• Sleep Medicine and Psychophysiology
• /
• v.19 no.1
• /
• pp.11-17
• /
• 2012

Objective: Among various methods developed to quantitatively explore electroencephalograms (EEG), we focused on a wavelet method that was known to yield robust results under nonstationary conditions. The aim of this study was thus to introduce the wavelet method and demonstrate its potential use in clinical sleep studies. Method: This study involved artificial EEG specifically designed to validate the wavelet method. The method was performed to obtain time-dependent spectral power and phase angles of the signal. Synchrony of multichannel EEG was analyzed by an order parameter of the instantaneous phase. The standard methods, such as Fourier transformation and coherence, were also performed and compared with the wavelet method. The method was further validated with clinical EEG and ERP samples available as pilot studies at academic sleep centers. Result: The time-frequency plot and phase synchrony level obtained by the wavelet method clearly showed dynamic changes in the EEG waveforms artificially fabricated. When applied to clinical samples, the method successfully detected changes in spectral power across the sleep onset period and identified differences between the target and background ERP. Conclusion: Our results suggest that the wavelet method could be an alternative and/or complementary tool to the conventional Fourier method in quantifying and identifying EEG and ERP biomarkers robustly, especially when the signals were nonstationary in a short time scale (1-100 seconds).

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.29 no.7A
• /
• pp.814-827
• /
• 2004

The compressed mode is used to perform inter-frequency and inter-system handover in WCDMA. The instantaneous transmit power is increased in the compressed frame in order to keep the QoS(Quality of Service) unaffected by the reduced processing gain. Furthermore, since the inner loop power control is not active during the transmission gap and the effect of interleaving is decreased, a higher Eb/No target is required, which directly affects the system performance. Due to the impact on performance, the compressed mode should be activated by the RNC(Radio Network Controller) only when there is real need to execute an inter-frequency or inter-system handover. However, 3GPP does not define the method that decides the compressed mode activation. In order to reduce performance degradation, there is need the decision method. In this paper, we consider a combined cell structure in which some neighbor cells have a frequency the same as serving cell and the others have a different frequency or system. Under consideration, we analyze the effect of the compressed mode on the WCDMA forward link performance. In order to avoid performance degradation, we propose an UE(User Equipment) measurement method that can restrict the activation area of the compressed mode of UE that does not need it and evaluate its performance by simulations. Analytical results show that the use of the compressed mode affects the performance degradation. And simulation results show that proposed method leads to better performance.

• Korean Journal of Environment and Ecology
• /
• v.25 no.3
• /
• pp.318-326
• /
• 2011

The population ecological characteristics of the Crucian carp, Carassius auratus, were determined in order to estimate stock of the mid-upper system of the Seomjin River. The fish ranged in size from 95 to 288mm total length. The age was determined by counting the scale annulus. The scales displayed clear annulus that were used to estimate the age. The oldest fish observed in this study was 5 years old. Age-2 fishes were the most numerous in the sample(n=38), followed in frequency be age-3(n=22). Marginal index analysis validated the formation of a single annulus per year. The relationship between body length and body weight was BW = $0.0038BL^{3.73}$($R^2$=0.96) (p<0.01). The relationship between the scale radius and body length was BL = 2.362R+2.76($R^2$=0.89). The von Bertalanffy growth parameters estimated from a non-linear regression method were $L_{\infty}$=33.2 cm, $W_{\infty}$=1,798.4 g, $K=0.20year^{-1}$ and $t_0$=-0.51year. Therefore, Growth in length of the fish was expressed by the von Bertalanffy's growth equation as $L_t=33.23$($1-e^{-0.20(t+0.51)}$)($R^2$=0.98). The annual survival rate was estimated to be 0.427year$^{-1}$. The instantaneous coefficient of natural mortality of estimated from the Zhang and Megrey method was $0.784year^{-1}$, and instantaneous coefficient of fishing mortality was calculated $0.067year^{-1}$. From the estimates of survival rate, the instantaneous coefficient of total mortality was estimated to be $0.851year^{-1}$.

• Proceedings of the Korean Society for Noise and Vibration Engineering Conference
• /
• 2009.10a
• /
• pp.231-239
• /
• 2009

The filtered-x LMS (FX-LMS) algorithm has been applied to the active noise control (ANC) system in an acoustic duct. This algorithm is designed based on the FIR (finite impulse response) filter, but it has a slow convergence problem because of a large number of zero coefficients. In order to improve the convergence performance, the step size of the LMS algorithm was modified from fixed to variable. However, this algorithm is still not suitable for the ANC system of a short acoustic duct since the reference signal is affected by the backward acoustic wave propagated from a secondary source. Therefore, the recursive filteredu LMS algorithm (FU-LMS) based on infinite impulse response (IIR) is developed by considering the backward acoustic propagation. This algorithm, unfortunately, generally has a stability problem. The stability problem was improved by using an error smoothing filter. In this paper, the recursive LMS algorithm with variable step size and smoothing error filter is designed. This recursive LMS algorithm, called FU-VSSLMS algorithm, uses an IIR filter. With fast convergence and good stability, this algorithm is suitable for the ANC system in a short acoustic duct such as the intake system of an automotive. This algorithm is applied to the ANC system of a short acoustic duct. The disturbance signals used as primary noise source are a sinusoidal signal embedded in white noise and the chirp signal of which the instantaneous frequency is variable. Test results demonstrate that the FU-VSSLMS algorithm has superior convergence performance to the FX-LMS algorithm and FX-LMS algorithm. It is successfully applied to the ANC system in a short duct.

• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.34 no.5
• /
• pp.1435-1442
• /
• 2014

This study presented numerical simulations of smooth-bed flows in the rectangular open-channel using the source code by OpenFOAM. For the analysis of the turbulent flow, Large Eddy Simulations were carried out and the dynamic sub-grid scale model proposed by Germano et al. (1991) is used to model the residual stress term. In order to analyze the coherent structure, the uw quadrant method proposed by Lu and Willmarth (1973) is used and the contribution rate and the fraction time of the instantaneous Reynolds stress are obtained in the Reynolds stress. The results by the present study are analyzed and compared with data from previous laboratory studies and direct numerical simulations. It is found that the contribution rate of the ejection events is larger than that of sweep events over the buffer layer in the open-channel flow over the smooth bed, however, the frequency of the sweep event is higher than that of the ejection events.

• Journal of computational fluids engineering
• /
• v.17 no.4
• /
• pp.81-86
• /
• 2012

The objective of the present study is to investigate the effects of various turbulence models on the aerodynamic noise of an air-conditioner (AC) indoor unit. The results from URANS (unsteady Reynolds-averaged Navier-Stokes) simulations with the standard k-$\varepsilon$, k-$\omega$ shear stress transport (SST) and Spalart-Allmaras (S-A) turbulence models were analyzed and compared with the noise data from the experiments. The frequency spectra of the far-field acoustic pressure were computed using the Farrasat equation derived from the Ffowcs Williams-Hawkings (FW-H) equation based on the acoustic analogy model. Two fixed fan casings and the rotating cross-flow fan were used as the source surfaces of the dipole noise in the Farrasat equation. The result with the standard k-$\epsilon$ model showed a much better agreement with the experimental data compared to the k-w SST and S-A models. The differences in the pressure spectra from the different turbulence models were discussed based on the instantaneous vorticity fields. It was found that the over-estimated power spectra with the k-w SST and S-A models are related to the emphasized small-scale vortices produced with these models.

• Journal of Electrical Engineering and Technology
• /
• v.10 no.5
• /
• pp.2205-2210
• /
• 2015

Experimental studies have been carried out to study the principle operation of the conductive type wire-mesh tomography sensor and analyse the wire-mesh tomography sensor for the liquid/gas two-phase flow interface and void fraction distribution in a process column. The measurement of the two-phase flows in the process column is based on the cross-sectional local instantaneous conductivity. The sensor consists of two planes of parallel electrode wires with 16 electrodes each and was placed orthogonally with each plane. The sensor electrode wires were made of tinned copper wire with an outer diameter of 0.91 mm which stretched over the sensor fixture. Therefore, this result in the mesh grid size with 5.53×5.53mm². The wire-mesh sensor was tested in a horizontal liquid/gas two-phase flows process column with nominal diameter of 95.6 mm and the sampling frequency of 5882.3529 Hz. The tomogram results show that the wire-mesh tomography provides significant results to represent the void fraction distribution in the process column and estimation error was found in the liquid/gas interface level

• Journal of Advanced Navigation Technology
• /
• v.24 no.2
• /
• pp.101-106
• /
• 2020

In order to smoothly control the speed of the induction motor, it is necessary to obtain the required rotor speed information. In order to obtain the speed information, it must be obtained using a sensor, but it can also be obtained using an appropriate algorithm without using a sensor. In order to obtain speed information, a system was designed using a model reference adaptive system (MARS). Indirect vector control, one of the speed control methods of induction motors, was calculated from the motor current and rotor parameter values. The method of obtaining the position information of the magnetic flux by combining the slip frequency with the rotor speed was used. It is possible to simply perform instantaneous current control in a wide speed range without actual magnetic flux information, and has the advantage that the structure of the controller is simple. Therefore, in this paper, the control system was constructed based on the indirect vector control method, and the speed control system of the induction motor was developed by estimating the required rotor speed information as an intelligent algorithm developed without using it as a sensor.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.39A no.9
• /
• pp.557-559
• /
• 2014

We propose an efficient resource allocation scheme based on interference awareness for D2D (Device-to-Device) communication in cellular networks. Recently, many researchers have studied how to allocate frequency resources to DUE (D2D User Equipment) with full interference channel information. However, it is difficult to assume a scenario where instantaneous interference information between the CUE (Cellular UE) and DUE is known to the BS (Base Station). To tackle this problem, we proposed in this paper a new scheme in which the BS allocates a resource to CUE and DUE without a full channel information and can aware interference based on only transmit power and distance between UEs. Simulation results show effectiveness of the proposed scheme.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.21 no.1
• /
• pp.29-34
• /
• 2017

This paper considers hybrid beamforming for millimeter wave system in uplink transmission where multiple users send their data streams simultaneously. Hybrid beamforming has low-cost and low power consumption features compared to conventional digital beamforming schemes. We assume that each user uses one transmit antenna and sends one data stream, while the base station has multiple receive antennas and multiple radio frequency chains. Therefore, hybrid beamforming is performed only at the base station. We also assume that each user does not know instantaneous channel side information (CSI), while the base station is able to estimate the CSI from all users accurately. Under this channel assumption, the outage probability is not zero. We evaluate the outage probability of the considered hybrid beamforming as a performance metric through computer simulations. We show that the outage probability of hybrid beamforming approaches that of digital beamforming in some cases.