• Transactions of the Korean Society of Mechanical Engineers A
• /
• v.32 no.3
• /
• pp.267-273
• /
• 2008

The circular cylinder pipes are used in the many industrial areas. In this paper, the acoustic wave propagation in the pipe containing a gas is researched. First of all, the theory for the coupled acoustic wave propagation in a pipe is investigated. Acoustic wave propagation in pipe can not be occurred independently between the wave of the fluid and the shell. It requires complicated analysis. However, as a special case, the coupled wave in a high density pipe containing a light density medium is corresponded closely to the uncoupled in-vacuo shell waves and to the rigid-walled duct fluid waves. The coincidence frequencies of acoustic and shell modes contribute to the predominant energy transmission. The coincidence frequency means the frequency corresponding to the coincidence of the wavenumber in both acoustic and shell. In this paper, it is assumed that the internal medium is much lighter than the pipe shell. After the uncoupled acoustic wave in the internal medium and uncoupled shell wave are considered, the coincidence frequencies are found. The analysis is successfully confirmed by the verification of the experiment using the real long steel pipe. This work verifies that the coupled wave characteristic of the shell and the fluid is occurred as predominant energy transmission at the coincidence frequencies.

• Journal of Animal Environmental Science
• /
• v.5 no.2
• /
• pp.79-86
• /
• 1999

Recently more dairy farmers are interested in the utilization of stretch film for wrapping silage material. Most of stretch film are imported from abroad and one domestic product was developed, but its quality has not yet been tested. Therefore this study was executed to offer basic data on this material to the farmers. Measured items were tensile load, extension ratio, and tear propagation strength of stretch films. Comparisons were made among the white color of domestic product(Kw), and white(Fw), black (Fb) and green color(Fg) of foreign products. The result were summarized as follows: 1. Tensile loads of lengthwise direction in stretch films were 557.4, 377.4, 282.6 and 398.4kgf/$\textrm{cm}^2$ in Kw, Fw, Fb and Fg, respectively, and tensile loads of width direction were 415.9, 418.1, 360.2 and 433.0kgf/$\textrm{cm}^2$ in Kw, Fw, Fb and Fg, respectively. 2. Extension ratios of lengthwise direction were 650, 462.5, 512.5% and 537.5% in Kw, Fw, Fb and Fg, respectively, Extension ratios of width direction were 930, 962.5, 950 and 1,000% in Kw, Fw, Fb and Fg, respectively. 3 Tear propagation strength of lengthwise direction 187.9, 148.9, 157.3 and 142.8kgf/cm, and tear propagation strength of width direction were 141.4, 129.8, 140.4 and 106.6kgf/cm in Kw, Fw, Fb and Fg, respectively. 4. In the light transmittance, there was no difference between white and green color stretch film, but it was very low in black one. Therefore, it is thought that research on quality of roll bale silage treated with each stretch film would be needed.

• Journal of Bio-Environment Control
• /
• v.5 no.1
• /
• pp.23-33
• /
• 1996

This study was performed to induce a quality improvement and standardization of materials used for greenhouse. For this purpose, physical and mechanical properties of agricultural films for greenhouse were measured by kinds and thickness of the films. The properties are composed of impact, tensile, tear propagation strength and light transmittance. The results were summarized as follows. 1. At the impact test result of the falling dart, the thicker the film, the greater the impact strength of soft film. The impact weight at 50 percents is from 158g to 213g and the strength of low density polyethylene(LDPE) film is higher than the rest of any other films. 2. Seeing the leveling of the impact rupture, maximum impact weight which was ruptured very little ranges from 62g to 192g. The impact strength of 0.1mm films was higher than that of 0.05mm as from 1.8 to 3.2 times. 3. Tensile weight covers from 0.95kg to 2.22kg in the test materials, and the weight of lengthwise film is larger than that of width. LDPE film has high value of tensile weight. Elongation range is from 345 to 102 percent and lengthwise elongation is greater than width as much as from 1.4 to 2.7 times. 4. Tea. propagation strength ranges from 80.5kg/cm to 121.7kg/cm, and unlike which of LDPE film has high value, EVA film has low value in the films tested. The width strength is higher than the lengthwise. 5. The light transmittance of the soft film is about 78-92 percent in the range of ultraviolet ray, but has high value in the visible ray range.

