• 한국수소및신에너지학회논문집
• /
• 제35권1호
• /
• pp.97-104
• /
• 2024

In this study, combustion experiments were conducted to assess engine performance and exhaust gas characteristics using four blends of 1-pentanol and diesel as fuel in a naturally aspirated 4-stroke diesel engine. The blending ratios of 1-pentanol were 5, 10, 15, and 20% by volume. The experiments were carried out under four different engine torque conditions (6, 8, 10, and 12 Nm) while maintaining a constant engine speed of 2,000 rpm for all fuel types. The results showed that the use of 1-pentanol/diesel blended fuel generally led to a decrease in brake thermal efficiency, attributed to the low calorific value of the blend and the cooling effect due to the latent heat of vaporization. Additionally, both brake specific energy consumption and brake specific fuel consumption increased. However, the use of the blended fuel resulted in a general decrease in NOx concentration, a decrease in CO concentration except some conditions, and a reduction in smoke opacity across all conditions.

• Journal of Biosystems Engineering
• /
• 제9권2호
• /
• pp.65-73
• /
• 1984

While most of researches on the performance of high temperature grain dryer have dealt mainly with improving dryer capacity and drying speed during the last twenty years, energy efficiency, in fact, has not been emphasized. Current fuel supplies and energy cost have shifted the emphasis to reducing the energy consumption for grain drying while maintaining dryer capacity and grain quality. Since the energy input for drying is relatively large, the recovery and reuse of at least part of the exhaust energy can significantly reduce the total energy consumption in existing drying systems. Unilization of exhaust heat in grain dryer either through direct recycling or by a thermal coupling in heat exchanger have been subject of a number of investigators. However, very seldom research in Korea has been done in this area. Three drying tests(non-recycling, 0.22 recycle ratio, and 0.76 recycle ratio)were performed to investigate the thermal efficiency and heat loss factors of continuous flow type dryer, and to analyze the effect of recycle ratio (weight of exhaust air recycled/total weight of input air) on the energy requriements for rough rice drying. The test results showed that when the exhaust air was not recycled, the energy lost from furnace was 15.3 percent of input fuel energy, and latent and sensible heat of exhaust air were 61.4 percent and 11.2 percent respectively. The heat which was required in raising grain temperature and stored in dryer was relatively small. As the recycle ratio of exhaust air was increased, the drying rate was suddenly decreased, and thermal efficiency of the kerosene burner was also decreased. Drying test with 0.76 recycle ratio resulted in 12.4% increase in fuel consumption, and 38.4% increase in electric power consumption as compared to the non-recycled drying test. Drying test of 0.22 recycle ratio resulted in 6.8% saving in total energy consumption, 8.0% reduction in fuel consumption, and 2.5% increase in electric power consumption as compared to the non-recycled drying test.

• 노동경제논집
• /
• 제38권1호
• /
• pp.1-30
• /
• 2015

한국의 구인 구직 매칭함수를 추정하였다. "사업체노동력조사"와 워크넷의 빈 일자리 수 과소 측정 문제를 극복하기 위해 채용동학모형을 통해 빈 일자리 잠재변수를 도출하고 이를 위한 도구변수를 매칭함수 추정에 활용하였다. 매칭 효율에 영향을 주는 구직자 속성과 공공고용서비스의 효과도 검증하였다. 구인 구직 매칭함수의 규모에 대한 수익불변(constant returns to scale)을 확인하였고, 매칭 효율은 구직자 중 전문대졸 학력자 비중과 정(+)의 상관관계를, 실업급여 수혜 비율과는 부(-)의 관계를 보였다.

• 한국환경과학회지
• /
• 제6권6호
• /
• pp.579-588
• /
• 1997

In order to see the stratification related to the heat flux In Deukryang Bay, the oceanographic data on July 12, 1994 and the meteorological data of Kohung and Kwangju meteorological stations were analysed. The temperature durerences between the sea surface and the near bottom were 1~3 ton spring tide (July 12, 1994) In Deukryang Bay. The temperature anomalies were high about 3t during summer In 1994. These mean that the non mixing was not effective In destroying the stratification due to the sea surface heating by the solar radition, even though it was on spring tide. The maximum solar radiation was about 600 ly/day, which was the value of the same date of oceanographic observation. The sensible and the latent heat flux which are 0~100 ly/day were not so varied during summer. The absorbed heat flux through the sea surface was mostly lost by the back radiation. which ranges are about 0~-400 ly/day. The dimensionless mixing parameter related to the buoyancy flux was 5~150$\times$$10^{-5}$. The efficiency of tidal mixing to destroy the stratecation was 0.4~0.6%.

