• Proceedings of the Korean Society of Tribologists and Lubrication Engineers Conference
• /
• 1998.10a
• /
• pp.181-189
• /
• 1998

In order to investigate the effect of base oil composition on the electronic insulating oil's performances, an experimental study has been conducted using different oils. Owing to their properties, like lower pour point and gas absorbing, naphthenic base oils are used more often than paraffmic base oils for the electronic insulating oil application. Naphthenic and paraffinic base oils are significantly different in their aromatic hydrocarbon content. In this paper, PXE(para xylyl ethane), LAB(linear alkylbenzene), C13 aromatic hydrocarbon mixture and C17 aromatic hydrocarbon mixture are investigated regarding their influence on insulating oil's performances. According to present study, breakdown voltage decreased with increasing aromatic lydrocarbon content in a deep dewaxed paraffmic base oil. However, any changing in the dissipation factor was not recognizable at small treated level. Furthermore, the volume resistance was not influenced by aromatic hydrocarbon content. The gassing tendency was found as a highly sensible property, changing with treating aromatic hydrocarbons. The higher benzene ring content in the hydrocarbon, the better gassing tendency.

• Proceedings of the KAIS Fall Conference
• /
• 2011.12a
• /
• pp.349-352
• /
• 2011

본 연구를 통해 개발하고자 하는 Wire-Mesh Type Mist Eliminator는 탄화수소(Hydrocarbon)를 취급하는 석유화학 공정 내에서 Vapor 중에 존재하는 $10{\mu}m$ 이하크기의 미세한 액체 Mist를 분리하는데 사용되는 화학 공정플랜트 요소부품이다. 석유화학 공정에서 발생되는 $5{\mu}m$이하의 크기를 가지는 액체 Mist를 제거하기 위해서는 Stainless와 Polypropylene 재질이 혼합된 새로운 WMT Mist Eliminator 국산화 제품개발 시급하다. 실험을 통해 확보한 인자를 바탕으로 제작된 시제품의 분석결과 석유 화학공정에 이용이 가능한 것을 확인하고 성능이 우수함을 알 수 있었다.

• Transactions of the Korean Society of Automotive Engineers
• /
• v.11 no.1
• /
• pp.1-6
• /
• 2003

Engine emission regulations are becoming more stringent nowadays. In cold transient regime, about 80% THC is exhausted to the atmosphere in the first 200s (US FTP cycles). Accordingly, reducing emission levels in the cold period immediately after the engine start before the catalysts reach their working temperature will be an especially critical factor in meeting more stringent regulations in the future. In this study, the total hydrocarbon quantities are measured using a Fast FID with gasoline fuel for a 4-cylinde. Sl engine, including Secondary Air Injection (SAI) system. Commercial SAI device's direction is reverse to the exhaust flow. In this study, a swirl flow type SAI system which is positioned between the exhaust manifold and exhaust port, was developed. We compared the swirl type secondary air injection with a commercial secondary air injection of .everse flow. The swirl type SAI showed better results in reducing HC by 26% than the commercial flow type SAI of reverse flow which was caused by the better mixing between the exhaust gas and the secondary air.

• Macromolecular Research
• /
• v.14 no.3
• /
• pp.365-372
• /
• 2006

Poly[styrene-b-(ethylene-co-butylene)-b-styrene](SEBS) triblock copolymer was studied by dissolving the ethylene butylene midblock in selective hydrocarbon oils. These oils differ in their aromatic, paraffinic and naphthenic content. Dynamic rheological studies showed that the storage modulus (G') exceeded the loss modulus (G') for all the gels over the entire range of frequency, thereby confirming them as physical gels. However, the behavior of G' and G' as a function of frequency depended primarily on the oil type. The gelation melting temperature decreased drastically with increased oil aromaticity. Small angle X-ray scattering studies revealed that the maximum interdomain interference shifted to a higher angle depending on the composition and type of hydrocarbon oil.

