• Korea-Australia Rheology Journal
• /
• 제16권4호
• /
• pp.175-182
• /
• 2004

Colloidal coating solution was prepared to enhance the hydrophilic property of the film surface. Water and ethanol were used as the dispersion media and (glycidoxypropyl) trimethoxysilane (GPS) as a binder in the colloidal silica coatings. Ethylene diamine was added to the colloidal silica solution as the curing agent. The colloidal silica solution was regarded as a hard-sphere suspension model with low volume fraction of the silica particles. Rheological properties of the silica suspensions modified with GPS have been investigated as a function of pH and concentration. The acidic solution showed high viscosity change by fast hydrolysis reaction and adsorption of the organic binders on the surface of silica particles. However, the hydrolysis was slow at the basic condition and the binders combined with themselves by condensation. The viscosity change was smallest at pH 7. The viscosity increased with the curing time after adding ethylenediamine, and the increase of viscosity at low pH was higher than that at high pH. The hydrophilic properties of the coating film were investigated by the contact angle of water and film surface. The smallest contact angle was shown under the strong acidic condition of pH 2.

• 한국건축시공학회:학술대회논문집
• /
• 한국건축시공학회 2007년도 추계 학술논문 발표대회
• /
• pp.37-40
• /
• 2007

This study investigates the effect of the pre-mix cement to the physical properties of the concrete according to the various combinations of the binders and the silica fume types. The results are summarized as following. For the properties of the fresh, the fluidity in the case that OPC+cilica fume-blast-furnace slag is appropriate compared to OPC+cilica fume+fly ash. Expecially, it is favorable when pre-mix is used. The fluidity time of the A, B depending on silica fume types is favorable, but it is decreased on C. The air content depending on silica fume types is low when the fly ash is used. Specially, the air content in the case that pre-mix is used is low caused by the dispersion of the silica fume. For the properties of the hardened concrete, the compressive and flexible strength when the blast-furnace slag is pre-mixed are high, and they exceed OPC. The strength depending on the silica fume types is high on B, and the strength of the others is similar.

• 콘크리트학회논문집
• /
• 제23권2호
• /
• pp.145-150
• /
• 2011

전국적으로 토목 및 건축 구조물의 대단위 공사 및 정비 사업이 발족 및 추진되어 부재 크기가 큰 매스 콘크리트 구조물이 많이 건설되고 있다. 대규모 콘크리트 구조물의 콘크리트 매트릭스 내 높은 수화열 발생은 콘크리트의 품질 및 시공 기간을 좌우하는 가장 중요한 요인이 되고 있다. 이로 인해 발생되는 내부 균열이 콘크리트의 내구성, 수밀성 및 강도를 저하 시키게 된다. 벨라이트계 저열 포틀랜드 시멘트와 산업부산물을 이용한 수화열을 저감시키는 방법으로 이 연구에서는 고로 슬래그 또는 플라이애쉬를 7단계로 치환한 2성 분계 결합재와 4단계로 치환한 3성 분계 결합재를 사용하였고, 혼화재의 치환율 변화가 재령에 따른 수화 발열량, 강도 및 SEM, XRD 등의 기초 물성에 미치는 영향을 비교 분석하였다. 플라이애쉬가 치환된 2성 분계 결합재의 28일 누적 수화열은 플라이애쉬 함유량의 증가함에 따른 높은 수화열 저감 효과를 보여주며, 고로 슬래그가 치환된 2성 분계 결합재의 28일 누적 수화열은 고로 슬래그 치환율이 증가함에 따라 감소하지만 수화열 감소 효과는 높은 치환율 대비 낮은 결과를 나타내었다. 3성 분계 결합재의 28일 누적 수화열의 경우 플라이애쉬 치환율이 높아짐에 따라 낮은 수화열 결과를 보여주며 특히 40% 플라이애쉬 및 30% 고로 슬래그 결합재는 벨라이트계 저열 포틀랜드 시멘트 대비 50%의 저열 효과를 보여주었다. 연구 결과를 통해 수화열 발생이 낮고 시공 가능한 압축강도를 가진 벨라이트계 혼합 결합재를 사용하여 콘크리트 내 온도 상승이 감소된 것을 보여주었다.

• Journal of Biosystems Engineering
• /
• 제15권1호
• /
• pp.52-60
• /
• 1990

The main purpose of this report is to analyse the utilization results of farm machinery, farm mechanization rate and influences on the farm household economy. These results are summarized as follows : 1) The annual working days of major farm machinery are from 34.3 to 68.8 days for power tillers and tractors ; 7.9 to 8.5 days for rice transplanters ; 3.6 to 6.9 days for binders ; and, from 18.6 to 20.6 days for combines. Also income and expenditures of the farm management reveals al surplus in major farm machinery except for binders. 2) The popularization rate of major farm machinery is currently low, reaching the level of the early 1970's in Japan and the level of the early 1980's in Taiwan for rice transplanters and harvesters respectively. 3) The farm mechanization rate is 81.7% in plowing & levelling, 66.3% in rice transplanting, 87.5% in pest and disease control, 62.1% in harvesting and 12.5% in drying. However the farm mechanization rate of rice transplanting, harvesting and drying still remains at a low level. 4) The composition rates of farm machinery and implements are 10.2% in farm management expenditures (23.6% in Japan) and 13.2% in fixed capitals (29.4% in Japan) which still reflect a low level, and below that of the 1970's in Japan. From these analysis results, farm mechanization contributes to the improvement of farm management. Nevertheless, the popularization status and mechanization rate are still at a low level in korea. Therefore, it is deemed desirable to furthure promote effective utilization methods and guide farmers in higher safety utilization and management technology.

