• Magazine of the Korea Concrete Institute
• /
• v.11 no.2
• /
• pp.197-208
• /
• 1999

The use of high-strength concrete which permits smaller cross sections, reduced dead loads, and longer spans has been getting more popular in tall buildings. However, there has been little research on behavior of high-strength concrete columns laterally reinforced with square ties and subjected to compressive loading. With the addition of transverse reinforcement which lead to triaxial compressive state, ductility behavior of high-strength column member shall be increased. In this study, rational quality and quantity evaluations were made to investigate the ultimate strength and strain ductility by confinement effect of tie reinforced high-strength concrete columns subject to uniaxial loads. Concrete failure theory at the triaxial compressive state and statistical results based on conventional experimental data were applied for this propose. Up to 185 columns, tested under monotonically increasing concentric loading, were evaluated in terms of strength and strain ductility. Analytical results show that confinement stress, maximum compressive strength, and increase of strain equations were developed with the consideration of concrete strength, yield strength, spacing, volumetric ratio, and configurations of tie reinforcement.

• 보존과학연구
• /
• s.31
• /
• pp.43-57
• /
• 2010

This study intends to provide quantitative data about the extraction characteristics of major elements of earthenware by executing soaking test of cleaning agents. It aims at providing basic data for the stability assessment when applying the cleaning agents for conserving earthenware. The data will be extracted from the analysis of co-relationship between the physical characteristics and the ion extraction characteristics. XRD analysis displayed that AT-1, AT-2 and AT-3 which did not generate mullite were fired at lower than 1,000 whereas AT-3 and AT-5 that included mullite were higher than 1,000. The degree of absorption was AT-4 > AT-2 > AT-1 > AT-3 > AT-5 in order and the correlation between the degree of absorption and firing temperature of earthenware displayed a positive correlation. Extraction amount of oxalic acid which was used for the removing iron oxide was AT-1 > AT-2 AT-4 > AT-3 > AT-5 in order. and the ion extraction data displayed that there is a positive correlation with absorption level. However AT-1 and AT-2 which were fired at lower temperature showed that there was no correlation between the ion extraction characteristics and absorption level. Ion extraction of citric acid produced little amount compared with the one of oxalic acid, yet it caused less damage to earthenware than oxalic acid when it applied. The result of ion extraction level in the absorption test displayed that Fe had higher level than in Si, Al from the test for both oxalic acid and citric acid. Based on the regression analysis of the data from the previous studies, the physical characteristics of the earthenware and ion extraction level, further studies will be conducted on the predicting technique on the extraction characteristics of major elements of earthenware samples for the conservation in future.

• The Journal of the Korean dental association
• /
• v.49 no.4
• /
• pp.211-218
• /
• 2011

Purpose: An impacted tooth is defined as a tooth that shows delayed eruption and is expected to erupt incompletely by clinical and radiograph examination despite it reaching its expected time of eruption. The aims of this study were to investigate the clinical and radiological characteristics and treatment duration and method of impacted teeth in Korean patients. Materials and Methods: For this study we used clinical records, study models, panoramic radiographs and intraoral photographs of patients who attended Gachon University Gil Hospital Orthodontic Department between 2005 and 2008. There were 164 patients with a total number of 202 impacted teeth. Results: Male patients shows a little more prevalence than female patients (1.13:1). The under 12 age group had the highest prevalence of tooth impaction, and the over 19 age group showed the least prevalence of tooth impaction. The ratio of tooth impaction between the left to right ratio was 1.73:1 and maxilla and mandible was 1.84:1. The impacted teeth were most commonly positioned buccally (76 cases, 41.5%). Full nap closure technique (108 cases, 81.2%)was most frequently used for attachment of surgical traction hooks. Maxillary canine impaction was most commonly encountered both in male and female patients. The mean treatment period was 12.2 months and the success rate of treatment was 90.3%. The canine tooth shows the longest treatment time and highest failure rate. The ankylosis was the major cause of failure. Conclusion: Impacted teeth most commonly show in left side maxilla in the under 12 age group. And it is most commonly positioned buccally. The mean treatment period was 12.2 months, and the success rate of treatment was 90.3%.