• Journal of Environmental Health Sciences
• /
• v.23 no.4
• /
• pp.82-90
• /
• 1997

This study was conducted to establish an ideal condition for obtaining maximum extraction efficiencies using an array of soil types and under a wide variety of conditions. Nine characteristic compounds were studied: benzene, toluene, ethylbenzene, o-xylene, m-xylene, p-xylene, n-propylbenzene, 1,2,4-trimethylbenzene, and n-butylbenzene which were found in gasoline. Increasing the moisture content resulted in decreased recovery, and recovery of hydrocarbons from wet soils was significantly lower than from dry soils. For the batch extraction process, 4 hours of extraction time was sufficient to give optimum recovery of the contaminants. With methanol as an extraction solvent, maximum recovery time appeared to be reached quicker for BTEX components than with 2-propanol. The 2 to 1 ratio of solvent/soil was chosen as a compromise to provide for the indicated minimum solvent use and high extraction efficiency. The 0.4 mg/g soil contamination was adequate to show quantitative recovery. The percent recovery of BTEX was concentration dependent more than the semivolatile compounds. Methanol and 2-propanol consistently gave higher efficiency than water. Methanol was superior to 2-propanol in removing contaminants from silty clay loam soil. Using the most efficient extraction procedure, the average recovery of the light hydrocarbons from the three soils was 66 percent. Recoveries were also dependent on soil type, solvent type, extraction time, solvent amount, contaminant concentration, and compounds volatility. This study provided a useful screening technique for procedures that can be used to remediate soils contaminated with light hydrocarbons.

• Applied Chemistry for Engineering
• /
• v.16 no.1
• /
• pp.21-27
• /
• 2005

In order to conduct research on oil originated in Mongolia for further application of petroleum not only as fuel but also as raw material for organic synthesis, we need to study the physical, chemical characteristics and individual, group hydrocarbon's compositions of main petroleum fractions. A number of studies and surveys on the physical and chemical characteristics, group hydrocarbon's composition of petroleum deposits in Zuun-Bayan, Sukhaibulag, Tsagaan Elst, Tamsagbulag have been carried out earlier through n-g-M, aniline point and dispersimetric methods successfully. Yet a detailed chromatographical and NMR spectroscopic study for the individual hydrocarbon's composition of Tamsagbulag oil main fractions has not been conducted. In the present study the results of GC analyses of gasoline fractions of wells 19-3, 19-13 and 19-10, Tamsagbulag (Eastern Mongolia) were presence. The gasoline fractions of given wells were characterized by the high concentration of paraffins and presence of trace amount of olefins. There were identified 69 paraffins, 45 naphthenes, 41 aromatics and 3 olefins in total 158 individual hydrocarbons from each samples of gasoline fraction. The first attempts to classify Tamsagbulag oil under the individual hydrocarbon's composition data were successfully conducted and the supposition of a genetic classification of given oil as "sapropelic" type was made.

• Bulletin of the Korean Chemical Society
• /
• v.30 no.4
• /
• pp.945-947
• /
• 2009

• Elastomers and Composites
• /
• v.39 no.4
• /
• pp.318-323
• /
• 2004

Cloud-point and bubble-point curves for poly(ethylene-co-13.8 mol% octene) ($PEO_{13.8}$) and Poly(ethylene-co-15.3 mol% octene) ($PEO_{15.3}$) were determined up to $150^{\circ}C$ and 450 bar in hydrocarbons which have different molecular size and structure. Whereas ($PEO_{15.3}$+ n-pentane) system has cloud-point and bubble-point type transitions, ($PEO_{15.3}$+ n-propane) and ($PEO_{15.3}$+ n-butane) systems do only cloud-point type transition. In cyclo-pentane, -hexane, -heptane, and -octane, $PEO_{15.3}$ has a bubble-point transition. ($PEO_{13.8}$+ n-butane) mixture has a critical mixture concentration at 5 wt% PEO. (PEO + hydrocarbon) mixtures exhibit LCST type behavior. Solubility of PEO increases with hydrocarbon size due to increasing dispersion interaction which is favorable to dissolve PEO.

• Proceedings of the Korean Society of Toxicology Conference
• /
• 2005.05a
• /
• pp.108-108
• /
• 2005

• Journal of the Society of Cosmetic Scientists of Korea
• /
• v.22 no.2
• /
• pp.20-40
• /
• 1996

The oil in water type ME of 4 component system was composed with POE monoalkyl ether and POE sorbitan monoalkyl ester as surfactant, saturated hydrocarbon, side chain structure and aromatic structure as oil, and glycerine as cosurfactant using high pressure homogenizer. The objective of this study was to examine the role of surfactant and oil structure on droplet size and stability. The experimental results showed that the droplet size was smaller with bigger polarity of oil, less hydrocarbon, longer hydrophilic chain of surfactant and higher concentration of glycerine. SQ and LP systems showed very stable but AB and ISB system unstable microemulsion.