• Journal of Bio-Environment Control
• /
• v.27 no.4
• /
• pp.363-370
• /
• 2018

The succulent plants of Echeveria genus are in increasing demand worldwide, but it is difficult to supply good quality young plants throughout the year because propagation efficiencies are depend on cultivar and environmental factors. This study was carried out to investigate the propagation efficiencies of leaf cutting in Echeveria cultivars at different LED light qualities in a closed-type plant factory system. Leaf cuttings cut from stock plants of six difficult-to-propagated cultivars 'Afterglow (AG)', 'Berkeley Light (BL)', 'Mason (MS)', 'Subsessilis Light (SL)', 'Cream Tea (CT)', and 'Ben Badis (BB)' were put into cutting media in the plant factory system maintained at a temperature of $24{\pm}2^{\circ}C$ and relative humidity of $60{\pm}10%$, and watered with over-head irrigation twice a week. Cuttings were irradiated with sole or mixed red (R, 660 nm), blue (B, 450 nm), green (G, 530 nm), and far-red (FR, 730 nm) LEDs as follows: R10, R8+B2, R5+B5, R7+B2+FR1, and R7+B2+G1. PPFD just above the cuttings was $200{\mu}mol{\cdot}m^{-2}{\cdot}s^{-1}$ and photoperiod was 16/8 (light/dark) hours. As a result, propagation efficiencies were dependent on cultivar. Rooting and shooting were relatively easy in 'SL' but shoot formation in 'AG' was very difficult. Light qualities from LEDs also affected plant regeneration. Light conditions with a higher ratio of B, R5+B5, R7+B2+FR1, and R7+B2+G1, promoted shoot formation and growth but inhibited rooting and root growth. R10 and R8+B2 with a higher ratio of R promoted rooting and root growth and inhibited shoot formation and growth of cuttings. In addition, the treatment with FR increased leaf size and biomass of the all plants. Therefore, further studies are needed to investigate the optimum compositions of LED light quality for the improvement of leaf cutting efficiency in difficultto-propagated Echeveria cultivars.

• Current Optics and Photonics
• /
• v.3 no.2
• /
• pp.105-110
• /
• 2019

The visible-light communication (VLC) system is a promising candidate to fulfill the present and future demands for a high-speed, cost-effective, and larger-bandwidth communication system. VLC modulates the visible-light signals from solid-state LEDs to transmit data between transmitter and receiver, but the broadcasting and the line-of-sight propagation nature of visible-light signals make VLC a communication system with a limited operating range. We present a novel architecture to increase the operating range of VLC. In our proposed architecture, we guide the visible-light signals through the fiber and amplify the dissipated signals using visible-light fiber amplifiers (VLFAs), which are the most important and the novel devices needed for the proposed architecture of the VLC. Therefore, we design, analyze, and apply a VLFA to VLC, to overcome the inherent drawbacks of VLC. Numerical results show that under given constant conditions, the VLFA can amplify the signal up to 35.0 dB. We have analyzed the effects of fiber length, active ion concentration, pump power, and input signal power on the gain and the noise figure (NF).

• Korean Journal of Optics and Photonics
• /
• v.10 no.2
• /
• pp.174-177
• /
• 1999

The propagation loss of silica slab waveguides were measured by immersing slab waveguides into a index matching liqiud. Index matching liqiud was used for out-coupling the light from arbitrary points of slab waveguide. The measured value of propagation loss are 0.04 dB/cm and 0.09 dB at 1300 nm and 633 nm respectively.

