• Progress in Superconductivity
• /
• v.9 no.1
• /
• pp.80-84
• /
• 2007

Charcoal was used as a carbon source for improving the critical current density of $MgB_2$ and the effect of annealing temperature on the $J_c$ of $MgB_2$ was investigated. The charcoal powder used in this study was $1{\sim}2$ microns in size and was prepared by wet attrition milling. $MgB_2$ bulk samples with a nominal composition of $Mg(B_{0.95}C_{0.05})_2$ were prepared by in situ process of Mg and B powders. The powder mixture was uniaxially compacted into pellets and heat treated at temperatures of $650^{\circ}C\;-\;1000^{\circ}C$ for 30 minutes in flowing Ar gas. It was found that superconducting transition temperature of $Mg(B_{0.95}C_{0.05})_2$ decreased by charcoal additions which indicates the carbon substitution for boron site. $J_c$ of $Mg(B_{0.95}C_{0.05})_2$ was lower than that of the undoped $MgB_2$ at the magnetic fields smaller than 4 Tesla, while it was higher than that of the undoped sample especially at the magnetic field higher than 4 T. High temperature annealing seems to be effective in increasing $J_c$ due to the enhanced carbon diffusion into boron sites.

• Journal of Environmental Health Sciences
• /
• v.37 no.1
• /
• pp.50-56
• /
• 2011

The adsorption capacity of charcoal is a function of the airborne concentration of the target chemical. To evaluate the adsorption capacity of charcoal packed in the cartridges of air purifying respirators, breakthrough tests were conducted with carbon tetrachloride for three commercial cartridges (3M models #7251, #6000 and AX) at 25, 50, 100, 250 and 500 ppm. Adsorption capacities were calculated using a mass transfer balance equation derived from the curve fitting to the breakthrough curves obtained experimentally. Carbon micropore volumes were estimated by iteration to fit the Dubinin/Radushkevich (D/R) adsorption isotherm. They were 0.6566, 0.5727 and 0.3087 g/cc for #7251, #6000 and the AX cartridge, respectively. Above 100 ppm (at high challenge concentrations), #7251 and #6000 showed higher adsorption capacities. However, as the challenge concentration decreased, the adsorption capacities of #7251 and #6000 sharply dropped. On the other hand, the adsorption capacity of the AX cartridge showed little change with the decrease of the challenge concentration. Thus, the AX showed a higher adsorption capacity than #7251 and #6000 at the 5-50 ppm level. It is concluded that service-life tests of cartridges and adsorption capacity tests of charcoal should be conducted at challenge concentration levels reflecting actual working environmental conditions. Alternatively, it is recommended to use the D/R adsorption isotherm to extrapolate adsorption capacity at low concentration levels from the high concentration levels at which breakthrough tests are conducted, at a minimum of two different concentration levels.

• Journal of Plant Biotechnology
• /
• v.29 no.4
• /
• pp.253-257
• /
• 2002

To establish the optimum condition for plant regeneration from somatic embryos of Acanthopanax sessiliflorus Rupr. et Maxim, a medicinal plant, somatic embryos were induced from zygotic embryo-derived embryogenic callus in hormoen-free MS medium. To induce plantlet conversion, cotyledonary somatic embryos were cultured on MS solid medium with GA$_3$at various concentrations (0~10 mg/L) for three weeks. Plantlets were transferred to 1/3 MS solid medium with 0.5% charcoal for 7 weeks. Stem length was increased proportionally to the concentration and treatment period of GA$_3$. Also, the highest leaf width (8.9 mm) and leaf number (2.84) of plantlet were obtained when plantlets were converted on 5,10 mg/L GA$_3$pretreatments, respectively. The highest plant conversion frequency (66.7%) was obtained when the somatic embryos were cultured on medium containing 5 mg/L GA$_3$ for 3 weeks and then were transferred to 1/3 MS medium with 0.5% charcoal. The highest survival rate of soil transfer was 90% when plantlets were regenerated on medium with 5 mg/L GA$_3$ for 3 weeks and then transferred to plastic pots containing vermiculite and sand mixture for 4 weeks.