• Magazine of the Korea Concrete Institute
• /
• v.6 no.1
• /
• pp.131-141
• /
• 1994

This experimental study was performed to lnvestigate the effects of the lergths dnd volume contents of glued hooked steel fiber for the fracture toughness and strength of c oncretc. The notched steel fiber reinforced concrete beams with different flber length(30, 60mm) and fiber volume content(O.0, 0.5, 1.0, 1.5, 2.0%) were tested under 3-point benclmg, md 1 he flexural strengths, fracture energy and CMOD were obtained from the experimental data. The fracture energy v~ds used as d means to evaluate the fracture toughness ot concrete. The results showed that the frdcture toughness and 5trength of conuett. were generally increased ds the content of steel fiber was inc~edsed, arid the length of steel ilber had a great efiect on the flexural strength but little on the compressive itrength and fractule toughness. And also, considering the distributions of steel fiber, workablity and the maxinium size of coarse dqgregates, the optimum content of steel fiber seemed to be about 1.0 '0, and when lts length uias longer the results were somewhat tavorable.

• Magazine of the Korean Society of Agricultural Engineers
• /
• v.26 no.3
• /
• pp.35-45
• /
• 1984

Generally speaking, agriculture exist in a climatic environment of uncertainty. Namely, normal rainfall value, as given by the mean values, does not exist. Thought on exists, itl does not affect like extreme Precipitation value on the part of agriculture and of others. Therefore, it is important that we measure the duration and severity index of drought caused by extreme precipitation deficit. In this purpose, this study was dealt with the calculation of drought duration and severity indexs by the method of monthly weighting coefficient. There is no quantitive definition of drought that is universally acceptable. Most of the criteria was used to identify drought have been arbitrary because a drought is a 'non-event' as opposed to a distinct event such as a flood. Therefore, confusion arises when an attempt is made to define the drought phenomenon, the calculation of duration, drought index is based on the following four fundamental question, and this study was dealt with the answers of these four questions as they related to this analytical method, as follows. First, the primary interest in this study is to be the lack of precipitation as it relates to agricultural effective rainfall. Second, the time interval was used to be month in this analysis. Third, Drought event, distinguished analytically from other event, is noted by monthly weighting coefficient method based on monthly rainfall data. Fin-ally, the seven regions used in this study have continually affected by drought on account of their rainfall deficit. The result from this method was very similar to the previous papers studied by many workers. Therefore, I think that this method is very available in Korea to identify the duration of drought, the deficit of precipitation and severity index of drought, But according to the climate of Korea exist the Asia Monsoon zone. The monthly weighting coefficient is modify a little, Because get out of 0.1-0.4 occasionally.

• Magazine of the Korean Society of Agricultural Engineers
• /
• v.31 no.3
• /
• pp.57-69
• /
• 1989

The study was carried out for the strength parameter of coarse grained Soil and slope stability analysis of earth dam. The test samples were taken fifteen kinds of soil from cohesive soil to coarse gravel. The degree of compaction of test samples for shear test and permeability test was chosen 95 percentage of maximum dry density. The results of this study are as follows ; 1.The maximum dry density(Yd) of coarse grained soil increase in proportion to coarse particles(P) with the relation of Y d= 1.609+0.0043P. 2.The coefficients of permeability(k) decrease by the increase of fine particles(n) with the relation of k=0.0426e-0 185n. 3.The cohesions of soil decrease by the increase of coarse particles, but internal friction angles are more increased in same condition. 4.The internal friction angles(${\Phi}$) decrease in inverse proportion to void ratio(e) with the relation of ${\Phi}$ = 73.068 - 69.268e. 5.The strength parameters( Ct ${\Phi}$t) by triaxial compression test are clearly smaller than that (Cd, ${\Phi}$d) by direct shear test in fine grained soil, but the differences between both parameters are a little in coarse grained soil.The relations of both parameters are as follows; Ct = O.544Cd + 0.04 ${\Phi}$t= 1.282${\Phi}$d-2306 6.In cohesive soil, the strength parameters( Cl ${\Phi}$l) by large size shear test apparatus are similar to the strength parameters(Cs , ${\Phi}$s) by small size shear test appratus, but Cs and ${\Phi}$s values are larger than Cl and ${\Phi}$l values from 10 percentage to 20 percentage in coarse grained soil. 7.The fine grained soil is inappropriate to high dam more than 20 meters and it must be taken coarse grained soil with high internal friction angle for high dam.

