• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2004.07a
• /
• pp.309-312
• /
• 2004

The electronic structure of ZnO oxide semiconductor having high optical transparency and good electric conductivity was theoretically investigated by $DV-X_{\alpha}$(the discrete variation $X_{\alpha}$) method, which is a sort of the first principle molecular orbital method using Hatre-Fock-Slater approximation. The electrical and optical properties of ZnO are seriously affected by the addition of impurities. The imnurities are added to ZnO in order to increase the electric conductivity of an electrode without losing optical transparency. In this study, the effect of impurities of III and IV family on the band structure, impurity levels and the density of state of ZnO were investigated. The cluster model used for calculations was $[MZn_{50}O_{53}]^{-2}$(M=elements belonging to III and IV family).

• Journal of Korean Society of Coastal and Ocean Engineers
• /
• v.27 no.2
• /
• pp.135-141
• /
• 2015

In this study, two different uniform placement methods are proposed for each of Tetrapod, Rakuna-IV, and Dimple armoring a rubble mound breakwater, and the corresponding stability coefficients are determined by hydraulic experiments. The Tetrapod and Rakuna-IV show similar stability coefficients regardless of the placement methods, whereas the Dimple shows somewhat different stability coefficients depending on the placement methods. It is shown that the Dimple gives the largest stability coefficient, whereas the Tatrapod gives the smallest value. The uniform placement methods of Tatrapod and Rakuna-IV give slightly larger stability coefficients than the random placement, whereas the uniform placements of Dimple give much larger stability coefficients than the random placement. However, the small void ratio of uniform placements of Dimple requires attention because the blocks would behave like single layer system blocks so that brittle failure could occur.

• The Korean Journal of Food And Nutrition
• /
• v.23 no.4
• /
• pp.607-614
• /
• 2010

The aim of this study was to investigate the quality characteristics of sponge cakes with added rice flour produced by a modified genoise method to prevent volume reduction. A control group and experimental group I were prepared by the genoise method and experimental groups II, III, and IV were produced by a modified genoise method in which they were mixed with wheat flour and water to a make paste to form gluten for 3, 6, and 9 minutes, respectively. One third of the wheat flour in all experimental groups was replaced by rice flour. The control and experimental groups were compared in terms of quality characteristics, including batter specific gravity, volume, color, textural characteristics, and sensory qualities, to determine the optimal pasting time for wheat flour in the formulation. The specific gravity of the experimental groups was higher than that of the control and decreased with increasing wheat flour pasting time. The volume of experimental group I was lower than that of the control group, and the volume values of experimental groups III and IV, made by the modified genoise method, were higher than that of the control group. $dL^*$ and $db^*$values for the crust and inside of the cake were lower in the experimental groups than in the control. The $dL^*$ value, indicating brightness, increased as pasting time increased. The hardness values of experimental groups I and IV were higher than that of the control whereas experimental groups II and III had lower hardness values. Chewiness was higher in the control group, as well as experimental groups I and IV than in the experimental groups II and III. The gumminess of experimental group IV was highest. Cohesiveness decreased by adding rice flour to the sponge cake. Sensory attributes of cell uniformity, tenderness, moistness, taste, and overall acceptability had the highest scores in experimental group III. Based on these results, we conclude that the quality of sponge cake containing one third of the wheat flour replaced by rice flour is best with 6 minutes pasting of the wheat flour to form gluten.

• Analytical Science and Technology
• /
• v.8 no.1
• /
• pp.1-7
• /
• 1995

Spectrophotometric determination of U(VI) and Th(IV) by Flow injection method is described. Chrome Azurol S forms water soluble complexes with U(VI) and Th(IV) in the presence of cethyltrimethylammonium bromide. The maximum adsorption of U(VI) and Th(IV) complexes are at 600nm with molar absorptivity of $2.3{\times}10^5Lmol^{-1}cm^{-1}$ and 611nm with molar absorptivity of $3.8{\times}10^5Lmol^{-1}cm^{-1}$ in acetate buffer medium having pH 5.0 and 5.5. The calibration curves of U(VI) and Th(IV) are linear over the range of 0.1~0.8ppm and the correlation coefficients are ca. 0.9960 and 0.9930 respectively. The detection limits(S/N) are 20ppb for U(VI) and 15ppb for Th(IV). The relative standard deviation are ${\pm}1.8%$ for U(VI) and ${\pm}2.1%$ for Th(IV). The sample throughput was ca. $50hr^{-1}$.

