borosilicate glass matrix (30SiO2-45B2O3-7.5Al2O3-7.5Na2O-7.5CaO-2.5GeO2(mole %)) was investigated by TEM and the temperature dependent optical spectroscopy. Two types of CuCl particles with different size were observed by TEM and it was confirmed by the splitting of Z3 absorption peak at low temperature and the occurrence of deflection point in the optical spectra with temperature.

• Transactions of Materials Processing
• /
• v.25 no.5
• /
• pp.306-312
• /
• 2016

Effects of manufacturing conditions, such as austenitizing temperature, patenting temperature and carbon content in steels, on mechanical properties, especially on reduction of area (RA), of hyper-eutectoid steel wires were investigated. RA increased and then decreased with transformation temperature. This was attributed to the presence of abnormal structures in steels transformed at low transformation temperatures and the occurrence of shear cracking during tensile testing of steels transformed at high transformation temperatures. The increase of austenitizing temperature resulted in the increased austenite grain size and consequently the decrease of RA. The decrease of RA with increasing the carbon content in steels was attributed to the increased fraction of cleavage fracture in tensile fractured surfaces.

• Korean Journal of Agricultural Science
• /
• v.41 no.2
• /
• pp.75-83
• /
• 2014

Recently, a quick drop of air temperature in plastic film houses by adverse weather conditions leads to the occurrence of low temperature damages to growing crops. Chilling injury, defined as a variety of growth restriction occurring below the optimal temperature, is one of environmental factors strongly affecting crop growth and yield. Low temperature causes the restricted evapotranspiration, reduced mineral uptake (P > K > $NO_3{^-}$), and an increase in electrolyte leakage such as K. Despite being different with plant species, an accumulation of soluble carbohydrates such as glucose, fructose, sucrose and starch under chilling condition is well known. A variety of environmental stresses are known to cause oxidative damage to plants either directly or indirectly by triggering an increased level of production of reactive oxygen species (ROS), and, to combat the oxidative damage, plants have the antioxidant defense systems comprising of enzymes, SOD, POD, CAT, GPX and APX, and non-enzymes, ascorbate, gluthathione, ${\alpha}$-tocopherol, phenolic compounds, carotenoid and flavonoids. The aim of this review is to provide basic information to build chilling-indicators and optimal nutrition management under adverse temperature conditions as broadly considering mineral uptake, carbohydrate metabolism and antioxidative defense system.

• KOREAN JOURNAL OF CROP SCIENCE
• /
• v.32 no.2
• /
• pp.130-136
• /
• 1987

The studies were carried out to investigate the occurrence of excessive dried leaves during burley tobacco curing. Six different periods of ventilation during the entire stage of curing were applied. And also 3 different heights of rolling up polyethlene film for side ventilation of the curing house combined with 4 different spaces between garlands were applied from after yellowing. The high air temperature and low relative humidity from end of yellowing to end of browning stage were the most critical to occur excessive dried \eaves. As side ventilation was continued for the entire stage of curing, air temperature in curing house was lower and occurrence of excessive dried leaves were remarkably decreased. The air temperature was not affected on hanging spaces, but relative humidity that resulted significantly in decreasing of the excessive dried leaves was increased by narrowing of hanging spaces. As excessive dried leaves were increased, its price per kg was lower, its physical properties was worse and its total nitrogen and total suger were higher than those of normal cured leaves.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.8 no.4
• /
• pp.938-945
• /
• 2004

On the relationship between the red tide occurrence and the oceanographic factors in the middle coastal area in the South Sea of Korea, the favorable oceanographic conditions for the red tide formation are considered as follows； the calm weather increases sea water temperature in summer and early-fall which the red tide occurs frequently, and the heavy precipitation brings some riverine water to ween: low salinity, high suspended solid, low phosphorus and high nitrogen, respectively. We decided the potential areas in the coastal zones vulnerable to the red tide occurrence based on the limited factors controlling the growth of phytoplankton. By using GIS through the overlap for three subject figures (phosphorus, nitrogen and suspended solids), it was founded that the potential areas are the Yeosu∼Dolsan coast, the Gamak bay, the Namhae coast, the Narodo coast, the Goheung and Deukryang bay. This result has very well coincided to the results of the satellite and in-situ data.

• Proceedings of the Korean Society for Technology of Plasticity Conference
• /
• 2006.05a
• /
• pp.159-163
• /
• 2006

The effects of annealing temperature and time on mechanical properties and microstructures were studied in cold drawn pearlitic steel wires containing 0.84wt% Si. Annealing was performed from $200^{\circ}C$ to $450^{\circ}C$ with different time of 30sec, 1min, 15min and 1hr. The increase of tensile strength at low temperature was related with strain ageing. The decrease of tensile strength at high annealing temperature was related with spherodization of cementite and the occurrence of recovery of the lamellar ferrite in the pearlite. The improvement of ductility was connected with spherodization of cementite plate in pearlite and recovery process by reduction of high dislocation density at short time annealing temperature of $400^{\circ}C$.

• Journal of Magnetics
• /
• v.9 no.3
• /
• pp.89-95
• /
• 2004

Magnetization and electrical resistivity measurements in the wide temperature and field ranges were performed on single crystals of $UGe_2$. The presence of extremely large anisotropy in the temperature dependence of the susceptibility and magnetization has confirmed the previously published results. The dependence of spontaneous magnetization, ${\sigma}_s$, on temperature has been inferred from the Arrot plot and compared to that determined from neutron diffraction data. The earlier transversal and present longitudinal results on the magnetoresistivity are discussed in the terms of possible f-electron dualism in $UGe_2$ and its connection with the occurrence of superconductivity under pressure in this compound.

• 제어로봇시스템학회:학술대회논문집
• /
• 2004.08a
• /
• pp.20-23
• /
• 2004

Tropospheric and ionospheric scintillation may impact on C-band satellite communication systems, particularly at lowmargin systems and low elevation angles. This paper presents the characteristics of C-Band scintillation at low elevation angle received and recorded the satellite signal from INTELSAT above the Pacific Ocean Region (POR) from January 2002 to December 2002 in the period of solar maximum. We received 3.9525 GHz beacon signal at Sri-Racha satellite earth station by the 32 meters in diameter antenna with 8 degrees of elevation. The analysis was found that the values of amplitude fluctuation is mostly about 0.5-0.6 dB peak to peak and $S_4$ = 0.03-0.04. The maximum amplitude fluctuation is about 9 dB peak to peak occurring in April. The occurrence numbers of scintillation is most frequently in April and minimum in November. The occurrence numbers of tropospheric scintillation are most frequently in April and October, and minimum in November. It relates to temperature and water vapor pressure variation in $N_{wet} $. The occurrence numbers of ionospheric scintillation are most frequently in April and September, and minimum in November. It varies corresponding to both equinoctial periods (vernal and autumnal equinox in March and September) and solstice periods (June and December) respectively.