• Proceedings of the Korean Geotechical Society Conference
• /
• 2009.03a
• /
• pp.805-812
• /
• 2009

Permeation water resulting in the reclaimed land of waste can possibly cause the second pollution, such as the underground water and environmental pollution. Accordingly, Liner layer has been installed in the reclaimed land of waste to block and purify permeation water and prevent this second pollution. The material used as Liner layer is the one for water resistance and that of less than permeability coefficient $1{\times}10^{-7}cm/sec$ is widely used. As it is very difficult to secure in bulk this natural clay with low permeability around the field, the suitable way to secure low permeable material is that we use blend with good watertighness by mixing it with natural soil which is spread in the site. While this mixed soil which can resist water is commonly used in the site, bentonite mixed soil which is widely used as Liner layer in the reclaimed land of waste is recognized in Liner and durability. In this study, the engineering characteristics of soil-bentonite mixed liner are investigated using the laboratory hydraulic conductivity and uni-axial strength tests. The soil used for the liner is the clay soil located near the site. Mixing ratio of the bentonite which satisfies the requirement of hydraulic conductivity is determined and the optimum mixing ratio of bentonite is recommended for the landfill. After the mixed liner is constructed using the optimum mixing ratio of bentonite, the block samples of the constructed liner are obtained and the strength tests were performed. The hydraulic and strength properties of the liner for construction of the waste landfill were both satisfactory.

• Nuclear Engineering and Technology
• /
• v.53 no.5
• /
• pp.1511-1518
• /
• 2021

In most countries, the thermal criteria for the engineered barrier system (EBS) is set to below 100 ℃ due to the possible illitization in the buffer, which will likely be detrimental to the performance and safety of the repository. On the other hand, if the thermal criteria for the EBS increases, the disposal density and the cost-effectiveness for the high-level radioactive wastes will dramatically increase. Thus, fundamentals on the thermal behavior of the buffer under the elevated temperatures is of crucial importance. Yet, the behaviors at the elevated temperatures of the bentonite under groundwater-saturated conditions have not been reported to-date. Here, we have developed an in-situ synchrotron-based method for the thermal behavior study of the buffer under the elevated temperatures (25-250 ℃), investigated dspacings of the montmorillonite in the Korean bentonite (i.e., Ca-type) at dry and KURT (KAERI Underground Research Tunnel) groundwater-saturated conditions (KJ-ii-dry and KJ-ii-wet), and compared the behaviors with that of MX-80 (i.e., Na-type, MX-80-wet). The hydration states analyzed show tri-, bi-, and mono-hydrated at 25, 120, and 250 ℃, respectively for KJ-ii-wet, whereas tri-, mono-, and de-hydrated at 25, 150, and 250 ℃, respectively for MX-80-wet. The Korean bentonite starts losing the interlayered water at lower temperatures; however, holds them better at higher temperatures as compared with MX-80.

• Journal of Nuclear Fuel Cycle and Waste Technology(JNFCWT)
• /
• v.4 no.3
• /
• pp.235-243
• /
• 2006

In this study, an experimental study on the sorption properties of uranium(VI) onto a bentonite colloid generated from Gyeongju bentonite which is a potential buffer material in a high-level radioactive waste repository was performed as a function of the pH and the ionic strength. The bentonite colloid prepared by separating a colloidal fraction was mainly composed of montmorillonite. The concentration and the size fraction of the prepared bentonite colloid measured using a gravitational filtration method was about 5100 ppm and 200-450 nm in diameter, respectively. The amount of uranium removed by the sorption reaction bottle walls, by precipitation, and by ultrafiltration was analyzed by carrying out some blank tests. The removed amount of uranium was found not to be significant except the case of ultrafiltration at 0.001 M $NaClO_4$. The ultrafiltration was significant in the lower ionic strength of 0.001 M $NaClO_4$ due to the cationic sorption onto the ultrafilter by a surface charge reversion. The distribution coefficient $K_d$ (or pseudo-colloid formation constant) of uranium(VI) for the bentonite colloid was about $10^4{\sim}10^7mL/g$ depending upon pH and ionic strength of $NaClO_4$ and the $K_d$ was highest in the neutral pH around 6.5. It is noted that the sorption of uranium(VI) onto the bentonite colloid is closely related with aqueous species of uranium depending upon geochemical parameters such as pH, ionic strength, and carbonate concentration. As a consequence, the bentonite colloids generated from a bentonite buffer can mobilize the uranium(VI) as a colloidal form through geological media due to their high sorption capacity.

