• Journal of Environmental Science International
• /
• v.24 no.12
• /
• pp.1617-1627
• /
• 2015

This study was carried out to investigate the characteristics of suspended solid concentration in small forest watershed, Hwacheon, Gangwondo. For five rainfall events from July 2013 to August 2013, rainfall, discharge, and suspended solid load has been measured. The results showed that the fist flush effect was observed for suspended solid in each rainfall event, sediment rating curve was obtained with $y=30.029x^{1.573}$ at rising limb and $y=12.902x^{1.8827}$ at falling limb, and EMC (event mean concentration) of suspended solid was calculated to 9.4 mg/L. EMC was compared to the values from the watershed that has various land use types and EMC from forest watershed was much lower that from the crop, paddy or low covered forest watershed.

• Environmental Engineering Research
• /
• v.14 no.1
• /
• pp.13-18
• /
• 2009

In this study, specific pollutant releases during the Asian monsoon season were estimated and the information was applied to the non-point pollutant sources management from two forested watersheds of the Soyang Lake. The two watersheds are part of the 2,703 km2 Soyang Lake watershed in the northern region of the Han River. The outlets of the two watersheds were respectively analyzed for continuous water quality concentration and for discharge during various single rainfall events. Statistical power function methods are utilized to compare stream discharge and pollutant flux release during the study period. Based on the monitoring data during the study period, the specific load flux method using simulated discharge was conducted and validated in the two watersheds. The model predictions corresponded well with the measured and calculated pollutant releases. The modeling approach taken in this study was found to be applicable for the two forested watersheds.

• Journal of Korean Society on Water Environment
• /
• v.37 no.4
• /
• pp.249-262
• /
• 2021

This study investigated the pollution characteristics of the main pollution zone in the Hwangguji watershed and the influence of the tributary on the main stream. The characteristics of the main pollution zone, including, the water quality index (WQI), stream rating, load duration curve (LDC), delivery load density (DLD), and contribution of the tributary to the mainstream, were evaluated by time-series visual heatmap. The WQI of the mainstream of Hwangguji was lowered to the poor (IV) level from the inflow point of Suwon stream (SW) and the LDC excess rate in the T-P was higher than that of BOD₅, especially for the wet season, suggesting that management of non-point source with T-P is preferred. The contribution (%) of the tributaries in the upstream section of Hwangguji watershed were BOD₅ 14.54%, TOC 15.67%, T-N 5.43%, and T-P 6.97%. In particular, the Suwon sewage treatment plant located in the mainstream showed a high contribution of BOD₅ (64.40%) and T-P (53.54%), respectively, due to the high discharge rate (6.019 m³/sec). Meanwhile, Sammi and Gal stream have a large impact on the mainstream with high DLD and poor WQI. Thus, both streams were considered as pollution hot spots. These results provide useful basic data for preparing more effective water quality improvement and management plans in the watershed.

• Journal of Korea Water Resources Association
• /
• v.42 no.9
• /
• pp.737-745
• /
• 2009

Field measured sediment yield from an experimental urbanized basin was compared with the predicted sediment yields with RUSLE (Revised Universal Soil Loss Equation), and MUSLE (Modified Universal Soil Loss Equation). The experimental basin is 3.1km2 in area and fifty six percent of the total area had been urbanized. The hydrological data have been measured with T/M at the outlet of the experimental basin. Runoff from the basin and rainfall depth of the basin were measured every minute. Bed load and suspended load were also measured for a given flow rate. Runoff rating curves and sediment rating curve were developed for the last three years. RUSLE showed scattered prediction results but the average of the prediction values was close to the measured one. Meanwhile, MUSLE showed linear correlation between the measured sediment yield and predicted one with high correlation coefficient. But MUSLE predicts high values than the real one. Therefore, adjustment is necessary to apply MUSLE in estimation of sediment yield from the experimental urbanized basin.

• Journal of Korea Water Resources Association
• /
• v.33 no.5
• /
• pp.527-536
• /
• 2000

This study estimates the pollution load in a basin by regional groups analyzing the relationship between the discharge and pollution load. The study area is placed in the Miho stream basin known as the main tributary of the Kum river. Four major Telemetary streamflow stations are chosen. In this research, discharge and water quality in a dry season and a flood season from the observed discharge in the stream are analyzed. The Rating-Curve and the Pollutograph are drawn analyzing discharge and water quality at the major stations. The characteristics of runoff for each stream are analyzed and the change of water quality are analyzed for rainfall period. The relationship between discharge and water quality has been investigated. The relationship between the discharge and pollution load is analyzed and a representative equation is derived. These relationships permit an estimates of the pollution load at the Miho stream basin. basin.

• Magazine of the Korean Society of Agricultural Engineers
• /
• v.18 no.1
• /
• pp.4052-4063
• /
• 1976

The observation and Studies on the two stations in the Ansung river are included that were justified types of Bed-materials movement and were estimated loads volume of sediment applied by sediment rating curve and/or drivel formulars according to both stream conditions. The results of evaluation for above purpose are given as follows 1) Drived formulas for sediment computation in accordance with river situations are given as follows. -Suspended load Yu-chun Ts=135H4.55 Hye-hwa Ts=454H3.71 -Bed load Yu-chun Tb=75.4H191 Hye-hwa Tb=134.5H1.82 2) Annual volume of surface erosion in the catchment area were obtained at yu-chun of 0.236mm Hye-hwa of 0.200mm and mean depth of 0.22mm 3) The Bed-materials movement with water depth were represented that ripple is bellow than 0.067 meter at yu-chun and bellow than 0.096 meter at Hye-hwa stream, Dunes is 0.067-0.22 at yu-chun and 0.096-0.23 at Hye-hwa, Transition is 0.22-0.46 at yu-chun and 0.23-0.58 at Hye-hwa and Antidunes is higher than 0.46 at yu-chun and 0.58 of water depth at Hye-hwa stream

