• 약학회지
• /
• 제30권6호
• /
• pp.352-355
• /
• 1986

Methyl-6-deoxy-$\beta$-L-idopyranoside was prepared in good yield by treatment of methyl 2,3,4-tri-O-benzyl-6-deoxy-$\alpha$-D-xylo-hex-5-enopyranoside with H$_2$ on pd, followed by reaction of Na/NH$_3$ at $-50^{\circ}C$. The ratio of L-idopyranoside and D-glucopyranoside was 7 to 1 in 80.7%. It was confirmed that L-idopyranoside was 1C conformation as being expected.

• KSTLE International Journal
• /
• 제1권2호
• /
• pp.107-112
• /
• 2000

In case of the limitation of Deep RIE fabrication far Micro Gas Turbine, bearing aspect ratio is limited in very small value. The characteristics such as pressure distribution, load capacity and non-linearity of a short bearing of L/D=0.083 and a conventional bearing of L/D=1.0 with coupled boundary effects are investigated for Micro Gas Turbine bearings. The coupled effect was analyzed by mass conservation at coupled end area. The results, increasing load capacity and non-linearity due to the coupled effect of thrust and journal bearing, are obtained and the selection of journal bearing type is discussed.

• 한국지반공학회:학술대회논문집
• /
• 한국지반공학회 2006년도 춘계 학술발표회 논문집
• /
• pp.1187-1194
• /
• 2006

This study analyzed characteristics of soft ground consolidation according to depths of vertical drain. As the result, when the depth ratio of vertical drains (L/D) were 0.5, 0.7, and 1.0, consolidation characteristics were similar up to 70% in consolidation degree under one-dimensional drain condition. However, above this degree, consolidation speed became slower as L/D became smaller. Two-dimensional drain condition also showed a similar tendency, but when L/D was 1.0, the consolidation speed was relatively higher.

• 한국윤활학회:학술대회논문집
• /
• 한국윤활학회 2000년도 제32회 추계학술대회 정기총회
• /
• pp.243-249
• /
• 2000

In case of the limitation of Deep RIE fabrication for Micro Gas Turbine, bearing aspect ratio is limited in very small value. The characteristics such as pressure distribution load capacity and non-linearity of a short bearing of L/D=0.083 and a conventional bearing of L/D=1.0 with coupled boundary effects are investigated far Micro Gas Tlubine bearings. The coupled efffect was analyzed by mass conservation at coupled end area. The results, increasing load capacity and non-linearity due to the coupled effect of thrust and journal bearing, are obtained and the selection of journal bearing type is discussed.

• 대한기계학회논문집
• /
• 제14권6호
• /
• pp.1603-1612
• /
• 1990

본 연구에서는 5개의 원관으로 이루어진 일행관군에서의 원관 주위의 유동특 성의 해명과 유동장이 열전달에 미치는 영향등을 보다 상세히 밝히는데 목적이 있으며, 이를위해 원관의 표면압력, 관 주위의 유동장의 평균속도 및 난류강도, 관의 표면온도 등을 측정하였다.

• 경영과학
• /
• 제16권1호
• /
• pp.63-74
• /
• 1999

This paper presents a R&D investment model for the Information and telecommunications(l&T) technology using multiple objective linear programming(MOLP). The MOLP model involves the simultaneous maximization of three linear objective functions associated with three criteria, which are social, technological, and economic criterion. This model is different from the traditional one which only involves the maximization of economic criterion. It yields a suitable R&D investment ratio to each technology field. Its application to the National R&D Project in l&t Industry is also presented. In this application, the Analytic Hierarchy Process(AHP) is proposed to estimate the weights, which used as the coefficients in each objective function of the MOLP model. Then the problem is solved using the interactive method STEM. It is showed that with the aid of STEM, the MOLP model can be useful decision aid in formulation R&D investment plan in l&t industry. It is expected that the MOLP model works as the basis for planning R&D investment strategy in l&T industry.

