• 한국원자력학회:학술대회논문집
• /
• 한국원자력학회 1996년도 추계학술발표회논문집(1)
• /
• pp.254-259
• /
• 1996

Phase Doppler particle analyze. (PDPA) is a instrument which can be used to obtain simultaneous size and velocity measurements in a multiphase flow. In this study, the size of the water droplets entrained from a bubbling surface of a stagnant liquid column is measured by PDPA with a specially designed transmitter of long focal length and large beam diameter. The test section tube is made of acryle with 18 mm I.D. and 900 mm length. The experimental data are obtained for the air superficial velocity between 0.7 m/s to 3.4 m/s at atmospheric pressure. The experimental results show that there exists large difference in the entrainment mechanism between the churn-turbulent flow and annular flow. Through the present study, the phase Doppler analyzer system is shown to be successfully applied to measure particle sizes larger than $2,000\mu\textrm{m}$ if a transmitter of long focal length is utilized.

• 융복합기술연구소 논문집
• /
• 제4권2호
• /
• pp.23-26
• /
• 2014

As an effective separation method for biomolecules, aqueous two-phase systems based on ionic liquids were suggested. Hydrophobic ionic liquids are more expensive and viscous in spite of their usage in the ionic liquid/water biphasic extraction compared with hydrophilic ionic liquids. In case of aqueous two-phase systems using hydrophilic ionic liquids, they can be diluted in aqueous phase. Experimental results show that aqueous two phase systems can be formed by adding appropriate amount of ionic liquids to aqueous salts solutions. The viscosity of ionic liquid aqueous phase is proportional to the cation chain length in ionic liquids. It is founded that the ionic liquid based aqueous two phase systems are effective for the separation of biomolecules such as acrylic acid.

• 설비공학논문집
• /
• 제27권10호
• /
• pp.520-526
• /
• 2015

The characteristics of gas-liquid Taylor (Slug) flow in a square micro-channel of $600{\sim}600{{\mu}m}$ were investigated experimentally in this paper. The test fluids were nitrogen and water. The liquid and gas superficial velocities were 0.01~3 m/s and 0.1~3 m/s, respectively. Bubble and liquid slug length, bubble velocity, and frequency were measured by analyzing optical images using a high speed camera. Bubble length decreased with higher liquid flow rate, which increased dramatically with higher gas flow rate. However, slug length did not vary with changes in inlet liquid conditions. Additionally, bubble velocities and frequencies increased with higher liquid and gas flow rates. It was found that measured bubble lengths were in good agreement with the empirical models in the existing literature, but slug lengths were not.

• Korea-Australia Rheology Journal
• /
• 제11권4호
• /
• pp.269-273
• /
• 1999

Immiscible polymer blends containing a liquid crystalline polymer dispersed phase can be described by existing blend theories when the dispersed-phase droplets are large relative to the orientation correlation length ("domain size") of the LCP. There does not appear to be an interfacial contribution to the linear viscoelastic properties of the blend from droplets smaller than the correlation length. Polyester blends, where interfacial interactions occur between the LCP and the matrix, exhibit a reduction in viscosity to below the viscosity of either component at low shear rates, where the droplet morphology is spherical. These anomalies cannot be explained in the context of existing theory.ng theory.

• 설비공학논문집
• /
• 제8권2호
• /
• pp.198-207
• /
• 1996

It is well known that drag reduction in single phase liquid flow is affected by polymer material, molecular weight, polymer concentration, pipe diameter, and flow velocity. Drag reduction in two phase flow can be applied to the transport of crude oil, phase change system such as chemical reactor, pool and boiling flow, and to present cavitation which occurs in pump impellers. But the research of drag reduction in two phase flow is not sufficient. The purpose of the present work is to evaluate the drag reduction by measuring pressure drop, void fraction, mean liquid velocity, and turbulent intensity whether polymer is added in the horizontal two phase system or not. Experiment has been conducted in a test section with the inner diameter of 24mm and the length of 1,500mm. The polymer materials used are two kinds of polyacrylamide[PAAM] and co-polymer[A611P]. The polymer concentration was varied with 50, 100 and 200 ppm under the same experimental conditions. Experimental results showed that the drag reduction of co-polymer is higher than that of polyacrylamide. Mean liquid velocities increased as polymer was added, and turbulent intensity decreased inversely near the pipe wall.