• 한국건축시공학회:학술대회논문집
• /
• 한국건축시공학회 2012년도 춘계 학술논문 발표대회
• /
• pp.69-70
• /
• 2012

This paper is to investigate the engineering properties of the concrete incorporating different types of low heat generating binders subjected to various W/B. As expected, it is found that increase of W/B resulted in a decrease of hydration heat and compressive strength. It also showed that the application of high early strength and low carbon type mixture had favorable strength development at early and later age, while hydration heat showed rather higher than existing low heat mixture.

• 보존과학회지
• /
• 제36권5호
• /
• pp.339-350
• /
• 2020

본 연구는 석조문화재 보존처리용(표면마감) 무기질바인더가 암석에 위해한 영향을 미치는 백화현상을 제어하기 위해 광물기반의 충전제와 발수제를 혼합한 하이브리드 기술을 적용하였다. 연구결과, 무기질바인더 성능개선에 효과적인 충전제(실리카흄 3.4%)와 발수제(실란-실록산 1%)를 선정하였으며, 해당 중량비율은 백화물질 제어에 효과가 있는 것으로 판단된다. 또한 압축강도 기준을(20 MPa) 상회하였고 흡수율은 낮아 투수저항성이 높은 것을 확인하였다. 이온용출 결과도 백화현상에 직·간접적으로 작용하는 이온의 검출량이 대조군보다 작게 검출되어 상대적으로 안정적인 것으로 판단된다.

• 한국분말재료학회지
• /
• 제29권4호
• /
• pp.291-296
• /
• 2022

The green body of WC-Co cemented carbides containing polymeric binders such as paraffin, polyethylene glycol (PEG), and polyvinyl acetate (PVA) are prepared. The green density of the WC-Co cemented carbides increases with the addition of binders, with the exception of PVA, which is known to be a polar polymeric substance. The green strength of the WC-Co cemented carbides improves with the addition of paraffin and a mixture of PEG400 and PEG4000. In contrast, the green strength of the WC-Co does not increase when PEG400 and PEG4000 is added individually. The compressive strength of the green body increases to 14 MPa, and the machinability of the green body improves when more than 4-6 wt% paraffin and a mixture of PEG400 and PEG4000 is used. Simultaneously, the sintered density of WC-Co is as high as 99% relative density, similar to a low binder addition of 1-2 wt%.

• 한국도로학회논문집
• /
• 제3권1호
• /
• pp.185-197
• /
• 2001

본 연구는 온도에 따라 특성이 변하는 아스팔트 콘크리트의 파괴인성을 규명하기 위하여 기존의 유효균열 모델을 수정하는 연구를 다루고 있다. 본래의 ECM모델은 콘크리트와 같은 고체에 적용되도록 개발되어 재료의 포아슨 비를 고려하지 않는다. 하지만 아스팔트 콘크리트는 온도변화에 민감하여 온도에 따라 포아슨 비가 변화하므로 다양한 온도하에서 정확한 파괴 특성을 알기 위해서는 포아슨 비가 고려되어져야 한다. 3개의 개질아스팔트 결합재를 포함한 4가지 결합재를 사용하여 밀입도 아스팔트 혼합물을 제조하여 초기균열 보에 대한 3점 휨 시험을 $-5^{\circ}C$부터 $-35^{\circ}C$까지에서 수행하였다. 탄성계수, 휨강도 및 파괴인성을 시험을 통하여 구하였다. 시험결과 포아슨비가 고려되는 수정 ECM 공식을 사용하므로서 보다 정확한 값들을 얻을 수 있었다. 폴리머 개질 아스팔트 혼합물이 일반아스팔트 혼합물에 비하여 더 낮은 저온하에서 더 높은 강성과 파괴인성을 유지함을 알 수 있었다.

• 펄프종이기술
• /
• 제45권5호
• /
• pp.37-43
• /
• 2013

This study was focused on applying a new paper coating binder, vinyl acetate-ethylene(VAE) emulsion, with SB-latex and acrylic emulsion for paper coating application. VAE emulsion has a low monomer cost and is non-toxic chemical than conventional adhesive for paper coating such as styrene-butadiene latex( SB-latex) and acrylic emulsion. We conducted double coating in order to test VAE emulsion, which was applied on top surface only. The results showed that optical properties of the coated paper with VAE were similar with the SB-latex binders. In case of bonding strength, dry-pick of the coated paper with VAE showed almost same with other binders while wet-pick of the coated paper with VAE had a little bit lower strength than that with SB-latex.

• 한국축산식품학회:학술대회논문집
• /
• 한국축산식품학회 2005년도 제36차 추계 학술발표대회
• /
• pp.131-135
• /
• 2005

In general, the application of HP contributes to improvement of functionalities of meat protein. In the current study, HP allowed the lower thermal processing of restructured meat product. Low thermal processing allowed fresh-like meat color which is one of problems in hot-set restructuring, while they showed slight discolorization induced by HP. In addition, HP processing combined with thermal processing could be achieved the palatable binding strength in restructured meat product. The addition of non-meat protein had an effect in binding strength. However, they showed no effect on water binding properties at 200 MPa, especially in milk proteins such as casein and whey protein. This is probably due to protein aggregation or to increase in surface hydrophobicity under HP. This result indicates that the application of HP on meat restructuring is more significant than the addition of binders. Therefore, the application of HP has apotential benefit in restructured meat product, and further investigations are needed.