• 해양환경안전학회지
• /
• 제27권1호
• /
• pp.67-73
• /
• 2021

본 연구는 충돌 사고 중에서 정박지에서 대기하고 있는 선박과 이 정박지를 통항하는 선박 간 충돌사고가 자주 발생함에 따라, 정박선 사이를 통항하는 선박의 충돌위험을 예측할 수 있는 모델을 개발하기 위한 기초 연구로 통항 선박의 안전 영역을 도출하는 것이 목적이다. 이를 위해 우리나라 최대 항만인 부산항 남외항 정박지를 대상 해역으로 선정하고 정박선이 가장 많이 대기한 기간 VTS(Vessel Traffic Service) 항적 자료를 추출하여 분석하였다. 정박선 사이를 통항하는 선박의 길이(L)를 기준으로 정박선과 어느 정도의 안전한 거리(D)를 두고 통과하는지를 알기 위하여 통항 선박의 방위별 D/L 비를 구하였다. D/L 비 분포의 평균 domain을 기준으로 기존 선박 domain 범위 안으로 정박선이 존재할 비율을 분석하여 VTS 관제사의 위험 정도를 반영한 domain을 도출하였다. 추후 연구로는 정박선 사이의 최소 안전거리인 Domain-watch와 정박지 통항 선박의 안전 domain을 활용한 정박지 통항 선박의 충돌위험도 평가 및 분석을 하고, 이를 통해 VTS가 정박지를 좀 더 효율적이고 안전하게 관리하기 위한 모델을 개발하고자 한다.

• 대한기계학회논문집B
• /
• 제23권6호
• /
• pp.761-768
• /
• 1999

This paper is studied to find the optimum condition of double-inlet Sirocco fan installed in an indoor PAC for low noise operation by the Taguchi method. The goal of this study is to obtain the best combination of each control factor which results in a desired flowrate of Sirocco fan with minimum variability. In this study, the parameter design of the Taguchi method is adopted for robust design by the dynamic characteristic analysis using orthogonal arrays and S/N ratios. The flowrate measurements are conducted by using a multiple-nozzle-type fan tester according to the orthogonal array L9($3^4$). The results of this study can be summarized as follows ; (i) The optimum condition of control factor is a set of where A is an inner to outer diameter ratio($D_1/D_2$), B is a width to outer diameter ratio($L/D_2$), C is a blade attachment angle(${\theta}$) and D is a number of blade(Z), (ii) The flowrate under the optimum condition satisfies the equation $y=0.0384{\cdot}M$ where M is a signal factor, namely number of revolution. The flowrate performance improves about 7.3% more largely as compared with the current condition, which results in about 35RPM reduction of number of revolution for the target flowrate $18.5m^3/min$, and (iii) The sensitivity analysis shows that the major factors in contribution to flowrate performance are A, B, and D ; the percentage contributions of each control factor are 44.01%(Z), 26.77%($D_1/D_2$) and 20.42%($L/D_2$).

• 한국연초학회지
• /
• 제26권2호
• /
• pp.73-78
• /
• 2004

This study was conducted to find out the relationship among agronomic characteristics including midrib ratio in Burley tobacco(N.tabacum L.) Four cultrivars, Burley 21, KB108, KB111 and KB301, were grown at Suwon Experimental Station in 2001. Several agronomic characteristics of these cultivars were measured for the analysis of correlations among agronomic characteristics. Midrib ratio of KB301 was somewhat higher than those of the other cultivars, but there is no significant differences among cultivars at $5\%$ probability level. Among four stalk positions, midrib ratio of cutters was the highest. Midrib ratio was correlated positively with length of leaf at $1\%$ level and negatively with weight of lamina at $5\%$ level, respectively.

• ETRI Journal
• /
• 제36권3호
• /
• pp.510-513
• /
• 2014

A Q-band pHEMT image-rejection low-noise amplifier (IR-LNA) is presented using inter-stage tunable resonators. The inter-stage L-C resonators can maximize an image rejection by functioning as inter-stage matching circuits at an operating frequency ($F_{OP}$) and short circuits at an image frequency ($F_{IM}$). In addition, it also brings more wideband image rejection than conventional notch filters. Moreover, tunable varactors in L-C resonators not only compensate for the mismatch of an image frequency induced by the process variation or model error but can also change the image frequency according to a required RF frequency. The implemented pHEMT IR-LNA shows 54.3 dB maximum image rejection ratio (IRR). By changing the varactor bias, the image frequency shifts from 27 GHz to 37 GHz with over 40 dB IRR, a 19.1 dB to 17.6 dB peak gain, and 3.2 dB to 4.3 dB noise figure. To the best of the authors' knowledge, it shows the highest IRR and $F_{IM}/F_{OP}$ of the reported millimeter/quasi-millimeter wave IR-LNAs.