• Bulletin of the Korean Chemical Society
• /
• v.33 no.3
• /
• pp.763-769
• /
• 2012

We investigated the width (N) dependence on the magnetization of N-ZSiC NR with electron and hole doping on the basis of systematic DFT calculations. The critical values of the upper and down critical concentration to give the maximum and zero magnetic moment at edge Si/C atoms by electron/hole doping ($x_{up,e}$, $x_{down,e}$, $x_{up,h}$, and $x_{down,h}$) depend on the width of N-ZSiC NR. Moreover, due to $x_{up,e}\;{\neq}\;x_{up,h}$ and $x_{down,e}\;{\neq}\;x_{down,h}$, the electron and hole doping effect are asymmetry, i.e, the critical electron doping value ($x_{down,e}$) is smaller than the critical hole doping value ($x_{down,h}$) and is almost independent of the width of NZSiC NR though the other critical values of the electron and hole doping that influence the magnetization of N-ZSiC NR depend on the width. It was also found that at $x_{down,e}$ or $x_{down,h}$ doping, the N-ZSiC NR turns into unusual non-magnetic metallic state. The magnetic behavior was discussed based on the band structures and projected density of states (PDOS) under the effect of electron/hole doping.

• Proceedings of the Korean Vacuum Society Conference
• /
• 2012.02a
• /
• pp.168-168
• /
• 2012

본 연구에서는 Molybdenum oxide (MoOx)-doped 4,4',4"-tris[2-naphthyl(amino)] triphenylamine(2-TNATA)의 P-doping에 의한 hole ohmic contact과 fullerene (C60)/lithium (LiF)의 electron ohmic contact에 의한 All Ohmic contact를 이용한 유기 발광 다이오드 (OLEDs)의 광저항 특성의 향상을 설명한다. 이 소자의 성능은 MoOx-doped 2-TNATA의 두께와 도핑농도에 큰 영향을 받는다. glass/ITO/MoOx-doped 2-TNATA (100 nm)/Al 구조의 소자에서 MoOx-doped 2-TNATA 도핑 농도가 25%에서 75%로 증가할수록 hole only device의 hole ohmic 특성이 향상됐다. 그 이유는 p-type doping effect 때문이다. 또한 photoemission spectra 분석결과, p-type doping effect는 hole-injecting barrier 높이는 낮추고, hole conductivity는 향상되었다. 이것은 2-TNATA에 도핑된 MoOx의 전하전송 콤플렉스의 형성으로 hole carrier의 수가 증가하여 발생되었다. MoOx-doped 2-TNATA의 hole ohmic contact과 fullerene (C60)/lithium fluoride (LiF)의 electron ohmic contact 으로 구성된 glass/ITO/MoOx-doped 2-TNATA (75%, 60 nm)/NPB (10 nm)/Alq3 (35 nm)/C60 (5 nm)/LiF (1 nm)/Al (150 nm)의 소자구조는 6,4V에서 127,600 cd/m2 최대 휘도와 약 1,000 cd/m2에서 4.7 lm/W의 높은 전력 효율을 보여준다.

• Korean Journal of Materials Research
• /
• v.29 no.12
• /
• pp.764-773
• /
• 2019

The gas response characteristic toward C₂H₅OH has been demonstrated in terms of copper-vacancy concentration, hole density, and microstructural factors for undoped/Li(I)-doped CuO thin films prepared by sol-gel method. For the films, both concentrations of intrinsic copper vacancies and electronic holes decrease with increasing calcination temperature from 400 to 500 to 600 ℃. Li(I) doping into CuO leads to the reduction of copper-vacancy concentration and the enhancement of hole density. The increase of calcination temperature or Li(I) doping concentration in the film increases both optical band gap energy and Cu2p binding energy, which are characterized by UV-vis-NIR and X-ray photoelectron spectroscopy, respectively. The overall hole density of the film is determined by the offset effect of intrinsic and extrinsic hole densities, which depend on the calcination temperature and the Li(I) doping amount, respectively. The apparent resistance of the film is determined by the concentration of the structural defects such as copper vacancies, Li(I) dopants, and grain boundaries, as well as by the hole density. As a result, it is found that the gas response value of the film sensor is directly proportional to the apparent sensor resistance.

• 한국정보디스플레이학회:학술대회논문집
• /
• 2006.08a
• /
• pp.1805-1808
• /
• 2006

In this paper, we describe a versatile use of fullerene(C60) as a charge transporting material for organic light-emitting diodes. The use of fullerene as a buffer layer for an anode, a doping material for hole transport layer, and an electron transport layer was investigated. Fullerene improved the hole injection from an anode to a hole transport layer by lowering the interfacial energy barrier and enhanced the lifetime of the device as a doping material for a hole transport layer. In addition, it was also effective as an electron transporting material to get low driving voltage in the device.

