• Proceedings of the Korean Society of Tribologists and Lubrication Engineers Conference
• /
• 1996.04b
• /
• pp.45-54
• /
• 1996

The effect of graphite on the frictional characteristics of Cu-based sintered friction materials was studied by pin-on-disk type wear test. A study has been carried out concerning the optimum concentration of graphite in sintered friction material to obtain the minimum wear rate and low friction coefficient . Friction coefficient and wear rate were increased as increasing the content of graphite in the matrix. In the study the optimum concentration of graphite was 19vol % to get the minimum wear rate and optimal frick'ion coefficient.

• Membrane Journal
• /
• v.18 no.3
• /
• pp.250-255
• /
• 2008

Zeolite A have been known to be chemically, mechanically and thermally quite stable. The ion-exchanged membranes were tested for the removal of water from ethanol/water mixtures by pervaporation. Since it is quite difficult to prepare the potassium form of zeolite A by a direct synthesis, it was obtained by the ion-exchange method from NaA zeolite. The effects of concentration of ethanol at the feed side and the temperature were studied on the permeation flux and the separation factor of water. After $Na^+$ ion was exchanged to $K^+$ ion, it was found that the total flux decreased and the separation factor increased.

• Journal of Microbiology
• /
• v.34 no.2
• /
• pp.179-183
• /
• 1996

Streptoccus Pneumoniae (pneumococcus), the most common cause of bacterial pneumonia, has an ample polysaccharide (PS) capsule that is highly antigenic and is the source of PS vaccine. This investigation was undertaken to optimize the culture conditions for the production of capsulard PS by type 1 pneumococcus. Among several culture media, brain heart infusion (BHI) and Casitone based media were found to support luxuriant growth of pneumococcus type 1 at the same level. Because BHI medium is rather expensive and more complex than the Casitone based media, the Casitone based media was uwed to study optimization of the culture condition. The phase of growth which accomodated maximum PS production was logarithmic phase. Concentrations of glucose greater than 0.2% did not ehnahce growth or PS production. Substitution of netrogen sources with other resources or supplementation of various concentrations of metal ion (with the exception of calcium ion) had adverse affects on growth and PS production. On the other hand, low level aeration was beneficial for increased PS production. Addition of 3 mg/1 concentration of methionine, phenylalanine, and threonine were found to enhance growth and PS production. The synerigistic effect of all the favorable conditions observed in pneumococcal growth assays provided a two-fold cummulative increase in capsular PS production.

• Journal of Korean Society of Environmental Engineers
• /
• v.22 no.1
• /
• pp.33-42
• /
• 2000

Adsorption onto the surfaces of solid particles is a well known phenomenon that causes the retardation effect of heavy metals in soils. For adequate remediation of soil and groundwater contamination, it is important to investigate the mobility of heavy metals that largely depends on pH conditions in the soil water since adsorption of heavy metals is pH-dependent. In this study, we investigated the transport of Zn ion under various pH conditions in a sandy soil by conducting batch and column tests. The batch test was performed using the standard procedure of equilibrating fine fractions collected from the soil with eleven different initial $ZnCl_2$ concentrations, and analysis of Zn ion in the equilibrated solutions using ICP-AES. The column test consisted of monitoring the concentrations of soil solutions exiting the soil column with time known as a breakthrough curve (BTC). We injected respectively $ZnCl_2$ and KCl solutions with the concentration of 10 g/L as a tracer in a square pulse type under three different pH conditions (7.7, 5.8, 4.1) and monitored the flux concentration at the exit boundary using an EC meter and ICP-AES. The resident concentration was also monitored at the 10cm-depth by Time Domain Reflectometry (TDR). The results of batch test showed that ion exchange process between Zn and other cations (Ca, Mg) was predominant. The retardation coefficients obtained from adsorption isotherms (Linear, Freundlich, Langmuir) resulted in the various values ranging from 1.2 to 614.1. No retardation effect but ion exchange was found for the BTCs under all pH conditions. This can be explained by the absence of other cations to desorb Zn ion from soil exchange sites under the conditions of ETC experiment imposing blank water as leachate in steady-state flow. As pH decreased, the peak concentration of Zn increased due to the competition of Zn with hydrogen ions ($H^+$) and the concentrations of other cations decreased. The peak concentration of Zn was increased by 12.7 times as pH decreased from 7.7 to 4.1.

