• Proceedings of the Korean Society for Technology of Plasticity Conference
• /
• 1999.08a
• /
• pp.172-179
• /
• 1999

As the martensite structure cause fracture failure during drawing from 5.5mm rod to 3.05mm dia. wire without additional heat treatment, the optium cooling condition to inhibit the occurrence of martensite was investigated. In order to get SAE9254+V quality, the effects of alloying element, vanadium on the mechanical properties were investigated. Based upon CCT and TTT curves and the results form cooling test in mill, optimun cooling was found in the condition of the laying head temp of 780$^{\circ}C$ and of the conveyor speed at 0.15m/sec with the whole cover closed. The wire rods produced under the condition showed the best mechanical properties of 120kg/$\textrm{mm}^2$ in TS and 50% in RA, having an excellent drawability. In vanadium added steels, tensile strength was improved without degrading elongation and charpy impact value. That means the strengthening by vanadium is mainly due to the grain refinement by the fine precipitates during tempering process.

• Proceedings of the KIEE Conference
• /
• 1996.07c
• /
• pp.1657-1659
• /
• 1996

The objective of this study is to provide a life prediction of isothermal fatigue using strain partitioning of high temp. steel for power plants. The experimental system was composed of Instron 8501, induction heating system, extensometer and pyrometer with hydraulic power system

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 1988.05a
• /
• pp.7-9
• /
• 1988

This paper considers problems which must be overcome to produce long lengths of superconductor wire from the 90K Tc superconducting ceramic material, $Y_1Ba_2Cu_3Ox$. Attention is focused on the powder-in-tube process where the superconducting powder is placed in a tube which is then formed into wire. Two major problems are considered, control of the oxygen level and improvement of Jc in the final wire. The results show that Jc of the wire were $400A/cm^2$ at liquid nitrogen temp.

• Journal of Korean Society of Water and Wastewater
• /
• v.21 no.1
• /
• pp.83-89
• /
• 2007

A biological anoxic-aerobic reactor filled with porous media was operated in lab scale for the advanced wastewater treatment. The experiments were conducted for 6 months with three HRTs (4, 6, 8hr) and temperature of $23{\sim}25^{\circ}C$. Some other experimental conditions were as follows; nitrification reactor (MLSS 4,500mg/L, DO 3.3mg/L, $23{\sim}28^{\circ}C$), denitrification reactor(MLSS 8,000mg/L, ORP -100mV, Temp.$19{\sim}23^{\circ}C$). Average removal efficiencies of SS, $BOD_5$, $COD_{Cr}$, T-N, and T-P were 97.8%, 95.5%, 94.5%, 80.2%, and 60.6%, respectively. The reactor filled with porosity media showed stable removal capacity for organics and nutrients. Fast and complete nitrification and denitrification were accomplished. Maintaining high MLSS with porous media in the nitrification and denitrification reactor appears to enhance the nitrogen removal process. For the higher T-P removal, some coagulant addition process will be needed.

• The Magazine of the Society of Air-Conditioning and Refrigerating Engineers of Korea
• /
• v.5 no.4
• /
• pp.272-280
• /
• 1976

A natural ventilating type store was designed for the economic and effective storage of citrus fruits in Jejudo. The material used for the wall is scoria, widely distributed in Jejudo and known for high strength and insulation. Design condition was chosen for the period till March of a year and the dry bulb temperature was taken from TAC $5\%$ base. The temperature of the store can be maintained below the limiting temperature of $8^{\circ}C$ for the time length of $7\frac{1}{2}$ hours under the condition of the atmospheric temp, $15.3^{\circ}C$ and the solar insolation. The limiting temperature can he recovered to the initial temperature $(7^{\circ}C)$ by the natural ventilation for 8 hours in the night.

• Journal of Korea Technical Association of The Pulp and Paper Industry
• /
• v.33 no.2
• /
• pp.32-40
• /
• 2001

It is desirable to reduce the amounts of fresh water and reuse the recycled water in papermaking process. In an attempt to improve the efficiency of recycling water refining treatment and to enhance the productivity of OCC recycling mill, up flow anaerobic sludge blanket(UASB) reactor was developed and introduced to Korea recently. In order to maximize the operating efficiency and minimize the adverse side effects it is imperative to estimate and evaluate the total effects of new system, UASB on the whole OCC recycling process. This study was carried out with a view to investigate the effects of the high temperature and alkalinity of process water on the quality ad productivity of testliner of OCC recycling mill which is equipped with UASB reactor and almost closed. Another object of this study was searching for the best available use of UASB treated process water. The results were as follows; Reuse of UASB treated water characterized with high temp and alkalinity was useful to improve the strength and drainage properties of recycled OCC owing to its good points of promoting OCC disintegration and reducing the calcium hardness of process water. However, it might not be avoidable to induce the increase of dissolved solids in process water in accordance with direct introducing of UASB treated water into the former stage of OCC stock preparation. So it would be advisable to adopt the UASB treated water in the stage of clean, screened OCC stock.

