• Journal of environmental and Sanitary engineering
• /
• v.10 no.3
• /
• pp.99-104
• /
• 1995

The objective of this study was to investigate the effect on denuclearization and decertification of flue gas by utilizing Mg( OH)$_{2}$ and NaOH as reagents in industrial boiler. We used packed absorber with Tellerette in all cases. And pH of circulation solution, rate of liquid per gas in absorber, COD concentration by pH variation in oxidation basin were inves- tigated. The following conclusions were obtained from experimental results: 1. Concerning running cost for reagents, Mg( OH)$_{2}$ reagent for treatment of flue gas was more economical than NaOH. 2. While Mg( OH )$_{2}$ and NaOH as absorbents were used, then the ratio of denuclearization was 96 and 97% respectively and nitrification was recorded 29 and 25% . 3. In this absorption tests the optimum condition for ratio of liquid per gas, pH and nonregenerable salt concentration of circulation solution were 3.6ℓ /Nm$^{3}$, 6.0, 0.5∼1.0% respectively, 4. Initial COD in oxidation basin was 800 ∼ 1,00099ut after adjusting to pH 7.0, COD of effluent water was less than 20ppm.

• Proceedings of the Korean Institute of Building Construction Conference
• /
• 2003.05a
• /
• pp.63-67
• /
• 2003

There are many factors that generate the early deterioration of the concrete structure. As the one of the representative factors, we can think an invasion of the water, air and so on. The water and air invade in inside void along the capillarity and they become the cause that the durability like corrosion of layer department due to freezing and thawing, inside steel frame corrosion, and so on blacks. Therefore with covering permeability covering waterproofing material of fluid condition in outer wall, intercepting the deterioration factor due to the infiltration of water from outside and for salt damage of concrete layer department, freezing damage and neutralization, it needs to improve durability of structure. This study separately examined physical and chemical specific of quality liquid siliceous of waterproofing material. Therefore as this applys the construction site, it improves the durability of concrete structure. Further this presents the application plan from the construction market against the new material.

• Bulletin of the Korean Chemical Society
• /
• v.17 no.11
• /
• pp.1004-1009
• /
• 1996

The interactions between a rod-coil liquid crystalline oligomer, ethyl 4-[4'-oxy-4-biphenylcarbonyloxy]-4'-biphenylcarboxylate with poly(ethylene oxide) (DP=12) (12-4) and LiCF3SO3 have been characterized by using Raman spectroscopy. Band assignments were made comparing the spectrum of 12-4 with those of the poly(ethylene glycol) monomethyl ether(PEGME) (Mw=550) and the ethyl-4'-hydroxybiphenyl-4-carboxylate (EHBPC), which are the coil and mesogen analogues, respectively. Analyzing characteristic bands of the 12-4-salt complex, we have found that the bands belonging to the coil and mesogenic units are changed in both intensities and frequencies. The spectral changes were interpreted from the viewpoint of the complexation between 12-4 and the Li+ ion. However, the possibility that the spectral changes in the mesogenic unit are not due to the complexation with the Li+ ion, but due to the conformational changes by the intercalation of nondissociated LiCF3SO3, is not ruled out.

• Elastomers and Composites
• /
• v.55 no.4
• /
• pp.249-256
• /
• 2020

Superabsorbent polymers (SAPs) can absorb and retain ten to thousand times their dry mass of water because of their three-dimensional hydrophilic structures. Conventional SAPs are mainly composed of poly(acrylic acid sodium salt) derived from petrochemicals. The present work is aimed at limiting the use of the petrochemical component by replacing it with a biomass-based material. First, the core-SAP was prepared via the terpolymerization of itaconic acid, vinylsulfonic acid, and cellulose, and the optimum conditions in terms of material input ratio were determined. Following this, the core-SAP was surface-crosslinked by esterification with butane diol to improve its liquid permeability and absorbency under load (AUL). The liquid permeability was measured according to the amount of 0.9 wt.% NaCl solution passing between the swollen SAP particles under a given pressure, and the AUL was estimated from the weight of this solution absorbed under 0.3 psi pressure.

• Proceedings of the Membrane Society of Korea Conference
• /
• 1993.10a
• /
• pp.59-60
• /
• 1993

막을 도구로 하여 물가등(Ion, Molecular)의 선택 분리 및 정제과정법에 대한 연구는 눈부신 발전을 가져 왔다. 콜로디온 막으로 투석과 한외 여과법이 나온 이래 1950년대 Juda의 연구 이온 교환법의 보고 후 전기투석법에 의한 바닷물의 담수화 농축 방법이 개발되고 Soeb, Sourirajan의 초산 셀루로즈 막의 보고는 Salt의 배제율이 높은 베막 법이 소개 된 후에 다양한 막의 응용법이 전개되었다. 막소제, 제막법, 고 분리기능막, 막형태, 얇은막, 막장치에 이르기 까지 막학 연구의 관심을 모아졌다.