• Journal of Korean Society of Steel Construction
• /
• v.11 no.2 s.39
• /
• pp.213-222
• /
• 1999

Elastic-plastic methods have been used for the better prediction of the actual behavior of continuous-composite plate girder bridges in the overload and maximum load analysis. The structural evaluation using ALFD(Alternate Load Factor Design) uses the elastic-plastic analysis. The plastic rotations that remain after the load is removed can be occurred by the yielding locations of the maximum moment section. This situation can occur due to the residual stresses even if the moment is below the theoretical yield moment. The local yielding causes positive automoments that assure elastic behavior under subsequent overloads. In this study, the automoments at the piers occurred due to the unit plastic rotations and other locations were calculated by the conjugate-beam method and three-moment equation, using the nine design span with progressively smaller pier sections. The automoments were determined by the developed computer programs in this study in which the moments and plastic rotations from the continuity and moment-inelastic rotation relationships must be equal. And also the ratings of 3-span continuous composite plate girder bridges with non-compact section were carried out according to the Korean Highway Bridge Specification.

• Magazine of the Korean Society of Agricultural Engineers
• /
• v.45 no.7
• /
• pp.49-56
• /
• 2003

Nonpoint source pollutant loading from watershed may cause a problem to the water quality of the reservoir and stream. The characteristics of stream flow and water quality were monitored to investigate the runoff loading of the Namdae-cheon watershed from May in 1999 to October in 2003. Stage-discharge rating curve at the stream gauging site was established, and annual stream runoff of the study watershed was estimated as 499.4∼1,330.8mm during four years. The concentrations of total-nitrogen and total-phosphorus of stream water quality ranged from 0.76 to 6.95mg/L and from 0.0010 to 0.2276 mg/L, respectively, where T-N was generally higher than the water quality standard 1.0 mg/L for agricultural water use. The loads by unit generation of pollutant mass with respect to population, livestock, land use in this watershed were calculated. The runoff pollutant loadings by concentrations of total-N and total-P were estimated during study period, where the annual runoff loading of total-P was much less than the load by pollutant mass unit generation. The relations between stream discharge and water quality were analysed, and there was a high correlation for total-N but low for total-P. These results will be used to develop the monitoring techniques and water quality management system of agricultural watershed.

• Proceedings of the Korea Water Resources Association Conference
• /
• 2020.06a
• /
• pp.85-85
• /
• 2020

South Korea experiences few large scale erosion and sedimentation problems, however, there are numerous local sedimentation problems. A reliable and consistent approach to modelling and management for sediment processes are desirable in the country. In this study, field measurements of sediment concentration from 34 alluvial river basins in South Korea were used with the Modified Einstein Procedure (MEP) to determine the total sediment load at the sampling locations. And then the Flow Duration-Sediment Rating Curve (FD-SRC) method was used to estimate the specific degradation for all gauging stations. The specific degradation of most rivers were found to be typically 50-300 tons/㎢·yr. A model tree data mining technique was applied to develop a model for the specific degradation based on various watershed characteristics of each watershed from GIS analysis. The meaningful parameters are: 1) elevation at the middle relative area of the hypsometric curve [m], 2) percentage of wetland and water [%], 3) percentage of urbanized area [%], and 4) Main stream length [km]. The Root Mean Square Error (RMSE) of existing models is in excess of 1,250 tons/㎢·yr and the RMSE of the proposed model with 6 additional validations decreased to 65 tons/㎢·yr. Erosion loss maps from the Revised Universal Soil Loss Equation (RUSLE), satellite images, and aerial photographs were used to delineate the geospatial features affecting erosion and sedimentation. The results of the geospatial analysis clearly shows that the high risk erosion area (hill slopes and construction sites at urbanized area) and sedimentation features (wetlands and agricultural reservoirs). The result of physiographical analysis also indicates that the watershed morphometric characteristic well explain the sediment transport. Sustainable management with the data mining methodologies and geospatial analysis could be helpful to solve various erosion and sedimentation problems under different conditions.

• Journal of the Korean Association of Geographic Information Studies
• /
• v.12 no.2
• /
• pp.82-98
• /
• 2009

This study applied SWAT model to analyze suspended sediment load that is influence on the high density turbid water in Donghyang and Cheoncheon basin, which are located in the upstream of Yongdam Dam. GIS data such as DEM, land cover map and soil map, and meteorological data were used as the input data of SWAT model. And the rating curve equation and Q-SS equation of Donghyang and Cheoncheon gauge station were applied as the measured values of them. As the result of flowout, the coefficient of determination ($R^2$) and the Nash-Sutcliffe coefficient of efficiency (EI) of model calibration showed high as 0.87 and 0.87 at Donghyang gauge station, and the $R^2$ and EI of model validation were high as 0.95 at Cheoncheon gauge station. Also, as the result of suspended sediment load, the $R^2$ and EI of model calibration were high as 0.77 and 0.76 at Donghyang gauge station, and the $R^2$ and EI of model validation marked high as 0.867 and 0.80 at Cheoncheon gauge station. It is considered that the suspended sediment load of 2003 showed the highest due to rainfall amounts and rainfall intensity in using SWAT model. The results of suspended sediment modeled in this study can be applied to the decision-making support data for the evaluation of soil erosion possibility and turbid water potential in the management of reservoir.