• 한국항해학회지
• /
• 제18권4호
• /
• pp.49-57
• /
• 1994

In marine transportation of bulk cargoes such as crude oil. ore, coal etc., a lot of full form ship which have poor manoeuvrability were presented in many countries. Since ship manoeuvrability depends upon many parameters namely hydrodynamic derivatives, interference factors etc., as external forces, it is of great importance that we investigate these values of parameters on analysis of manoeuvrability. In this paper, we investigated and analyzed interaction coefficients among hull-propeller-rudder for a full form ship by captive model test in circulating water channel, and then compared with experimental results by PMM test. A tanker model ship which has 0.83 as block coefficient and MMG mathematical models were used in this experiment. Almost same tendencies were found in qualitative analysis, even though more serial experiments were demanded in quantitative analysis.

• 대한조선학회논문집
• /
• 제53권6호
• /
• pp.494-502
• /
• 2016

The accurate assessment of hull-appendage interaction in the early design stage is important to control the inflow to the propeller plane, which can cause undesirable hydrodynamic effects in terms of cavitation phenomenon. This paper describes a numerical analysis for the flow around a fully appended surface ship model for which KRISO has carried out a model test in the Large Cavitation Tunnel(LCT). This numerical study was performed with the LCT model test in a complementary manner for a good reproduction of the wake distribution of surface ships. A second order accurate finite volume method provided by a commercial computational fluid dynamics(CFD) program was used to solve the governing Reynolds Averaged Navier-Stokes(RANS) equations, where the SST $k-{\omega}$ model was used for turbulence closure. The numerical results were compared to available LCT experimental data for validation. The calculations gave good predictions for the boundary layer profiles on the walls of the empty cavitation tunnel and the wake at the propeller plane of the fully appended hull model in the LCT.

• 대한조선학회논문집
• /
• 제59권1호
• /
• pp.1-8
• /
• 2022

To understand physical phenomena of ship maneuvering deeply, a numerical study based on computational fluid dynamics is required. A computational method that can simulate the interaction between the ship hull, propeller, and rudder will provide informative local flows during ship maneuvering tests. The analysis of local flows can be applied to improve a physical model of ship maneuvering that has been widely used in maneuvering simulations. In this study, the numerical program named as WAVIS that has been developed for ship resistance and propulsion problems is extended to simulate ship maneuvering by free-running tests. The six degree-of-freedom of ship motion is implemented based on Euler angles and the overset technique is applied to treat the moving grid of ship hull and rudder. The propulsion force due to a propeller is calculated by a panel method that is based on the lifting-surface theory. The newly extended code is applied to simulate turning and zig-zag tests of KCS and the comparison with the available experimental data has been made.

• 대한조선학회논문집
• /
• 제34권3호
• /
• pp.9-18
• /
• 1997

복합추진장치가 포함된 경우와 포함되지 않은 경우의 축대칭 물체 주위 유동특성을 조사하기 위한 실험적 수치적 연구가 수행되었다. 축대칭 물체주위 유동특성 파악을 위해 선박해양공학연구센터의 캐비테이션 터널에서 표면압력분포와 LDV 장치를 이용한 주위유속분포 계측 시험이 우선적으로 이루어졌으며, 비압축성 RANS 방정식을 유한체적법으로 해석하는 수치적 방법이 표준 k-${\varepsilon}$ 난류모형을 이용하여 수행되었다. 선체와 프로펠러 상호작용은 양력면이론에 의하여 계산된 유기속도를 프로펠러 면에 분포하여 경계조건으로 처리하는 방법을 택하였다. 추진장치의 여러 가지 배열변화에 따른 실험적 결과를 기반으로 타당한 수치적 방법이 개발될 수 있다고 생각된다.

• 대한기계학회논문집B
• /
• 제41권6호
• /
• pp.373-380
• /
• 2017

본 연구에서는 레이놀즈 평균 나비어-스톡스(Reynolds-averaged Navier-Stokes, RANS) 방정식을 적용하여 스러스터(thruster) 상호작용에 대한 점성 유동 CFD 해석을 수행하였다. 수치해석은 상용 프로그램인 STAR-CCM+를 이용하였으며, 프로펠러와 No.19a 덕트로 스러스터 모델을 구성하였다. 프로펠러의 회전에 의한 동적인 움직임의 해석을 위해 슬라이딩 격자(sliding mesh)기법을 사용하였으며, 격자구성은 다중영역으로 구분하여 육면체 격자(hexahedral element)로 구성하였고, 계산 시간의 경제성을 고려하여 비등각(non-conformal) 격자를 이용하였다. 스러스터 배치를 그대로 유지한 상태에서 상류방향 스러스터의 방위각(azimuth angle)과 축 기울기에 따라 스러스터 상호작용이 크게 변화하였다. 이러한 결과를 통해 축 기울기와 방위각이 추진성능에 중요한 영향을 미치는 것을 확인하였다.