• Journal of the Korean Chemical Society
• /
• v.17 no.1
• /
• pp.53-59
• /
• 1973

The adsorptivity of Methylene Blue on Korean Yeongil bentonite which was premixed with a salt of KF or $NH_{4}Cl$ etc., treated at $200-500^{\circ}C$, washed and dried, was studied. In case of treatment with$NH_{4}Cl$, slight improvement of the adsorptivity of methylene blue on the products was observed. With KF, treated at$200-300^{\circ}C$, the best results was obtained. The adsorption capacity of the products was improved about 1.7 times than that of original bentonite. With $FeSO_4$ or $Na_{2}CO_3$ etc. improvement of the adsorption capacity on the products was not observed.

• Journal of the Korean GEO-environmental Society
• /
• v.1 no.1
• /
• pp.65-70
• /
• 2000

Recently, soil-bentonite mixtures are frequently used as impervious liners for waste disposal sites. In the present work, bentonite composite liner systems have been developed by utilizing Korean zeolitic bentonites. The geomechanical properties of the liner systems, such as strength hydraulic conductivity, etc. have also been studied. The laboratory and field test results showed that uniaxial strengths of the system were improved by addition of bentonite and CaO-based additive to the upper and lower layer of the liner systems, respectively. Hydraulic conductivity values measured on field liner systems showed less $1{\times}10^{-3}cm/s$, which is considered to be minimum regulation requirement for waste disposal sites.

• Proceedings of the Korean Society of Soil and Groundwater Environment Conference
• /
• 2001.09a
• /
• pp.228-230
• /
• 2001

지하수 개발·이용을 위한 정호심도는 지속적으로 증가하는 추세이다. 이에 따라 보다 깊은 심도에서 또는 특정한 대수층에서의 대수성시험 및 오염방지를 위한 그라우팅 기술이 필요 하다. 기존의 팩커기술이 이를 기술적으로 만족시키고 있지만, 일반적인 정호에서는 경제성과 공정의 복잡성 때문에 적용이 보편화되어 있지 않다. 그러나 bentonite pellet을 이용하여, 간단하고 경제적으로 이 문제를 해결할 수 있다.

• Journal of Soil and Groundwater Environment
• /
• v.20 no.6
• /
• pp.28-36
• /
• 2015

Simultaneous mobility reduction of explosives and heavy metals in an operational range by monopotassium phosphate (MKP) and bentonite spreading technology was investigated. Potassium ion and phosphate ion in MKP act as explosives sorption enhancer and insoluble heavy metal phosphate formation, respectively, while bentonite acts as the explosives adsorbent. Then, the decrease in surface water concentration of the pollutants and resulting risk reduction for local residents of the operational range, by MKP/bentonite application was estimated. Under untreated scenario, the noncancer hazard index (HI) exceeded unity on February, July and August, mainly due to 2,4,6-trinitrotoluene (TNT); however, MKP/bentonite treatment was expected to lower the noncancer hazard index by decreasing the surface water concentration of explosives and heavy metals (especially TNT). For example, on July, estimated surface water concentration and HI of TNT were 0.01 mg/L and 1.1, respectively, meanwhile the sorption coefficient of TNT was 3.9 mg¹⁻ⁿkg⁻¹Lⁿ. However, by MKP/bentonite treatment, the TNT sorption coefficient increased to 113.8 mg¹⁻ⁿkg⁻¹Lⁿ and the surface water concentration and HI decreased to about 0.002 mg/L and 0.2, respectively. Based on the result, it can be concluded that MKP/bentonite spreading is a benign technology that can mitigate the risk posed by the pollutants migration from operational ranges.

