• Journal of the Korean earth science society
• /
• v.42 no.6
• /
• pp.646-661
• /
• 2021

The Zagros fold-thrust belt formed from the collision of the Arabian and Eurasian plates during Cenozoic periods and extends for 2,000 km, from Turkey to the Hormuz Strait, in the northeast-southwest direction. Anticline traps in the front of the Zagros thrust fold hold approximately 8% of the world's petroleum reserves. Middle Cretaceous to Early Miocene petroleum systems of the belt have the largest original oil in place (OOIP). The oil is expelled from Kazhdumi and Pabdeh source rocks, and accumulated in the Asmari and Bangestan (including Sarvak and Ilam formations) reservoir rocks covered by the evaporitic Gachsaran and the marly Gurpi formations. The hydrocarbons trapped in the Asmari and Sarvak reservoirs are mainly charged (more than 90%) by the Kazhdumi Formation whereas the rest are charged by the Pabdeh Formation. In the Dezful Embayment, all the large high-relief anticlines have been drilled into, except in the Asmari, Sarvak and Khami formations, where a few anticlines of smaller size and deeper strata remain unexplored. Therefore, the exploration potential of these regions strengthens our understanding of the Zagros fold-thrust belt's petroleum system.

• The Journal of The Korea Institute of Intelligent Transport Systems
• /
• v.20 no.6
• /
• pp.177-191
• /
• 2021

One of the major causes of serious air pollution worldwide is emissions from road transportation. A number of countries are working to reduce vehicle emissions, and the Seoul Metropolitan Government is also implementing active policies to reduce emissions by setting a target of 40% by 2030. Implementing these policies requires the introduction of practical indicators. Most of the domestic emissions are calculated by the emission coefficient, a function of speed at the National Institute of Environmental Research under the Ministry of Environment, but the dynamic variable speed is limited to being used as an indicator of the number of eco-friendly vehicles. Therefore, this study calculated the emission rates in Seoul using the vehicle registration data of Seoul and the vehicle inspection data from the Korea Transportation Safety Authority. The tendency of emissions was determined according to key variables such as vehicle type, fuel and mileage. Emissions were based on carbon monoxide, hydrocarbons, nitrogen oxides and particulate matter measured by vehicle inspection from the Korea Transportation Safety Authority. As a result, the emission rates showed a significant trend according to the model year and mileage. This can be used as a policy indicator to preferentially switch commercial vehicles with old model years and long mileage when switching eco-friendly vehicles in Seoul.

• Journal of Soil and Groundwater Environment
• /
• v.27 no.2
• /
• pp.50-60
• /
• 2022

The concentration levels and distribution characteristics of 16 polycyclic aromatic hydrocarbons (PAHs) were investigated and evaluated for total 100 soil samples as a part of the survey on soil contamination in Gwangju. The results (median and range) of T-PAHs (sum of 16 PAH concentrations), C-PAHs (sum of carcinogenic PAH concentrations) and T-TEQs (sum of 16 TEQ concentrations) were 20.8 (7.6~1158.1), 2.2 (N.D~509.6), and 0.3 (N.D~424.6) ㎍/kg, respectively. There was a positive correlation between C-PAHs/T-PAHs and T-TEQs/T-PAHs except one point where the concentration of benzo(a)pyrene was high. The ratios of the C-PAHs/T-PAHs were 31.7% for low molecular weight-PAHs and 68.3% for high molecular weight-PAHs, suggesting that PAHs generation mainly arose from combustion sources. The ratio of isomers of individual PAHs, Phe/Ant, Flu/Pyr, Ant/(Ant+Phe), Flu/(Flu+Pyr), and BaA/(BaA+Chr), also confirmed the predominance of PAHs from combustion activities. Statistical tracing of the source of PAHs through principal component analysis indicated that the main sources of combustion were automobile fuel and coal. The overall results of this study suggested HMW-PAHs, T-PAHs, C-PAHs and T-TEQs should be separately evaluated to better assess the toxicity and environmental behavior of individual PAHs.

