• Tribology and Lubricants
• /
• v.37 no.3
• /
• pp.99-105
• /
• 2021

In this study, for a high-pressure turbine (HPT) of 800 MW class supercritical thermal-power plant, considering aerodynamic cross-coupling, we performed a rotordynamic logarithmic decrement (LogDec) stability analysis with various tilting pad journal bearing (TPJB) designs, which several steam turbine OEMs (original equipment manufacturers) currently apply in their supercritical and ultra-supercritical HPTs. We considered the following TPJB designs: 6-Pad load on pad (LOP)/load between pad (LBP), 5-Pad LOP/LBP, Hybrid 3-Pad LOP (lower 3-Pad tilting and upper 1-Pad fixed), and 5-Pad LBPs with the design variables of offset and preload. We used the API Level-I method for a LogDec stability analysis. Following results are summarized only in a standpoint of LogDec stability. The Hybrid 3-Pad LOP TPJBs most excellently outperform all the other TPJBs over nearly a full range of cross-coupled stiffness. In a high range of cross-coupled stiffness, both the 6-Pad LOP and 5-Pad LOP TPJBs may be recommended as a practical conservative bearing design approach for enhancing a rotordynamic stability of the HPT. As expected, in a high range of cross-coupled stiffness, the 6-Pad LBP TPJBs exhibit a better performance than the 5-Pad LBP TPJBs. However, contrary to one's expectation, notably, the 5-Pad LOP TPJBs exhibit a slightly better performance than the 6-Pad LOP TPJBs. Furthermore, we do not recommend any TPJB design efforts of either increasing a pad offset from 0.5 or a pad preload from 0 for the HPT in a standpoint of stability.

• Journal of the Korean Chemical Society
• /
• v.48 no.3
• /
• pp.266-272
• /
• 2004

We developed a miniaturized solid-state carbonate ion-selective electrode (carbonate ISE) based on one-component room temperature vulcanizing type silicone rubber 730 (730 RTV) without adding plasticizer to the matrix. The optimized carbonate ion selective membrane is prepared with 85.8 wt% of 730 RTV, 11.1 wt% of trifluoroacetyl-p-decylbenzene (TFADB), and 3.1 wt% of tridodecyl-methylammonium chloride (TDMACl). This carbonate ISE exhibited excellent potentiometric properties (i.e., slope: 26.3 mV/dec; selectivity: $logKT^{pot}_{CO_{2},Cl^-}$= -4.00 and $logKT^{pot}_{TCO_{2},Sal^-}$=1.69); and detection limit for $TCO_2:\;4.0{\times}10^{-4}M$). In addition, the early potentiometric properties of the solid-state sensor with optimized membrane composition were not deteriorated for more than 60 days.

• The Korean Journal of Emergency Medical Services
• /
• v.14 no.1
• /
• pp.31-46
• /
• 2010

This study was intended to analyze the clinical characteristic of the patient with hypoglycemia and the status of prehospital treatments by 119 emergency medical technicians well as the cause of inappropriate emergency treatment by 119 emergency medical technicians in a bid to seek the measures for improvement, thereby enhancing the emergency medical services before medical treatment at hospital. Examination of the daily work log on 430 patients suffering with hypoglycemia who were sent to the university hospital in Gyunggi-Province by 119 emergency medical technicians, beginning on Jan 1, 2004 till Dec 31. 2008 was carried out and the survey of 206 119 emergency medical technicians working at the region of Gyunggid-Province was conducted from Sep 19 through Oct 6, 2009. Evaluation of the frequency and percentage and ANOVA analysis using SPSS WIN 14.0 program was carried out. In view of the examination of daily emergency work log and questionnaire, prehospital treatment for the patients with hypoglycemia needs to be further improved in general, and to provide the emergency treatment in accurate and timely manner, improvement of the system such as assignment of licensed rescue members and development of protocol that will replace the medical consultant system, mandatory emergency treatment, constant and efficient training and maintenance of emergency rescue records shall be implemented, and furthermore, social recognition to 119 emergency medical technicians shall be improved to encourage them to perform more positive way and manner.

