• Journal of the Korean GEO-environmental Society
• /
• v.12 no.3
• /
• pp.55-61
• /
• 2011

Song-Do international city is the area developed in large-scale land reclamation. Song-Do area consists of reclamation layer, sedimentary layer(loose silt, soft clay and sand alternating) and residual layer from the ground surface. Therefore, using pile foundation is inevitable to build structures safely. In this area, driven PHC piles have been generally constructed in terms of environmental and economic conditions. As a result of analyzing 4 sites in Song-Do district 5 and 7 recently, the method of driving pile has many problems because of existence of rigid soil in sedimentary layer and installation of more than 30m piles. In this case, when installing piles by drive after pre-boring up to appropriate depth, the results of constructability analysis were very good. And in the economic efficiency, although 4% of construction cost rose, it was a very slight increase in comparison with improvement of workability. In the case of the stability, more than 70% compared to the allowable stress of piles was satisfied through the load test. As a result, when PHC piles is installed in Song-Do district, the proper construction method is that piles are located at bearing layer after boring rigid sand layer.

• Membrane Journal
• /
• v.33 no.4
• /
• pp.191-200
• /
• 2023

Polyethersulfone (PES) is a widely employed membrane material for water and industrial purification applications owing to its hydrophilicity and ease of phase separation. However, PES membranes and filters prepared using the nonsolvent induced phase separation method often encounter significant flux decline due to pore clogging and cake layer formation on the dense membrane surfaces. Our investigation revealed that tight microfiltration or loose ultrafiltration membranes can be subject to physical fouling due to the formation of a dense skin layer on the bottom side caused by water intrusion to the gap between the shrank membrane and the substrate. To investigate the effect of the bottom surface porosity on membrane fouling, two membranes with the same selective layers but different sub-layer structures were prepared using single and double layer casting methods, respectively. The double layered PES membrane with highly porous bottom surface showed high flux and physical fouling tolerance compared to the pristine single layer membrane. This study highlights the importance of physical optimization of the membrane structure to prevent membrane fouling.

• Korean Journal of Heritage: History & Science
• /
• v.45 no.1
• /
• pp.122-147
• /
• 2012

The Four-guardian statues in Song-gwang buddhist temple, Suncheon, Korea, have been remade in AD 1628 and have been repaired and repainted over several times since then. Therefore, the study of the pigments applied on the statues can provide good chance for investigation about pigments used in the late Chosun Period. Pigments on fragments from Gwang-mok(Virupaksha), one of the Four-guardian statues, have been analyzed by optical microscope, SEM-EDX and XRD in order to identify the components and compounds. Six types of materials were found from the fragments, which are soil layer with brown clay band, soil layer containing a lot of fibers, Korean paper with loose texture, Korean paper with dense texture, silk, and hemp textile. Presumably, the soil layer which have brown clay band is basis layer and the other layers are repaired layers. From comparative study for the components of the pigments, applied on upper and lower parts of the repaired layers, we have concluded that those repaired layers had been applied on the statue by the following order; basis layer ${\rightarrow}$ Korean paper with loose texture ${\rightarrow}$ soil containing a lot of fibers ${\rightarrow}$ silk ${\rightarrow}$ hemp textile and Korean paper with dense texture. In addition, the years that those materials were applied on the statue have been estimated as 1720~1891, 1926, 1946 and 1976, respectively. The distinct features of each age are as the following; lead white and copper chloride hydroxide are major white and green pigments before 1891, zinc white, barium white, emerald green, and ultramarine blue appear after 1926 and titanium white uprises around 1976. Our result presented here, study on pigments applied on traditional statues over several different periods, will provide good database for future study on pigments used for traditional painting in Buddist temples and Dancheong.