• Journal of Advanced Marine Engineering and Technology
• /
• v.38 no.2
• /
• pp.169-174
• /
• 2014

This paper proposes a novel beehive-shaped reflector for application to light-emitting diode (LED) transceivers for illumination and bi-directional visible light communication (VLC). By using a diffuse propagation model extended to line-of-sight and direct signals, the distribution of illuminance and the path loss of the transceiver are investigated to evaluate the performance of the beehive-shaped reflector. To verify bi-directional communication, a VLC-based image capture system, comprising a complementary metal-oxide semiconductor (CMOS) image sensor and video processor unit, is demonstrated. Real-time images captured by the CMOS camera are successfully transmitted to the monitoring system via a free-space channel at a rate of 115.2 kbps.

• Journal of Sensor Science and Technology
• /
• v.11 no.5
• /
• pp.273-278
• /
• 2002

An intrusion-sensitive capability of multimode graded-index (GRIN) optical fibers under bending has been investigated. In this system, the data light is transmitted in the fundamental mode while alarm monitor light is launched in a high-order mode at the same time. An attempted intrusion to drain data by bending the fiber results in greater attenuation of a monitor signal in higher order modes, thereby setting off an alarm at the receiver. Light propagation in a multimode graded-index fiber is also analyzed theoretically when the fundamental mode is selectively excited and the fiber is bent around a constant radius mandrel. The bending generates coupling between the various modes of the fiber. Power transitions of the fundamental mode by changing the bending radius were also analyzed numerically using program simulation. It is shown that Asawa-Taylor model[4] is valid up to 1cm of the radius of curvature of the fiber bend.

• Proceedings of the Plant Resources Society of Korea Conference
• /
• 2019.04a
• /
• pp.44-44
• /
• 2019

This study aimed to develop a suitable method for inducing the proliferation of prothallus and producing sporophytes of rock polypody (Polypodium vulgare L.). The prothalli used in all experiments were obtained from spore germination and sub-cultured for 8-week intervals. The most appropriate media for prothallus propagation were investigated by culturing 300 mg of prothallus in MS ($1/4{\times}$, $1/2{\times}$, $1{\times}$, and $2{\times}$ strength) medium and in Knop medium for 8 weeks. Cultures were maintained at a temperature of $25{\pm}1^{\circ}C$, light intensity of $30{\pm}1.0{\mu}mol-m-2{\cdot}s-1$, and a photoperiod of 16/8 h (light/dark). Fresh weight of prothalli was 4.8 g on $1{\times}$ MS, 4.5 g on $1/2{\times}$ MS and 4.3 g on 1/4 MS medium. To select a suitable soil combination for sporophyte formation, 1.0 g of prothallus was ground with distilled water, spread in five combinations onto different soil substrates (decomposed granite, horticultural substrates, peat moss, and perlite), and then cultivated for 13 weeks. The sporophyte cultures were maintained at a temperature of $25{\pm}1^{\circ}C$, light intensity of $43{\pm}2.0{\mu}mol-m-2{\cdot}s-1$, humidity of $84{\pm}1.4%$, and a photoperiod of 16/8 h (light/dark). The results showed that a mixture containing a 2:1 (v:v) ratio of horticultural substrate and perlite, increased sporophyte formation to 462.5 sporophytes per pot (7.5 cm2). The other soil substrates produced from 314.5 to 405.3 sporophytes per pot. Therefore, our results will provide conditions suitable for mass production of Polypodium vulgare L.

• Journal of Sensor Science and Technology
• /
• v.28 no.6
• /
• pp.341-344
• /
• 2019

Liquid crystal (LC) mesophase materials manifest a variety of phase transitions. The optical properties of LCs are highly dependent upon the phase and orientation of the optical axis with respect to the polarization of incoming light. Studying the LC phase transitions is significantly important for a wide range of scientific and industrial applications. In this study, we demonstrate the propagation velocity of the phase boundary between the nematic and isotropic phase of 4-Cyano-4-pentylbiphenyl (5CB) liquid crystal for different electric fields using a polarized optical microscope. The results demonstrate that the propagation velocity of the phase boundary exhibits a peak value for a specific voltage, attributed to the supercooling of the isotropic phase of the LC. The analysis of the propagation velocity for different electric fields also provides a simple optical platform to measure the thermal anisotropy and voltage dependent thermal properties of the homogeneously aligned LC.