• Korean Journal of Materials Research
• /
• v.29 no.5
• /
• pp.297-303
• /
• 2019

A triple-layered $PMMA/Ni_{64}Zr_{36}/PDMS$ hydrogen gas sensor using hydrogen permeable alloy and flexible polymer layers is fabricated through spin coating and DC-magnetron sputtering. PDMS(polydimethylsiloxane) is used as a flexible substrate and PMMA(polymethylmethacrylate) thin film is deposited onto the $Ni_{64}Zr_{36}$ alloy layer to give a high hydrogen-selectivity to the sensor. The measured hydrogen sensing ability and response time of the fabricated sensor at high hydrogen concentration of 99.9 % show a 20 % change in electrical resistance, which is superior to conventional Pd-based hydrogen sensors, which are difficult to use in high hydrogen concentration environments. At a hydrogen concentration of 5 %, the resistance of electricity is about 1.4 %, which is an electrical resistance similar to that of the $Pd_{77}Ag_{23}$ sensor. Despite using low cost $Ni_{64}Zr_{36}$ alloy as the main sensing element, performance similar to that of existing Pd sensors is obtained in a highly concentrated hydrogen atmosphere. By improving the sensitivity of the hydrogen detection through optimization including of the thickness of each layer and the composition of Ni-Zr alloy thin film, the proposed Ni-Zr-based hydrogen sensor can replace Pd-based hydrogen sensors.

• Journal of the Korean Institute of Illuminating and Electrical Installation Engineers
• /
• v.27 no.3
• /
• pp.1-6
• /
• 2013

In this study, we propose a fiber-optic hydrogen sensor using a polarization-diversity loop configuration composed of a polarization beam splitter, two quarter-wave plates, and a polarization-maintaining fiber coated with palladium whose thickness is ~400nm. One transmission dip of the output interference spectrum of the proposed sensor, chosen as a sensor indicator, was observed to spectrally shift with the increase of the hydrogen concentration, and the sensing indicator showed a wavelength shift of ~2.48nm at a hydrogen concentration of 4%. Except for a hydrogen concentration of 4%, the response time of the proposed sensor was measured as less than 12.5s and did not show significant dependence on the hydrogen concentration. In particular, the proposed fiber hydrogen sensor is more durable and highly resistant to external stress applied on a transverse axis of an optical fiber, compared with other hydrogen sensors based on side-polished fibers or fiber gratings.

• Transactions of the Korean hydrogen and new energy society
• /
• v.27 no.5
• /
• pp.510-516
• /
• 2016

This study examines the effects of linear alkylbenzene sulfonate on hydrogen fermentation of food waste. The hydrogen production rate was similar with different linear alkylbenzen sulfonate (LAS) concentrations. The maximum hydrogen yield increased with increasing LAS concentration. The highest maximum hydrogen yield was $0.550{\pm}0.005mol$ H2/mol hexose at LAS for 5.52 mg/L. But the maximum hydrogen yield decreased above LAS for 11.05 mg/L. The concentration of acetate in control reactor was increased, but it decreased with increasing LAS concentration in other reactors.

• Nuclear Engineering and Technology
• /
• v.47 no.2
• /
• pp.139-147
• /
• 2015

Recently, severe accidents in nuclear power plants (NPPs) have become a global concern. The aim of this paper is to predict the hydrogen buildup within containment resulting from severe accidents. The prediction was based on NPPs of an optimized power reactor 1,000. The increase in the hydrogen concentration in severe accidents is one of the major factors that threaten the integrity of the containment. A method using a fuzzy neural network (FNN) was applied to predict the hydrogen concentration in the containment. The FNN model was developed and verified based on simulation data acquired by simulating MAAP4 code for optimized power reactor 1,000. The FNN model is expected to assist operators to prevent a hydrogen explosion in severe accident situations and manage the accident properly because they are able to predict the changes in the trend of hydrogen concentration at the beginning of real accidents by using the developed FNN model.

• Journal of the Korean Society of Clothing and Textiles
• /
• v.29 no.11
• /
• pp.1454-1464
• /
• 2005

The study was based on a three-stage, non-repetitive factorial experiment in which chemical-rotted kenaf fibers were treated separately with hydrogen peroxide concentrations of $0.5\%,\;1\%\;and\;2\%$, with pH solutions of 7, 9 and 11, and treatment times of 30, 60 and 90 minutes. Under optimal conditions, the study was conducted to determine the strength and elongation of kenaf fibers by the addition of chelators, penetrants and surfactants. The hydrogen peroxide concentration, solution pH and treatment time directly affected the strength of kenaf fibers. The hydrogen peroxide concentration, solution pH affected the elongation of kenaf fibers. It was found, however, that the interaction between pH and treatment time, concentration and treatment time, concentration and treatment time and pH affected the strength of kenaf fibers. Also, It was found that the interaction between pH and concentration, concentration and treatment time, concentration and treatment time and pH affected the elongation of kenaf fibers. Under the hydrogen peroxide conditions of $2\%$ concentration, pH 11 and a treatment time of 60 minutes, there were no effects on the strength and elongation of kenaf fibers with the addition of chelator SP, CA.