• Journal of Gastric Cancer
• /
• v.6 no.4
• /
• pp.291-294
• /
• 2006

F-18 FDG-PET/CT could be used to evaluate the surveillance of recurrent stomach cancer, but some cases reported as false-positives. The authors found an activated charcoal granuloma from intraperitoneal chemotherapy by using a curative resection and mitomycin C for stomach cancer. A mass behind the right colon that showed on CT 6 months after an operation in a 46-year-old male patient had no progression in size, but 36 months after the operation, an increase was seen on F-18 FDG-PET/CT, and a metastatic tumor was suspected. The tumor was resected by an explorative laparotomy and was diagnosed as being an activated charcoal granuloma based on the histologic finding. Based on this case, we should be reminded of the possibility of a false-positive on analysis of F-18 FDG-PET/CT caused by an activated charcoal granuloma in a patient who has intraperitoneal chemotherapy.

• Resources Recycling
• /
• v.9 no.4
• /
• pp.44-49
• /
• 2000

Among dusts which were generated in AOD process producing a medium-low carbon ferromanganese, the dust collected in bag filter contained manganese about 63% and its phase was $Mn_3$$O_4$. the maximum extraction of Mn by nitric acid is about 67% because of remaining amorphous $MnO_2$. Therefore this research investigated reducibility of the activated charcoal in Mn extraction from the dust. Addition of charcoal over 10% of pulp density made possible Mn extraction of 90% at $70^{\circ}C$, 0.5N $HNO_3$. To convert $Mn_3$$O_4$ to MnO by reducing roasting, the minimum mixture ratio of activated charcoal was 5% in $750^{\circ}C$, 1 hour. Extraction of Mn from the reduced dust was over 99% with nitric acid at $25^{\circ}C$, 6N $HNO_3$, pulp density 150 g/l§.

• Journal of radiological science and technology
• /
• v.29 no.2
• /
• pp.53-56
• /
• 2006

The purpose of the present study is to find ways to reduce the quantity of indoor radon contamination. The study was done from July, 2005 until December, 2005. It was found out that the easiest and most effective way to do that is to open the windows as often as possible and let the indoor air flow outside. When it is not possible to ventilate a room, the indoor radon contamination quantity can reduced by providing activated charcoal in the room. It has been proved that activated charcoal can absorb the room in the air. We need more activated charcoal in proportion to the size of the room. A further research is needed to investigate the amount of activated charcoal that will work most effectively.

• The Plant Pathology Journal
• /
• v.26 no.4
• /
• pp.372-379
• /
• 2010

Macrophomina phaseolina causing charcoal rot was isolated from sesame seeds (cvs. Giza 32 and Shandawel-3) collected from different localities of Assiut, Sohage and El-Minia Governorates. The fungus was found in the highest frequently in samples collected from Assiut Governorate followed by Sohag and finally EL Minia Governorate. The obtained isolates were different in their virulence on the tested sesame cvs. Also, they differed in their growth nature including colony color and sclerotial production. The color of colonies of the pathogen seem to be correlated with density of sclerotial formation. Aqueous extracts of Majorna, Wild chamomile, Geranium oil and Nees plants were highly toxic to tested isolates of M. phaseolina, in vitro. On the other hand the rest of the tested aqueous extracts had no effect. Under greenhouse conditions in 2005 and 2006 seasons, soaking seeds of sesame before sowing in aqueous extracts of Eucalyptus, Nerium, Ocimum and Roesmary plants decreased the disease incidence. Aqueous extracts of Eucalyptus and Ocimum were the most effective treatment. Dipping sesame seeds in hot water at $60^{\circ}C$ for 5 minutes increased seed germination of Giza 32 and Shandawel-3 cvs. followed by $55^{\circ}C$, $50^{\circ}C$ and $45^{\circ}C$, while $40^{\circ}C$ treatment resulted the lowest seed germination rate. Dipping sesame seeds in hot water at different temperature before planting decreased seed, seedling and charcoal rots. Soaking seeds in hot water at $60^{\circ}C$ increased greatly plant height and decreased seed, seedling rot and charcoal rot followed by $55^{\circ}C$ and $50^{\circ}C$, under greenhouse condition.

