• Journal of the Korea Organic Resources Recycling Association
• /
• v.25 no.3
• /
• pp.63-71
• /
• 2017

In this study, washing parameters such as washing time, agitation velocity, and cycles were optimized for high surface area of the activated carbon (AC) by KOH activation. Even though AC with high surface area showed at higher washing efficiency, over 90% on washing efficiency was regulated by the intra-particle diffusion due to high tortuosity of the pore structures on AC. In addition, we can obtain $K_2CO_3$ through the evaporation from the wastewater and use it for chemical activation of AC. The AC with $K_2CO_3$ activation has specific surface area values of $2,219m^2/g$ equally that of KOH activation. Considering that $K_2CO_3$ is an effective alternative as a KOH, our results demonstrated that the process by recycling wastewater on AC production could be applicable for near-zero wastes.

• Journal of Yeungnam Medical Science
• /
• v.5 no.2
• /
• pp.53-58
• /
• 1988

KOH examination is a simple, rapid and diagnostic procedure to confirm dermatophytic infections. It is important to select a proper examination site of the lesion. To determinate the proper examination site of the lesion, mycologic studies were done with multiple specimens collected from the center, margin and out of margin of the ring-shaped dermatophytotic skin lesion on the 58 patients. The results were as follows. Positive rate of KOH wet smear was 94.8% at the center and 100% at the margin of the lesions, 22.4% at the 1cm and 5.2% at the 2cm out of the lesions. The more hyphae were found in the lesion, the more hyphae were found out of the lesion. Culture was done on the Sabouraud's glucose agar from the highest KOH positive area and the positive culture was 48 strains(82.8%) of 58 patients. These findings suggested that the ring-shaped active margin was the best site to examine mycologic studies.

• Journal of the Korean Ceramic Society
• /
• v.48 no.1
• /
• pp.99-105
• /
• 2011

Lead titanate ($PbTiO_3$) powder was prepared from lead nitrate ($Pb(NO_3)_2$) and titania ($TiO_2$) by hydrothermal route. Phase formation process was investigated by observing the phases formed in various experimental conditions like different KOH concentration, reaction temperature and time. $PbTiO_3$ powder was fabricated when the KOH concentration was 0.8M or higher. An intermediate compound, $PbTi_{0.8}O_{2.6}$, was formed at first by a reaction between PbO and $TiO_2$ and changed into $PbTiO_3$ powder with a perovskite crystal structure. A $PbTiO_3$ phase was formed in a shorter time when a KOH concentration was increased from 0.8M to 8M because a driving force for a $PbTiO_3$ formation was increased due to an increase in a degree of supersaturation. And $TiO_2$ (rutile) and $3PbO{\cdot}H_2O$ were observed at room temperature in a 0.8M KOH solution and $TiO_2$(rutile) and PbO (litharge) in a 8M KOH. A $PbTiO_3$phase was also formed in a shorter time at a higher reaction temperature as a reaction temperature influenced the rates for a dissolution and a precipitation.

• Journal of the Semiconductor & Display Technology
• /
• v.2 no.4
• /
• pp.37-40
• /
• 2003

We have studied micro-machining technologies to fabricate parts and sensors used in the semiconductor equipment. The studies were based on the silicon integrated circuit processes, and composed of the anisotropic etching of single crystal silicon to fabricate a membrane structure for hot and cold junctions in the infrared absorber. KOH and TMAH were used as etching solutions for the anisotropic wet etching for membrane structure formation. The etching characteristic was observed for the each solution, and etching rate was measured depending upon the temperature and concentration of the etching solution. The different characteristics were observed according to pattern directions and etchant concentration. The pattern was made to incline $45^{\circ}$ on the primary flat, and optimum etching property was obtained in the case of 30 wt% and $90^{\circ}C$ of KOH etching solution for the formation of the membrane structure.

• Journal of the Korean Applied Science and Technology
• /
• v.31 no.3
• /
• pp.408-415
• /
• 2014

In order to prepare high-quality activated carbons (ACs), coal tar pitch (CTP), and mixtures of CTP and petroleum pitch (PP) were activated with KOH. The ACs prepared by activation of CTP in the range of $700{\sim}1000^{\circ}C$ for 1~5 h had very porous textures with large specific surface areas of $2470{\sim}3081m^2/g$. The optimal activation conditions of CTP were determined as CTP/KOH ratio of 1:4, activation temperature of $900^{\circ}C$, and activation time of 3 h. The obtained AC showed the highest micro-pore volume, and pretty high specific surface area and meso-pore volume. The micro-pore volumes and specific areas of activated mixtures of CTP and PP were similar to each other but the meso-pore volume could be increased. In order to change the degree of crystallinity of precursors before KOH activation process, the CTPs were carbonized in the range of $500{\sim}900^{\circ}C$. As the carbonization temperature increased, the specific surface area and pore volume of the activated ACs with the same activation conditions for CTP decreased dramatically. It was demonstrated that the increased pore size distribution of AC electrodes in the range of 1 to 2 nm plays an important role in the performance of electric double-layer capacitor.