• Environmental Engineering Research
• /
• v.22 no.1
• /
• pp.95-107
• /
• 2017

Adsorption equilibrium and kinetic behavior of two toxic heavy metals hexavalent chromium [Cr(VI)] and mercury [Hg(II)] on mustard oil cake (MOC) was studied. Isotherm of total chromium was of concave type (S1 type) suggesting cooperative adsorption. Total chromium adsorption followed BET isotherm model. Isotherm of Hg(II) was of L3 type with monolayer followed by multilayer formation due to blockage of pores of MOC at lower concentration of Hg(II). Combined BET-Langmuir and BET-Freundlich models were appropriate to predict Hg(II) adsorption data on MOC. Boyd's model confirmed that external mass transfer was rate limiting step for both total chromium and Hg(II) adsorptions with average diffusivity of $1.09{\times}10^{-16}$ and $0.97m^2/sec$, respectively. Desorption was more than 60% with Hg(II), but poor with chromium. The optimum pH for adsorptions of total chromium and Hg(II) were 2-3 and 5, respectively. At strong acidic pH, Cr(VI) was adsorbed by ion exchange mechanism and after adsorption reduced to Cr(III) and remained on MOC surface. Hg(II) removal was achieved by complexation of $HgCl_2$ with deprotonated amine ($-NH_2$) and carboxyl (COO-) groups of MOC.

• Journal of Sensor Science and Technology
• /
• v.8 no.4
• /
• pp.341-346
• /
• 1999

In general cases, compared with glass electrode, FET type electrolyte sensors have many advantages. But the drift, memory effect and the poor reproducibility of the FET type electrolyte sensor cause the decrease of the reliability in the measurement system. To improve the reliability, an ion-measuring system using FET type electrolyte sensor array with 8 sensors has been developed. Developed system employed the electronic switchs to connect a signal detecting circuit with 8 sensor array and the system can measure ion concentration of 4 different type electrolyte($H^+$, $Na^+$, $K^+$, $Ca^{2+}$). The signal processing algorithm with insertion sorting method was adopted to enhance the reliability. We measured 3 different ion($H^+$, $Na^+$, $K^+$) to evaluate the performance of developed system. The results show that the designed signal processing algorithm can reduce the error range in comparison with a simple arithmetic mean and the developed system has a good reliability over the previous single channel sensor system.

• Journal of environmental and Sanitary engineering
• /
• v.20 no.4 s.58
• /
• pp.9-20
• /
• 2005

The purpose of the study was characteristics of secondary pollutants of $PM_{10}$ collected in pocheon between August 2002 and June 2003. The ambient concentrations of $PM_{10}$ mass, 9 water-soluble anions and cations, and 13 bulk composition trace elements were determined from filter samples collected by $PM_{10}$ high volume air sampler(UV-15H, Graseby-Anderson Co., USA). During this period average $PM_{10}$ mass concentration was $83.8{\mu}g/m^3(49.8{\mu}g/m^3\~111.6{\mu}g/m^3)$ in Pocheon. Mechanism for transformation of secondary pollutants by soluble ion components is divided into two categories; $NaNO_3$ type by the reaction of sea salt and $HNO_3$ in the atmosphere, and nitrate salt or phosphate salt type such as $(NH_4)_2SO_4,\;NH_4NaSO_4,\;and\;(NH_4)_2SO_4(2NH_4O_3)$.

