• Proceedings of the IEEK Conference
• /
• 2002.07b
• /
• pp.1312-1315
• /
• 2002

This research describes the design of a fully integrated fractional-N frequency synthesizer intended for the local oscillator in IMT-2000 system using 0.18-$\mu\textrm{m}$ CMOS technology and 1.8-V single power supply. The designed fractional-N synthesizer contains following components. Modified charge pump uses active cascode transistors to achieve the high output impedance. A multi-modulus prescaler has modified ECL-like D flip-flop with additional diode-connected transistors for short transient time and high frequency operation. And phase-frequency detector, integrated passive loop filter, LC-tuned VCO having a tuning range from 1.584 to 2.4 ㎓ at 1.8-V power supply, and higher-order sigma-delta modulator are contained. Finally, designed frequency synthesizer provides 5 ㎒ channel spacing with -122.6 dBc/Hz at 1 ㎒ in the WCDMA band and total output power is 28 mW.

• Korean Journal of Optics and Photonics
• /
• v.15 no.4
• /
• pp.337-342
• /
• 2004

Laser optical power stabilization of a radio frequency excited $CO_2$ slab laser using the opto-Hertzian effect generated from the laser itself is achieved on the peak of the Doppler broadened gain curve. The opto-Hertzian signal was generated by a modulation of the optical flux circulating inside the laser cavity from a variation in the cavity length caused by the vibrations of the PZT. The opto-Hertzian signal is directly coupled from a RE discharge chamber via a loop antenna into a detector and applied to a lock-in stabilizer as an reference signal. The power stability of an RF excited slab laser is estimated to be better then 0.2%.

• The Transactions of the Korean Institute of Electrical Engineers D
• /
• v.51 no.2
• /
• pp.78-85
• /
• 2002

We introduce a rotational decision-directed joint algorithm of blind equalization coupled with carrier recovery for 32-QAM demodulation with high symbol rate. The proposed carrier recovery, which we call a rotational decision-directed carrier recovery(RDDCR), removes the residual phase difference by rotating the decision boundary for the kth received symbol by the frequency detector output of the (k-1)th received symbol. Since the RDDCR includes the function of PLL loop filter by rotating the decision boundary, it gives a simpler demodulator structure. The rotational decision-directed blind equalization(RDDBE) with the rotated decision boundary based on the Stop-and-Go Algorithm(SGA) operated during tracking the frequency offset by the RDDCR and removes intersymbol interference due to multipaths and channel noise. Test results show that symbol error rate of $10^{-3}$ is obtained before the forward error correction when SNR equals 15dB with 150KHz of carrier frequency offset and two multipaths, which is the channel condition for 32-QAM receiver.

• Proceedings of the Korean Institute of Intelligent Systems Conference
• /
• 2008.04a
• /
• pp.276-285
• /
• 2008

Traffic monitoring method is mainly loop detector and piezo sensor. But this method is only detecting the number of vehicle. Monitoring traffic volume is not checking the number of vehicle but checking the length of access road, width of road, number of passing people,passing vehicle,delayed vehicle. The traffic signal control cycle is not fixed by only passing vehicle number but all related traffic proposal. This paper proposed selecting common characteristic out of each unrelated traffic proposal through Analytic Hierachy Process and this characteristic is applied to compose fuzzy sensor algorithm which find out new traffic volume concept of confusion degree. The accumulated delayed vehicle time is shorter in new fuzzy sensor algorithm applied by AHP than other traffic method

• 제어로봇시스템학회:학술대회논문집
• /
• 2000.10a
• /
• pp.496-496
• /
• 2000

We propose a neuron computer for tracking motion of particles in multi-dimensional space. The neuron computer is constructed of neural networks and their connections, which is a simplified model of the brain. The neuron computer is assemblage of neural networks, it includes a control unit, and the actions of the unit are represented by instructions. We designed a neuron computer to recognize and predict motion of particles. The recognition unit is constructed of neuron-array, encoder, and control part. The neuron-array is a model of the retina, and particles crease an image on the array, where the image is binary. The encoder picks one particle from the array, and translates the particle's location to Cartesian coordinates, which is scaled in [0, 1] intervals. Next, the encoder picks another particle, and does same process. The ordering and reduction of complex processes are executed by instructions. The instructions are held in the control part. The prediction unit is constructed of a multi-layer neural network and a feedback loop, where real time learning is executed. The particles' future locations are forecasted by coordinate values. The neuron computer can chase maximum 100 particles that take evasions.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.10 no.6
• /
• pp.816-824
• /
• 1999