• Proceedings of the Korean Nuclear Society Conference
• /
• 1996.05c
• /
• pp.231-237
• /
• 1996

Defect equilibrium equations were modelled, and the relations of P $o_2$, venus x were derived using the mass action law. The dominant defect species active in a specified region were determined by fitting the curve of experimental data to the calculated curve of log P $o_2$, versus log x for each theoretical model. The calculated curve for (2:1:2) and (Er')$^{x}$ in the hyperstoichiometric $U_{1-y}$E $r_{y}$ $O_{2＋x}$ and that for (2Er'quot;)$^{x}$ $_{dec}$ in the hypostoichiometric $U_{1-y}$E $r_{y}$ $O_{2－x}$ are in good agreement with the present experimental results. The sintering behavior of Er-doped U $O_2$ is observed with erbium content in oxidizing and reducing atmospheres. For sintering in oxidizing atmosphere, sintered density decreases as increasing y in $U_{1-y}$E $r_{y}$ $O_{2＋x}$. However, in hydrogen atmosphere, sintered density decreases as increasing y at lower erbium content but the density increases again above y=0.10. In oxidizing sintering conditions, the formation of (Er'U')$^{x}$ clusters hinders the diffusion of cations, and hence the sinterability of Er-doped U $O_2$ decreases. In reducing atmosphere of Er-doped U $O_2$ for higher Er concent, the oxygen vacancies make (Er')$^{x}$ cluster decompose by charge compensation and the concentration of mobile cations increases, thereby improving the sinterability.ntration of mobile cations increases, thereby improving the sinterability.ability.

• Bulletin of the Korean Chemical Society
• /
• v.35 no.11
• /
• pp.3175-3180
• /
• 2014

A potentiometric sensor based on the 1-benzyl-3-(4-nitrophenyl) thio-urea was synthesized and tested as an ionophore in PVC based membrane sensor towards $SCN^-$ ions. This membrane exhibits a linear stable response over a wide concentration range ($1.0{\times}10^{-5}$ to $1.0{\times}10^{-2}M$) with a slope of -59.2 mV/dec., a detection limit of ${\log}[SCN^-]=-5.05$, and a selectivity coefficient for thiocyanate against perchlorate anion of ${\log}K^{pot}_{SCN^-j}=-0.133$. The selectivity series of the membrane is as follows: $SCN^-$ > $ClO_4{^-}$ > $I^-$ > $NO_3{^-}$ > $HSO_3{^-}$ > $Cl^-$ > $HSO_4{^-}$ > $F^-$ > $CH_3COO^-$ > $HCO_3{^-}$ > $Br^-$ > $H_2PO_4{^-}$ > $SO{_3}^{2-}$ > $SO{_4}^{2-}$ > $CO{_3}^{2-}$. The proposed electrode showed good selectivity and a good response for the $SCN^-$ ion over a wide variety of other anions in pH 6.0 buffer solutions and has a fast response time of about < 5s. The influences of the membrane by pH, ionophore, and plasticizer were studied.

• Transactions of the Korean Society for Noise and Vibration Engineering
• /
• v.21 no.6
• /
• pp.562-569
• /
• 2011

In this study linear and nonlinear dynamic stability characteristics of a medium-size high-speed turbocharger, whose rotor is supported by two 3-lobe journal bearings, are analyzed to evaluate and identify the effects of its bearing design variables. The rotor has the rated speed of 40,500 rpm and maximum continuous speed of 45,000 rpm. At first, utilizing the linear stability analysis method, bearing designs of yielding stable or unstable LogDecs as small as possible are searched by manipulating with machined bearing clearances and preloads. As next, utilizing the nonlinear analysis method, limit cycles of the rotor responses at the rated and maximum continuous speeds are simulated to check their acceptances. Results have shown that for the turbocharger rotor-bearing system considered, the 3-lobe journal bearing design with a smaller machined clearance and a larger preload are preferred for the stable rotor responses. More importantly, since there exists a good correlation between the linear and nonlinear stability analysis results, it is concluded that firstly the linear stability analysis method may be applied to screen quickly the ranges of bearing designs for stable or least unstable solutions and then, lastly the nonlinear stability analysis method may be deployed to check an absolute motion stability in terms of the limit cycle.

• The Journal of the Korean bone and joint tumor society
• /
• v.1 no.1
• /
• pp.17-22
• /
• 1995

From Sept. 1986 to Dec. 1992, seventy three cases of Enneking's stage IIB osteosarcoma of extremities, which were proved histologically, took neoadjuvant chemotherapy and completed our protocol. Their average age was 16.7 years(7 to 57). For neoadjuvant chemotherapy, 37 cases took high dose methotrexate(HDMTX)-adriamycin(ADR)-cisplatin(CDDP) regimen(HDMTX group) and 36 cases took ADR-CDDP(ADR-CDDP group). The average follow up was 17 months(2-63). According to Kaplan-Meier's plot, 5-year continuously disease free survival for whole 73 cases of neoadjuvant group was 45.2%, for HDMTX group 68.4%, for ADR-CDDP group 26.6%. There was significant stastical difference between these two groups(p<0.001), with log-rank test. There can be a different survival according to the chemotherapeutic protocols. Better results can be achieved through refined protocol and effective chemotherapeutic agents.