• Journal of Ship and Ocean Technology
• /
• 제8권2호
• /
• pp.1-12
• /
• 2004

To keep the ocean environment from pollutions, strict international requirements on the controllability are arisen to the VLCC. Especially in low speed operations near the harbor, the VLCC is often supported by tug to replenish the insufficient rudder force. When water jet is blown to the flapped rudder, the Coanda effect induces a high-lift force by delaying stall and re-enforcing circulation in a large angle of attack (Lachmann 1961, Ahn 2003). Based on numerous research efforts, the rudder system supported by the Coanda effect was devised and its performances were evaluated in the towing tank for a large VLCC model. Hydrodynamic forces acting on the rudder system were measured with a water jet blowing on the rudder surface and compared with those acting on a conventional rudder. The effectiveness of the new rudder system was proven through an experimental evaluation.

• 대한조선학회논문집
• /
• 제53권6호
• /
• pp.447-455
• /
• 2016

Precise propulsion shafting alignment of ships is very important to prevent damage of its support bearings due to excessive reaction forces caused by hull deflection, forces acted on propeller and crankshaft, and so forth. In this paper, a new iterative shafting alignment calculation procedure considering the interaction between shaft deflection and oil film pressure of Sterntube Journal Bearing (SJB) bush with single or multiple slopes is proposed. The procedure is based on a pressure analysis to evaluate distributed equivalent support stiffness of SJB by solving Reynolds equation and a deflection analysis of shafting system by a finite element method based on Timoshenko beam theory. SJB is approximated with multi-point biaxial elastic supports equally distributed to its length. Their initial stiffness values are estimated from dynamic reaction force calculated by assuming SJB as single rigid support. Then, the shaft deflection and the support stiffness of SJB are sequentially and iteratively calculated by applying a criteria on deflection variation between sequential calculation results. To demonstrate validity and applicability of the proposed procedure for optimal slope design of SJB, numerical analysis results for a shafting system are described.

• 대한조선학회논문집
• /
• 제41권6호
• /
• pp.75-83
• /
• 2004

Ice rubble pieces broken by the bow impact load and side hull of an icebreaking vessel usually pass along the ship's bottom hull and may hit the propeller/rudder or other stern structures causing serious damage to ship's hull . Therefore it is important to estimate the size of broken ice pieces during the icebreaking process. The dynamic interaction process of icebreaker with infinite ice sheet is simplified as a wedge type beam of finite length supported by elastic foundation. The wedge type ice beam is leaded with vertical impact forces due to the inclined bow stem of icebreaking vessels. The numerical model provides locations of maximum dynamic bending moment where extreme tensile stress arises and also possible fracture occurs. The model can predict a failure length of broken ice sheet given design parameters. The results are compared to Nevel(1961)'s analytical solution for static load and observed pattern of ice sheet failure onboard an icebreaker. Also by comparing computed failure length with the characteristic length, the meaning of ice rubble sizes is discussed.

• 대한조선학회논문집
• /
• 제35권4호
• /
• pp.19-26
• /
• 1998

본 논문은 선박의 조종성능을 추정하기 위하여 선체에 작용되는 유체력과 선체-프로펠라-타 상호 간섭 계수들에 대해 실험 및 반경험적 방법을 사용한 유사선 개념[1,2]을 도입하였다. 유사선 개념은 새로운 선박과 가장 유사한 선박의 기 실험된 데이타를 기본으로 채택한다. 유사선 개념을 적용하기 위해 기 실험된 선박에 대한 실험데이타가 존재해야 되며, 선체력의 변화를 평가하기 위한 반경험적방법이 채택되어야 하고, 기 실험된 선박의 데이타를 수정할 방법이 반드시 존재해야 된다. 유사선 개념을 근간으로, 만재흘수 상태의 실험결과를 이용하여 경하 및 하기만재흘수 상태에서의 선박조종성능을 추정하였고, 또한 유사선으로 기 실험된 선박을 선택하여 새로운 선박의 조종성능을 추정하였다. 본 논문의 계산 방법이 초기 설계단계에서 선박의 조종성능을 정확하게 추정할 수 있음을 확인하였다.

• 대한조선학회논문집
• /
• 제37권1호
• /
• pp.40-49
• /
• 2000

본 논문에서는 흔타를 장착한 유조선의 조타기 토오크를 초기 설계 단계에서 추정할 수 있는 경험식을 통계분석 방법을 사용하여 개발하였다. 흔타의 타단독 상태에서의 유체역학적 특성은 Molland의 수정 양력선 이론에 따라 계산하였고, 선미 와류 내의 추진기와 선체의 영향은 실적선 자료의 회귀 분석을 통하여 추정하였다. 끝으로 본 방법에 의해 얻어진 조타기 토오크 추정경험식을 실적선에 적용한 후 그 결과를 비교하였으며, 매우 유의성이 높음을 확인하였다.