• 태양에너지
• /
• 제18권3호
• /
• pp.95-105
• /
• 1998

In this study, basic design data which were required for development of highly efficient ice storage system with low temperature latent heat were experimentally obtained. The ice storage system considered in this study was the one that has been widly used in the developed country and called the ice-on-coil type. Using the system, the ice storage performance for various design parameters which were the flow direction and the inlet temperature of the secondary fluid was tested. In addition, the timewise variation of the interface profiles between the solid and the liquid were visualized, and the heat transfer characteristics of the Phase Change Material(PCM) in the ice storage tank were Investigated. During the freezing processes in the ice storage tank with several vertical tubes, decrease of the heat transfer area and the heat resistance of the ice layer made the increasing rate of ice packing factor(IPF) less. The total freezing energy for the upward flow of the secondary fluid was higher than that for the downward flow. The average ice storage efficiency for the upward flow of the secondary fluid was higher than that for the downward flow.

• Journal of Advanced Marine Engineering and Technology
• /
• 제29권2호
• /
• pp.177-184
• /
• 2005

Experimental studies on the characteristics of ice slurry flows in a circular pipe is rare due to the deficiency of conventional measurement techniques. In this report the flow characteristics are quantitatively investigated by the use of PIV technique concerning the Ice Packing Factor(IPF) and the power changes of pump motor It was experimentally verified that the power loss does not increase any more at a certain IPF value.

• 태양에너지
• /
• 제18권1호
• /
• pp.99-109
• /
• 1998

공기조화 설비에 있어서 시스템의 성능을 향상시키고 에너지의 유효이용 및 경제성을 높일 수 있는 빙축열 시스템에 대한 연구이다. Ice Ball을 내장한 빙축열조를 횡형 사각형과 입형 원통형 축열조에 대하여 조내로 유입하는 브라인의 유량(2, 4, 6LPM)과 온도(-3, -5, $-7^{\circ}C$)를 변화시키고, 또한 유입 브라인의 유동을 상 하향유동으로 하면서 빙축열조내의 온도분포를 파악하여 열유동 특성 및 빙충전율에 대하여 고찰하였다. 연구결과 빙축열조내 열성층을 향상시키기 위해서는 조내 유입 브라인의 유동이 상향 압출흐름이어야 한다는 것을 알았다.

• 설비공학논문집
• /
• 제16권2호
• /
• pp.142-149
• /
• 2004

Recently, the government introduced the thermal storage system for reducing the electric power load. Especially, the ice slurry type has gained lots of interest due to its good heat transfer and flowing characteristics. This study was peformed to understand the effects of transporting ice slurry through elbows of various angle. Propylene glycol water solution was used and about 2 mm ice particles were circulated. The experiments were carried out under various conditions, such as concentration and velocity of water solution ranging between 0∼20 wt％, 1.5∼2.5 m/s, respectively. And elbows with 4 different angles of 30$^{\circ}$, 45$^{\circ}$, 90$^{\circ}$, 180$^{\circ}$. The differential pressure and IPF (ice packing factor) between the pipe entry and exit were measured. The tendency of pressure loss and outlet IPF in elbow is that the pressure loss was reduced as concentration and flow velocity of water solution is increased, and low value appeared at 10 wt％ and 2.5 m/s. The variation of outlet IPF was compared with the inlet IPF in the range of $\pm$20％.

• Journal of Advanced Marine Engineering and Technology
• /
• 제27권2호
• /
• pp.272-279
• /
• 2003

This study aimed to understand the effects of transporting ice slurry Particles through Pipes with branches. The experimental apparatus was constructed as ice slurry mixing tank. vortex pump, manometers for differential pressure measuring. IPF(ice packing factor) measuring instruments and branches as test sections. The experiments were carried out under various conditions. with concentration of water solution ranging between 0∼20wt% and velocity of water solution at the entry ranging between 1.5∼2.5m/s. The differential Pressure and IPF between the pipe entry and exit were measured. and flowing form was checked throughout the experiment. The pressure loss in 3d branches appeared compared with 6d branches so that it was very high. In the pressure loss of the inside and outside of branches. 6d branches was showed the difference. but was agreed in 3d branches The pressure loss according to concentration of water solution, low value appeared at 10wt% in 6d branches, at 20wt% in 3d branches. The pressure loss according to velocity, did not show large difference. The change of IPF at outlet, appeared +15∼-25% in 6d branches and 0∼-20% in 3d branches. The difference of IPF at the inside and outside of branches. appeared 10∼15% in 6d branches and maximum 5% in 3d branches.

• 대한설비공학회:학술대회논문집
• /
• 대한설비공학회 2006년도 동계학술발표대회 논문집
• /
• pp.5-5
• /
• 2006

• 태양에너지
• /
• 제16권2호
• /
• pp.65-77
• /
• 1996

동적형 빙축열 시스템의 빙축열조에서 세가지 얼음충진율에 대해 분산유체의 유온, 유량을 변화시켜 용융실험을 행하였다. 빙축열조에 분산되는 분산유체의 온도가 높고 유량이 많을수록 빙축열조 내의 온도성층화 현상도 뚜렸하였고 온도성층화에 돌입하는 시간이 단축되었다. 분산유체의 유량이 많을 때는 잠열이 방출되는 시기에 걸쳐서 빙축열조 내의 온도안정화 현상이 나타나고 온도안정화에 소요되는 시간도 단축되었다. 그러나 얼음의 용융이 끝난 후는 유량이 적을 때가 온도성층화 현상이 뚜렸하였다. 빙축열조 얼음충진율이 높을 때 온도성층화에 소요되는 시간이 길었으며 빙축열조 내 온도분포는 안정되었고 빙축열조의 벽면 영향으로 인해 빙축열조 상부의 온도가 높게 나왔다. 실험초기온도를 유지하는 기간은 빙축열조 내의 얼음이 존재하는 기간과 일치하였다. 빙축열조 내의 평균온도 상승은 분산유체의 유량이 많고 온도가 높을수록 일찍 상승하였다. 총방열에너지에 대한 잠열에너지($E/E_{ot}$)의 시간에 대한 변화비는 분산유체의 온도가 동일한 조건에서 유량이 많을수록, 분산유체의 온도가 높을수록 큰 값으로 나타났다.

• 에너지공학
• /
• 제19권4호
• /
• pp.234-239
• /
• 2010

원형 파이프를 유동하는 6.5% EG 수용액으로부터 만들어진 아이스슬러리의 열전달 특성을 분석하기 위한 실험을 수행하였다. 실험 장치의 시험부는 13.84 mm 내경과 1,500 mm의 길이를 가진 동관으로 제작되었다. 아이스슬러리는 시험부 주변에 이중관 형태로 만들어진 원형관 내부를 유동하는 온수에 의해 가열되었다. 본 연구의 실험에 적용된 IPF와 질량 유속은 각각 0 ~ 25% 그리고 1000 ~ 3,000 kg/$m^2s$의 범위이었고, 온수의 온도와 유량은 일정하게 유지하였다. 측정된 열전달량은 질량 유량과 IPF가 증가함에 따라 증가하였으나, IPF의 영향은 높은 질량 유량에서는 작은 것으로 나타났다. 낮은 질량유량에서는 열전달 계수의 급격한 상승이 15 ~ 20%의 IPF에서 나타났다. 마지막으로 측정된 열전달계수는 기존의 열전달상관식들에 의해 계산된 열전달계수와 비교하여 제시하였다.