• Bulletin of the Korean Chemical Society
• /
• v.9 no.5
• /
• pp.289-291
• /
• 1988

The ratio of trivalent to divalent copper has been determined by the redox titration for two superconducting phases of $YBa_2Cu^{3+}_{2x}Cu^{2+}_{3-2x}O_{6.5+x}$ with the onset temp. of 60K (x = 0.23 ${\pm}$ 0.01) and 90K (x = 0.35 ${\pm}$ 0.02), and for the insulating one (x ${\cong}$ 0) which was kept in an ambient atmosphere for 72 hrs. It is found that $T_c$, and the ratio of $Cu^{3+}/Cu^{2+}$ depend strongly on the annealing temperature and time. A typical orthorhombic phase can easily be obtained by a slow cooling or stepwise cooling at $PO_2$ = 1 atm, and shows a high Tc (ca. 90K) superconductivity.

• Journal of Environmental Health Sciences
• /
• v.34 no.5
• /
• pp.374-381
• /
• 2008

In this study, the factors affecting biological N and P removal using SND (simultaneous nitrification and denitrification) process were investigated and evaluated to examine the possibility of treating N and P through SND with NADH by surveying N and P traces in an aeration tank. Variations of $NH_4^+$-N+$NO_3^-$-N concentration were used to estimate the degree of SND in each point (P2, P3, P4, P5) of the aeration tank and these variations showed that denitrification efficiency in P2 (front zone), nitrification and denitrification efficiencies in P4 (middle zone) were 67%, 86% and 39%, respectively. When $PO_4^{-3}$-P concentration was analyzed in each point of the aeration tank, it was shown that $PO_4^{-3}$-P concentration coming into P2 was 1.25 mg/L, which increased to 2.22 mg/L by P release in P2 zone and then decreased to 0.74 mg/L by P uptake in P4. Consequently, we were able to estimate which high P removal efficiency observed in this study was caused by biological phosphorus removal. To determine the operating factors affecting effluent T-N, we analyzed the correlation among FN/M ratio, C/N ratio, Temp., SRT etc and these results showed that the correlation among FN/M ratio, C/N ratio and Temp was not high. However, the relationship of SRT and other parameters (effluent $NH_4^+$-N and effluent BOD) and the short SRT could have an affect on effluent $NH_4^+$-N and so effluent BOD could be increased. Thus, SRT operation should be controlled over 10 days. The results for analyzing the correlation between SRT and influent $NO_3^-$-N in order to investigate the operating factors affecting effluent T-P showed that T-P or $PO_4^{-3}$-P was not highly correlation with SRT, whereas $PO_4^{-3}$-P concentration increased along with increasing $NO_3^-$-N concentration into P2. Based on these results, we concluded, using regression analysis (R2=0.97), that effluent $PO_4^{-3}$-P concentration depends on $NO_3^-$-N concentration into P2.

• Korean Journal of Materials Research
• /
• v.8 no.10
• /
• pp.879-883
• /
• 1998

In the vacuum casting process for superalloys, molten metal are poured into the heated ceramic mold up to $1000^{\circ}C~1700^{\circ}C$. The mold has to have the high temperature strength during casting and made by hlgh purity alumina. In this sturdy, the mold was made by low purity alumina and changed silica contents intended to have high strength The 7.7wt.% SiOz specimens have 10- 55% higher strength than others in room and high temp. Therefore, the cast mold has been developed in this study for single crystal vacuum cast by controlling the ratio of fused alumina and colloidal silica which are used commercially for conventional casting in industries.

• Korean Journal of Weed Science
• /
• v.16 no.4
• /
• pp.309-316
• /
• 1996

In this study, germination characteristics and herbicidal response of green kyllinga(Kyllinga brevifolia var. leiolepsis H.) were investigated. The storage method desirable for a rapid dormancy release was to keep the seed under low temp. and wetting condition for one to two months, or high temp($40^{\circ}C$) and drying condition for three months. The dormancy of rhizome was hardly observed. The optimum temperature for germination of seed and rhizome was around $30^{\circ}C$ and 16-$20^{\circ}C$, repectively. The germination of dormancy-breaked seed was completely dependent on light. Shoot emergence ratio(%) was decreased with increase of planting depth ; for example, only 18% of rhizome segments planted in the depth of 4cm under soil surface emerged above soil surface. Flooding at earlier growth stage resulted in significant decrease in shoot emergence as well as in dry weight. The germinablity of rhizome was almost lost as a decreased in fresh weight reached to 50%. Usually, green kyllinga was sensitive to herbicides such as bentazone, bensulfuron and benfuresate etc. which were known to be effective in Cyperaceae weeds, indicating that green kyllinga can be used as a representative plant in the screening of herbicides for Cyperus weeds.