• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.36 no.4
• /
• pp.413-417
• /
• 2023

Gallium Oxide (Ga₂O₃) is preferred as a material for next generation power semiconductors. The Ga₂O₃ should solve the disadvantages of low thermal resistance characteristics and difficulty in forming an inversion layer through p-type ion implantation. However, Ga₂O₃ is difficult to inject p-type ions, so it is being studied in a heterojunction structure using p-type oxides, such as NiO, SnO, and Cu₂O. Research the lateral-type FET structure of NiO/Ga₂O₃ heterojunction under the Gate contact using the Sentaurus TCAD simulation. At this time, the VG-ID and VD-ID curves were identified by the thickness of the Epi-region (channel) and the doping concentration of NiO of 1×10¹⁷ to 1×10¹⁹ cm-3. The increase in Epi region thickness has a lower threshold voltage from -4.4 V to -9.3 V at I_D = 1×10^-8 mA/mm, as current does not flow only when the depletion of the PN junction extends to the Epi/Sub interface. As an increase of NiO doping concentration, increases the depletion area in Ga₂O₃ region and a high electric field distribution on PN junction, and thus the breakdown voltage increases from 512 V to 636 V at I_D =1×10^-3 A/mm.

• Journal of the Korea institute for structural maintenance and inspection
• /
• v.25 no.4
• /
• pp.28-36
• /
• 2021

It is known that buried rebars inside concrete structures are protected from corrosion due to passive layer. It is very important to delay the timing of corrosion or evaluate a detection of corrosion initiation for the purpose of cost-beneficiary service life of a structure. In this study, corrosion monitoring was performed on concrete specimens considering 3 levels of cover depth(60 mm, 45 mm, and 30 mm), W/C(water to cement) ratio(40.0%, 50.0%, and 60.0%) and chloride concentration(0.0%, 3.5%, and 7.0%). OCP(Open Circuit Potential) was measured using agar-based socket type sensors. The OCP measurement showed the consistent behavior where the potential was reduced in wet conditions and it was partially recovered in dry conditions. In the case of 30 mm of cover depth for most W/C ratio cases, the lowest OCP value was measured and rapid OCP recovery was evaluated in increasing cover depth from 30 mm to 45 mm, since cover depth was an effective protection against chloride ion ingress. As the chloride concentration increased, the effect on the cover depth tended to be more dominant than the that of W/C ratio. After additional monitoring and physical evaluation of chloride concentration after specimen dismantling, the proposed system can be improved with increasing reliability of the corrosion monitoring.

• Food Science of Animal Resources
• /
• v.38 no.5
• /
• pp.1080-1091
• /
• 2018

The eggshell, which is a complex and highly ordered structure, is very important factor for food safety and egg marketing. This study investigated the changes in eggshell structure and shell components in relationship to hen age. For this study, we examined the histological change of the endometrium of the 30-, 60-, and 72-wk-old commercial layers, and analyzed the ultrastructure and ionic composition of their eggshells. The results showed that histological deformation, fibrosis, atrophy and elimination of micro-villi in the uterus endometrium were found through microscopic observation that was associated with increasing hen age. Concentration of blood-ion components such as $Ca^{2+}$, $Na^+$, $K^+$, and $Cl^-$ ions did not change with age. Along with the results from the ultrastructure analysis of the eggshell, the palisade layer ratio and the density of mammillary knobs were significantly decreased in older hens. In addition, the type B mammillary knobs were frequently observed with increasing hen age. In the mineral element assay from the eggshell, $Ca^{2+}$, $S^{2-}$, and $Co^{2+}$ significantly decreased with increasing hen age, whereas $Na^+$, $K^+$, and $V^{2+}$ significantly increased. Therefore, the damages of endometrial tissue inhibit the processes of ion transmission and the crystallization of eggshell formation, resulting in a large and non-uniform mammillary knob formation. This means the conditions of endometrial cells affect the formation of the eggshell structure. In conclusion, hen aging causes the weakness of the eggshell and degrades the eggshell quality.