• Asian Pacific Journal of Cancer Prevention
• /
• v.14 no.1
• /
• pp.43-45
• /
• 2013

Background: The aim of this epidemiological study was to establish the laterality of breast cancer (BC) and its association with size, receptor status of the primary tumor and bone metastasis (BM) in a local population. Materials and Methods: This retrospective study included cases of BC from Jan-2009 to Dec-2011 who were referred for metastatic work up or follow up survey with Technetium-99m MDP bone scan (BS) to the Nuclear Medicine Department of Karachi Institute of Radiotherapy and Nuclear Medicine (KIRAN). A total of 384 patients out of 521 were included and all reviewed for age, primary tumor size (PTS), laterality, receptor status like estrogen receptor (ER) progesterone receptor (PR) and Her-2-Neu receptor, presence or absence of BM with sites of involvement and time interval between diagnosis of BC and appearance of BM. Results: The left to right sided BC proportion was significantly higher than unity (59%:41%; p<0.001). The right sided BC was observed in younger age group (46:52 years; p<0.0001) and with a smaller PTS than the left sided (3.43:4.15 cm; p<0.0001). The patients with BM had relatively higher negative receptor status with a significant predominance of right sided BC. The overall incidence of BM on BS was 28% and relatively higher in right than left breast (33%:24% p=0.068). The average number of BM sites was also significantly greater for the right side (6:4, P<0.0001). The % cumulative risk of BM in right breast was noted at significantly smaller PTS than left side with log rank value of 5.579; p<0.05. The Kaplan Meier survival plot for event free survival of BM in left sided BC was significantly higher than for the right side (log rank value=4.155, p<0.05), with an earlier appearance of BM in right BC. Conclusions: 1) A left sided predominance of BC was seen in local population; 2) right sided BC had a more aggressive behavior with extensive and earlier appearance of BM at relatively younger age, smaller PTS and receptor (s) negativity.

• Tribology and Lubricants
• /
• v.30 no.1
• /
• pp.9-14
• /
• 2014

In this Part II study, rotordynamic stability analyses were carried out to confirm improvements to the stability of a process high-speed lightweight centrifugal compressor, depending on the effects of tilting pad journal bearing designs. The bearing design variables considered were the clearances, LBPs, LOPs, and preloads. The results showed that the rotordynamic stability of the subject compressor rotor-bearing system improves exactly in accordance with the effects of the bearing design variables, which were determined in the preceding Part I study, owing to reduced bearing stiffnesses. Specifically, it was confirmed that the stability of the rotor system can be greatly improved by increasing both the machined and assembled bearing clearances, but there were no stability improvements by simply changing from an LBP to an LOP design. In addition, it was confirmed that for given fixed machined bearing clearances, the stability can be additionally improved by decreasing the preloads, i.e., by increasing the assembled clearances. In conclusion, it may be necessary to improve the designs of the original tilting pad bearings to obtain a sufficient margin of rotordynamic stability against a possible aerodynamic cross-coupled stiffness in a process high-speed centrifugal compressor. Thus, increasing the machined and assembled bearing clearances and decreasing the preload could be effective solutions.

• Journal of Environmental Science International
• /
• v.19 no.3
• /
• pp.331-342
• /
• 2010

Aerosol physical properties have been measured at Pusan National University by using the 16-channel LPC(Laser Particle Counter), and particle characteristics have been examined for the period from Aug. 4 2007 to Dec. 30, 2008. Annual total average, seasonal average, and other averages of the meteorologically classified four categories such as Asian dust, precipitation, foggy, and clear days are respectively described here. Both annually and seasonally averaged number concentration show three peaks at the particle diameter of 0.3, 1.3, and $4{\mu}m$, respectively. However, the first peak for summer season tends to be shifted toward smaller size than other seasons, implying the strong fine particle generation. Meteorological condition shows strong contrast in aerosol concentrations. In Asian dust case, relatively lower number concentrations of fine particles (i.e., smaller than $0.5{\mu}m$) were predominant, while higher concentrations of coarse particles were found particularly for the size bigger than $0.5{\mu}m$. In precipitation day, number concentrations were decreased by approximately 30% due to the removal process of precipitation. Foggy day shows significantly higher concentrations for fine particles, implying the importance of the aerosol condensation process of micro-fine-particle growing to fine-particle. Finally the regressed particle size distribution function was fitted optimally with two log-normal distribution, and discussed the similarities and differences among four categorized cases of the Asian dust, precipitation, foggy, and clear days.