• KCID journal
• /
• v.19 no.1
• /
• pp.3-18
• /
• 2012

In recent years, as environmental problems have become great concerns among many people, th loss of beach sand has become one of the highly controversial issue. Major reasons for the beach erosion within the cases of West Coast can be classified as: 1) erosion at Unyeo, Baeksajang beaches are caused by the wave refraction according to the large-scale sand dredging, 2) erosion at Kkotji, Baeksajang, and Unyeo beaches are caused by large-scale embankment construction and the coastal road construction, and 3) erosion at Chollipo and Hakampo beaches are caused by construction of small ports. Erosion in the west coast of Korea coast beach erosion control measures, include groin, zeotube, terraced stone, jetty groin, and beach nourishment. Erosion control measures initially installed to prevent erosion showed a positive effect. However, if there is no continuous source of sand, the effect of measures is fewness.

• Journal of Korea Water Resources Association
• /
• v.55 no.11
• /
• pp.865-875
• /
• 2022

Field measurements and numerical simulations using EFDC model were performed to quantify the changes of water circulation near Gusipo coast located in the Yellow Sea of Korea to estimate the impact of the construction of the coastal structures (jetty, groin, Gusipo port and bridge). The model predicted tide and tidal currents agreed reasonably well with the measurements. The maximum currents during spring tide near the Gusipo Beach (GB) have the range of 20~40 cm/sec whereas those off the GB range from 60 to 80 cm/sec. The typical patterns of tidal current show parallel with the local isobath. Tidal currents flow northeastward during the flood tide whereas the currents during the ebb tide flow southwestward. The current speeds at shielded waters after the construction of coastal structures strongly decreased as compared with those before the construction. The tidal volume due to the construction of coastal structures was estimated using the depth averaged velocity for 24 hours of spring tide. Tidal volume after construction of coastal structures was compared with initial state (before construction). Tidal volume at present state (after construction of jetty, groin, Gusipo port and bridge) decreased by 28.4% as compared with that of the initial state. The volume after construction of jetty and groin decreased by 21.3%, and the volume after construction of Gusipo port and bridge decreased by 9.8%.

• Journal of the Korean Institute of Navigation
• /
• v.13 no.1
• /
• pp.77-106
• /
• 1989

Two numerical models of the shoreline change and sediment transport rates, explicit and implicit, are simulated with shore structures such as breakwaters, a jetty, groins and a seawall. The applied study area is songdo Beach, Youngil bay, Korea since it has all the shore structures mentinoed above. The two models investigate the beach line changes and sedimen transport rates for the beach before design of three groins with and without an offshore breakwater. In order to estimate the shoreline changes after three groins were built, the beach response inside the three groin compartiments and the offshore barrier are also investigated. The simulation based on the initial shoreline conditions surveyed by the Hydrographic office, Koreai 1979 and 1984. The breaking wave characteristics are introduced into the models by calculation from the empirical equations and modification from the numerical and hydraulic model test results developed for waves behind an offshore breakwater. The numerical simulation describes well the tendencies of the sand transport and shoreline changes affected by wave diffraction behind a detached breakwater and by interruption of sand transport at three groins.

• Journal of the Korean Geosynthetics Society
• /
• v.1 no.1
• /
• pp.13-21
• /
• 2002

Geotextile tubes hydraulically or mechanically filled with dredged materials have been applied in hydraulic and coastal engineering in recent years(detached breakwater, groins and jetty). The geotextile tubes are made of sewn geosynthetics sheets. If the sandy soil is use to fill material, these inlets should be spaced closely to assure uniform filling of the tubes because sandy soil and geosynthetic is very pervious. However, the clayey soil or contaminated slurry is used, the inlets can be located relatively long distance. The fine clayey particles tend to rapidly blind the fabric slowing down water escape through the geotextile. This paper presents a field test result of a geotextile tube in the land reclamation project for the Songdo New City construction site. The dredged silty clay was dredged by the dredging ship and hydraulically pumped into the geotextile tube. The height of geotextile tube was measured at every filling stage and also measured width and diameter of geotextile tube with the elapsed time. Based on the test results, if the clayey filling material is used, the pumping step must be divided 3~4 stages for drainage and sediment. After complete drainage, the height of the geotextile tube reduces by approximately 50%.

• Journal of the Korean Geotechnical Society
• /
• v.18 no.5
• /
• pp.251-260
• /
• 2002

Geotextile tribes are made of sewn geotextile sheet and hydraulically or mechanically filled with dredged materials. They have been applied in hydraulic and coastal engineering in recent years(shore protection structure, detached breakwater, groins, and jetty). Therefore, it is composed of geotextile and confined fill material. Recently, new preliminary design criteria supported by model and prototype tests, and some stability analysis calculations have been studied. The stability analysis of geotextile tube is composed of geotechnical and hydrodynamic analysis. The stability check points are sliding failure, overturning, bearing capacity failure against the wave attack. In this paper are presented the stability analysis method by empirical equation and 2-D equilibrium analysis for geotextile tube. Also, the hydraulic model tests were performed to verify the theoretical stability analysis with geotextile tube shape, filling ratio, significant wave height, and so on. The results of this study show that the stability of geotextile tube depends on the tube shape, contact area, projection area. The theoretical analysis and hydraulic model test show almost the same results.