• Korean Journal of Applied Biomechanics
• /
• v.17 no.1
• /
• pp.69-79
• /
• 2007

The purpose of this study was to examine the characteristics of throwing motion in the elementary school students from the developmental point of view. For the purpose of this, total of nine subjects(each of three students in five, third, and first grades) were participated. They were asked to throw the ball as far as they can and the motions were videotaped with the 30frames/sec and 1/500 shutter speed. The successful motions for each subject were selected for three dimensional analysis. The collected data were analyzed using DV express 1.0 and Kwon3D 3.0 softwares. The results obtained from this study were as follows; 1. Total time for the throwing motion of the first grade was longer than that of the fifth and third grades. 2. The resultant displacement and velocity of COM for the fifth and third grades were greater than that of the frist grade. 3. The first grade tended to flex the trunk forward excessively during the throwing motion. 4. The fifth grade tended to place the upper arm close to the sagital plane and move the forearm and hand freely. 5. Looking at the greater variability of the angular velocity of the hand segment, the fifth grade seemed to have faster and more flexible movement of the wrist. 6. There were somewhat differences in the patterns and magnitudes of ground reaction forces among the different grades.

• Korean Journal of Applied Biomechanics
• /
• v.17 no.1
• /
• pp.129-134
• /
• 2007

The purpose of this study was to determine the variability of components of the vertical ground reaction force signal to seek the suitable number of attempt datum to be analyzed during running at 2m/s and 4m/s. For this study, six subjects (height mean:$174.5{\pm}4.4cm$, weight $671.5{\pm}116.4N.$, age:$25.0{\pm}yrs.$) were selected and asked to run at least 3 times each run condition randomly. FFT(fast Fourier transform) was used to analyze the frequency domain analysis of the vertical ground reaction forces signal and an accumulated PSD (power spectrum density) was calculated to reconstruct the certain signal. To examine the deviation of the vertical ground reaction between signals collected from an different number of attempt, variability of frequency, magnitude of passive peak, time up to the passive peak and maximum load rate were determined in a coefficient of variance. The variability analysis revealed that when analyze the vertical reaction force components at 2m/s speed running, which belongs to slow pace relatively, it would be good to calculate these components from signal of one attempt, but 4m/s speed running needs data collected from two attempts to decrease the deviation of signal between attempts. In summary, when analyzing the frequency and passive peak of the vertical reaction force signal during the fast run, it should be considered the number of attempt.

• Korean Journal of Applied Biomechanics
• /
• v.23 no.1
• /
• pp.77-83
• /
• 2013

The purpose of this study was to compare kinematic variables and stiffnesses of ankle joints between normal person and transfemoral amputee gait in order to develop or fit prosthetic leg. Twenty subjects (ten normal persons and ten transfemoral amputees) participated in this experiment, and walked three trials at a self-selected pace. The gait motions were captured with Vicon system and variables were calculated with Visual-3D. The velocity, stride length, stride width, cycle time, double limb support time and right swing time of gaits were statistically significant. Because coefficients of variability of normal persons on velocity, double limb support time and swing time were greater than transfemoral amputees, normal persons controlled these gait variables effectively. The stiffnesses of ankle joints were not statistically significant, but patterns of stiffnesses of ankle joints during three rockers were absolutely different. The negative correlations between stiffnesses of ankle joints and cycle time and swing time were presented. These differences suggest that developing and fitting prosthetic leg were demanded. Further studies should develop fitting program and simulator of prosthetic leg.

• Korean Journal of Applied Biomechanics
• /
• v.23 no.1
• /
• pp.19-24
• /
• 2013

The aim of the study was a quantitative analysis of elite athlete's $540^{\circ}$ Dwihuryeochagi and effects of ground movements to the jumping height and kicking velocity. Eleven elite players(Taekwondo demonstration team) participated in this study. In order to get the kinetic and kinematic variables, ten Vicon cameras and a force plate were used. Foot segment velocity(FSV), vertical ground reaction force(GRF), impulse, ground time(GT) in phase 1, trunk angular velocity(TAV), vertical center of gravity(COG), flight time(FT) in phase 2 and kicking leg segment velocity(KSV) in phase 3 were measured and analyzed. Results indicated that there were similar patterns of variables among phases between subjects. Non-significant correlation(r=.145) between flight time(FT) and impulse was found. Also non-significant correlation(r=.119) between center of gravity(COG) and impulse was found. In conclusions, there were similar strategies in phase 1, phase 2, and phase 3 between subjects.

• Korean Journal of Applied Biomechanics
• /
• v.23 no.1
• /
• pp.1-9
• /
• 2013

The purpose of this study was to provide information on athletes' characteristics and advantages and disadvantages by analyzing the kinematic factors having a decisive influence on competitive abilities such as release conditions in the delivery phase on major Korean javelin athletes. Two supported javelin throwers of the Korean national team participated in this study. The total average time required of the delivery phase was 0.31(${\pm}0.016$). The athletes' release angle was 33.2 to 41.7 degrees. The attack angle varied widely from -3.5 to 5.9 degrees. The Javelin heights of Subject A and B were 95.9 and 89.2%Ht. The average stride length were 180.6 and 176.7cm. The center of mass velocity of LFD and REL was relatively low in all the subjects. The average deceleration rates of center of mass velocity of Subject A and B were 57.2 and 48.9%lose. The left knee angles of Subject A and B were 160.1 and 155.5 degrees in LFD, 153.0 and 164.0 degrees in REL. The joint velocity of upper limb segments was relatively low in all the subjects. The maximum average wrist velocity of Subject A and B was 18.2 and 16.3 m/s in REL.