• Restorative Dentistry and Endodontics
• /
• v.16 no.1
• /
• pp.87-105
• /
• 1991

The purpose of this experiment was to measure the leaking and solubility of commonly used dental restorative materials - Silux plus (CS), Hi-pol (CH), Clearfil F-II, Fissureseal (FS), Glass-Ionomer cement Fuji Type II (GI), Amalgam Cavex 68 (AM), Zinc Phosphate Cement (ZP) and gutta-percha (GP) and investigate the relation between the solubility and marginal leakage. Disc-shape specimens were fabricated with each material and dipped into deionized water, 0.01M lactic acid and 0.005M KOH solution, thus the total ionic concentrations in each solution was measured with ion chromatograph after 1, 3, and 7 days, respectively. For the solubility test, each specimen was immersed in 0.001M and 0.01M lactic acid for 24 hours, respectively and total weight loss was calculated. Also, Zn leaking through the margin of restorations was measured. The obtained results were as follows: 1. The amounts of eluted ion from the eight materials were most in 0.01M lactic acid and least in deionized water. 2. Of the eight materials, the fluoride release was greatest for glass ionomer cement (GI) in 0.01 M lactic acid after 7 days. 3. In analysis of the divalent cation, Mg was eluted most for zinc phosphate cement (ZP) and Ca for Clearfil F-II (CF) in 0.01M lactic acid after 7 days. 4. In analysis of transition metals, Cu and Zn were detected only. 5. The solubility rate of eight materials was greater in 0.01M lactic acid than in 0.001M for 24 hours, for zinc phosphate cement (ZP) the rate was greatest (5.4%) in 0.001M lactic acid, and amalgam least (0.01%). 6. The Zn concentration of restorative material with Z.P.C base was greater in 0.01M lactic acid than in 0.001M lactic acid.

• The Korean Journal of Zoology
• /
• v.39 no.3
• /
• pp.307-316
• /
• 1996

A persistent major haemolyruph protein (MHP) was confirmed, and its ontogeny and physicochemical charadedstics were investigated in Helicoverpa assulta. The MHP existed continually during larval-pupal-adult development, and its ontogeny was similar to that of total haemolymph protein concentration during development. Its content increased with larval growth, and kept to high level during pupal-adult development except for temporary decrease at the early pupal and adult stages. The MHP was purified by ammonium sulfate precipitation, gel filtration and ion exchange chromatography. The purified MHP was determined to be hexamer glycolipoprotein (pI 5.9, M.W. 414kDa) consisted of single type subunit (69kDa). Amino acid analysis suggested that the MHP contained a relatively high content of aromatic amino acids (18.27 mole % of tryptophan, 7.47 mole % of tyrosine and 6.51 mole % of phenylalanine) compared to storage proteins from other insects. Immunodiffusion test and electrophoretic analysis of the organ proteins (gut, fat body, and Malphigian tubule) suggested that the major haemolymph protein was present in the fat body.

• Analytical Science and Technology
• /
• v.13 no.6
• /
• pp.699-704
• /
• 2000

A study has been made for the electrochemical destruction of cyanide ions and removal of zinc ions from a simulated electroplating wastewater by the use of a platinum platized-titanium anode and a stainless steel cathode. Several experimental parameters, including electrolysis time, cell current, additives, and chloride concentration, have been investigated and used for efficient destruction of cyanide waste and removal of zinc ions from aqueous solutions. It was found that cell current and type of additives gave great effects on the destruction of cyanide ions and removal of zinc ions. The optimized conditions (electrolysis time: 1hr, current: 12A, additive: 0.5 M NaCl) have been defined to destroy cyanide ions and remove zinc ions with high efficiency and low operation cost. The proper reaction mechanism leading to the destruction of cyanide on the anode has also been discussed.

• Applied Chemistry for Engineering
• /
• v.30 no.1
• /
• pp.34-38
• /
• 2019

A cement industrial by-product was used as a Ca source for the carbonation process. It was confirmed that the most of cement industrial by-products was composed of CaO and KCl through ICP and XRD analyses. The optimal extractant type and concentration was 1.5 M of hydrochloric acid, and the solid/liquid ratio was 0.1 g/mL. It was assumed that the cation extraction efficiency was dependent of the pair ions and their binding formation and also the solubility from extraction efficiency results by varing extractants. After extraction process, it was also confirmed that the cation could be selectively separated from the solution with respect to the kind of additives and the injection order. When NaOH was injected into the solution to control pH values ranging from 9.5 and 13, impurities and $Ca(OH)_2$ were precipitated, whereas the separated K ion was precipitated in the form of KCl under the injected $C_2H_5OH$.

