• Journal of Biomedical Engineering Research
• /
• v.28 no.3
• /
• pp.429-440
• /
• 2007

A coded excitation has been studied to improve the performance for ultrasound imaging in term of SNR, imaging frame rate, contrast to tissue ratio, and so forth. However, it requires a complicated arbitrary waveform transmitter for each active channel that is typically composed of a multi-bit Digital-to-Analog Converter (DAC) and a linear power amplifier (LPA). Not only does the LPA increase the cost and size of a transmitter block, but it consumes much power, increasing the system complexity further and causing a heating-up problem. This paper proposes an optimized 1.5bit fourth order sigma-delta modulation technique applicable to design an efficient arbitrary waveform generator with greatly reduced power dissipation and hardware. The proposed SDM can provide a required SQNR with a low over-sampling ratio of 4. To this end, the loop coefficients are optimized to minimize the quantization noise power in signal band while maintaining system stability. In addition, the decision level for the 1.5 bit quantizer is optimized for a given input waveform, which results in the SQNR improvement of more than 5dB. Computer simulation results show that the SQNR of a FM(frequency modulated) signal generated by using the proposed method is about 26dB, and the peak side-lobe level (PSL) of its compressed waveform on receive is -48dB.

• Korean Journal of Environmental Agriculture
• /
• v.39 no.2
• /
• pp.138-141
• /
• 2020

BACKGROUND: Fresh weight is one of the major quality measurement factors in determining the quality of fresh fruits. A practical method has been developed for rapid and non-destructive measurement using the Chlorophyll Fluorescence Image (CFI) technique to estimate changes in fresh weight of post-harvest products. METHODS AND RESULTS: Kiwifruit (Actinidia deliciosa) was used and measured for the fresh weight and CFI under different temperature conditions at 0, 10, and 20℃, from 0 to 21 days after storage (DAS). We observed the fresh weight of kiwifruit and measured the surface image for determining F_v/F_m value in terms of maximum quantum yield on each day. To estimate freshness of kiwifruit we applied linear regression between the measured fruit weights and F_v/F_m values. Results showed that fruit weights were reduced by 4% at 0℃, 6% at 10℃, and 14% at 20℃ for 21 days, respectively. And also, the value of Fv/Fm was shown as decreasing trend at all temperature conditions, especially at 20 ℃. Fv/Fm values showed highly significant correlation (R²>0.9) with fresh weight of kiwifruit at all different storage temperatures. CONCLUSION: Thus, CFI technique can be useful to estimate the fresh weight of kiwifruit.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.24 no.1
• /
• pp.82-90
• /
• 2013

In this paper, conducted emission from the MDS(Motor Drive System) of a HEV/EV was analyzed using high- frequency circuit modeling in system-level approach. The conducted emission by PWM process can cause RFI(radio- frequency interference) problems in the AM/FM frequency range. In order to mitigate this conducted emission, a high-frequency equivalent circuit model is proposed by analyzing the fundamental circuits, parasitic components in their parts and connections and non-linear characteristics of IGBTs, high-power capacitors, inverters, motors, high-power cables, and bus bars which are composed of the MDS. It is confirmed that the simulated result by the proposed model is well agreed with measured results in spite of a large-scaled analysis in system level. We are looking forward that this approach can be effectively used in the EMC design of HEV/EV.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.29 no.2
• /
• pp.138-141
• /
• 2018

In this paper, we describe the designed digital waveform of a linear frequency-modulated (FM) chirp signal using field-programmable gate arrays (FPGAs) for image radar, and this signal is modulated with an I-Q modulator, and multiplied by 24 frequency multipliers to obtain a 94-GHz W-band wideband chirp generator. The developed chirp generator is an FM signal with a 94-GHz carrier frequency and a 960-MHz bandwidth, and the flatness is less than 1.0 dB at intermediate frequency (IF) (3.9 GHz), 2.0 dB in the W-band, and it has a 0.3-W output power in the W-band.

• Journal of The Geomorphological Association of Korea
• /
• v.19 no.4
• /
• pp.123-137
• /
• 2012

Reddish superficial materials in southern area of Korean Peninsula have been defined as lateritic red soil in Korea. In A-CN-K ternary plots, CaO and $Na_2O$ show similar linear distribution along a A-K line to kaolinite profile and laterite in southern Spain and Cameroon, respectively, and it means strong alteration. But $K_2O$ is weak alteration, plotting between muscovite and illite zone. Granitic reddish weathering mantles in study area show bulk distribution in center when plotted in A-CNK-Fm space, in contrast to laterite in Cameroon, plotting linearly in the middle along a A-FM line. Therefore, alteration of reddish saprolites in Southern Korea have not progressed as much as laterite. To define Reddish saprolite in southern Korean Peninsula as a lateritic red soil, more many studies are necessary.