• Proceedings of the Membrane Society of Korea Conference
• /
• 1998.06a
• /
• pp.135-153
• /
• 1998

Nanofiltration (NF) is a recently introduced term in membrane separation. In 1988, Eriksson was one of the first authors using the word 'nanofiltration' explicitly. Some years before, FilmTech started to use this term for their NF50 membrane which was supposed to be a very loose reverse osmosis membrane or a very tight ultrafiltration membrane. Since then, this term has been introduced to indicate a specific boundary of membrane technology in between ultrafiltration and reverse osmosis. The application fields of the NF membranes are very broad as follows: Demeneralizing water, Cleaning up contaminated groundwater, Ultrapure water production, Treatment of effleunts containing heavy metals, Offshore oil platforms, Yeast production, Pulp and paper mills, Textile production, Electroless copper plating, Cheese whey production, Cyclodextrin production, Lactose production. The earliest NF membrane was made by Cadotte et al, using piperazine and trimesoyl chloride as monomers for the formation of polyamide active layer of the composite type membrane. They coated very thin interfacially potymerized polyamide on the surface of the microporous polysulfone supports. The NF membrane exhibited low rejections for monovalent anions (chloride) and high rejections for bivalent anions (sulphate). This membrane was called NS300. Some of the earliest NF membranes, like the NF40 membrane of FilmTech, the NTR7250 of Nitto-Denko and the UTC20 and UTC60 of Toray, are formed by a comparable synthesis route as the NS300 membrane. Commercially available NF membranes nowadays are as follows: ASP35 (Advanced Membrane Technology), MPF21; MPF32 (Kiryat Weizmann), UTC20; UTC60; UTC70; UTC90 (Toray), CTA-LP; TFCS (Fluid Systems), NF45; NF70 (FilmTec), BQ01; MX07; HG01; HG19; SX01; SX10 (Osmonics), 8040-LSY-PVDI (Hydranautics), NF CA30; NF PES 10 (Hoechst), WFN0505 (Stork Friesland). The typical ones among the commercially available NF membranes are polyamide composite membrane consisting of interfacially polymerized polyamide active layer and microporous support. While showing high water fluxes and high rejections of multivalent ions and small organic molecules, these membranes have relatively low chemical stability. These membranes have low chlorine tolerance and are unstable in acid or base solution. This chemical instability is appearing to be a big obstacle for their applications. To improve the chemical stability, we have tried, in this study, to prepare chemically stable NF membranes from PVA. The ionomers and interfacially polymerized polyamide were used for the modification of'the PVA membranes. For the detail study of the active layer, homogeneous NF membranes made only from active layer materials were prepared and for the high performance, composite type NF membranes were prepared by coating the active layer materials on microporous polysulfone supports.

• Proceedings of the Korean Geotechical Society Conference
• /
• 2008.03a
• /
• pp.1042-1050
• /
• 2008

In this study, SCP method was used by purpose to improve loose sand and soft clay that is drilled Sand Compaction Pile in underground. Settlement behavior of field analyzed through SCP method. When sand Compaction Pile drilled in clay, forming composite ground that foundation and Sand Compaction Pile behavior. According to SCP method can expect bearing capacity improvement, Settlement reduction, lateral flow protection. SCP increase the consolidation settlement of ground and it reduce settlement for that purpose increase liquefaction resistance, lateral Resistance. Because SCP had been widely used for sand. Area of Inchon-A by sand compose clay and silt to upper Ground and compose soft clay to under ground. After pre-loading, it measured settlement by extensometer and settlement extensometer that purpose of ground improvement with 13% in replacement ratio. The result analyzed settlement behavior is similar to Multi-layered Ground that it happened to elastic settlement at upper ground and to consolidation settlement at under ground.

• Proceedings of the Korean Geotechical Society Conference
• /
• 2006.03a
• /
• pp.445-454
• /
• 2006

Myungji Housing Complex is located in the Nakdong River plain in which the Busan soft clays are developed. It has thick soft soil laver of about GL(-)50m including loose sandy layers, upper and lower clayey layers. The clayey layers have been being consolidated since the land reclamation was completed to build the place for Housing Complex(Apartment) in 1997. Therefore, as one of a series of advance preparations of this project, study was carried on the geotechnical characteristics under the foundation The first part of this paper represents a brief geological history. Then, geotechnical characteristics of clay was analyzed in the classical developments in soft clay. They were based on the geotechnical data obtained by site investigations performed from 1992 to 2005. Finally, we evaluated the average degree of consolidation at this point in time and the residual settlements of upper clayey layer using dissipation and oedometer tests for this project

