• 한국지구과학회지
• /
• 제28권5호
• /
• pp.598-602
• /
• 2007

A long-term in situ observation was carried out in the Ice-valley at Milyang in order to explain the factors and processes associated with the summertime ice formation. The variation of temperature inside Ice-valley in relation with ice formation in summer time was found to depend on precipitation rate in spring and cold air sinking in autumn and winter. The rate of temperature rising tends to correspond to sensible heat release depending on the precipitation amount at the freezing location. The reason of the cold air accumulation in a talus in the Ice-valley is the cold air sinking over the surface of talus due to the occurrence of outside clod air mass and the accumulated cold air from autumn to spring flow outside at the bottom of talus. The out-flowing cold air can result in the ice formation in the hot summer.

• 설비공학논문집
• /
• 제18권7호
• /
• pp.596-602
• /
• 2006

Ice adhesion and blockage problems have been issued in continuous ice slurry making process. So we composed continuous ice slurry making device using a commercial small plate heat exchanger (PHX), and investigated character of ice formation. An experiment of ice formation was peformed with an aqueous solution of ethylene glycol 7 mass%. In the experiment, the effect of the pressurization on ice slurry formation during the cooling process was investigated. The pressurization test for the aqueous solution was performed by setting valves at the PHX inlet and outlet. At the results, the time of continuous ice formation increased as the pressure of the plate heat exchanger increased for cooling temperature of $-5^{\circ}C$. Also continuous ice formation at the cooling temperature of $-7^{\circ}C$ showed a possibility. It was found that the pressurization may contribute to suppress the dissolution of supercooled aqueous solution in the PHX.

• 풍력에너지저널
• /
• 제5권1호
• /
• pp.43-49
• /
• 2014

Primarily, tower loads of a wind turbine arise from aerodynamic effect and a top head mass. But sometime asymmetric loads of rotor also affect on the tower loads. Especially ice formation on two blades out of three causes the asymmetric loads, because the ice formation on blades lead to large rotating mass imbalance. This rotating mass imbalance of rotor affects tower fatigue loads. So design load cases of ice formation on blade should be considered in the fatigue design loads of the tower according to GL guideline 2010. This paper describes the change of tower fatigue loads following increase of tower height in the condition of ice formation. Finally, the optimal operation strategy is examined in order to reduce tower fatigue design loads.

• Ocean and Polar Research
• /
• 제26권1호
• /
• pp.1-10
• /
• 2004

Ice cliff retreat and sea-ice formation around King Sejong Station in King George Island were analysed and compared with air temperature change. Analysis of 33-year (1969-2001) air temperature records at Bellingshausen Station has revealed regional atmospheric warming, and the increasing rate of air temperature Is equivalent to a warming of $1^{\circ}C$ for 27-year period. Here we present time-series of observations for the areal extent of the ice cliff and ice sheet, showing that they have retreated dramatically in the past 45 years (1956-2001). Retreat of 1,050 m in length of the ice clifr has changed the Marian Cove into a low rectangular form of 4 km in length and 1 to 1.3km in width. The retreat rates have since increased from 6 m/yr of the Primary investigated Period to 54 and 81m/yr in the recent years. Exceptionally, the ice cliff had been advanced of 21m in length for a year between 1987 and 1988 of cold winters. Ice sheet in King George Island also shows a similar decrease, and the decreasing extent is much larger at the southern part of the Main Cove, relatively more exposed to the sun, than at the northern part. Comparing sea-ice formation in winter with air temperature data shows a pattern starting to freeze below $-5^{\circ}C$ and to thaw over $-3^{\circ}C$. It is conclusively estimated that the patterns and magnitudes of ice cliff retreat and sea-ice formation are consistent with fluctuations of the air temperature, and that the recent rapid retreat of ice cliff and less formation of sea-ice are caused especially by the warming trends in autumn accompanied with expansion of summer thawing period.

• 한국환경과학회지
• /
• 제11권9호
• /
• pp.857-863
• /
• 2002

The meteorological elements were measured to investigate cause of summertime ice formation at Unchiri, Gangwon Province. The cause of freezing at valley was conformed as adiabatic expansion theory, latent heat of evaporation, natural convective theory, cold air remain theory, and convective freezing theory according to former study. However nither theory produced a satisfactory explanation. This studying area is not valley but ridge, and underground water surface exists at below than freezing height. wintertime temperature drop and summertime cold air spouting were explain as natural convective theory, generation of water drop on the rock was explained as cooling theory by air expansion, and ice formation on the rock was explained as adiabatic expansion theory. In conclusion, formation of ice valley at Unchiri was formed by natural convective theory, adiabatic expansion theory, and latent heat of evaporation successively.