• Clean Technology
• /
• v.15 no.1
• /
• pp.31-37
• /
• 2009

This study deals with the production process of activated carbons from the sewage sludge char by chemical activation reaction. KOH and NaOH were used as activating agents, which react well with carbon. From the experiments, it was found that activated carbons made with KOH treatment had better physicochemical properties in terms of iodine number and BET value than those made with NaOH treatment. It was also found that the optimal deposition ratio of an activating agent to the sewage sludge char was 75 wt% of KOH and 50 wt% of NaOH. Activated carbons were washed out by distilled water after neutralization with 5 M hydrochloric acid solution. The activated carbons that were produced from a sewage sludge char at this optimal conditions have BET surface areas of approximately $600m^2/g$.

• Journal of the Korean Crystal Growth and Crystal Technology
• /
• v.4 no.3
• /
• pp.223-229
• /
• 1994

$KTP(KTiOPO_4)$ single crystals have been hydrothermally grown in KOH solutions. Properties and Raman spectra of grown crystal were investigated. The most effective solvents for the crystal growth of KTP were KOH and KF solutions. In this study, the properties of KTP single crystals grown hydrothermally at $500^{\circ}C$ in 9 m KOH solution were measured. The following results were obtained : lattice parameters ; a=1.281 nm and c=1.058 nm, density ; $2.94 g/cm^3$, Vickers hardness ; $562kg/cm^2$, refractive indices ; $n_e=1.740$ and $n_e= 1.747.$ And Raman spectra of hydrothermal growth KTP single crystal have been investigated at room temperature under atmospheric pressure. As a result, the $A_1$ modes agree very well with KTP single crystal of high temperatures solution growth but the behavior of $B_2$ modes were slightly different.

• Journal of the Korean Recycled Construction Resources Institute
• /
• v.11 no.4
• /
• pp.391-399
• /
• 2023

Recently, low-temperature pyrolysis technology has been studied as a recycling method for waste plastic. Low-temperature pyrolysis technology for waste plastic produces pyrolysis oil that can be used as an energy resource, but solid residue remains. Waste plastic pyrolysis residues are mostly landfilled due to their limited use. In this study, it is investigated that mixed waste plastic pyrolysis residues could be recycled into activated carbon. It was confirmed that the fixed carbon content of the residue was 33.69 % from proximate Analysis. Chemical activation was used to manufacture activated carbon. KOH was used as an activator. To investigate the effect of the mixing ratio of KOH and residue, samples were mixed at ratios of 0.5, 1.0, and 2.0. The mixed sample was chemically activated at an activation temperature of 800 ℃ for 1 hour. As a result of analyzing the characteristics of activated carbon through BET, it was confirmed that the specific surface area increased as the mixing ratio of KOH increased.

• Resources Recycling
• /
• v.17 no.6
• /
• pp.68-78
• /
• 2008

Using a Pinus koraiensis and Pinus rigida which are normally being discarded in South Korea, optimal conditions of producing activated carbons have been studied to recycle as a higher value-added product. This study consists of two processes, the production process of charcoals from waste timbers by low temperature pyrolysis and the production process of activated carbons from the charcoals by chemical activation reaction. This paper deals with the production process of activated carbons from the charcoals by chemical activation reaction. As an alkali has been generally used as an activating agent, KOH and NaOH which react well with a carbon were used in this study. As a result of the experiments, it is confirmed that activated carbons made with KOH treatment had superior values in physicochemical properties to NaOH, showing that there was no remain of KOH at the surface of the charcoals while there was $3{\sim}4%$ of NaOH remaining after the experiments. Thus, it is concluded that KOH reacted more actively with a charcoal than NaOH. Moreover, it was also found that values in physicochemical properties when using a Pinus koraiensis are superior to the ones when using a Pinus rigida. The optimal mixing ratio of an activating agent to a charcoal was 400 wt.%. To improve the physicochemical properties, activated carbons were washed out by distilled water after neutralization with SM hydrochloric acid solution. When activated carbons were produced from a Pinus koraiensis in this optimal conditions, value of BET surface area was found to be approx. $2400\;m^2/g$.

• Applied Chemistry for Engineering
• /
• v.8 no.4
• /
• pp.602-609
• /
• 1997

The seed formation and growth of $\alpha$-ferric oxyhydroxide with aerial oxidative precipitation from aqueous solution of ferrous sulfate with KOH, NaOH, $Na_2CO_3$ and $K_2CO_3$ as precipitants have been studied by free pH drift experiment. It has been shown that all precipitants give same particle formation and growth path, and average particle length from KOH and NaOH as precipitants was about 1.5 times shorter than that of $K_2CO_3$ and $Na_2CO_3$. When initial mole ratio, $R_o=[Fe^{2+}]_o/[OH^-]_o$ of KOH was decreased the particle was grown oxyhydroxide seed growth from aqueous solution of ferrous sulfate with KOH has been studied. The influence of the air flow rate, reaction temperature and initial mole ratio, $R_o=[Fe^{2+}]_o/[OH^-]_o$, on the kinetics of seed growth are investigated by static pH experiment. The oxidation rate of seed growth increased with increase in the air low rate, reaction temperature and initial mole patio. The activation energy of seed growth is 16.16 KJ/mol and the rate equation of seed growth can be written as follows: $-\frac{d[Fe^{2+}]}{dt}=1.46{\times}10^4[P_{o2}]^{0.66}[OH^-]^{2.19}exp(-\frac{16.16}{dt})$.