• Korean Journal of Pharmacognosy
• /
• v.53 no.3
• /
• pp.170-180
• /
• 2022

Polycyclic aromatic hydrocarbons(PAHs) contents were analyzed by measuring benz(a)anthracene(BaA), chrysene(Chr), benzo(b)fluoranthene(BbF) and benzo(a)pyrene(BaP), and the related risk characterization was conducted for 113 samples out of 14 different agricultural products used for food and medicine. Detection rate of PAHs was 90.3% as a whole, and the highest one was 80.5% for BaP. The detection rate of BaP exceeding the maximum permitted concentration of Rehmanniae Radix Preparata and Rehmanniae Radix, 5.0 ㎍/kg was 1.8%, and the detection rates of BaA, Chr and BbF were within the range of 2.7~10.6%. The highest average concentration of BaA was 3.41 ㎍/kg detected from Lycii Fructus, while those of Chr, BbF, BaP and PAH4(sum of detected BaA, Chr, BbF and BaP) were 5.00, 1.79, 2.36, 12.36 ㎍/kg, respectively, detected from Rehmanniae Radix Preparata. As for the risk characterization on PAHs, the overall MOE(Margin of Exposure) values were measured within the range of 10⁵~10⁷, which is unlikely to cause direct health concerns, but the worring values of MOE were measured 6.57×10⁴ for BaP and 6.10×10⁴ for PAH4 from Rehmanniae Radix Preparata, which may require an improvement plan to reduce BaP contents.

• Applied Chemistry for Engineering
• /
• v.34 no.1
• /
• pp.15-22
• /
• 2023

Recent studies have actively investigated ways to improve the economic feasibility and efficiency of the Fischer-Tropsch process by increasing the yields of the monocyclic aromatic compounds (BTEX). In this study, ethylene was selected as a model of F-T-derived hydrocarbons, and the ethylene-to-aromatics (ETA) reaction was investigated according to changes in acid characteristics, mesopores, and crystallinity of HZSM-5 (HZ5). Fluorinated HZ5 was prepared by calcination followed by impregnation of an aqueous NH₄F solution having different molar concentrations in HZ5, and the structural and chemical properties of F/HZ5 were investigated through Brunauer-Emmett-Teller (BET), solid-state nuclear magnetic resonance (NMR), X-ray photoelectron spectroscopy (XPS), NH₃-temperature-programmed desorption (TPD), and pyridine-IR spectroscopy. The ETA reactions were performed at 673 K under 0.1 MPa, and fluorinating HZ5 by an aqueous NH₄F solution of 0.17 M improved ethylene conversion, BTEX selectivity, and catalytic stability due to acidity, mesopore fraction, and crystallinity.

• Clean Technology
• /
• v.29 no.3
• /
• pp.185-192
• /
• 2023

This study was conducted to obtain basic process simulation data before conducting pyrolysis experiments for the development of a thermochemical conversion system by recirculation of heat carrier and gases thereby. In this study, polypropylene (PP) was used as a pyrolysis sample material as an alternative to waste plastics, and fluid sand was used as a heat transfer medium in the system. Manganese (Mn) was chosen as the catalyst for the pyrolysis experiment, and the catalyst pyrolysis was performed by impregnating it in the sand. The basic properties of PP were analyzed using a thermogravimetric analyzer (TGA), and liquid oil was generated through catalytic pyrolysis under a nitrogen atmosphere at 600℃. The carbon number distribution of the generated liquid oil was confirmed by GC/MS analysis. In this study, the effects of the presence and the amount of Mn loading on the yield of liquid oil and the distribution of hydrocarbons in the oil were investigated. When Mn/sand was used, the residue decreased and the oil yield increased compared to pyrolysis using sand alone. In addition, as the Mn loading increased, the ratio of C₆~C₉ range gasoline in the liquid oil gradually increased, and the distribution of diesel and heavy oil with more carbon atoms than C₁₀ in the oil decreased. In conclusion, it was found that using Mn as a catalyst and changing the amount of Mn could increase the yield of liquid oil and increase the gasoline ratio in the product.

• Clean Technology
• /
• v.29 no.2
• /
• pp.118-125
• /
• 2023

Once a site is contaminated with polychlorinated biphenyls (PCBs), serious environmental and human health risks are inevitable. Therefore, innovative but economical in situ remediation technologies must be immediately applied to the contaminated site. Recently, nanoscale zero-valent iron (nano-ZVI) particles have successfully been applied for the dechlorination of various chlorinated organic compounds like TCE, PCE and DDT, and they are considered to be environmentally safe due to the high abundance of iron in the earth's crust. Nano-ZVIs are much more reactive than granular ones, but tend to agglomerate due to their high surface energy and magnetic properties. In order to prevent them from being agglomerated toward larger particles, TiO₂ was used as a support to immobilize the nano-ZVI particles as much as possible. 10wt% ZVI/TiO₂ was prepared by adding NaBH₄ slowly into an FeSO₄/TiO₂ aqueous slurry. In spite of their non-uniformity in size, the nano-ZVI particles were quite successfully dispersed onto the exterior surface of a non-porous TiO₂ powder. The ZVI/TiO₂ was then employed to degrade Aroclor 1242, a kind of PCBs standard, in spiked soil, and its reactivity towards the degradation of Aroclor 1242 was investigated. The fabricated ZVI/TiO₂ degraded Aroclor 1242 in soil quite effectively, but the creation of remaining dechlorinated compounds, possibly high molecular weight hydrocarbons, in the soil was unavoidable.