• Current Photovoltaic Research
• /
• v.10 no.1
• /
• pp.23-27
• /
• 2022

In this study, we investigate organic-inorganic halide perovskite solar cells with a vacuum thermal evaporated hole transporting layer (NPB/MoO_3-x). By replacing solution process based Spiro-MeOTAD with vacuum thermal evaporation based NPB/MoO_3-x, a thin hole transporting layer was implemented. In addition, parasitic absorption that may occur during the doping process was eliminated by excluding solution process doping. In a solar cell with a thin vacuum thermal evaporated hole transporting layer, the short-circuit current density (Jsc) increased to 23.93 mA/cm², resulting in the highest power converstion efficiency (PCE) at 18.76%. Considering these results, it is essential to control the thickness of hole transporting layer located at the top in solar cell configuration.

• 한국정보디스플레이학회:학술대회논문집
• /
• 2005.07b
• /
• pp.1401-1403
• /
• 2005

We present that the carrier balance can be improved by doping a hole transport layer of 4,4'- bis[N-(1-napthyl)-N-phenyl-amino]-biphenyl (${\alpha}$-NPD) with a hole blocking material of 2,9-dimethyl- 4,7-diphenyl-1,10-phenanthroline (BCP). The doping leads to disturb hole transport, which can enhance the balance of electron s and holes concentration in the emitting layer, aluminum tris(8 -hydroxyquinoline) (Alq3), resulting in enhanced electroluminescence (EL) quantum efficiency for the device with the doped ${\alpha}$-NPD.

• Progress in Superconductivity and Cryogenics
• /
• v.20 no.1
• /
• pp.28-31
• /
• 2018

Phase diagrams of electron- and hole-doped $Sr_2VO_3FeAs$ are investigated using Co and Mn substitution at Fe site. Metallic nature survives only for Co (electron) doping, not for Mn (hole) doping. The conductivity of $Sr_2VO_3(Fe,M)As$ (M=Mn,Co) is sensitive to the structural modification of FeAs microstructure rather than carrier doping. This finding implies that the FeAs layer plays a dominant role on the charge conduction, thus the $SrVO_3$ layers should be considered as an insulating block. Also, we found that the superconductivity is rapidly suppressed by both dopants. This result is different from the conventional behavior that superconductivity is induced by doping in the most of Fe pnictides. Our finding strongly supports the uniqueness of $Sr_2VO_3FeAs$ among the Fe pnictide superconductors.

• 한국정보디스플레이학회:학술대회논문집
• /
• 2006.08a
• /
• pp.70-73
• /
• 2006

Pentacene films, grown on polyethylene terephthalate (PET) substrates, were doped with Iodine. ESR measurements were made for the films in the temperature range of 100-300 K. Two regimes of doping stages were discernible: a light (intercalation) doping regime and a heavy doping regime. The light doping regime was concluded to be dominated by localized holes that were trapped at low temperatures, which indicated trap states near the valence band edge.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2002.07b
• /
• pp.1034-1037
• /
• 2002

In this study, we fabricated red organic electrolu-minescent device with a doping material (DCJTB), and The cell structure used ITO:indium tin oxide $[20{\Omega}]$/CuPc:Hole injection layer 20nm/NPB: Hole transfer layer 40nm/$Alq_3$ (host) + DCJTB(1% or 3%) (guest) Emitting layer 40nm/$Alq_3$ : Electron transfer layer 30nm/Al :Cathode layer 150nm. the luminescent layer consisted of a host material. 8-hydrozyquinoline aluminum $(Alq_3)$, and DCJTB dye as the dopant. a stable red emission (chromaticity coordinates : x=0.64, y=0.36) was obtained in this cell with the luminance range of $100-600cd/m^2$. we study the electrical and optical properties of devices.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.3 no.3
• /
• pp.165-169
• /
• 2002

Silicon wafer is very important accuracy make use semiconductor device substrate. In this research, for the uniformity dopant density distribution obtained to Neutron Transmutation Doping on make use Si in P Doping study work. In this research. we irradiated neutron on FZ silicon wafers which had high resistivity (1000~2000 ${\Omega}$cm), HANARO reactor was utilized resistivity changes due to observed, the generation of neutron irradiation on point defect analyzed, point defect on resistivity changes inquire into the effect. Before neutron irradiation theoretical due to calculated 5 ${\Omega}$-cm, 20.1 ${\Omega}$-cm for HTS hole and 5 ${\Omega}$-cm, 26.5 ${\Omega}$-cm, 32.5 ${\Omega}$-cm for IP3 hole. After neutron irradiation through SRP measurement the designed resistivities were approached, which were 2.1 H-cm for HTS-1, 7.21 ${\Omega}$-cm for HTS-2, 1.79 ${\Omega}$-cm for IP-1, 6.83 ${\Omega}$-cm for IP-2, 9.23 ${\Omega}$-cm for IP-3, respectively. Also after neutron irradiation resistivity changes due to thermal neutron dependent irradiation hole types free.