• Proceedings of the Korean Fiber Society Conference
• /
• 1998.10a
• /
• pp.232-235
• /
• 1998

ion conducting polymers have been extensively investigated because of their potential application as an electrolyte in solid state batteries [1]. Among the polymer electrolytes, solid polymer electrolytes (SPEs) composed of ion conducting polymer and alkali metal salt have many advantages such as high ionic conductivity, high energy density and light weight. This made them suitable replacement for liquid electrolytes. (omitted)

• Analytical Science and Technology
• /
• v.18 no.3
• /
• pp.224-231
• /
• 2005

In this study, the optimum conditions for the LPME (liquid phase microextraction) were investigated to overcome several shortcomings of traditional liquid-liquid extraction method. The LPME, which is automatic and dynamic, was used to analyze the five pesticides (dementon-S-methyl, diazinon, parathion, fenitrothion, EPN) extracted from vegetable, and HP 6890 GC/NPD was used as an analytic instrument. It was possible to optimize the extraction condition using the automatic LPME. The optimum extraction rate was obtained at pH 3.0 and $100{\mu}g/mL$ of salt concentration and standard curve showed linearity with over $R^2=0.9921$ in the range of $0.2{\sim}10{\mu}g/g$. The relative standard deviations were 7.7%, 9.8%, 7.8%, 9.7% and 8.2% in the $5.0{\mu}g/g$ concentration of dementon-S-methyl, diazinon, parathion, fenitrothion and EPN, respectively. The acquired accuracies were satisfactory showing 12.7%, 7.8%, 10.4%, -6.7% and -0.7% for dementon-S-methyl, diazinon, parathion, fenitrothion and EPN respectively.

• Bulletin of the Korean Chemical Society
• /
• v.32 no.3
• /
• pp.829-835
• /
• 2011

A dispersive liquid-liquid microextraction based on solidification of floating organic droplet (DLLME-SFO) has been developed as a new approach for the extraction of trace copper in water and beverage samples followed by the determination with flame atomic absorption spectrometry. In the DLLME-SFO, 8-hydroxy quinoline, 1-dodecanol, and methanol were used as chelating agent, extraction solvent and dispersive solvent, respectively. The experimental parameters related to the DLLME-SFO such as the type and volume of the extraction and dispersive solvent, extraction time, sample volume, the concentration of chelating agent and salt addition were investigated and optimized. Under the optimum conditions, the enrichment factor for copper was 122. The method was linear in the range from 0.5 to $300\;ng\;mL^{-1}$ of copper in the samples with a correlation coefficient (r) of 0.9996 and a limit of detection of $0.1\;ng\;mL^{-1}$. The method was applied to the determination of copper in water and beverage samples. The recoveries for the spiked water and beverage samples at the copper concentration levels of 5.0 and $10.0\;ng\;mL^{-1}$ were in the range between 92.0% and 108.0%. The relative standard deviations (RSD) varied from 3.0% to 5.6%.

• Korean Journal of Community Nutrition
• /
• v.17 no.5
• /
• pp.637-651
• /
• 2012

The purpose of this study was to investigate salinity and sodium content in foods served at industry foodservice operations in selected workplaces in Daegu. The researcher collected 1,142 food items categorized into 22 menu item groups from lunch samples served at 100 industry foodservice operations and measured the salinity of the food items, and calculated sodium and salt contents from the salinity. In terms of salt content of one meal at each workplace, 46% of the meals were 3-<5 g, and only 3.0% of them were 1.7 g or less, which is one third of the daily target intake (5 g) presented by the Dietary Reference Intakes for Koreans. In terms of sodium content, 35.3% of the meals were 1,000-< 1,500 mg (most), and only 2.5% of them were 667 mg or less, which is, again, one third of the daily target intake. As to the salinity of each menu item group, side dishes such as sauces, kimchi, seasoned vegetables, hardboiled foods, and stir-fried foods were significantly higher, but the sodium content was not higher, because their quantity per serving was small. The salinity of foods with liquid such as stews, noodles, soups, and broths was relatively lower, but the sodium content was higher, because their quantity per serving was large. This indicates that an education program should be developed for foodservice workers who prepare food for the workplace regarding the development and promotion of various menus for reducing sodium content, in order to reduce sodium content in meals served by food service in the workplace.

• Korean Journal of Plant Resources
• /
• v.24 no.2
• /
• pp.208-213
• /
• 2011

This study was carried out to determine the effect of medium solidity, salt strength, sugar and nitrogen sources, and pH levels on in vitro multiplication of pathogen-free yam (Dioscorea opposita Thunb.). Liquid medium was more effective in the growth of plant height, fresh weight, and formation of microbulb than the solid medium. Optimal condition for plant fresh weight, growth, and multiplication axillary bud was in 1MS salt strength with 60 $g{\cdot}L^{-1}$ sucrose and half strength of $KNO_3$. Optimal condition for microbulb formation was $\frac{1}{2}$ MS salt strength supplemented with glucose 60 $g{\cdot}L^{-1}$ and half strength of $KNO_3$. The number of leaves and nodes were sharply increased from 2 to 5 weeks, whereas plant fresh weight was steadily increased from 3 to 11 weeks after inoculation. Microbulbs were formed at 2 weeks after inoculation and continuously increased until 12 weeks.