• 한국에너지공학회:학술대회논문집
• /
• 한국에너지공학회 2000년도 추계 학술발표회 논문집
• /
• pp.237-242
• /
• 2000

This study was carried out to optimize burner of the condensing gas boiler which can save energy by utilizing the latent heat of combustion gas and reduce pollutants emission. Three reasonable distances between burner and heat exchanger were decided through the experiments of model flat burner. The optimum burner geometry was determined from flame stability, pollutant emission characteristics and applicability to practical boiler system. The boiler designed by this research reaches turn-down ratio 5:1 in the domain of equivalence ratio 0.68∼0.85 and thermal efficiency of 98%. Emission of NOx and CO concentration was under 35ppm and 104ppm.

• 수산해양기술연구
• /
• 제36권3호
• /
• pp.249-256
• /
• 2000

In order to investigate the effectiveness of methanol, which has high latent heat of evaporation and oxygen contents, for DI diesel engine performance and exhaust emission, the methanol was injected at the suction port of DI diesel engine. The injector used for test was conventional gasoline engine injector and controlled the quantity of methanol per cycle by the power supply controller which designed specially for injector. The results shown that the maximum pressure point was delayed, the value of maximum pressure was decreased, and the concentrations of both NOx and Soot were decreased, as the methanol injection quantity increased, and also the thermal efficiency of engine injected methanol under the high load condition was similar to no methanol injection but under the medium load condition was decreased within the experimental conditions.

• 기술혁신학회지
• /
• 제6권1호
• /
• pp.74-91
• /
• 2003

Science and Technology University(STU) will be established by twenty-two government institutes next year. STU has latent problems with geographical limitations caused by organizing the faculties and facilities of the government research institutes, which are located all over the country. This study tries to examine the Educational Administration(Opreation) Model of STU and analyse expected problems and further, proposes the introduction of cyber education system which will maximize efficiency of educational operation of the system and enhance learning. It also discusses the practical problems in the implementation of cyber education system.

• Journal of Mechanical Science and Technology
• /
• 제15권6호
• /
• pp.796-803
• /
• 2001

Numerical solutions for the convection-dominated melting in a rectangular cavity are presented. The enthalpy-porosity model is employed as the mathematical model. This model is applied in conjunction with the EIT method to detect boundary movement in a phase changing environment. The absorption and evolution of latent heat during the phase change is dealt with by the enthalpy-based energy equation. This seems to be more efficient than resolving the temperature-based energy equation. The velocity switch-off, which is required when solid changes into liquid, is modeled by the porous medium assumption. For efficiency and simplicity of the solutions procedure, this paper proposes a simple algorithm, which iterates the temperature and the liquid fraction of the cells comprising the front layer. The numerical results agree reasonably well with the experimental data and other previous works using the transformed-grid system.

• 설비공학논문집
• /
• 제28권4호
• /
• pp.165-170
• /
• 2016

Long-term performance of the enthalpy exchange element is a topic of current interest due to the concern of possible performance degradation over time. In this study, a 350 CMH enthalpy recovery ventilator equipped with an enthalpy exchange element was installed in an office room, and the performance has been traced over the past 5 years. The appearance, overall dimension, thermal performance, leakage ratio and anti-bacterial performance were checked annually. Results showed that the change in thermal performance (sensible, latent and enthalpy efficiency) was negligible with periodic cleaning with an air gun. However, the leakage ratio increased with time, measuring 7.3% after 5 years. Anti-bacterial test revealed that no bacteria were found during the test period. The largest change in the dimension occurred at the middle location of the element, although the change was less than 2% of the initial value.

• 한국산업융합학회 논문집
• /
• 제12권3호
• /
• pp.163-169
• /
• 2009

A preheating module for domestic heating facility will increase a energy efficiency. That collects the wasted heat of exhaust gas and saves the energy. So a heating load is decreased because of a preheating that has a heating energy. Using of a preheating module, a boiler can reduce frequent operation of a burner. So it is increased persistence, decreased discharging noxious gases. Therefore we will intend to develop a heating facility that is a convenient system for the saving energy.