• Korean Journal of Applied Biomechanics
• /
• v.23 no.1
• /
• pp.11-17
• /
• 2013

The purpose of this study was to provide a fundamental information for enhancing 110m hurdlers' performance through conducting comparative biomechanical analysis between Skilled Group(SG) and Less-Skilled Group(LSG) those who are not in the first section of 110m hurdles. To persue the purpose of this study, total of 10 hurdlers participated. Then they were divided into two groups; SG: five hurdlers who have won awards with 14-second range at 2010 national track and field event, and LSG: five hudlers who did not win any awards with 15-second range. Three-dimensional motion analysis with 12 infrared cameras(Oqus 300, Qualisys) and 1 force plate(Type 9286AA, Kistler) was performed. From this study following conclusions were obtained. 1) For the overall runtime, SG revealed faster elapsed time than that of LSG. 2) At E4, LSG showed greater trunk angle than that of SG. 3) At E3 LSG revealed higher angular velocities than that of SG. 4) No significant differences was found for AP GRF between groups but LSG showed greater VGRF than that of SG.

• Korean Journal of Applied Biomechanics
• /
• v.23 no.1
• /
• pp.45-51
• /
• 2013

The current study developed the analysis program by employing the Polygon Clipping Algorithm to calculate the open area on the court when players try to spike a ball. The program consists of two kinds of output screen. First, on the main output screen, it is possible to calculate both blocked area by net and blockers, and opened area to avoid the blocked area when players spike the ball. Additionally, the secondary output screen shows the moving path of setter and the location of set. Main output screen indicates hitting points of spiking, blocking, and open area. Also, it is possible to analyze the movement of setter, location of set, and hitting point of attacker. The program was tested by comparing real coordinate value and location coordinate value which is operated on the program. To apply this program in the field, future study needs to develop the program that can calculate three dimensions coordinate fast by tracking the location of players or ball in real time.

• Korean Journal of Applied Biomechanics
• /
• v.23 no.1
• /
• pp.63-76
• /
• 2013

The purpose of this study was to investigate the effects of knee joint muscle fatigue and overweight on the angular displacement and moments of the lower limb joints during landing. Written informed consent forms, which were approved by the human subject research and review committee at Dong-A University, were provided to all subjects. The subjects who participated in this study were divided into 2 groups: a normal weight group and an overweight group, consisting of 15 young women each. The knee joint muscle fatigue during landing was found to increase the dynamic stability by minimizing the movements of the coronal and horizontal planes and maintaining a more neutral position to protect the knee. The effect of body weight during landing was better in the normal weight group than in the overweight group, with the lower limbs performing their shock-absorbing function in an efficient manner through increased sagittal movement. Therefore, accumulated fatigue of knee joint muscles or overweight may be highly correlated with the increase in the incidence of injury during landing after jumping, descending stairs, and downhill walking.

• Korean Journal of Applied Biomechanics
• /
• v.29 no.4
• /
• pp.213-217
• /
• 2019

Objective: The purpose of this study was to investigate the ratio of carrie's and run's distance in golf running approach using 52° and 48° wedges. Method: 2 women's professional golfers from the LKPGA were given the running approach in the 5 m, 10 m, 15 m respectively. The variables were analyzed through a golf analyzer and actual measurement. Results: If you send 5 m with 52° and 48° wedges, the ball run about 5 m, 10 m respectively, if you carry 10 m with 52° and 48° wedges, the ball run about 10 m, 13 m respectively. And if you carry 15 m with 52° and 48° wedges, the ball run about 13 m, 15 m respectively. Conclusion: Based on the results, if you are confident in distance, if you choose the club properly and if you are confident, if you try to send the correct distance to the hole cup, then you will have a more confident approach, which will lead to better results.

• Korean Journal of Applied Biomechanics
• /
• v.29 no.4
• /
• pp.219-226
• /
• 2019

Objective: The purpose of this study is to provide a better understanding of short turn mechanism by describing short turns after kinematic analysis and provide skiers and winter sports instructors with data through which they are able to analyze right postures for turns in skiing in a systematic, rational and scientific manner. Method: For this, a mean difference of kinematic variables (ski-hip angle, ski-shoulder twist angle, pole checking angle, the center of gravity (CG) displacement, trunk forward lean angle) was verified against a total of 12 skiers (skilled and unskilled, 6 persons each), regarding motions from the up-start to down-end points for short turns. Results: There was no difference in a ski-hip twist angle. The ski-shoulder twist angle was large at the up-start point while a pole-checking angle was high at the down-end point in skilled skiers. Concerning the horizontal displacement of CG, skilled skiers were positioned on the right side at the upstart point. No significant difference was observed in the trunk forward lean angle. Conclusion: According to the ski-shoulder twist angle and CG horizontal displacement results, the upper body should be kept leant toward the pole. In addition, big turns should be made via edging and angulation. During pole checking, the hand holding the pole should be thrown and released toward a vector direction of the forearm.