• Journal of Korean Society for Atmospheric Environment
• /
• v.6 no.2
• /
• pp.147-154
• /
• 1990

A sensitive method for the determination of total selenium in aerosol particles is described. The method involves dissolution of aerosol particles by $HNO_3-HClO_4$ mixed acids, pre-reduction of Se (VI) to Se (IV) by boiling hydrochloric acid, and hydride generation followed by atomic absorption detection. Dissolved Se (IV) in 4M hydrochloric acid is reacted with $NaBH_4$ to form $H_2Se$, which is subsequently collected in an U-tube cooled in liquid nitrogen. Upon the completion of $H_2Se$ generation, the collected $H_2Se$ is rapidly vaporized into a quartz cuvette burner by removing the U-tube from liquid nitrogen, atomized, and then detected by an atomic absorption spectrophotometer. The absolute sensitivity of the method is 0.49 ng/0.0044 Abs. The accuracy of the method evaluated by analyzing standard reference materials for urban aerosol is better than 10%. Analytical results for urban and rural aerosol particles are reported.

• Korean Journal of Food Science and Technology
• /
• v.40 no.4
• /
• pp.375-381
• /
• 2008

This study developed the simultaneous analysis method for efficient safety controls of import food of Orange II, Rhodamine B, Para Red, and Sudan dye I-IV among disapproved coloring agents that use is prohibited in foods. The analysis method was developed according to the sample pre-treatment and HPLC conditions, and a documentary survey was used to establish the detection limit of the method, followed by effectiveness verification and recovery percentage examinations. Recovery percentage examination for 26 products resulted Orange II displayed recovery percentage of 96.46-121.26%, Rhodamine B displayed recovery percentage of 70.86-106.53%, Para Red displayed recovery percentage of 97.00-116.86%, Sudan I displayed recovery percentage of 92.93-112.44%, Sudan II displayed recovery percentage of 96.63-115.10%, Sudan III displayed recovery percentage of 92.21-114.73%, Sudan IV displayed recovery percentage of 93.22-122.91%. Correlation coefficient of gradient of this analysis method exhibited more than 0.999, RSD exhibited fewer than 2 as 0.8-1.39%, exactitude exhibited more than 90%. At this time, detection limit and fixed quantity limit decided by each 0.1 mg/L, 0.3 mg/L.

• Korean Chemical Engineering Research
• /
• v.51 no.2
• /
• pp.195-202
• /
• 2013

$TiO_2$ powders were prepared from titanium (IV) sulfate ($Ti(SO_4)_2$) solution using ammonia solution at low reaction temperature ($80{\sim}100^{\circ}C$) and atmospheric pressure by hydrothermal precipitation method without calcination. The effect of reaction conditions, such as reaction temperature, initial concentration of titanium (IV) sulfate ($Ti(SO_4)_2$) solution, pH of mixture solution and the physical properties of the prepared $TiO_2$, such as crystallite structure, crystallite size were investigated. The photocatalytic activity of prepared $TiO_2$ was tested by the photolysis of brilliant blue FCF (BB-FCF) under the UV and the analysis of UV-VIS diffuse reflectance spectroscopy (DRS). The physical properties of prepared $TiO_2$ were examined by X-ray diffraction (XRD), scanning electron microscopy (SEM), photoluminescence spectrometer (PL), particle size distribution measurements. The crystallite size and crystallinity of prepared $TiO_2$ increased with increasing titanium (IV) sulfate ($Ti(SO_4)_2$) concentration, but photocatalytic activity decreased. The crystallite size decreased with increasing pH of mixture solution, but photocatalytic activity increased. The crystallinity and photocatalytic activity increased with increasing reaction temperature. The results showed that anatase type $TiO_2$ could be prepared by hydrothermal precipitation method using titanium (IV) sulfate ($Ti(SO_4)_2$) solution and ammonia solution at low reaction temperature and atmospheric pressure without calcination.