• Nuclear Engineering and Technology
• /
• 제31권1호
• /
• pp.29-48
• /
• 1999

Local two-phase flow parameters of subcooled flow boiling in inclined annulus were measured to investigate the effect of inclination on the internal flow structure. Two-conductivity probe technique was applied to measure local gas phasic parameters, including void fraction, vapor bubble frequency, chord length, vapor bubble velocity and interfacial area concentration. Local liquid velocity was measured by Pilot tube. Experiments were conducted for three angles of inclination; 0$^{\circ}$(vertical), 30$^{\circ}$, 60$^{\circ}$. The system pressure was maintained at atmospheric pressure. The range of average void fraction was up to 10% and the average liquid superficial velocities were less than 1.3 m/sec. The results of experiments showed that the distributions of two-phase How parameters were influenced by the angle of channel inclination. Especially, the void fraction and chord length distributions were strongly affected by the increase of inclination angle, and flow pattern transition to slug flow was observed depending on the How conditions. The profiles of vapor velocity, liquid velocity and interfacial area concentration were found to be affected by the non-symmetric bubble size distribution in inclined channel. Using the measured distributions of local phasic parameters, an analysis for predicting average void fraction was performed based on the drift flux model and flowing volumetric concentration. And it was demonstrated that the average void fraction can be more appropriately presented in terms of flowing volumetric concentration.

• Korean Chemical Engineering Research
• /
• 제54권4호
• /
• pp.543-547
• /
• 2016

직경 0.152 m이고 높이 2.5 m인 전해질용액 기포탑에서 기포의 크기(chord length)와 상승속도 등 기포의 물성에 대해 고찰하였다. 기포의 크기와 상승속도는 이중저항탐침법을 사용하여 측정하였다. 기체와 액체의 유속 그리고 액상의 이온강도가 기포의 크기와 상승속도에 미치는 영향을 결정하였다. 기포의 크기는 기체의 유속이 증가함에 따라 증가하였으나 액체의 유속과 액상의 이온강도가 증가함에 따라서는 감소하였다. 기포의 상승속도는 기체의 유속이 증가함에 따라 증가하고 액상의 이온강도가 증가함에 따라 감소하였으나 액체유속의 변화에 따라서는 약한 최대값을 나타내었다. 기포의 크기와 상승속도는 운전변수들의 상관식으로 잘 나타낼 수 있었다.

• 공업화학
• /
• 제8권4호
• /
• pp.617-623
• /
• 1997

폴리솔베이트-핵산올-물의 3성분계의 상거동에 관한 메카니즘을 조사한 것으로, 등방성인 미셀영역에서 비등방성인 모자이크 액정상을 편광현미경에 의해 관찰하였다. 액정상 및 다른 상들은 약 20~70 wt% 범위에서 관측되었으며, 이 영역에서는 보다 안정한 유화계나 분산계의 포뮬레이션에 대한 기본적인 데이터를 제공할 수 있다. 알킬기의 탄소수 증가에 따라 3상 영역이 감소한 반면에, 2상 영역이 증가되었으며 비등방성 액정상은 관찰되지 않았다.

• 한국분무공학회지
• /
• 제24권4호
• /
• pp.185-193
• /
• 2019

The effervescent atomizer is one of twin-fluid atomizers that aeration gas enters into bulk liquid and two-phase flow is formed in the mixing section. The effervescent atomizer requires low injection pressure and small amount of aeration gas, as compared to other twin-fluid atomizers. In this study, cold flow test was conducted to investigate the spray characteristics of aerated impinging jets. The present effervescent impinging atomizers were composed of the aerator device and like-on-like doublet impinging atomizer which had different impinging angles. To analyze the spray characteristics such as breakup length and droplet size distribution, the image processing technique was adopted by using instantaneous images at each flow condition. Non-dimensional parameters, induced by the homogeneous flow model, were used to predict the breakup length. The breakup length was decreased with the mixture Reynolds number and impinging angle increasing. The result of droplets showed that the size distribution was axisymmetric about the center of the injector and their diameter tended to decrease with increasing GLR.

• Bulletin of the Korean Chemical Society
• /
• 제20권12호
• /
• pp.1421-1427
• /
• 1999

4-Hydroxy-4'-methoxyazobenzene and 4-hydroxy-4'-cyanoazobenzene were synthesized from phenol with p-anisidine and p-aminobenzonitrile through a diazotization reaction, respectively. They were reacted with 2-chloroethanol, 2-(2-chloroethoxy)ethanol, or 2-[2-(2-chloroethoxy)ethoxy]ethanol to produce six kinds of new mesogenic alcohols having an azobenzene group that is sensitive to the ultraviolet. Twelve kinds of new photoresponsive monomers with two symmetrical mesogens were prepared by the reaction of the mesogenic alcohols with fumaric acid or maleic acid through a Mitsunobu reaction. The resulting monomers have different length of flexible ethyleneoxy spacer tethered to azobenzene group. The length of the spacer affected their thermal stability, solubility, and phase transition temperature. Structures of the monomers were identified by FT-IR and ¹H-NMR spectra. Their phase transition temperatures and thermal stability were also investigated by a differential scanning calorimetry (DSC) and a thermogravimetric analysis (TGA). From an optical polarizing microscopy, all the prepared monomers except fumarate-1 and maleate-1 were found to show enantiotropic liquid crystallinity with a smectic texture like focal-conic, fan-shaped, and batonnet textures.