• Environmental Engineering Research
• /
• v.25 no.1
• /
• pp.96-103
• /
• 2020

The aim of this study is to investigate the effect of five different combinations including: sand 70%, bentonite 30% (S₇₀B₃₀)- sand 80%, bentonite 20% (S₈₀B₂₀)- sand 80%, organophilic 20% (S₈₀M₂₀)- sand 60%, bentonite 20%, organophilic 20% (S₆₀B₃₀M₂₀) and sand 75% - bentonite 15% - organophilic 10% (S₇₅B₁₅M₁₀) on landfill linear structure in order to decrease phenol leaching. Hydraulic conductivity and adsorption behavior of the samples were investigated. The results demonstrated that the lowest hydraulic conductivity coefficient ($1.16{\times}10^{-11}{\frac{m}{s}}$) was obtained for S₇₀B₃₀. Furthermore, adding more than 20% of bentonite had no significant effect on reducing permeability. Moreover, Freundlich isotherm was introduced as the best model explaining adsorption behaviour due to its highest determination coefficient (0.945). The best samples for adsorption capacity of phenol and for both permeability and adsorption are S₈₀M₂₀ and S₆₀B₃₀M₂₀, respectively. Although the presence of bentonite was effective in reducing hydraulic conductivity, organic clay had no considerable impact on reducing permeability. Though, it's an exceptional role in adsorbing organic contaminants including phenol cannot be ignored. To meet all regulatory constraints, the optimal compound is made up of 10.2% of bentonite and 2.8% of organophilic clays with a minimized cost of 13.64 ($/ton).

• Journal of Nuclear Fuel Cycle and Waste Technology(JNFCWT)
• /
• v.9 no.4
• /
• pp.199-206
• /
• 2011

The influence of water salinity on the hydraulic conductivities of compacted bentonites with several dry densities were studied. The hydraulic conductivity increases with increasing salinity only when the dry density of bentonite is relatively low. The degree of increase becomes more remarkable at a lower dry density of bentonite. For bentonite with the density of 1.0 $Mg/m^3$ and 1.2 $Mg/m^3$, the hydraulic conductivity of the 0.4 M NaCl solution increases up to about 7 times and 3 times, respectively higher than that of freshwater. However, for the bentonite with a dry density higher than 1.4 $Mg/m^3$, the salinity has an insignificant effect on the hydraulic conductivity, and the hydraulic conductivity is nearly constant within the salinity range of 0.04 to 0.4 M NaCl. The pre-saturation of the bentonite specimen with freshwater has no significant influence on the hydraulic conductivity.

• Korean Journal of Materials Research
• /
• v.20 no.3
• /
• pp.167-173
• /
• 2010

In this study, we used activated carbon (AC) and titanium oxysulfate as a titanium precursor to prepare carbon/titania composites. We then mixed it with bentonite in different ratios to make a carbon/titania/bentonite monolith for use in architecture bricks by using Phenolic rosin (PR) as a bonding agent. The physicochemical properties of the prepared composites were analyzed by BET surface area, scanning electron microscopy (SEM), X-ray diffraction (XRD), energy dispersive X-ray analysis (EDX), self-cleaning effect and bactericidal tests. The BET surface areas increased as the ratio of carbon/titania composites increased. The SEM microscopy showed that the $TiO_2$ and bentonite were coated on the surface of the AC. The XRD patterns showed a mixture structure of anatase and rutile of $TiO_2$ with a clear $SiO_2$ structure. The EDX spectra of the carbon/titania/bentonite monolith confirmed the presence of various elements, namely C, O, Ti and Si, as well as other, impure elements. Moreover, to determine the self-cleaning effect of the carbon/titania/bentonite monolith, we used methylene blue (MB, $C_{16}H_{18}N_3S{\cdot}Cl{\cdot}3H_2O$) in an aqueous solution under the irradiation of visible light. Accordingly, all of the samples had excellent degradation of the MB solution. Furthermore, it was observed that the composites with sunlight irradiation had a greater effect on E. coli than any other experimental conditions.