• Analytical Science and Technology
• /
• v.9 no.3
• /
• pp.221-234
• /
• 1996

Basic studies for the effective extraction of dibenzylammonium dibenzyldithiocarbamate(DBADBDC) complexes of Ag(I), Pd(II), Au(III) and Pt(IV) into chloroform have been conducted. The effects of pH on the extraction of ligand itself and metal cemplexes showed that DBADBDC itself was uniformly extracted in the pH range of 2~9 and metal complexes were effectively extracted at the pH range as follows. That is, Ag(I) : in an acidic aqua medium, Pd(II) : > 4, Au(III) : wide range, and Pt(IV) : > 3. The distribution ratio and extractabilities were obtained from the partition and extraction equilibria of metal-DBDC complexes between aqueous solution and chloroform. Ag(I) : log D=4.226 : E(%)=99.9% in the aqueous solution of pH 0, Pd(II) : log D=1.804 : E(%)=98.5% at pH 4~7, Au(III) : log D=3.755 : E(%)=99.9% at pH 2~10, and Pt(IV) : log D=0.165 : E(%)=57.2% at pH 8.0. And also mole ratio of metal ion to ligand in complexes were determined by mole ratio method : 1 : 1 for Ag(I) and 1 : 2 for Pd(II), Au(III) and Pt(IV). $Cl^-$ was included as a coordination species in complexes of Au(III) and Pt(IV). Besides, extraction mechanisms of compleses sere examined in the presence of chloride ion in an aquous solution, and extraction reactions and estraction constants could be proposed and calculated, respectively.

• The Plant Pathology Journal
• /
• v.22 no.1
• /
• pp.36-45
• /
• 2006

Twenty isolates of Didymella bryoniae were isolated from infected cucurbit plants in various growing areas of southern Korea in 2001 and 2002. Random Amplified Polymorphic DNA (RAPD) group [RG] I of D. bryoniae was more virulent than RG IV to watermelon. Virulence of the RG I isolate was strong to moderate to cucumber, whereas that of the RG IV varied from strong, moderate to weak. Two hundred seventy-three amplified fragments were produced with 40 primers, and were analyzed by a cluster analysis using UPGMA method with an arithmetic average program of NTSYSPC. At the distance level of 0.7, two major genomic DNA RAPD groups were differentiated among 20 isolates. The RG I included 7 isolates from watermelon and one isolate from melon, whereas the RG IV included 12 isolates from squash, cucumber, watermelon and melon. Amplification of internal transcribed spacer (ITS) region and small subunit rRNA region from the 20 isolates yielded respectively a single fragment. Restriction pattern with 12 restriction enzymes was identical for all isolates tested, suggesting that variation in the ITS and small subunit within the D. bryoniae were low. Amplification of the genomic DNAs of the tested isolates with the sequence characterized amplified regions (SCAR) primer RG IF-RG IR specific for RG I group resulted in a single band of 650bp fragment for 8 isolates out of the 20 isolates. Therefore, these 8 isolates could be assigned into RG I. The same experiments done with RG IIF-RG IIR resulted in no amplified PCR product for the 20 isolates tested. An about 1.4 kb-fragment amplified from the RG IV isolates was specifically hybridized with PCR fragments amplified from genomic DNAs of the RG IV isolates only, suggesting that this PCR product could be used for discriminating the RG IV isolates from the RG I isolates as well other fungal species.

• Journal of Korean Neurosurgical Society
• /
• v.50 no.3
• /
• pp.205-208
• /
• 2011

Objective : Retrospective analysis to compare the effect and complication of epidural patient-controlled analgesia (epidural PCA) with intravenous patient-controlled analgesia (IV PCA) for the treatment of the post-operative pain after posterior lumbar instrumented fusion. Methods : Sixty patients who underwent posterior lumbar instrumented fusion for degenerative lumbar disease at our institution from September 2007 to January 2008 were enrolled in this study. Out of sixty patients, thirty patients received IV PCA group and thirty patients received epidural PCA group. The pain scale was measured by the visual analogue scale (VAS) score. Results : There were no significant difference between IV PCA group and epidural PCA group on the PCA related complications (p=0.7168). Ten patients in IV PCA group and six patients in epidural PCA group showed PCA related complications. Also, there were no significant differences in reduction of VAS score between two groups on postoperative 2 hours (p=0.9618) and 6 hours (p=0.0744). However, postoperative 12 hours, 24 hours and 48 hours showed the significant differences as mean of reduction of VAS score (p=0.0069, 0.0165, 0.0058 respectively). Conclusion : The epidural PCA is more effective method to control the post-operative pain than IV PCA after 12 hours of spinal fusion operation. However, during the first twelve hours after operation, there were no differences between IV PCA and epidural PCA.