• Proceedings of the Korean Institute of Building Construction Conference
• /
• v.y2004m10
• /
• pp.1-6
• /
• 2004

We ensure a flat and regular basic surface by using part of joint waterproofing improved sheet method applying the upper slab of a concrete structure. We solve the problem of getting loose scale the general sheet by waterproofing of the sheet and improving adhesive strength of the basic concrete. Also, waterproofing sheet union to problem of joint have solved using of insertion type method so that, it improved a watertightness. It has improved in resist impact, resist abrasion and it is the effect of shortened construction period and cutting down on construction expenses. Here are the special quality and superiority of this waterproofing research. (1) Level material has the super adhesive strength so that it makes the basic surface without the gab of waterproofing sheet and waterproofing layer with the string adhesive strength. (2) We unite the sheet with the joining part between sheets by waterproofing sheet joint using of method. (3) There is the effect of shortened construction period and cutting down on construction expenses without waterproofing of protection.

• Korean Journal of Environmental Biology
• /
• v.38 no.3
• /
• pp.416-423
• /
• 2020

The genus Petroderma never been reported from the coast of Korea. In this study, our collection from Chaeseokang is matched with P. maculiforme morphologically. Petroderma maculiforme is characterized by having small irregular light to dark brown crusts, a basal layer of irregularly shaped cells giving rise to erect parallel filaments which easily separate with pressure, single chromatophore per cell, small spherical to cylindrical unilocular sporangia in a terminal position, and plurilocular sporangia narrower than erect filaments or wider and shorter than erect filaments in a terminal position. In addition, Hineksia sordida was also collected from Korea. It is mostly epiphytic and characterized by uniseriate filamentous thalli forming loose tangled masses, sparse and spiral branching, some long lateral branches, rhizoids occurring throughout the plant, plurilocular and unilocular sporangia scattered on separate plants. Our molecular analyses based on the rbcL gene reveal that our samples of P. maculiforme and H. sordida are nested within the clades of Petroderma and Hincksia, respectively. Therefore P. maculiforme and H. sordida are reported as new records from Korea based on morphological and molecular analyses.

• Proceedings of the Korean Geotechical Society Conference
• /
• 2009.09a
• /
• pp.884-890
• /
• 2009

The bi-directional pile load test with variable end plate overcomes the shortcoming of the Osterberg cell test. It is possible that the ultimate bearing capacity of the bi-direction can be known by using the loading of the end plate and two step procedures. The first step is to confirming end bearing capacity with variable end plate and the second step is similar to the conventional O-cell test. In the study, To calculate ultimate capacity of bi-directional load test using model with the pile with variable end plate O-cell, operated with end plate of 3 type on sand layer according to the relative density, loose, medium and dense conditions.

• Advances in Computational Design
• /
• v.4 no.2
• /
• pp.141-153
• /
• 2019

This research is comprised of virtually simulating behavior while experiencing low gravity effects in advance of real world testing in low gravity aboard Zero Gravity Corporation's (Zero-G) research aircraft (727-200F). The experiment simulated a drill rig penetrating a regolith simulant. Regolith is a layer of loose, heterogeneous superficial deposits covering solid rock on surfaces of the Earth' moon, asteroids and Mars. The behavior and propagation of space debris when drilled in low gravity was tested through simulations and visualization in a leading dynamic simulation software as well as discrete element modeling software and in preparation for comparing to real world results from flying the experiment aboard Zero-G. The study of outer space regolith could lead to deeper scientific knowledge of extra-terrestrial surfaces, which could lead us to breakthroughs with respect to space mining or in-situ resource utilization (ISRU). These studies aimed to test and evaluate the drilling process in low to zero gravity environments and to determine static stress analysis on the drill when tested in low gravity environments. These tests and simulations were conducted by a team from Texas A&M University's Department of Construction Science, the United States Air Force Academy's Department of Astronautical Engineering, and Crow Industries