• 대한기계학회논문집B
• /
• 제21권11호
• /
• pp.1552-1561
• /
• 1997

In this numerical study, it is investigated for the ice-formation phenomena for water flow in a concentric tube. The freezing layers of ice in both the inner and outer wall of a concentric tube are simultaneously considered. In the solution strategy, the complete set of governing equations in both the solid and liquid regions are resolved. Numerical results are obtained by varying the inner/outer wall temperatures and Reynolds number. The results show that the inner/outer wall temperatures have the great effect on the thickness of the solidification layer thereof. The shapes of ice layer in both the inner and outer wall can be expressed as a function of inverse Graetz number. As the wall temperature in inner or outer tube decreases, the heat transfer coefficients in both inner and outer ice layer surfaces increase absolutely.

• 설비공학논문집
• /
• 제29권8호
• /
• pp.437-445
• /
• 2017

Because of improvement of living standards and increased use of ice at home, built-in ice makers are of interest. In this study, refrigeration cycle of a unitary ice maker for residential usage was optimized using R-404A. Optimization was achieved through a search for proper refrigerant charge amount. For the present ice maker producing ice for 24 cups, the optimum charge amount was 200 g. In this configuration, the ice making cycle time was 17 minutes 53 seconds, ice production was 1.27 kg/h and COP was 0.310. After initial start-up, condensation and evaporation temperatures gradually decreased with time. As ice builds in the cup, heat transfer performance of the evaporator decreases, that results in decrease of evaporation and condensation temperatures. Replacement of existing slit nozzles with individual circular hole nozzles improved ice production capacity by 10 percent. Through visualization of ice formation in the ice cup, growth rate of the ice in the cup was relatively uniform.

• 터널과지하공간
• /
• 제16권1호
• /
• pp.38-49
• /
• 2006

복공식 LNG 지하저장기지 건설을 위해서는 암반역학, 열역학 및 수리지질특성과 관련된 여러 가지 기술이 요구되며, 이러한 기술의 적용성을 입증하기 위한 일환으로 대전에 Pilot cavern을 건설하였다. 이 논문에서는 Pilot cavern에 적용된 기술 중 배수시스템 평가과 Ice ring모사에 관한 수치해석 연구를 수행하였다. 대수층관점의 Modflow와 유동시스템 관점의 Seep/W 해석을 통해 적용된 배수시스템이 효율적으로 작용하였음을 확인하였다. Ice ring 형성은 열전달과 지하수 흐름의 상호작용을 통해 모사될 수 있는데, 이에 대한 모사를 위해 Temp/W-Seep/W 프로그램을 이용한 냉열수리 연동해석을 수행하였다. 이러한 해석을 통해 Ice ring의 형성 위치를 추정 할 수 있었고, Ice ring형성에 지하수 유동 속도 및 방향이 영향을 크게 미친다는 것을 확인했다.

• 설비공학논문집
• /
• 제14권12호
• /
• pp.1071-1077
• /
• 2002

Ice adhesion on cooling wall is very important in continuous ice formation. The purpose of the present study is to investigate the possibilities of a three-component aqueous solution as a thermal storage material for the continuous ice formation. By freezing under stirring the solution of 300 mL in a stainless steel vessel which was immersed and cooled in a temperature controlled bath, an ice slurry was formed experimentally with measuring the temperature and stirring load variation. From the experiment, the ice adhesion was suppressed when the supercooling degree decreased and the concentration of aqueous solution increased.

• 터널과지하공간
• /
• 제16권3호
• /
• pp.241-250
• /
• 2006

LNG지하저장 핵심기술 중 하나인 ice ring 형성을 열-수리 역학 해석을 통해 분석하였다. ice ring은 극저온물질의 누출에 대한 이차방벽 역할과 지하수의 저장공동 침투에 대한 일차방벽역할을 수행한다. 따라서 ice ring의 두께와 위치는 콘크리트와 PU foam 및 멤브레인으로 구성된 일차방호재의 무결성 유지에 있어서 핵심인자가 된다. 수치해석을 통해 이러한 ice ring의 위치와 두께를 추정하였으며 온도와 지하수위 결과를 계측치와 비교하였다. 수치해석결과는 PU foam 열전도도의 온도의존성과 지하수의 상변화를 고려한 경우 파일럿 공동에서 측정한 계측치와 잘 일치하였다. 본 논문에서 제시한 수치해석 기법은 실규모 저장시설의 설계에 있어서 ice ring 형성을 모델링하는 데에 바로 사용될 수 있을 것으로 판단된다.