• Magazine of the Korean Society of Agricultural Engineers
• /
• v.17 no.3
• /
• pp.3885-3893
• /
• 1975

This work was intended to study the cutting graph and vibratory phenomina of a newly developed mower which may be suitable for mowing agricultural product having large and hard stems like corn and sugar beet. The system consists of cutter-bar having Curvilinear-translation motion, which attached to drag-crank mechanism. The motion of equation developed for experimental vibratory system which equipped with the cutter-bar system was established and the parameters defining the system's vibratory motion were experimentally determined. The optimum balancing weight for the cutter-bar am vibratory characteristics of the cutter-bar for various counterweight were analyzed to provide the design and operational conditions. The results of the study are summarized as follows; (1) The cutting graph by the new cutter-bar system depends upon the magnitude of ratio of forward travel(Vm) to crank speed (R$\omega$); The cutting pitch for Vm/R$\omega$ 1 (whole cycle cutting) and Vm/R$\omega$=2/$\pi$ (a half cycle cutting) are 2$\pi$ Vm and 4R, respectively. (2) The experimental vibratory system had been proved to function adequately so that it can be used in determining the required counterweight to minimize the vibratory motion of cutter-bar. (3) Experimentally determined counterweight to give the least vibratory motion was a little greater than the theoretically determined one. With the optimum counterweight it was possible to reduce up to about 87% of the amplitude without counterweight, which may be considered to be within safe operational region. (4) To avoid the actual operation of the cutter-bar at resonance which occured in low frequency ratio, it was considered that the rotational speed of the crank for a specific design of mower should be determined separately in connection with the desired cutting graph.

• The Journal of the Korean dental association
• /
• v.22 no.9 s.184
• /
• pp.793-801
• /
• 1984

Though oral microgranisms were among the first to be observed by humans, the interest in oral microbiology lagged. When it became apparent that the oral microflora did influence systemic disease of the body, interest was aroused in the nature and kinds of the microgranisms. The risk of infection in dental procedures is due to the abundant flora of the mouth. This hazard can be reduced to some extent by the use of a local disinfectant. The present studies were undertaken to evaluate and compare the various disinfectants which are commonly used in clinics and hospitals. The results were as follows. 1. The bactericidal activity of the disinfectants mainly depends upon the kinds of the agents, not upon the kinds of the microorganisms. 2. In H₂O₂(3%), the bactericidal activity was greatly related to the contact time. So, at least 4 minitues of contract time was required to use it as an oral antiseptic. 3. In ethyl alcohol (70%), Pseudomonas aeruginosa and Streptococcus salivarius surived a little after 15 seconds of contact time, but, no other colony was discovered after more than 15 seconds of contact time in any kins of microorganisms. 4. Merthiolate (0.1%) showed low antibacterial activity, more in Gram-positive organisms and less in Gram-negative organisms. 5. Benzalkonium chloride (0.1%) and povidone-iodine (10%) showed the most excellent results, revealing no surviving organisms only after 14 seconds of contact time.

• Magazine of the Korea Concrete Institute
• /
• v.2 no.1
• /
• pp.91-100
• /
• 1990

In most of the structural members with initial cracks(or initial notches), the strength tends to decmase as the member size increases. This phenomenon is known as size effect. Among the structural materials of glass, metal or concrete, etc., concrete represents the size effect even without initial crack. According to the previous size effect law, the concrete mem¬ber of very large size can resist little stress. Actually, however, even the large size member can resist some stress if there is no initial crack made artificially, consequently showing a rather milder strength reduction compared to the severe strength reduction by tbe previously derived size effect law. In this study, the theoretical size effect law previously derived by Z.P. Bazant was discussed based on nonlinear fracture mechanics of concrete structures With dissimilar initial cracks, and the prediction models are proposed by regression analysis with the existing test data of more large size speciments for splitting tensile strength, shear strength and uniaxial compressive strength tests.

• Current Industrial and Technological Trends in Aerospace
• /
• v.6 no.1
• /
• pp.105-115
• /
• 2008

The organization for satellite operation team is mainly based on the number of satellites to be controlled, operator's workload of payload operation support and the degree of automation of the operation system. Although the structure and its functionality of satellite operation organization are a little different according to the complexity of the operation, most satellite control centers have adapted the similar architecture for single or multiple satellite support. KARI Satellite Operation Center(KSOC) has started its simple mission operations since the launch of KOMPSAT-1(21st Dec. 1999) and has been evolving into multiple mission operations for various satellites such as KOMPSAT-2, KOMPSAT-3, KOMPSAT-5 and COMS(Communication Ocean Meteorological Satellite). This paper presents the appropriate direction of future deployment for KSOC by comparing the current status with the recommendation of the advanced satellite operation organization and analyzing their experiences in order to propose the better solution for efficient and safe satellite operations.