• Proceedings of the Korean Vacuum Society Conference
• /
• 2012.08a
• /
• pp.240-240
• /
• 2012

Linear ion source (LIS)를 사용하여 Si wafer 위에 Si 이온이 첨가된 DLC 박막을 증착하였다. 참가된 Si 이온의 양에 따라 DLC 박막에 미치는 영향을 분석하기 위하여 마찰 계수 및 경도를 비교하였고, Micro raman spectroscopy, Field Emission-Scanning Electron Microscope(FM-SEM) and X-ray Photoelectron Spectroscopy (XPS)를 통하여 표면 상태를 분석하였다. 천체 주입된 가스량의 약 2%까지 Si 이온 주입이 늘어날수록 DLC 박막의 마찰계수는 낮아졌고, 경도는 Si 이온이 주입되지 않았을 경우와 비슷한 값(약 20~23GPa)을 가졌다. 2% 이상의 주입량에서는 마찰계수는 주입량이 늘어날수록 높아졌으며 경도는 떨어지는 경향을 보였다. 이는 Si 이온이 2% 이하로 첨가되었을 경우, DLC 박막의 생성시 탄소 이온들의 결합 Stress를 줄여 마찰계수가 줄어든다고 볼 수 있으며, 그 양이 2% 이상이 되면 오히려 불순물로 작용하여 DLC 박막의 Stress는 급격히 증가하고 마찰계수도 높아짐을 알 수 있다.

• Journal of the Korea Institute of Military Science and Technology
• /
• v.9 no.3
• /
• pp.95-100
• /
• 2006

The pulse compression technique using Linear FM signal is commonly used for improving the performance of both the detection range and range resolution in radar system. In general, the compressed LFM waveform has relatively large sidelobe level which may prevent a target from being detected when strong jammer or clutter signal is near the target signal. In this paper, we propose a new weighting method which uses the square-root weight to suppress the sidelobe level. Typical applications are missile seekers and tracking radar systems where target tracking range is available prior to the signal processing. By computer simulation, we show that the performance of the proposed method is better than that of the conventional weighting methods in terms of sidelobe suppression.

• Electronics and Telecommunications Trends
• /
• v.9 no.4
• /
• pp.131-138
• /
• 1994

최근 무선통신의 활성화에 따라, V/UHF(very/ultra high Frequency) 대역에서 한정된 주파수를 효율적으로 이용하기 위한 방법의 하나로서, 점차 점유 주파수 대역의 폭을 축소하여 보다 많은 이용자를 수용하도록 무선 채널의 협대역화가 추진되고 있다. 본 고에서는 먼저 V/UHF 대역 무선 통신에서 채널의 협대역화에 관련된 기술 중에서 현재까지 사용되고 있는 FM(frequency modulation), AM(amplitude modulation) 변조 방식의 장,단점을 살펴본후, 새로운 LM(linear modulation) 변조 방식에 대한 기술적 배경 및 특성을 알아보았다. LM은 SSR(single side band)-AM이 발전한 것으로서, TTIB(transparent tone-in-band), CLT(Cartesian loop transmitter), FFSR(feed-forward signal regeneration), DSP(digital signal processing)등 4가지의 기술이 결합하여 만들어진 것이다. LM 방식에 사용된 4가지 기술을 소개하고, 기존의 변조 방식에 비해 개선된 사항에 대해 서술한다.

• Journal of Electrical Engineering and Technology
• /
• v.9 no.2
• /
• pp.771-776
• /
• 2014

In this paper, an agile programmable chirp spread spectrum generator for wideband frequency-jamming applications from 20 MHz to 3 GHz is proposed. A frequency-mixing architecture using two voltage-controlled oscillators is used to achieve a wideband operating frequency range, and the direct digital synthesizer (DDS)-based chirping method with a two-point modulation technique is employed to provide a programmable and consistent chirp bandwidth. The proposed signal generator provides the various programmable FM signals from 20 MHz to 3 GHz with a modulation bandwidth from 0 to 400 MHz. The prototype successfully demonstrates arbitrary sequential jamming operation with a fast band-to-band hopping time of < 10 ${\mu}sec$.

• Journal of Photoscience
• /
• v.1 no.2
• /
• pp.95-105
• /
• 1994

Experiments were carried out to investigate whether P, deficiency in detached 25 mM mannose-feeding led to a decline of the photosynthetic electron transport rates through acidification of the thylakoid lumen. With increasing mannose-feeding time, the maximal CO2 exchange rates and the maximal quantum yields of photosynthesis decreased rapidly up to 6 h by 73% then with little decrease up to 12 h. The ATP/ADP ratio declined by 54% 6 h after the treatment and then recovered to the control level at 12 h. However, the NADPH/NADP~ ratio was not significantly altered by mannose treatment. Electron transport rates of thylakoid membranes isolated from 6 h treated leaves did not change, but they decreased by 30% in 12 h treated leaves. The quenching analysis of Chl fluorescence in mannose-treated leaves revealed that both the fraction of reduced plastoquinone and the degree of acidification of thylakoid lumen remained higher than those of the control. The reduction of PSI in mannose fed leaves was inhibited due to acidification of thylakoid lumen (high qE). The reduction of primary quinone acceptor of PSII was inhibited by mannose feeding. Mannose treatment decreased the efficiency of excitation energy capture by PSII. Fo quenching was induced when treated with mannose more than 6 h, and had a reverse linear correlation with (Fv)m/Fm ratio. These results suggest that Pi deficiency in Chinese cabbage leaves reduce photosynthetic electron transport rates by diminishing both PSII function and electron transfer from PSII to PSI through acidification ofthylakoid lumen, which in turn induce the modification of photosynthetic apparatus probably through protein (de)phosphorylation.