• Research in Plant Disease
• /
• v.28 no.4
• /
• pp.209-220
• /
• 2022

Charcoal canker of oak, which has recently increased in southern Iran, could pose a serious threat to the entire forest ecosystem in the near future. In addition, it seems that climate change and its consequences, such as drought in the southern regions of Iran, have exacerbated this phenomenon. Consequently, the objective of this study was to identify the fungal pathogens that could cause charcoal canker disease in the oak forests of South Zagros. It was also sought to find associations between changes in the occurrence/exacerbation of charcoal canker disease under non and intense drought stress in non-inoculated or inoculated Quercus brantii seedlings. In total, 120 isolates were obtained from eight oak forests located in the Zagros Mountains of Southern Iran, Kohgiluyeh & Boyer-Ahmad and Fars provinces, which were classified as Biscogniauxia mediterranea based on morphological assessment. Subsequently, molecular assay confirmed the result by phylogenetic inference of internal transcribed spacer-rDNA regions, α-actin, and β-tubulin genes. The results of the pathogenicity test showed that the response of isolates of B. mediterranea (Iran-G1 and Iran-M70) was varied in different environments for the measured necrotic lesion length. In comparison with the control moisture treatments (non-stress), the necrotic lesion length in inoculated treatments increased under intense drought stress. In general, inoculated oak seedlings' exposure to water-deficient stress by the pathogen of B. mediterranea could affect the spread/severity of the charcoal canker disease.

• Journal of Korean Society of Occupational and Environmental Hygiene
• /
• v.4 no.2
• /
• pp.127-136
• /
• 1994

Diffusional sampling devices offer many advantages for measuring concentration levels of industrial contaminants than the conventional pump and charcoal tubes because they are lightweight, require no power, pump or tubing. This study designed to evaluate and compare the sampling performance of passive sampler to charcoal tube from mixed organic solvent workplace with 181 organic solvent using workers working in different concentration of organic solvents. All study workers kept both devices in their breathing zone simultaneuosly in the workplaces, and the sampling analytical results were compared with those of charcoal tube. The results obtained are as follows: 1. The concentrations of toluene and xylene measured by passive sampler were slightly higher than those of charcoal tube, but there were no significant statistical differences between two methods. 2. The concentrations of MEK and cyclo-hexanone measured by passive sampler in low exposure workplace (below 0.20 of MEK TLV levels and 0.1 of cyclo-hexanone TLV levels) were about 2 times higher than that of charcoal tube sampling. While, absorption efficiency of passive sampler was reduced according to increasing concentration measurements of MEK and cyclo-hexanone in air. 3. The ratios of concentrations of toluene, xylene, MEK and cyc1o-hexanone measured by passive sampler over those measured by charcoal tube were 1.11, 1.07, 1.63 and 3.65 respectively. 4. The percentages of concentration of passive samplers within 0.75 and 1.25 of charcoal tube value as a reference value of 1.0 were 57% in toluene, 74% in xylene, 34% in MEK and 32% in cyclo-hexanone respectively. 5. The correlation coefficients of toluene, xylene, MEK and cyclo-hexanone between passive sampler and charcoal tube sampler were 0.963, 0.957, 0.943 and 0.562 with statistical significance.

• Nuclear Engineering and Technology
• /
• v.16 no.2
• /
• pp.80-88
• /
• 1984

The removal mechanism of air borne methyl iodide by triethylenediamine (TEDA) impregnated charcoal bed was investigated. The analysis of experimental data indicates that pore diffusion is the rate controlling step when the air velocity is over 20cm/sec, and both fore diffusion resistance and external mass transfer resistance are contributed to the overall resistance when the air velocity is 10cm/sec. The adsorption model to describe the performance of impregnated charcoal bed under dry condition where water vapors do not exist in air, is proposed. The calculated values and experimental results are well matched.