• Bulletin of the Korean Chemical Society
• /
• v.34 no.10
• /
• pp.2900-2904
• /
• 2013

We present the synthesis and characterization of DTPA-bis(histidylamide) (1a), DTPA-bis(aspartamide) (1b), and their gadolinium complexes of the type $[Gd(L)(H_2O)]$ (2a:L = 1a; 2b:L = 1b). Thermodynamic stabilities and $R_1$ relaxivities of 2a-b compare well with Omniscan$^{(R)}$, a well-known commercial, extracellular (ECF) MRI CA which adopts the DTPA-bis(amide) framework for the chelate: $R_1$ = 5.5 and 5.1 $mM^{-1}$ for 2a and 2b, respectively. Addition of the Cu(II) ion to a solution containing 2b triggers relaxivity enhancement to raise $R_1$ as high as 15.3 $mM^{-1}$, which corresponds to a 300% enhancement. Such an increase levels off at the concentration beyond two equiv. of Cu(II), suggesting the formation of a trimetallic ($Gd/Cu_2$) complex in situ. Such a relaxivity increase is almost negligible with Zn(II) and other endogenous ions such as Na(I), K(I), Mg(II), and Ca(II). In vivo MR images and the signal-to-noise ratio (SNR) obtained with an aqueous mixture of 2b and Cu(II) ion in an 1:2 ratio demonstrate the potentiality of 2 as a copper responsive MRI CA.

• Bulletin of the Korean Chemical Society
• /
• v.15 no.3
• /
• pp.256-260
• /
• 1994

Perovskite type oxides of the $Sr_xHo_{1-x}FeO_{3-y}$ system with compositions of x=0.00, 0.25, 0.50, 0.75, and 1.00 have been prepared at 1200$^{\circ}$C in air. X-ray powder diffraction assigns the compositions with x=0.00 and 0.25 to the orthorhombic crystal system and those with x=0.50, 0.75, and 1.00 to the cubic one. The unit cell volumes of solid solutions increase with x in the system. Nonstoichiometric chemical formulas were determined by Mohr salt titration. The mole ratio of $Fe^{4+}$ ions to total iron ions and the concentration of oxygen ion vacancies increase with x. Mossbauer spectra for the compositions of x= 0.00, 0.25, and 0.50 show six lines indicating the presence of $Fe^{3+}$ ions in the octahedral site. However, the presence of $Fe^{4+}$ ions may also be detected in the spectra for the compositions with x=0.25 and x=0.50. In the compositions with x=0.75 and 1.00, single line patterns show also the mixed valence state of $Fe^{3+}$ and $Fe^{4+}$ ions. The electrical conductivity in the temperature range of -100$^{\circ}$C to 100$^{\circ}$C under atmospheric air pressure increases sharply with x but the activation energy decreases with the mole ratio of $Fe^{4+}$ ion. The conduction mechanism of the perovskite system seems to be hopping of the conduction electrons between the mixed valence iron ions.

• Journal of Powder Materials
• /
• v.15 no.2
• /
• pp.125-135
• /
• 2008

[ $TiO_2$ ] nanotubes for photocatalytic application have been synthesized by hydrothermal method. $TiO_2$ nanotubes are formed by washing process after reaction in alkalic solution. Nanotubes with different morphology have been fabricated by changing NaOH concentration, temperature and time. $TiO_2$ nanoparticles were treated inside NaOH aqueous solution in a Teflon vessel at $110^{\circ}C$ for 20 h, after which they were washed with HCl aqueous solution and deionized water. Nanotube with the most perfect morphology was formed from 0.1 N HCl washing treatment. $TiO_2$ nanotube was also obtained when the precursor was washed with other washing solutions such as $NH_4OH$, NaCl, $K_2SO_4$, and $Na_2SO_3$. Therefore, it was suggested that $Na^+$ ion combined inside the precursor compound slowly comes out from the structure, leaving nanosheet morphology of $TiO_2$ compounds, which in turn become the nanotube in the presence of hydroxyl ion. To stabilize the sheet morphology, the different type of washing treatment solution might be considered such as amine class compounds.