• Proceedings of the Technology Innovation Conference
• /
• 2005.08a
• /
• pp.5-28
• /
• 2005

This paper estimates the effect of networks on innovative performance at the firm level , using Korean Innovation Survey (KIS) dataset Product innovation, product improvement , and process innovation are used as proxies for innovative activity. The explanatory variables such as firm size, market concentration ratio, lagged profitability, foreign ownership, export ratio, firm's age, formal R&D activity, and industrial R&D intensity are yet other considerations. With two year-long (2000 and 2001) data from 1,124 Korean manufacturing firms, we estimated the logistic regression model. The research finding indicates that the external networks have a strong positive effect on innovative output regardless of type of innovation. However, the network effects by partner (other firms or research institutions) vary across the type of innovation. Especially, we found that the user-supplier linkage plays an important role in product ion innovation, product improvement, and process innovation.

• Korean Journal of Microbiology
• /
• v.26 no.1
• /
• pp.1-5
• /
• 1988

The esolation and characterization of a new type II restriction endounclease, BamI, from Bacellus macerans ATCC 8244 were described. BmaI endonuclease was partially purified by procedures of ammonium sulfate fractionation, DEAE-cellulose and phosphocellulose chromatographies. This enzume recognized one site on pBR322 DNA, two sites on Bluescribe DNA, three sites on $\lambda$DNA and no site on SV 40 DNA. The same cleavage patterns for vareius DNAs as PvuI indicated that BamI is an isoschisomer of PvuI whose recognition sequence is 5'-CGATCG-3'. The optimal pH for the BmaI endonuclease activity was about 7.0 and optimal NaCl concentration was about 100mM. Manganese ion could partially replace magnesium as a cofactor, but calcium could not at all.

• Korean Journal of Microbiology
• /
• v.12 no.4
• /
• pp.159-179
• /
• 1974

In order to investigate morphological and cultural characteristics of strains in species, Flammulina velutipes, the author collected isolates of Flammultina velutipes at 49 locations in Korea and cultivated these isolates on the various kinds of solid media. After investigating the cultural characteristics, appeared on the various media, he obtained the following results : 1. The variation of colors in the fruit bodies is connected with the variation of climatic environments(composite effects between mean temperature in January and number of rain days of 1mm and over precipitation). The author, therfore, can find out the trend that brown type is distributed in the midland climatic region and yellow type in the southern climatic regoin. 2. Two types can be classified into several strains respectively : the strain of abundant or insufficient productivity, and strain of selectivity or non-selectivity of media. 3. According to the results of mutual comparison of soluble mycelial proteins by disc electrophoresis using polyacrylamide gels, each type has special common protein fractions(brown type : band located at 26..5mm position from surface of gel, yellow type : band located at 24.5mm position from surface of gel), and each strain has special protein fractions too. Therefore this phenomenon seems to support the results obtained by the above-stated morphological and cultural studies. 4. In the adaptability of strains to the temperature, every strain has the nature of growing in lower temperature(the optimum temperature of 20.deg.C to 25.deg.C) except that YI-1 strain has the optimum temperatue of $25^{\circ}C$-26^{\circ}C. And mycelial growth of every strain is discontinued at $35^{\circ}C.$ 5. In the adaptability of strains to the H-ion concentration, every strain has wide adaptable range of H-ion concentration, and has optimum range of pH 5.5 to 6.6 in mycelial growth excepting YA01, BI-2 and YI-1. 6. In the utility of carbon sources, the mycelial growth of every strain is very poor on the media containing xylose(average diameter of mycelial growth : 18mm), and most strains utilize favorably sucrose(39mm), maltose(37mm) and dextrose(35mm) in mycelial growth. In the utility of nitrogen sources, every strain utilizes favorably organic nitrogens(36 mm)more than inorganic nitrogens (25 mm), and utilizes fully peptone nad asparagine in organic nitrogens. Especially BA-1, BIK-2 and YA-1 strains grow vigorously on each media containing various carbon and nitrogen sources. 7. The characteristic tests of the number of days required for mycelial growth, the number of days requried for sprout of young bodies, the length of stipe and the number of fruit bodies formation seem to be useful methods in the early selection of the strain of the abundant productivity.