Design and performance of 18 GHz phase locked dielectric resonator oscillator(PLDRO) for Point-to-point radio link using analog phase locked loop is described which achieve high stability and low SSB phase noise. The module consists of an 18 GHz voltage controlled dielectric resonator oscillator(VCDRO), buffered amplifier, analog phase detector which are integrated to form a miniature hybrid circuit. In addition, containing a low phase noise VHF PLL has been designed to lock any other conventional N times frequency of crystal oscillator. The module achieves stable phase locked state, exhibits output power of 21 dBm at 18.00 GHz, -34 dBc harmonic suppression and -75 dBc/Hz phase noise at 10 kHz offset frequency from carrier.

• Journal of Institute of Control, Robotics and Systems
• /
• v.14 no.2
• /
• pp.133-140
• /
• 2008

In this paper, a small and effective attitude estimation system for a humanoid robot was developed. Four small inertial sensors were packed and used for inertial measurements(3D accelerometer and three 1D gyroscopes.) An effective 3D pose estimation algorithm for low cost DSP using an extended Kalman filter was developed and evaluated. The 3D pose estimation algorithm has a very simple structure composed by 3 modules of a linear acceleration estimator, an external acceleration detector and an pseudo-accelerometer output estimator. The algorithm also has an effective switching structure based on probability and simple feedback loop for the extended Kalman filter. A special test equipment using linear motor for the testing of the 3D pose sensor was developed and the experimental results showed its very fast convergence to real values and effective responses. Popular DSP of TMS320F2812 was used to calculate robot's 3D attitude and translated acceleration, and the whole system were packed in a small size for humanoids robots. The output of the 3D sensors(pitch, roll, 3D linear acceleration, and 3D angular rate) can be transmitted to a humanoid robot at 200Hz frequency.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.15 no.12
• /
• pp.1044-1052
• /
• 1990

We have investigated the digital bit synchronization problem in baseband communication receiver systems using the Gauss-Markov estimation technique which is equivalent to the weighted least square method. The realized bit synchronizer, including the data detector, processes the input signal two dimensionally into the transition phase and data level under the white Gaussian noise environment. We have confrmed the realiation of the bit synchronizer via computer simulation. In addition, we have compared and evaluated the estimation error performance of the proposed method with that of the conventional DTTL method and of the minimum likelihood method.

• 한국정보통신설비학회:학술대회논문집
• /
• 2005.08a
• /
• pp.159-165
• /
• 2005

The proposed optical transmitter is composed of FF(flip flop) , PLL (phase locked loop), reference clock generator, serializer and LD driver 10x250 Mb/s data arrays are translated to the 2.5 Gb/s data signal by serializer. In this case, 1 data bus is allocated usually as a reference clock for synchronization. In this proposed optical transmitter, 125 MHz reference clock is generated from 10x250 Mb/s data arrays by reference clock generator. From this method. absent of reference clock bus is available and more data transmission become possible. To achieve high speed operation, the serializer circuit is designed as two stacks. For 10:1 serialization, 10 clocks that have 1/10 lambda differences is essential, so the VCO (voltage controlled oscillator) composed of 10 delay buffers is designed. PLL is for runing at 250 MHz, and dual PFD(phase frequency detector) is adopted for fast locking time. The optical transmitter is designed by using 0.35 um CMOS technology.

• Proceedings of the KIEE Conference
• /
• summer
• /
• pp.1477-1479
• /
• 2004

Increasing numbers of photovoltaic arrays are being connected to the power utility through the power conditioning systems (PCS). This has raised potential problems of network protection. If, due to the action of the PCS, the local network voltage and frequency remain within regulatory limits when the utility is disconnected, then islanding is said to occur. In this paper, the representative methods to prevent the islanding are described and a PSIM-based model and analysis of the reactive power variation (RPV) method are presented. A novel phase detector using the all-pass filter and digital phase locked loop (DPLL) is proposed especially for the single-phase PCS. Finally, this paper provides the simulation and experimental results with a single-phase 3kW prototype PCS. Islanding test method of IEEE Std. 929-2000 was performed for verification.