• Analytical Science and Technology
• /
• v.19 no.5
• /
• pp.415-421
• /
• 2006

The following concentrations of some PAHs were investigated; [benzo(a)anthracene, chrysene, benzo(b)fluoranthene, benzo(k)fluoranthene, benzo(a)pyrene, dibenzo(a,h)anthracene, benzo(g,h,i)perylene, indeno (1,2,3-c,d)pyrene] in vegetables(n=160) and fruits(n=50). The food samples were purchased at the local markets in Seoul, Chuncheon, Daejeon, Kwangju and Pusan. The samples were radish, onion, bean sprouts, welsh onion, chinese cabbage, spinach, young pumpkin, garlic, cucumber, carrot, lettuce, sesame leaf, tangerine, persimmon, apple, pear and banana. The methodology involved ultrasonic extraction with dichloromethane, clean-up on Sep-Pak florisil cartridges and determination by HPLC/FLD (High Performance Liquid Chromatography/Fluorescence Detector). Overall method recoveries for 8 PAHs spiked into these products ranged from 95 to 102%. The mean level of the following PAHs were determined; benzo(a)anthracene, chrysene, benzo(b)fluoranthene, benzo(k)fluoranthene, benzo(a)pyrene, dibenzo(a,h)anthracene, benzo(g,h,i)perylene and indeno(1,2,3-c,d)pyrene in vegetables and fruits was N.D., 0.014 ng/g, 0.031 ng/g, 0.016 ng/g, 0.019 ng/g, 0.091 ng/g, 0.016 ng/g and N.D., respectively.

• Analytical Science and Technology
• /
• v.19 no.1
• /
• pp.86-95
• /
• 2006

This study was carried out to estimate leaching characteristics of incineration residues from municipal solid waste incinerators, and determine organic compounds in raw ash, leaching water and leaching residue. A total of 44 organic compounds, which were analyzed by GC/MSD and identified by wiley library search, were contained in bottom ashes. A total of 17 organic compounds were contained in fly ashes. Bottom ash and fly ash were found to contain a wide range of organic compounds such as aliphatic compounds and aromatic compounds. Organic compounds such as Ethenylbenzene, Benzaldehyde, 1-Phenyl-Ethanone and 1,4-Benzenedicarboxylic acid dimethyl ester were detected in raw ash, leaching water and residues (from bottom ash). Organic compounds such as Naphthalene, Dodecane, 1,2,3,5-Tetrachlorobenzene, Tetradecane, Hexadecane and Pentachlorobenzene were detected in raw ash, leaching water and residues (from fly ash). Through the leaching characteristics of incineration residue, it was represented that the open dumping of incineration residue can contaminate the soil and undergroundwater. In order to prevent environmental contamination that derived from extremely toxic substances in the incineration residues, it is particularly important that the incineration residues should be treated before disposal the incineration residues. Further study and proper management about leaching characteristics of organic compounds might be required.

• Conservation Science in Museum
• /
• v.30
• /
• pp.47-70
• /
• 2023

In 2019, the first excavation survey was conducted at the Temple Site No. 4 of Yaksugok Vally in Namsan Mountain, Gyeongju to determine the original location of the headless stone Buddha statue and the structure of the temple site. The survey excavated a stone Buddha head that was confirmed in a comparative analysis to be petrologically and mineralogically identical to a headless stone seated Buddha statue found derelict nearby. Traces of gold leaf and black adhesive were found on a portion of the right side of the face of the Buddha head buried in the ground. Since it is exceedingly rare for lacquer and gilding techniques to have been applied to a large stone Buddha statue without a base layer, this study examines the gilding techniques of the time by analyzing the characteristics of the materials used. In this process, the structure of the gold foil was observed through analytical microscopy and scanning electron microscopy with energy dispersive X-ray spectrometry, and the gold (Au) component was identified. As a result of analyzing the black adhesive using pyrolysis-gas chromatograph/mass spectrometry (pyrolysis-GC/MS), pyrolysis compounds such as hydrocarbons, fatty acids, catechol, and catechol oxidation products were detected. This was identical to the characteristics identified upon analyzing lacquer collected from species of lacquer tree whose main component is urushiol. Therefore, it was confirmed that the stone Buddha head excavated from the Temple Site No. 4 of Yaksugok Valley was separated from a nearby stone seated Buddha statue, and that the gold foil was attached using lacquer sap collected from lacquer trees, which grow in Korea, China, and Japan.