• Microbiology and Biotechnology Letters
• /
• v.17 no.6
• /
• pp.629-633
• /
• 1989

In the continuous reactor, the hydrogen production rate and residual glucose concentration were increased with increase of input glucose concentration, dilution rate, and recycle rate. The maximum production rate was 91 mL/Lㆍh at dilution rate 0.4/h, input glucose concentration 5.4g/L, and recycle rate 70/h in this experimental range.

• Transactions of the Korean hydrogen and new energy society
• /
• v.18 no.4
• /
• pp.382-390
• /
• 2007

To check the feasibility of SMART(Steam Methane Advanced Reforming Technology) system, an experimental investigation was performed. A fluidized bed reactor of diameter 0.052m was operated cyclically up to 10th cycle, alternating between reforming and regeneration conditions. FCR-4 catalyst was used as the reforming catalyst and calcined limestone(domestic, from Danyang) was used as the $CO_2$ absorbent. Hydrogen concentration of 98.2% on a dry basis was reached at $650^{\circ}C$ for the first cycle. This value is much higher than $H_2$ concentration of 73.6% in the reformer of conventional SMR (steam methane reforming) condition. The hydrogen concentration decreased because the $CO_2$ capture capacity decreased as the number of cycles increased. However, the average hydrogen concentration at 10th cycle was 82.5% and this value is also higher than that of SMR. Based on these results, we could conclude that the SMART system can replace SMR system to generate pure hydrogen without HTS (high tempeature shift), LTS (low temperature shift) and $CO_2$ separation process.

• Nuclear Engineering and Technology
• /
• v.52 no.9
• /
• pp.2041-2046
• /
• 2020

The present article investigates the influence of hydrogen concentration on the creep performance of cold-worked stress-relieved unirradiated Zircaloy-4 cladding tube using nanoindentation technique. The as-received Zircaloy-4 tube is hydrided to the concentrations of 600 ppm and 900 ppm using gaseous hydrogen charging method. Constant load indentation creep tests are performed for a dwell period of 600 s in the temperature range of 300℃-500 ℃ at 1000 μN, 2000 μN, and 3000 μN. The impact of hydrogen is evaluated in terms of steady state power law creep exponent and activation energy. The power law creep exponent decreases with increase in hydrogen concentration, however, it remains fairly constant with increase in temperature up to 500 ℃. Moreover, activation energy too decreases significantly with increase in hydrogen concentration. The mean stress exponent and activation energy are found to be 3.58 and 28.67 kJ/mol, respectively, for as-received sample.

• Proceedings of the Korean Society of Soil and Groundwater Environment Conference
• /
• 2004.09a
• /
• pp.191-194
• /
• 2004

The concentration of hydrogen peroxide in soil and effluent was measured to understand the relationship between the profile of hydrogen peroxide and the removal efficiency of phenanthrene in an Electrokinetic-Fenton process. Electrokinetic phenomena were observed in two different conditions for 1, 2, 4, and 7 days; 3.5% and 10% hydrogen peroxide. The concentration of hydrogen peroxide in soil was high near the anode and decreased towards the cathode due to the direction of electroosmosis. The hydrogen peroxide concentration in effluent increased with time, but the value was lower than the initial. The removal efficiency of phenanthrene at 10% hydrogen peroxide was higher than the case at 3.5%. The removal efficiency after 7 days was high(> 97%) in both cases.

• KSBB Journal
• /
• v.8 no.3
• /
• pp.243-255
• /
• 1993

In this study, it was observed that hydrogen Productivity varied with stirrer speed, bead radius, input glucose concentration and dilution rate in a continuous stirred tank reactor in which immobilized R. rubrum KS-301 was used as a hydrogen-producing bacterium The mass transfer resistance due to cell immobilization was also studied. In order to estimate an effectiveness factor, Des of glucose was first obtained, which was subsequently represented by the correlation equation between Dos and Xb, As a result external mass transfer resistance could be neglected for stirrer speeds greater than 400rpn With bead radius increasing, the hydrogen productivity and internal effectiveness factor decreased. With input 91ucose concentration increasing, the hydrogen productivity and interval and external effectiveness factor increased. Although an Internal effectiveness factor was not affected, hydrogen productivity Increased with dilution rate increasing. An overall effectiveness factor remained nearly constant for the dilution rates investigate4 but increased with input 91ucose concentration increasing.